The objective of the present study was to investigate the responses of the chironomid communities (Diptera: Chironomidae) to environmental variables in four moderately and highly disturbed rivers located in one of the most degraded watersheds in South America. Sampling campaigns were carried out during 2014–2016 in four sites of the Matanza-Riachuelo basin. The physical-chemical and hydrological variables were measured and, the ecological indices were calculated and evaluated by ANOVA. The responses of Chironomidae to the environmental variables were evaluated by redundancy analysis (RDA), and the sampling sites were grouped according to the populations of chironomids and the main environmental variables. Finally, the Spearman correlation was made to determine which of these variables were significant. In total, 13 chironomid taxa were found in 36 samples during the study period. The greatest density registered belongs to Rheotanytarsus and Cricotopus. The ANOVA detected the greatest Chironomidae density and taxonomic richness in the sites with agricultural-urban impact. The changes in the distribution of Rheotanytarsus, Thienemanniella, and Polypedilum were mainly explained by the increase in current velocity, organic matter, and hardness, and the decrease of NH3 and BOD. On the other hand, Goeldichironomus, Chironomus, Parachironomus, Dicrotendipes, and Cricotopus were explained by the increase in conductivity, dissolved oxygen, and temperature, and the decrease of the variables NO3, BOD, and Cu. In addition to this, the sites with urban-agricultural impact were clearly separated from sites with urban-industrial impact. The last one was more related to the increase in BOD, Cu, and NO3 that indicates moderate to poor water quality. In conclusion, we can infer that the physical and chemical variables are correlated with changes in the structure and distribution of the chironomid community and there are genera that respond differently at high and intermediate situations of disturbances. This knowledge contributes to the execution of strategies for the conservation and restoration of the lotic ecosystems.

Cadmium (Cd) contamination in agricultural soils is a prevalent environmental issue and poses potential threats to food security. Foliar ascorbic acid might prove a potent tool to alleviate toxicity of Cd toxicity in maize. An experiment was conducted with objectives to study exogenous ascorbic acid–modulated improvements in physiochemical attributes of maize under Cd toxicity. The experiment was conducted under completely randomized design. Treatments were comprised of varying concentrations of foliar ascorbic acid viz. 0.0, 0.1, 0.3, and 0.5 mM of AsA. Toxicity of Cd decreased the maize growth, increased lipid peroxidation, disturbed protein metabolism, and reduced the antioxidant defense capabilities compared with the control. However, foliar AsA significantly improved maize growth and development, photosynthetic capabilities, and protein concentrations in Cd-stressed maize plants. Meanwhile, the malondialdehyde contents and hydrogen peroxide accumulation levels in Cd-stressed maize plants decreased remarkably with increasing AsA concentrations. Furthermore, the combined treatments conspicuously boosted activities of superoxide dismutase, peroxidase, catalase, and glutathione reductase under the Cd stress alone. In addition, the application of AsA reduced the Cd uptake by 10.3–12.3% in grains. Conclusively, foliar ascorbic acid alleviated the negative effects of Cd stress in maize and improved photosynthetic processes, osmolytes, and antioxidant defense systems.

The microalgae-based water treatment is gaining importance in recent years as it serves multiple purposes of which includes water treatment and biofuel production. Garcinia cambogia, a Malabar tamarind is a tropical fruit and the active ingredient hydroxycitric acid is popularly used as a weight-loss supplement. After extraction of the hydroxycitric acid, the wash water of G. cambogia is considered as an effluent. The potential microalgal species that can grow and treat G. cambogia wash water were isolated and identified as Dicloster acuatus BVR1 and Kalenjenia gelanitosa BVR2. Both the microalgal species adapted to G. cambogia wash water and entered exponential phase after sixth day with maximum specific growth rate of 0.310 day⁻¹ for D. acuatus and 0.296 day⁻¹ for K. gelanitosa during tenth day. The biomass productivity of D. acuatus was 0.03 g L⁻¹ day⁻¹ which is 58% higher than K. gelanitosa with 0.019 g L⁻¹ day⁻¹. The microalgal strains besides water treatment were subsequently subjected for lipid extraction and lipid productivity determination. The lipid productivity of D. acuatus was 2.68 mg L⁻¹ day⁻¹ which is lesser compared to 3.38 mg L⁻¹ day⁻¹ for K. gelatinosa. Both the microalgal isolates were promising for G. cambogia wash water treatment and lipid production. Hence, an environment friendly approach of water treatment with simultaneous lipid production for biofuel conversion is conducted.

The anaerobic feed of tannery effluent was treated using a new invention of an integrated approach: electrochemical oxidation with aerobic pretreatment, which reduces the chemical oxygen demand (COD) and sulfur/sulfide gas formation. Bacterial consortium was used in the present study isolated from a common effluent treatment plant (CETP). Microbial community analysis of anaerobic feed of tannery effluent (AFTE) was done by next generation sequencing. Under aerobic treatment, 79% and 85% of COD reduction were achieved during 3rd and 5th days of the aerobic process. The electrochemical oxidation process was applied for 60 min to reduce the remaining COD using the current density of 20 mA/cm². Ti-TiO₂/IrO₂/RuO₂-coated mesh and titanium sheet were used as anode and cathode respectively in an electrochemical reactor. A separate electrooxidation experiment was also carried out with galvanostatic mode of constant current density (20 mA/cm²) which enhanced the duration of electrochemical oxidation up to 13 h for complete reduction of COD concentration. UV-Vis and NMR spectroscopy were used to confirm the degradation of organic matter in the tannery effluent during aerobic and electrooxidation processes, where aerobic bacterial degradation is significant. The presence of mixed salt chloride and sulfate was recovered and the elemental composition was confirmed by EDAX analysis.

The use of banana peel as a sustainable and low-cost precursor for the fabrication of effective biochar was exploited. Here, calcined magnetic biochar (CMB) was fabricated and characterized. CMB possesses surface acidic functional groups (–OH and COO⁻), porous structures, high saturation magnetization (39.55 emu/g), and larger surface area than the non-magnetic biochar (CB). The CMB adsorption performance (72.8, 75.9, and 83.4 mg/g for Zn²⁺, Cu²⁺, and Hg²⁺, respectively at pH 6) in a single component was described suitably by pseudo-second order kinetic model, Langmuir, and Redlich-Peterson adsorption isotherms. Notably, the selectivity factor values in the extended Langmuir isotherm indicated that CMB has higher adsorption affinity toward Hg²⁺ than Cu²⁺ and Zn²⁺ in the multi-component system. Owing to its high adsorption efficiency and fast and easy separation, the calcined magnetic biochar is considered promising and effective for the purification of heavy metal–bearing wastewater.

Because of its high toxicity, thallium (Tl) causes environmental pollution even at very low concentrations. Despite its extremely high environmental risk, limited information about Tl removal from water is present on the literature. This work focused on the use of an eco-friendly and low-cost Ilex paraguariensis (yerba mate) biowaste to remove Tl from environmental water samples. Raw (YM) and L-cysteine chemically modified yerba mate (YM@LC) were used. The effect of pH and biosorbent concentration on the biosorption capacity was studied using an experimental design. The optimal experimental conditions were as follows: YM concentration 0.25 g L⁻¹, pH 6.0, and YM@LC concentration 0.25 g L⁻¹, pH 4.0. Kinetic studies yielded data that were in accordance with pseudo-second-order model. Equilibrium studies were also developed and indicated that the most appropriate model was that of Sips, with a maximum capacity of biosorption at 328 K of 333.4 mg g⁻¹ for YM and 384.4 mg g⁻¹ for YM@LC. The thermodynamic evaluation exhibited an endothermic, spontaneous, and favorable biosorption for both biosorbents. YM and YM@LC showed significant potential for Tl removal from environmental water samples.

Mongolia has been a pristine environment without much pollution. Our objective is to study a section of the Tuul River to evaluate the present condition of this pristine environment. Sediment metal (Al, Fe, Mn, Cu, Zn, Pb, Ni, Cd, Hg, and Cr) concentrations and Pb-210 were sampled and analyzed. Results showed that metal concentrations are much higher at areas near the capital city and municipal sewage outlet, with enrichment factor values up to 18 for Cu, and 26 for Cr. Higher copper concentrations were found at sites about ~ 50 km downstream from the source, an indication that pollutions are spreading further down the river. Vertical metal concentration profiles indicated that pollutions could be traced back to the 1960s. Inefficient sewage treatment plants and poorly managed power plant ash ponds were major sources of metals leaking into the Tuul River. Sewage wastewater is carrying metals through Tuul River to the lower river basin. Dusts from ash ponds are airborne and transport to greater area. These findings indicate that new and alternative measures have to be enforced to prevent further pollution entering the Tuul River drainage basin and airborne dust to other broader regions of the Asia and ocean.

Physicochemical and morphological characteristics of atmospheric particles in new urban centers of fast-developing megacities are not well understood. In this study, atmospheric coarse particles (PM₂.₅–₁₀) were simultaneously collected in multiple stations (10) in new urban centers, namely Beylikduzu, Buyukcekmece, and Esenyurt, of Istanbul using a modified passive particulate sampling method. Scanning electron microscope and energy dispersive X-photon spectroscopy (SEM-EDS) was used to investigate the size distribution characteristics, chemical composition and their weight percent abundances, and morphological properties of the collected particles. The particle clusters were mainly dominated by Ca-rich Al silicates, Ca dominant, Ca- and S-rich, and NaCl particles, respectively. Their potential sources were assigned to the natural sources (e.g., wind erosion, soil resuspension, and sea sprays) and anthropogenic activities (construction, transportation, mining and crushing, and cement production). In addition to the major contributions (up to 47% of particle number abundance), the minor contribution clusters (less than 1%) with transitional metals rich particles (Fe, Zn, and Cu rich) mainly from anthropogenic sources (combustion, traffic, and vehicular emissions) were identified. The typical size range (> 0.65 to < 11.00 μm) distribution of the major particle clusters fits a left-skewed modal distribution with a peak at 1.10–2.30-μm size range. However, the number of particles decreases significantly with increasing distance to the source, and this justification is stronger for larger size fractions (> 2.3 μm). Particle numbers and varieties indicated significant spatial variations depending upon the identified sources, meteorological factors, and temporal conditions. In general, the results of this study suggest that the passive sampling of PM₂.₅–₁₀ coupled with SEM/EDS based single-particle analysis is an effective tool to understand the physicochemical characterization and spatial and temporal variations of atmospheric particles in urban environments.

This paper develops the specific emission factors for buses in the real-world traffic conditions in the inner city of Hanoi, Vietnam. An engine stationary cycle consisting of 14 modes was developed based on the typical driving cycle of Hanoi buses which had been constructed with the application of Markov chain theory. This is the first engine stationary emissions test cycle constructed for heavy-duty engine in Vietnam. Based on this cycle, the country-specific emission factors (CSEFs) of air pollutants including CO, HC, NOₓ, CO₂, and PM for buses in Hanoi have been developed using the emission measurements on the engine test bed. It is found that almost all developed emission factors are higher than those derived from the emission measurements to the ECE R49 on the same engine. These emission factors, therefore, can be used to improve the quality of the emission inventory of buses in Hanoi.

Whether exposure to air pollution is associated with the increased incidence of childhood eczema is controversial. Only a few previous researches about the relationship between gestational and early-life exposures to ambient air pollutants and childhood eczema were conducted in China, and there is a lack of studies in Hubei province. This study aimed to explore the associations between air pollution exposure in gestation and the first year of life and childhood eczema. From November to December 2017, a total of 3383 children aged 3–6 years were recruited from 12 kindergartens in Hubei, China; 3167 were included in the final analysis. Parent-reported data involved with childhood eczema was inquired by questionnaire, and the concentrations of NO₂, PM₂.₅, and PM₁₀ were acquired from air quality monitoring stations which were the nearest to the twelve kindergartens. A binary logistic regression model was used to evaluate the associations of period-mean concentrations of individual pollutant exposure with childhood eczema. Of the 3167 children, 848 (26.8%) had a history of doctor-diagnosed eczema. After adjusting for the covariates, high levels of NO₂, PM₂.₅, and PM₁₀ exposures were significantly associated with a positive increase in risk of childhood eczema during the gestational period and the first year of life. In the gestational period, the estimate OR in the 3rd and 4th quartiles of NO₂ was 1.256 and 1.496, respectively. During the first year of life, the estimate OR in the 3rd and 4th quartiles of NO₂ was 1.371 and 1.335, respectively. Our study indicated that the gestational period and the first year of life exposures to high levels of ambient NO₂, PM₂.₅, and PM₁₀ were significantly associated with increased eczema among preschool children. Some effective measures of prevention and intervention could be developed for preschool children.