The aim of this work was to characterize the coal fly ash from gasification process (G-CFA) and to analyze its potential as hexavalent chromium Cr (VI) adsorbent. The G-CFA was characterized in terms of physical, chemical, mineralogical, and morphological analyses. Bach adsorption studies were carried out in order to evaluate the influence of pH on the adsorption capacity and removal efficiency of Cr (VI). The G-CFA characterization demonstrated that the material possessed potential to be applied as an effective low-cost adsorbent, once it presents 18.82 m² g⁻¹, 0.036 cm³ g⁻¹, and 7.56 nm of surface area, pore volume, and average pore diameter, respectively. The results also showed well-defined mineralogical phases and high content of siliceous material. The adsorption experiments demonstrated that the material has potential to be used as a chromium adsorbent with high removal efficiencies.

Herein, we attempt to improve the mechanical stability of anionic functionalized cellulose nanofibers (a-CNF) having 1.25 mmol of carboxymethyl groups per gram of cellulose nanofibers (CNF). The a-CNF and cross-linked a-CNF (zₐ-CNF) then used for water desalination in the continuous mode using a tubular adsorption column. It is worth mentioning that the zₐ-CNF possess 40% degree of cross-linking provided better mechanical stability as the tensile strength improved from 3.2 to 5.2 MPa over a-CNF. The IR spectroscopy was used to confirm the success of chemical modifications. Upon ionic cross-linking, the BET surface area reduced from 13.53 to 7.54 m²·g⁻¹ corresponds to a-CNF and zₐ-CNF, respectively. Moreover, this research was extended to determine the dynamic adsorption capacities for a-CNF and zₐ-CNF, which were found to be 21 and 10 mg·g⁻¹ respectively at a flow rate of 5-mL·min⁻¹ explained by Thomas model.

Air pollution has been suggested to affect semen quality, but the evidence is still contradictory. To assess whether any differences occur in conventional sperm parameters of men life-long resident in low, middle-low, middle, and high industrial density zones in the province of Messina. We retrospectively analyzed the conventional sperm parameters of patients to whom the sperm analysis was requested during their female partner counseling for infertility in an assisted reproductive technique (ART) center. A total of 184 men were enrolled. Total sperm count was higher in patients living in low and middle-low industrial density areas compared with that of men living in middle and high ones (123.5 ± 146.8 vs. 80.7 ± 92.7 mil/ejaculate, p < 0.05). No difference was found for sperm concentration (37.2 ± 49.7 vs. 30.5 ± 37.2 mil/mL), progressive motility (15.4 ± 19.8% vs. 14.2 ± 18.4%), total motility (62.3 ± 20.5 vs. 58.4 ± 19.9 mil/mL), and normal forms (2.7 ± 1.5 vs. 2.3 ± 3.0 mil/mL). These results add further evidence to findings from Sicilian population. Effective control of air pollution should be accomplished to prevent its negative impact on human reproductive health.

Seasonal distribution of phytoplankton community and size structure was assessed in three different tropical ecosystems of the western Bay of Bengal viz. estuary (Mahanadi), lagoon (Chilika), and coastal waters (off Gopalpur) in response to ambient hydrobiology. Salinity regimes differentiated the study regions as contrasting ecosystems irrespective of seasons (pre-monsoon, monsoon, post-monsoon). Taxonomic account revealed a total no of 175, 65, and 101 phytoplankton species in the estuary, lagoon, and coastal waters, respectively. Prevalence of marine, brackish, and fresh water types in the coastal waters, lagoon, and estuary, respectively, characterized the contrasting nature of the study regions in hosting the phytoplankton community. In general, phytoplankton abundance was observed in increasing order of coastal waters > estuary > lagoon during post-monsoon and pre-monsoon, while lagoon > coastal waters > estuary during monsoon. Bacillariophyta dominated the phytoplankton community in the estuary and coastal waters during all the seasons. In contrast, the lagoon exhibited a diverse array of phytoplankton group such as cyanophyta, dinophyta, and bacillariophyta during monsoon, post-monsoon, and pre-monsoon, respectively. Over the seasons, microphytoplankton emerged as the dominant phytoplankton size class in the coastal waters. Diversely, nanophytoplankton contributed to major fraction of chlorophyll-a concentration in the estuary and lagoon. Interestingly, pre-monsoon dinophyta bloom (causative species: Noctiluca scintillans with cell density 9 × 10⁴ cells·l⁻¹) and monsoon bacillariophyta bloom (causative species: Asterionellopsis glacialis 5.02 × 10⁴ cells·l⁻¹) resulted decline in species diversity. Multivariate statistical analysis deciphered salinity as a major environmental player in determining the distribution, diversity, and composition of phytoplankton communities in the three contrasting environments. Trophic state indices signified the lagoon and estuary as hypereutrophic during all season. The coastal water was marked as highly eutrophic through trophic state index during monsoon and pre-monsoon.

The objective of this paper was to study the pore-size distribution of municipal solid waste (MSW) and provide a basis for understanding the mechanism of preferential flow in MSW. Two methods were used to investigate the pore-size distribution in MSW. The first was an indirect method based on the soil-water characteristic curve (SWCC) and the second was a direct method using nuclear magnetic resonance (NMR). Samples taken from different depths of a landfill were used. In the SWCC method, SWCCs of the matrix region were obtained by a pressure plate extractor and SWCCs of the macropore region were determined by water breakthrough tests. A SWCC equation is proposed by modifying the Van Genuchten equation to consider the dual-porosity feature of MSW and the pore-size distribution was obtained based on the Young–Laplace equation. In the NMR method, the pore-size distribution of MSW was obtained by analyzing the T₂ curves. The results of the two methods were qualitatively similar and both showed a dual-porosity characteristic of MSW. The average macropore radii of shallow, middle, and deep MSWs obtained from the SWCC method are 0.193, 0.184, and 0.173 mm, and those obtained from the NMR method are 0.213, 0.138, and 0.145 mm, respectively. The proportion of macropores decreases with depth. The average micropore radii given by the SWCC method are 0.022, 0.011, and 0.008 mm, and those given by the NMR method are 0.013, 0.011, and 0.008 mm, respectively. As the depth and fill age increase, the average micropore size becomes smaller and the proportion of micropores increases. The volume ratios of macropores obtained by the two methods are quantitatively quite different. The discrepancy is mainly caused by the different test principles adopted by the two methods.

Proper management of biomedical waste (BMW) is required to avoid environmental and human health risks. The current study evaluated the BWM practices in public and private health care facilities of Fatehgarh Sahib District in Punjab, India. The study was conducted, using a modified World Health Organization (WHO) tool in 120 health care facilities randomly selected from rural and urban areas. At primary health care level, BMW management guidelines were followed in 67.2% of the public sector and 40.4% of the private sector facilities, whereas in secondary health care sectors both private and public sector follows 100% compliance. Health facilities were graded into different categories according to median score, i.e., scores less than < 2.5 was categorized as red (no credible BMW management system in place), scores between 2.5 to 7.5 as yellow (system present but needs major improvement) and scores > 7.5 as green (good system in place for BMW). It was observed that among primary health care facilities, 85% of the public sector and 64% of private sector facilities falls in the red category, whereas for secondary health care facilities only 8% fall in the red category. Logistic regression helped to identify the major factors that affect the performance of the health care facility, and it shows that regular training on BMW and improved infrastructure can improve the BMW management practices. Further, proper management of BMW requires multi-sectoral coordination, which can be better addressed through policies and by providing periodical training to all stakeholders.

Concerns over the health risk of the widely distributed, commonly used silica nanoparticles (SiNPs) are increasing worldwide. Yet, up to now, there are still many major knowledge gaps over the potential adverse effects of SiNP exposure on human cardiovascular health and the underlying mechanisms. In this study, comet assay and micronucleus test were employed to determine the genotoxic potentials of four sizes (10, 25, 50, 100 nm) of SiNPs to human umbilical vein endothelial cells (HUVECs) in culture. The intracellular redox statuses were explored through the determination of the levels of reactive oxygen species (ROS) and reduced glutathione (GSH) with kits, respectively. The protein levels of nuclear factor erythroid 2-related factor 2 (Nrf2) were also detected by Western blot. The results showed that at the administrative levels (1, 5, 25 μg/mL), all the four sizes of SiNPs could induce an increase of both DNA damages and MN frequencies in HUVECs in culture, with a positive dose- and negative size-dependent effect relationship (S100 < S50 < S25 < S10). Also, significantly enhanced levels of intracellular ROS, but decreased levels of GSH, were observed in the SiNP-treated groups. Interestingly, a very similar manner of dose- and size-dependent effect relationship was observed between the ROS test and both comet assay and MN test, but contrary to that of GSH assay. Correspondingly, the levels of Nrf2 protein were also enhanced in the SiNP-treated HUVECs, with a negative size-dependent effect relationship. These results implicated that induction of oxidative stress and subsequent genotoxicity may be an important biological mechanism by which SiNP exposure may affect human cardiovascular health.

This study deals with further and systematic laboratory evaluation of the already known ammonium 12-molybdophosphate (AMP)-diffusive gradient in thin film (DGT) method, which is used for measuring total Cs concentration in environmental waters. This study confirms that the AMP-binding gel is not stable for pH > 6. In order to reveal a potential impact of AMP degradation on DGT application, time-series experiments were performed by deploying AMP-DGT samplers in Cs-doped moderately basic soft and hard water up to total AMP-binding gel degradation (60 and 175 h of deployment time, respectively). Linear accumulation of Cs by AMP-DGT samplers was observed up to 48 and 58 h in hard and soft waters, respectively. For this deployment time range, AMP-DGT measured over 77 ± 10 and 94 ± 16% of total Cs concentration in hard and soft water, respectively. The difference in DGT response was attributed to Ca²⁺ and Mg²⁺ competition reducing the uptake of AMP-DGT samplers in hard water. Shrinkage of agarose-polyacrylamide diffusive gel was experimentally observed only in hard water due to more intensive AMP-binding gel degradation in hard water. Even if the AMP-DGT response was not impacted in this study, it is recommended to use agarose hydrogel as standard diffusive gel. Based on the experience obtained from this detailed validation process, the authors propose a number of key requirements that need to be considered when developing DGT devices, with testing the performance over longer deployment times being critical. Graphical abstract ᅟ

In the transportation of petroleum, large amount of oil polluted water will be produced, and the oil polluted water pumping into ocean will destroy ocean environment. To address oil-bearing ballast water, we fabricated a novel type of Fe–C microelectrolysis filler by using magnet powder, coconut shell biochar powder, bentonite, ammonium oxalate, and nickel powder. The COD and oil content removal efficiencies of 100 g/L oily wastewater were approximately 79.82% and 91.68%, respectively, after 100 min treatment at the following conditions: Fe–C mass ratio, 5:1; bentonite content, 20%; calcination temperature, 900 °C; calcination time, 2 h; ammonium oxalate content, 1.5%; and amount of nickel addition, 6.78%. The characteristics of the Fe–C microelectrolysis filler were analyzed. The surface structure of the filler was loose and porous, and its pores were developed. The Brunauer–Emmett–Teller (BET) surface area reached 49.4667 m² g⁻¹. A microelectrolysis filler is mainly mesoporous and contains large pores. Its average pore size is 2.6942 nm. Meanwhile, the results of our XRD analysis showed that some fillers were metal oxides, and most of them were simple metal substances.

This study investigated the prevalence of antibiotic-resistant bacteria and genes in fecal sludge and soil in Ho Chi Minh City, Vietnam, and identified the factors contributing to the survival of antibiotic-resistant bacteria in soil. Sludge and soil samples (n = 24 and 55, respectively) were collected from residential septic systems and environmental reservoirs (i.e., canals, rivers, and parks) in twelve districts of Ho Chi Minh City and tested against a library of 12 antibiotic-resistant genes and 1 integron gene. The susceptibility of isolated Escherichia coli from sludge and soil (n = 104 and 129, respectively) was tested against nine antibiotics. Over 60% of sludge and soil samples harbored sul1, ere(A), intI1, cmIA, and tet(A) genes. The three most common phenotypic resistances found in E. coli isolated from sludge and soil were to ampicillin, tetracycline, and sulfamethoxazole/trimethoprim. In a temporal microcosm study of antibiotic-susceptible and multi-drug-resistant E. coli inoculated in soil, temperature (21.4 vs. 30 °C), resistance phenotype, and soil background microbial community were associated with E. coli decay rates over 73 days. This is the first study that provides insights into the high prevalence of antibiotic resistance in septic systems and environmental reservoirs in Ho Chi Minh City, Vietnam. Findings highlight that the fecal sludge and soil environments in Vietnam are likely reservoirs for dissemination of and human exposure to antibiotic resistance.