In the current study, the toxicity bioassay of three pollutants abamectin (ABM), thiamethoxam (TMX), and acrylamide (ACR) against land snails Theba pisana was measured. Also, the ecotoxicological effects of dietary exposure to sublethal concentration (1/20 LC₅₀) of these pollutants for 2-week exposure and 1-week recovery on some physiological endpoints evaluated as feeding activity, growth response, and carbonic anhydrase activity as a marker in charge of shell formation and seromucoid level as a marker in charge of mucus synthesis of the snails were studied. The results exhibited that the 48-h LC₅₀ values were 0.91, 313.8, and 45.7 μg/g dry food for ABM, TMX, and ACR, respectively. The sublethal concentrations of these pollutants in the diet after 2-week exposure were found to reduce the food consumption and inhibit growth rate of the snails. Also, the data illustrated that carbonic anhydrase activity was significantly decreased. On the other hand, there was a significant increase in the seromucoid level as a marker responsible for mucus synthesis in ABM- and TMX-exposed snails, while ACR showed significantly decreased level when compared to control. After 1-week recovery, the tested endpoints of treated snails were slightly repaired but still less than that of the untreated animals. The overall outcome of this investigation suggests the utility of this animal as a good bioindicator organism for ABM, TMX, and ACR exposure in pollution monitoring studies.

The aim of this study is to provide an analysis of the impact of ecogenotoxicity on native flora abortivity in various urban areas. In which, there was an analysis of 5 groupings of locations with a differing environmental load intensity within the city of Bratislava (Slovakia) over a 2-year period. Our results show varying data depending on the proximity of each site relating to a direct source of pollution and the potential impact of localized wind currents on the distribution of pollutants in the urban environment. The highest value of pollen abortivity in the city was observed in a group of locations exposed to heavy traffic pollution loads. Abortivity of native flora near heavy traffic road areas correlated with the imissions data measured in the same area. Wind-exposed uncovered sites also experienced higher values of native flora abortivity. These results confirmed the varying intensity of genotoxic impact in differing localities and also suggest that xenobiotic effects on flora can occur remotely from the original source of pollution.

Passive samplers based on diffusive gradients in thin hydrogel films (DGT) were recently modified for sampling of polar organic compounds in water. However, since the sampling rates of the commonly used DGT design with the surface area of 3.1 cm² are low, we propose to increase them by applying a two-sided design with a larger sampling surface area of 22.7 cm². The sampler design consists of two sorptive hydrogel disks compressed between two diffusive hydrogel disk layers strengthened by nylon netting and held together by two stainless steel rings. Sorbent/water distribution coefficients (KSW) were determined, and the sampler was calibrated for monitoring 11 perfluoroalkyl substances and 12 pharmaceuticals and personal care products in water at laboratory conditions using a closed system with artificial flow generated by submersible pumps. A field performance test was conducted at five locations in the Morava River basin in Czech Republic. The median value of laboratory-derived sampling rates was 43 mL day⁻¹ with extreme values of 2 mL day⁻¹ and 90 mL day⁻¹ for perfluorotridecanoic and perfluoroheptanoic acids, respectively. The log KSW values of tested compounds ranged from 3.18 to 5.47 L kg⁻¹, and the estimated halftime to attain sampler-water equilibrium ranged from 2 days to more than 28 days, which is the maximum recommended exposure period, considering potential issues with the stability of hydrogel. The sampler can be used for assessment of spatial trends as well as estimation of aqueous concentration of investigated polar compounds.

This paper presents the methodology and results of the national radon survey in Bulgaria and its spatial variability. The measurements were carried out in 2778 dwellings using CR-39 track detectors over two successive 9 and 3-month periods from April 2015 to March 2016. The arithmetic (AM) and geometric (GM) means of annual indoor radon concentration were 111 ± 105 Bq/m³ and 81 Bq/m³ (GSD = 2.15), respectively. The distribution of data has been accepted to be log-normal. Two hypotheses have been investigated in the paper. The first one was a spatial variation of indoor radon concentration and the second was spatiality of the factor that influences radon variation. The indoor radon concentrations in the 28 districts have been significantly different, which prove the first hypothesis. The influence of the factors, geology (geotectonic unit, type of rock, and faults distance of the measuring site), type of the region, and the presence of the basement in the building on radon spatial variation, was examined. The analyses have been shown that they significantly affect radon variations but with a relatively small contribution in comparison to the radon variation between district. Furthermore, the significance and contribution of the investigated factors were different in each district, which confirmed the second hypothesis for their spatiality.

This research focuses on the detailed experimental assessment of compression ignition (CI) engine behavior fuelled with Aegle marmelos (AM) seed cake pyrolysis oil blends. The study on effects of engine performance and emission a characteristic was designed using L₂₅ orthogonal array (OA). These multi-objectives were normalized through gray relational analysis (GRA). Likewise, the principal component analysis (PCA) was performed to assess the weighting values respective to every performance and emission characteristics. The variability induced by using the input process parameters was allocated using analysis of variance (ANOVA). Hence, GRA-coupled PCA were employed to determine the optimal combination of CI engine control factors. The greater combination of engine characteristics levels were selected with F₅ and W₅. The higher brake thermal efficiency (BTE) have been obtained for F20 fuel as 22.01% at peak engine load, which is 11.43% for diesel. At peak load condition, F20 fuel emits 14.99% lower HC and 18.52% lower CO as compared to diesel fuel. The improved engine performance and emission characters can be attained by setting the optimal engine parameter combination as F20 blend at full engine load condition. The validation experiments show an improved average engine performance of 67.36% and average lower emission of 64.99% with the composite desirability of 0.8458.

Workers chronically exposed to respirable crystalline silica (CS) are susceptible to adverse health effects like silicosis and lung cancer. This study aimed to investigate potential early peripheral biomarkers of inflammation and oxidative stress in miners. The subjects enrolled in this study were occupationally unexposed workers (OUW, n = 29) and workers exposed to crystalline silica (WECS), composed by miners, which were divided into two subgroups: workers without silicosis (WECS I, n = 39) and workers diagnosed with silicosis, retired from work (WECS II, n = 42). The following biomarkers were evaluated: gene expression of L-selectin, CXCL2, CXCL8 (IL-8), HO-1, and p53; malondialdehyde (MDA) plasma levels and non-protein thiol levels in erythrocytes. Additionally, protein expression of L-selectin was evaluated to confirm our previous findings. The results demonstrated that gene expression of L-selectin was decreased in the WECS I group when compared to the OUW group (p < 0.05). Regarding gene expression of CXCL2, CXCL8 (IL-8), HO-1, and p53, significant fold change decreases were observed in workers exposed to CS in relation to unexposed workers (p < 0.05). The results of L-selectin protein expression in lymphocyte surface corroborated with our previous findings; thus, significant downregulation in the WECS groups was observed compared to OUW group (p < 0.05). The MDA was negatively associated with the gene expression of CXCL-2, CXCL8 (IL-8), and p53 (p < 0.05). The participants with silicosis (WECS II) presented significant increased non-protein thiol levels in relation to other groups (p < 0.05). Taken together, our findings may contribute to help the knowledge about the complex mechanisms involved in the silicosis pathogenesis and in the risk of lung cancer development in workers chronically exposed to respirable CS.

In this study, reduced graphene oxide (RGO) was synthesized by L-ascorbic acid reduction, which was a relatively mild and environmental friendly reduction method, and the adsorption of organic contaminants was compared to graphene oxide (GO) to probe the potential adsorption mechanisms. The morphology properties of GO and RGO were characterized by X-ray photoelectron spectroscopy (XPS), Fourier transform infrared transmission (FTIR), Raman spectrometer, transmission electron microscope (TEM), and scanning electron microscopy (SEM). The adsorption affinities of GO and RGO for phenanthrene and 1-naphthol were studied in batch experiments. The effects of pH and surfactants were also assessed. The results demonstrated that RGO reduced by L-ascorbic acid show significantly greater adsorption affinity for both phenanthrene and 1-naphthol than GO, and even greater than most of RGOs that reduced by the strong reductive reagents. This was mainly attributed to the hydrophobic interaction, π–π interaction, and H-bonding between graphene sheets and organic contaminants. Both GO and RGO showed stronger adsorption to phenanthrene than to 1-naphthol. The adsorption of 1-naphthol increased with decreasing pH and reached a maximum around pH = 7.34. The surfactants, sodium dodecyl benzene sulfaonate (SDBS) and cetyltrimethyl ammonium bromide (CTAB), had negligible influence on adsorption to GO. Note that CTAB significantly inhibited the adsorption of phenanthrene/1-naphthol on RGO, which could be attributed to the pore blockage effect. In addition, RGO could be regenerated and reused with high recyclability over five cycles. The present study suggests that RGO obtained via L-ascorbic acid reduction can be deemed as a promising material for organic contaminated wastewater treatment.

Arbuscular mycorrhizal fungi (AMF) are obligate plant root symbionts delivering a range of benefits to the host plant such as improved nutrient acquisition and resistance to pathogens and abiotic stress. However, whether they can enhance the function of plant root systems damaged due to subsidence caused by excessive coal mining has not been well explored. In the present study, we investigated the effects of AMF using Funneliformis mosseae (FM) as the test fungus on maize (Zea mays L.) growth and hormone levels under different levels of root damage stress by simulating mining subsidence. The results show that plants treated with FM had more shoots, roots, mycorrhizal colonization and higher hyphal density than those without FM under the same simulated mining-induced subsidence conditions. In addition, plants treated with FM also possessed higher N, P, K, Ca, and Mg contents in the shoots and the roots and higher indole-3-acetic acid, gibberellin (GA), and cytokinin (CTK) contents in the roots, indicating that the mycorrhizal association promoted plant biomass and nutrient uptake. FM treatment was no longer beneficial when root damage due to mining-induced subsidence affected more than half of the roots. Soil SOC, AK, and TG were identified as key factors affecting GA, CTK, IAA, and ABA, and AMF can alter plant hormones directly via the hyphae and indirectly by altering soil physicochemical properties under root damage stress. Overall, our results provide baseline data for assessing the biological reclamation effects of AMF on coal mining-induced subsidence.

This study evaluated an enhancement of simultaneous polycyclic aromatic hydrocarbon (PAH) biodegradation and lipid accumulation by Rhodococcus opacus using biochar derived cheaply from biomass gasification effluent. The chemical, physical, morphological, thermal, and magnetic properties of the cheaply derived biochar were initially characterized employing different techniques, which indicated that the material is easy to separate, recover, and reuse for further application. Batch experiments were carried out to study biochar-aided PAH biodegradation by R. opacus clearly demonstrating its positive effect on PAH biodegradation and lipid accumulation by the bacterium utilizing the synthetic media containing 2-, 3- or 4-ring PAH compounds, at an initial concentration in the range 50–200 mg L⁻¹, along with 10% (w/v) inoculum. An enhancement in PAH biodegradation from 79.6 to 92.3%, 76.1 to 90.5%, 74.1 to 88.2%, and 71.6 to 82.3% for naphthalene, anthracene, phenanthrene, and fluoranthene, respectively, were attained with a corresponding lipid accumulation of 68.1%, 74.2%, 72.4%, and 63% (w/w) of cell dry weight (CDW). From contact angle measurements carried out in the study, enhancement in PAH biodegradation and lipid accumulation due to the biochar was attributed to an improved bioavailability of PAH to the degrading bacterium.

The three-dimensional quantitative structure-activity relationship (3D-QSAR) model is established for polychlorinated naphthalenes (PCNs) using the biological degradability (total score) results to modify CN-56 to design 37 new derivatives with higher degradability (increased by 14.55–38.79%). Furthermore, five new CN-56 derivatives are selected through evaluation of their persistent organic pollutant properties (toxicity, bioconcentration, long-range transport) and practicability (stability, insulativity, flame retardancy) using 3D-QSAR, density functional theory (DFT) and molecular docking methods. Environmental and health-based risk assessments are conducted using the multimedia fugacity model and fuzzy theory for complete screening of the new CN-56 derivatives. Whereas CN-56 is classed as high risk, three new derivatives can be classed as medium risk. The biodegradability mechanism analysis of the PCNs indicates that the electrostatic property is the main factor that affects the degradability, which provides a favorable theoretical reference to obtain environmentally friendly fire retardant and insulating materials.