This study reports the evaluation of chemical composition of a Black Vistula and White Vistula streams' waters taking into consideration both geological conditions of the stream's catchment area and different water' level related to seasonal variations in particular catchment ecosystem (high stage: beginning of the vegetation period; medium stage: vegetation period; low stage: final time of vegetation period). The complex data matrix (744 observations), obtained by the determination of major inorganic analytes (Cl⁻, NO₃ ⁻, SO₄ ²⁻, NH₄ ⁺, Na⁺, K⁺, Ca²⁺, Mg²⁺) in water samples by ion chromatography was treated by linear discriminant analysis and non-parametrical testing. In case of both streams obtained results indicate presence of two discriminant functions (DFs). The data variance explained by DFs is as follows: Black Vistula stream--first DF: 93.5%, second DF: 6.5%; White Vistula stream--first DF: 66.3%, second DF: 33.7%. In case of Black Vistula stream first DF allows distinction of medium, high and low waterstage related samples while second DF between high/low and medium water stage related samples. In case of White Vistula stream first DF allowed to distinguish between medium/high and low water stage related samples while second DF between medium and high water level samples. In case of both streams, the most informative DFs were related to geological conditions of investigated catchments (contents of Cl⁻, Na⁺, K⁺, Mg²⁺, Ca²⁺, SO₄ ²⁻), while the second to nutrient biocycle (mainly NH₄ ⁺ and NO₃ ⁻) related to slope's exposition and inclination.

The arsenic bioavailability in the bed sediments from the Anllóns River (NW Spain) has been assessed by using several analytical approaches. A six-step sequential fractionation was compared to three general availability tests: the Toxicity Characteristic Leaching Procedure (TCLP) extraction, which estimates the leaching potential of As and its effect on the survival of microorganisms (Vibrio fischeri), an extraction with 1 M HCl extraction, which estimates the bioavailability to higher plants, and a physiologically based extraction test (PBET), which estimates the bioavailability to superior animals. Arsenic was found to be mainly associated to the least mobile fractions: bound to Fe-Al oxides and in the residual phase. Among the three single extractants considered, the PBET extracted the highest As concentrations (1-11% of the total As). The TCLP extracts showed toxicity to Vibrio fischeri whereas for the plants evaluated, aqueous extracts did not show adverse effects.

Acid mine drainage (AMD), a legacy of coal and mineral extraction, contaminates streams with complex mixtures of acid and heavy metals that are usually partitioned between the water column and substrate. Understanding the conditions under which sediments retain toxicity after the water column is cleared is important for predicting the long term success of remediation efforts. We conducted laboratory and field experiments to evaluate the relative contribution of acidity versus metals to the toxicity of AMD contaminated sediment towards aquatic macroinvertebrates. Laboratory bioassays showed that precipitate-coated substrate from AMD-impacted sites were toxic to Ctenodaphnia magna and reduced growth of mayflies (Ephemeroptera: Heptageniidae). Toxicity correlated more with acidity released from the sediment than with metals. After transplantation to a clean stream, the same Al- and Fe-contaminated substrate were not toxic to daphnia and was readily colonized by benthic macroinvertebrates within 5 weeks.

Otoliths of black bream (Acanthopagrus butcheri) collected from the Swan River Estuary were analysed by Laser Ablation Inductively Coupled Plasma Mass Spectrometry (LA-ICP-MS) to measure concentrations of 14 trace metals. Trace metal concentrations in the otoliths may be related to the environmental exposure history of fish to contamination. The following metal isotopes were investigated: aluminium (²⁷Al), calcium (⁴⁴Ca), manganese (⁵⁵Mn), iron (⁵⁷Fe), copper (⁶⁵Cu), zinc (⁶⁶Zn), strontium (⁸⁸Sr), cadmium (¹¹¹Cd), tin (¹²⁰Sn), barium (¹³⁸Ba), mercury (²⁰²Hg), lead (²⁰⁸Pb) and the metalloids arsenic (⁷⁵As, ⁷⁷As) and selenium (⁸²Se). Significant differences in otolith trace metal composition were found between sampling sites. Lead and ⁵⁷Fe were consistently lower in downstream fish relative to upstream fish, while ⁸⁸Sr varied with the salinity gradient in the urban estuary. Lead and ⁵⁷Fe followed similar patterns within the otoliths, and appeared to provide the best discriminatory power for relating otolith metal concentration to the environmental history of the fish.

Aqueous phase adsorption of three textile dyes onto a granular activated carbon produced from acid activation of almond shells is presented. Primarily, the sorption of three basic dyes, methylene blue, rhodamine b, and malachite green oxalate were studied. Four models, the Freundlich, the Langmuir, the Redlich-Peterson, and the Toth isotherms were compared for their quality of fit to the single-solute sorption data. Next, sorption of the three likely binary systems was examined. Four bi-solute models, the extended Langmuir with and without an interaction term, the extended Redlich-Peterson with an interaction term, and the empirical extended Freundlich model were used to predict sorption in the binary systems. Nonlinearly determined constants of the corresponding single-solute isotherms were used in the binary models to compare with experimental binary sorption data. For the single-solute system, the three-parameter models of the Redlich-Peterson and the Toth isotherms outperformed the Langmuir and Freundlich models. The empirical extended Freundlich model produced the closest comparison to the binary data in each system. In general, the nonlinear method provided a simple and computationally effective technique of producing optimal fitting parameters for the bi-solute sorption models.

The mass, ionic and elemental size distributions of particulate matter (PM) measured indoors and outdoors in an apartment situated in a north-westward suburb of Prague are presented. The PM samples were collected by two Berner type low pressure impactors separating particles into 10 size fractions from 26 nm to 10 μm and were further analyzed by ion chromatography (IC) and proton induced X-ray emission (PIXE). Temperature, pressure and relative humidity were measured both indoors and outdoors parallel to PM sampling. The indoor and outdoor PM dynamics were recorded by two scanning mobility particle sizers (SMPS) and an aerodynamic particle sizer (APS). Finally, the ventilation rate was determined by a radon technique. Ion chromatography showed that the major inorganic components of the fine particle mode are sulfate, nitrate, and ammonium with very low indoor nitrate concentration. Crustal elements (Al, Si, Ca, Ti, Mn, and Fe) were associated with the coarse aerosol mode. The presence of people increased the mass concentration of coarse particles, whereas cooking, smoking, and burning of incense and candles contributed predominantly to the fine particle mode. Smoking and the burning of incense also increased the concentration of potassium, bromine and chlorine content in fine particles.

In the present study, during a period of 16 months Colilert 3000 was validated in laboratory and field tests and compared to standard laboratory methods for monitoring of coliforms and E. coli. No false positive/negative results for coliforms/E. coli were found in 80 potable well water samples monitored with the Colilert 3000 and compared to standard methods. Although usage of Colilert 3000 to monitor raw water is not recommended by the manufacturer, the E. coli results of 100 samples were 100% positive by membrane filtration, Colilert 18 and MPN and only 80% positive by the Colilert 3000. In addition, in all positive samples, Colilert 3000 and Colilert 18 showed higher results of two to three orders of magnitude compared to MF and MPN. This significant difference was probably due to the presence of Aeromonas spp. and Vibrio spp. (natural inhabitants of the raw surface water) known to interfere with the Colilert test. Treated surface water was monitored by Colilert 3000 for the presence of coliforms and E. coli. Among the 100 samples tested in parallel by membrane filtration all were negative, while with Colilert 3000 only 76% were negative. Post-test identification of the positive samples did not reveal the presence of E. coli but interfering microorganisms. The last application was to evaluate Colilert 3000 to monitor accidental or deliberate pollution of drinking water with sewage sources. Among 20 samples spiked with raw sewage (0.1 and 1%) all results were positive for both coliforms and E. coli. The time span required for Colilert 3000 to detect positive samples was 6-10 h compared to 24 h with the standard membrane filtration.

The chemical composition of precipitation in the city of Mersin on the Mediterranean coast of Turkey has been studied. Spatial and temporal variability of rainwater constituents have been determined from samples collected at two central and two suburban stations for the December 2003-May 2005 period. A total of 246 samples covering all precipitation events were analyzed to determine pH, conductivity, as well as major anion (Cl-, [graphic removed] , [graphic removed] ); major cation (H⁺, Na⁺, K⁺, Ca²⁺, Mg²⁺, [graphic removed] ) and formaldehyde (HCHO) concentrations. The pH varied within a range of 4.8-8.5, with only 8 out of 246 samples being acidic (pH < 5.6), and the remaining highly alkaline samples being neutralized by either [graphic removed] in rainwater, or by CaCO₃ resulting from wet deposition of atmospheric dust. The volume weighted mean ΣAnion/ΣCation ratio was 0.49. The equivalent concentration of major ionic species followed the order: [graphic removed] . Formaldehyde concentrations varied in the range of 0.01-17.9 μM, and was found to be dependent on precipitation volume. Relatively higher [graphic removed] , [graphic removed] , [graphic removed] and HCHO concentrations, mainly of anthropogenic origin, measured near the city center suggest increased pollution from local anthropogenic sources, e.g., residential heating, industrial and/or traffic emissions. In general, the results of this study suggest local precipitation chemistry is more strongly influenced by natural (mineral dust and marine) sources compared to anthropogenic ones.

In Europe more than 2,500 lysimeters operated by research institutes and industry (Lanthaler 2005). Originally lysimeters were built for investigations of soil water and solutes, nutrient leaching and pesticide degradation (see e.g. Winton and Weber 1996). Currently lysimeters additionally used as a tool for investigations on biological processes, and structural changes of plants, including root distribution, and enzyme activities etc. (see e.g. Dizer et al. 2002; Schloter et al. 2005).

Spectroscopic (XRD, XPS, ICP-MS and AAS) and microscopic (ESEM) techniques have been used in order to study the chemical effects with emphasis on mercury speciation, during thermal treatment of a mercury contaminated soil. In the untreated soil, mercury was found concentrated in spherical particles, which were successively broken down upon thermal treatment. Hg⁰ and inorganic mercury compounds (presumably HgO(s) and HgSO₄(s)) could be detected. No (CH₃)₂Hg and only traces of CH₃Hg⁺ could be found. The dependence on temperature and heating time indicated that the evaporation of mercury from the soil was partly controlled by diffusion mechanisms. Mercury volatilized in two separate stages during heating; initial elemental vaporization, and subsequent volatilization of the oxide or sulfate phase at higher temperatures (>230°C). By thermal treatment at 470°C and 20 min, a removal of >99% of the mercury could be achieved.