The main objective of this study was to examine the efficacy and capacity of constructed wetlands for metal removal. Between January 2006 and December 2008, removal of Cr, Cu, Cd, Zn, Pb, B, Ni, As, Fe, Hg, and Mn was measured on a monthly basis at a hierarchical mosaic of artificial ecosystems which has been in operation since 1998. The results showed a great variety of average removal efficiencies, in the range of 55% for chromium and −73% for manganese. Four elements presented negative removal: nickel, iron, arsenic, and manganese. Seasonal removal efficiencies were also studied for each element. Moreover, a correlation assessment among metal removal efficiencies and different parameters of each basin in the hierarchical mosaic of artificial ecosystems was performed. Negative significant correlations were found among Fe, Zn, Cu, Mn, As, Ni, Cd, and Hg removal and the inlet concentrations. In general, the treatment system was not a good system for removal of metals from wastewater as, in relation to other constructed wetlands, the system was not able to provide efficient removal of metals.

An exploratory survey of the mercury content of some common California biomass feedstocks shows that the concentrations are well below EPA toxicity levels with representative feedstock concentrations of 20 ppb for rice straw, 28 ppb for wheat straw, and 32 ppb for whole-tree wood chips. The temporal variability for rice straw (17-20 ppb) is near the analytical uncertainty (∼2 ppb). Saline-irrigated feedstock does not contain greatly higher mercury contents (17-38 ppb) compared to normally irrigated feedstock. Water leaching has likewise no detectable effects on mercury mobility, despite an up to 30% increase in the Hg concentrations attributable to mass losses during leaching. Combustion at temperatures of at least 575°C results in complete volatilization of mercury leaving solid ash and slag residuals with mercury contents at or near the lower limit of detection (5 ppb). The mercury strongly concentrated in fly ash can reach concentrations up to 40 times (<1,166 ppb) the corresponding fuel concentrations.

Cultures of the flagellate Isochrysis galbana were used to carry out the ecotoxicological evaluation of four PAHs [(naphthalene, phenanthrene, pyrene (Pyr) and fluoranthene (Flu)] by monitoring growth rate and the fluorescence variables F ₀, F m, F v and F v/F m, determined with a fast repetition rate fluorometer. The results presented in this investigation showed that F v was a suitable endpoint in acute ecotoxicological tests with marine phytoplankton. The derived effective concentrations followed the known narcotic mechanism of toxicity and showed sensitivity levels comparable to marine invertebrate embryo-larval bioassays. Pyr and Flu showed the lowest EC₁₀, which ranged between 168-279 and 189-697 nM, respectively.

Three organic wastes (banana skin (BS), brewery spent grain (BSG), and spent mushroom compost (SMC)) were used for bioremediation of soil spiked with used engine oil to determine the potential of these organic wastes in enhancing biodegradation of used oil in soil. The rates of biodegradation of the oil were studied for a period of 84 days under laboratory conditions. Hydrocarbon-utilizing bacterial counts were high in all the organic waste-amended soil ranging between 10.2 × 10⁶ and 80.5 × 10⁶ CFU/g compared to unamended control soil throughout the 84 days of study. Oil-contaminated soil amended with BSG showed the highest reduction in total petroleum hydrocarbon with net loss of 26.76% in 84 days compared to other treatments. First-order kinetic model revealed that BSG was the best of the three organic wastes used with biodegradation rate constant of 0.3163 day⁻¹ and half-life of 2.19 days. The results obtained demonstrated the potential of organic wastes for oil bioremediation in the order BSG > BS > SMC.

In this work, we evaluated the effect of harmful ecotoxins, 4,5,6-trichloroguaicol (4,5,6-TCG) and tetrachloroguaiacol (TeCG), on the oxidation of the fluorescent probe dihydrorhodamine 123, the content of free phenols and the level of the total, oxidized and reduced glutathione in the leaves of reed canary grass (Phalaris arudinacea). Furthermore, the effect on the activity of guaiacol peroxidase and glutathione S-transferase was investigated. Both 4,5,6-TCG and TeCG increased the activity of guaiacol peroxidase and glutathione S-transferase, they also elevated the content of free phenols and the level of the total glutathione. A stronger effect was exerted by tetrachloroguaiacol, which strongly increased the level of the total glutathione and the content of free phenols on the 3rd and 6th day of the experiment. The activity of glutathione S-transferase was more intensively induced by trichloroguaiacol. Both 4,5,6-TCG and TeCG oxidized dihydrorodamine 123 and the effect was stronger in the presence of magnesium ions.

The present study determines the source of dust particles and investigates their impact on the chemical compositions of plants and soils around a cement factory in Oman within a radius of 10 km of this disturbed ecosystem. A total number of nine samples of the species of plants (Rhazya stricta), nine samples of soils, and nine samples of dust were collected and analyzed for major ions and trace elements including rare earth elements (REEs). Principal component analysis applied to the major and trace element concentrations in the dust indicated the input of at least two sources to the dust in the study area: ophiolites and cement. The REE distribution in the plants and soils revealed that the most available elements to plants originated dominantly from ophiolites rather than from cement. The contribution of cement industry is significant only in the zone located at about 0.500 to 2 km around the cement factory, whereas the contribution of ophiolites increases with distance from the cement factory.

The city of La Plata and its surroundings are a very populated area, which has an important Industrial Pole and intense traffic activity but environmental studies have been rare so far. This article presents and discusses the importance of wind frequencies and velocities for the transport of air pollutants. The study emphasizes the importance of knowing wind patterns on an hourly basis that can be helpful for designing a monitoring network as well as for preventing exposure to pollutants. Correlation between monthly SO₂ concentrations and wind frequencies and velocities are discussed for a particular set of directions NNW-NE that carry pollutants from industrial sources toward populated areas. As a result, averaged wind frequencies have been found to be very important for determining patterns influencing pollutants transport; the influence of averaged velocities has shown low variability (hourly and monthly). Hierarchical cluster analysis applied to wind roses provided a useful approach for analyzing and describing the general daily occurrence of winds.

This study was carried out in order to assess both the deposition of heavy metal and nitrogen in a mountain ecosystem with low levels of metal deposition and its possible interactions with factors such as lithology and topography. For this purpose, samples of Hypnum cupressiforme Hedw. and topsoils were collected in a forest catchment within Bertiz Natural Park, an International Cooperative Programme on Integrated Monitoring site. Trace metals levels in mosses can be considered low compared with values reported elsewhere in Europe, and the dust soil mineral particles seemed to be the main source of these values. Only Cd and Hg presented external inputs, probably with an anthropic origin, for mosses according to the enrichment factor values, whereas historical pollution-related deposition in soils was determined for Pb, Cu, and Ni, attending to their total/extractable ratio.

Background, aim, and scope Diffusive gradients in thin films (DGT) have been recognized as a suitable tool to assess in situ metal bioavailability in soils. Mine tailings have some singular characteristics such as high heavy-metal concentrations, low pH, or absence of water retention capacity that may compromise the correct application of this technique whose applicability is known to be pH dependent. The goal of this study was to determine the response of DGT devices in heavy-metal-polluted mine tailings with different pH. In addition some experiments were performed in order to determine the effect of acidic pH and dissolved ions on the binding properties of the chelating resin. Materials and methods We tested DGT devices on three different mine tailings: acid pH 3, acid tailing limed to pH 5.5, and neutral pH 7.2. The tailings showed high metal concentrations, e.g., 7,000 mg kg⁻¹ Pb, 9,000 mg kg⁻¹ Zn, and 380 mg kg⁻¹ Cu. Diffusive and Chelex resin gels were prepared according to previously published methods. Two chelating resins and diffusive gels thicknesses (0.4 and 0.7 mm) were tested. Four DGT devices of each type were placed during 24 h in pots (one device per pot) containing 1 kg mine tailings in a climate chamber with humidity (50-90%) and controlled temperature conditions (night 16°C and day 23°C). Pots were irrigated with deionized water to field capacity, and then two different experiments were performed: (a) allowing free drainage and (b) maintaining the water saturation. In addition, we tested DGT devices in solutions at pH 3 with similar properties to the soil solution measured in the acid tailing. Eluted Zn, Cd, Pb, and Cu from the chelating resins were measured using inductively coupled plasma-optical emission spectrometer (ICP-OES; Vista-MPX Varian). Results and discussion The metal concentrations taken up by the DGT devices were affected by the different pH values of the tailings. The highest metal concentrations measured with DGT (C DGT) were obtained in the pH 3 treatments (both saturated and free drainage). Significant differences for C DGT were observed between water-saturated and free drainage treatments in the acid pH 3 tailing. When limed pH 5.5 tailing and neutral pH 7 tailing were considered, these differences were lower and not significant. In pH 3 tailings low values for C DGT/C soil solution were obtained (<0.06), indicating that these soils have a low capacity to resupply depleted metals to the solution. The limed acid tailing and the neutral tailing showed values between 0.05 and 0.94 indicating a much more rapid resupply from the solid phase. Deployment under water-saturated conditions yielded much higher C DGT values than under free drainage, indicating the importance to adequately control the moisture content in these soils with poor water retention capacity. In solutions with pH 3 mimicking the soil solution composition of the tailings, a loss of the binding capacity of the resin of 50-60% and 60-80% for Zn in 0.7-mm DGT and 0.4-mm DGT devices, respectively, was observed. As a consequence, 0.7-mm DGT devices had better reliability to carry out in situ determinations in solutions with high metal concentrations and low pH. Conclusions The use of DGT in mining soils can be a promising tool to study bioavailable metals concentrations in mine tailings but it has to be used carefully under acidic pH. Competition with other cations that are present at very high concentrations may hinder the accumulation of metals by the chelating resins, which should be tested under the conditions of the particular mine tailing.

Mining wastes may pose risk nearby urban and agricultural areas. We investigated a lettuce crop land close to a former capped mine tailing in order to determinate the metal uptake by crops. Soil plot sampling design within the crop area and two transects along the tailing were performed. In addition, lettuces (root and leaves) were analyzed after transplant and harvest. The results showed a pH of around 7-8 for all the soil samples. Total metal concentrations were as follows: 190-510 mg kg⁻¹ Pb, 13-21 mg kg⁻¹ Cu, and 210-910 mg kg⁻¹ Zn. Diethylene triamine pentaacetic acid-extractable Pb was around 18% of the total Pb in some samples. Transects along the base and on the plateau of the tailing showed high metal concentrations of Pb (up to 5,800 mg kg⁻¹) and Zn (up to 4,500 mg kg⁻¹), indicating that capping layer had been eroded. Lettuce leaves showed Pb concentrations within standard for human health (<0.3 mg kg⁻¹ in fresh weight). For essential micronutrients such as Cu and Zn, leaves had optimal content (10-28 mg kg⁻¹ Cu, 60-85 mg kg⁻¹ Zn). A continued monitoring in metal uptake is needed in crop lands close to mining wastes in order to prevent risks in food safety. Capped tailings must be monitored and rehabilitation works performed from time to time.