Nitrate pollution in water is a common environmental problem worldwide. The Qinhe Basin (QHB) faces with the risk of eutrophication. To clarify nitrate pollution of river water, water chemical data, water isotope values (δD and δ¹⁸O–H₂O), and dual nitrate isotope values (δ¹⁵N–NO₃⁻ and δ¹⁸O–NO₃⁻) were used to discern sources and transformation mechanisms of nitrogen in the QHB. The nitrate concentrations of river water ranged from 0.71 to 20.81 mg L⁻¹. The δD and δ¹⁸O–H₂O values of river water varied from − 74 to −52‰ and from − 10.8 to − 7.2‰, with an average value of − 60‰ and − 8.2‰, respectively. The δ¹⁵N–NO₃⁻ and δ¹⁸O–NO₃⁻ values of nitrate ranged from − 6.7 to + 14.8‰ and from − 6.0 to + 5.6‰, with a mean value of + 4.6‰ and − 0.6‰, respectively. Assimilation by algae and the mixing of soil nitrogen, chemical fertilizer, sewage, and industrial wastewater could account for increasing δ¹⁵N–NO₃⁻ values. There was neither significantly positive nor negative correlation between δ¹⁵N–NO₃⁻ and δ¹⁸O–NO₃⁻ in river water, indicating that no obvious denitrification shifted isotopic values of nitrate in the QHB. Based on the dual isotopic values of nitrate and land use change in the watershed, it could be concluded that intensive nitrification dominated in the QHB, and dissolved nitrate was mainly derived from nitrification of ammonium in fertilizer, soil nitrogen, and domestic sewage. As the primary nitrate sources identified in the QHB, effective fertilization and afforestation can be taken to protect water resource from nitrate pollution.

Aerobic granular sludge was considered as a leading wastewater technology in the next century. However, the loss of granule stability limited the application of this promising biotechnology. Increasing aeration intensity and height to diameter (H/D) ratio were conventional strategies to enhance granule stability. In this study, hydraulic effects of aeration intensity and H/D ratio were explored basing on bubble behavior analysis. However, results revealed that due to viscous resistance, increasing aeration intensity and H/D ratio had limited effects on enhancing hydraulic shear stress, not to mention the extra operation and construction cost. A deflector component was further applied to regulate hydraulic shear stress on large granules under low aeration intensity and H/D ratio. Hydraulic shear stress of large granules was constantly around 3.0 times higher than that in the conventional reactor, resulting in higher percentage of granules within optimal size range (81.95 ± 5.13%). A high abundance of denitrifying bacteria was observed in reactors, which led to high TN removal efficiency of 88.6 ± 3.8%.

The adsorption of Pb²⁺ by a compost obtained from the treatment of tobacco from smuggled cigarettes (SCT) and industrial sewage sludge (ISS) was investigated. The Pb²⁺ adsorption process was evaluated as function of different concentrations of adsorbent and adsorbate, pH variations, and contact time. Fourier transformed infrared spectroscopy (FTIR) and energy dispersive X-ray spectrometry (EDX) were adopted to obtain information regarding structural changes and a better understanding of the adsorption mechanism. The adsorbent maximum adsorption capacity for Pb²⁺, calculated using the Sips equation, was 21.454 mg/g with 3 g/L adsorbent at pH 5. The adsorption kinetics best adjustment was obtained using the pseudo-second-order model with a time of 240 min to reach the adsorption equilibrium. FTIR and EDX results suggest that Pb²⁺ might have bonded to phenolic, carboxylic, hydroxyl, and amine groups; they also show formation of organometallic complexes and cationic exchange between the compost and the solution. The study confirmed that the compost evaluated can be used as a potential adsorbent in environments contaminated with Pb²⁺.

In this work, a novel biochar was prepared from the Artemisia argyi stem at 300 °C (AS300), 450 °C (AS450), and 600 °C (AS600). The structural properties of these biochars were characterized with various tools. The sorption kinetic processes of Cr(VI) and Cu(II) onto these biochars were better described by the pseudo-second order. The sorption isotherm processes of Cr(VI) onto these biochars were better described by the Freundlich model while the adsorption processes of Cu(II) were consistent with the Langmuir model. Batch sorption experiments showed that AS600 had the maximum adsorption capacity to Cr(VI) and Cu(II) with 161.92 and 155.96 mg/g, respectively. AS600 was selected for the follow-up batch and dynamic adsorption experiments. Results showed that AS600 had larger adsorption capacity for Cr(VI) at lower pH while the larger adsorption capacity for Cu(II) was found at higher pH. The effect of ionic strength on the adsorption of Cu(II) by AS600 was greater than that on the adsorption of Cr(VI). Dynamic adsorption experiments showed that Cu(II) had a higher affinity for the adsorption sites on the AS600 compared with Cr(VI). The adsorption mechanisms mainly involved electrostatic attraction, ion exchange, pore filling, and chemical bonding effect. Graphical abstract

This study examines the impact of fossil fuel consumption, nonrenewable energy consumption, population, affluence, and poverty on carbon emissions in Pakistan by using a time series data from 1972 to 2014. The study uses a flexible ecological framework known as the STIRPAT model. The Auto Regressive Distributive Lag (ARDL) Model and Error Correction Model (ECM) are used to estimate the robust results. The results show that consumption of fossil fuels, population growth, improvement in affluence level, and urbanization are contributing factors to high carbon emissions in Pakistan. The results also highlight that poverty alleviation and carbon emissions have opposite trends, this shows that the efforts to reduce poverty are stimulating the consumption of low-cost energy sources such as fossil fuels, and contributing to carbon emissions. However, results indicate that an increase in the share of renewable energy in total energy use and consumption of hydroelectric energy has the potential to reduce carbon emissions in Pakistan. The results highlight that there is a need to promote the use of renewable and hydroelectric energy. At domestic level, this will assist to meet the energy demand of the growing population and also prove helpful to reduce carbon emissions. Thus, the study recommends that a transition from fossil fuel energy to renewable and hydroelectric energy could prove an effective strategy to improve the affluence level, to alleviate poverty and effective to reduce carbon emissions in Pakistan.

Extensive application of pesticides has caused a lot of environmental pollution and health problems, prompting the development of highly efficient and lowly toxic pesticide formulations. Here, buprofezin (BPF)-loaded poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) (P(HB-HH)) microspheres were prepared by O/W emulsion/solvent evaporation method. Under optimal conditions (P(HB-HH) 7.07% (w/v) and PVA 1.84% (w/v)), the spherical and monodispersed microspheres were obtained. The average particle size, pesticide loading (PL), and encapsulation efficiency (EE) of the optimized microspheres were 1.2 μm, 15.68%, and 78%, respectively. Release of 80% BPF from the microspheres in pH 5 (192 h) was faster than that in pH 7 (228 h) and 8 (204 h). Moreover, kinetic analysis indicated that BPF release behaved in a non-Fickian diffusion manner (0.43 < n < 0.85) and the release mechanism was the combined effects of pesticide diffusion and hydrolysis of polymer. The bioassay and toxicity results showed that encapsulation of BPF could exhibit high efficacy on the target organism and low toxicity to the non-target organism. Therefore, these results demonstrated that BPF-loaded P(HB-HH) microspheres with good stability were prepared successfully, and they could be further explored for constructing other highly efficient and lowly toxic pesticide formulations.

In this study, a composite remediation material for the enhanced reductive dechlorination (ERD) of 1,1,1-trichloroethane (1,1,1-TCA) in aqueous solution was prepared. This material was comprised of biochar as the carrier and adsorbent, and carrageenan (CG) as the embedding medium to entrap the organic carbon sources and zero-valent iron (ZVI). We determined the suitable biochar dosage and organic carbon source in the composite alongside the optimal preparation conditions. Furthermore, using an anaerobic microcosm study, we discussed the performance and possible mechanisms of the composite on 1,1,1-TCA removal in aqueous solution. From this, we found that the suitable dosage of biochar in water during the preparation of composite microspheres was 0.2% (w/v). Under this condition, the biochar had a strong capacity to adsorb 1,1,1-TCA with a removal efficiency of 84.2%. Soluble starch was selected as the appropriate organic carbon source, because starch-microspheres show an excellent slow-release effect in water. The optimal preparation conditions of microspheres were identified as follows: 2% CG (w/v) colloidal solution, 6% CaCl₂ (w/v) solution, and a 12-h curing time. After 25-day incubation with the composite prepared under optimized conditions, the removal efficiency of 1,1,1-TCA was 95.68%, which was 24.69% higher than that observed in the microcosm with a commercial remediation material. The scanning electron microscopy (SEM) images show that the amounts of ZVI and soluble starch inside the microsphere decreased obviously, while the biochar amount remained about the same. This indicates that 1,1,1-TCA in aqueous solution was mainly removed via soluble starch-enhanced biotic reductive dechlorination and ZVI-enhanced abiotic reductive dechlorination. The changes in microbial community structure demonstrate that the composite stimulated the activities of functional anaerobic bacteria, in particular, regarding dechlorination and fermentation abilities in the microcosm, therefore enhancing the anaerobic biodegradation of 1,1,1-TCA. This study suggests that the composite, entrapping biochar, ZVI, and organic carbon source in CG microspheres can significantly enhance the reductive dechlorination of 1,1,1-TCA in aqueous solution. We anticipate this novel remediation material could be successfully applied to the in situ ERD remediation of natural groundwater mainly contaminated with 1,1,1-TCA.

Finance plays a crucial role in a fast-growing economy that can lead to environmental degradation. The present study utilizes balanced panel data of 105 countries for the time span 1980–2016 to investigate empirical linkage among environmental degradations: economy and finance. It also unfolds the nonlinear impact of economy and finance on environmental degradation. Existing literature on environmental issues mainly focuses on individual case studies uncovering particular regions, but the comprehensive analysis is not available. To fill this gap, panels were classified into five divisions: global, regional, income-based, OECD-based, and carbon emission. The cross-sectional dependence test is applied to identify the degree of cross-sectional dependence among concerned 16 divisions. The second-generation panel models (CADF and Westerlund cointegration, DOLS, and DH heterogenous causality) are employed on a sample set to compute to unit root, cointegration, and long-run and short-run dynamics among concerned variables, respectively. The findings infer the inverted EKC and U-shaped EKC in 10 and 3 out of 16 divisions with respect to environmental degradation—economy nexus, respectively, while 8 and 2 out of 16 divisions indicate the inverted EKC and U-shaped EKC, respectively, in terms of environmental degradation—finance nexus. In 12 out of 16 divisions, the energy consumption uplifts the CO₂ emissions. The DH causality affirmed a bidirectional causality among economy, finance, and energy consumption, respectively.

As an important renewable energy source, wind power plays a key role in mitigating climate change and has become one of the fastest growing clean energies globally. In China, wind energy development has been a vital component of national energy transformation strategy. Over the years, the Chinese government has introduced a series of policies to promote the development of wind power and also to regulate this emerging industry. Base on examining all the key policy documents on wind power issued by the Chinese government over the last 30 years, we find that China has built up a comprehensive policy system, and summarized the current framework of Chinese wind power policy systematically. Then, we analyze the policy objectives, policy tools, major measures, their results in each development stage, and the characteristics and trends of China’s wind power policies. Finally, we discuss the limitations of the current policy and put forward corresponding suggestions.

The objective of the present study was to investigate the responses of the chironomid communities (Diptera: Chironomidae) to environmental variables in four moderately and highly disturbed rivers located in one of the most degraded watersheds in South America. Sampling campaigns were carried out during 2014–2016 in four sites of the Matanza-Riachuelo basin. The physical-chemical and hydrological variables were measured and, the ecological indices were calculated and evaluated by ANOVA. The responses of Chironomidae to the environmental variables were evaluated by redundancy analysis (RDA), and the sampling sites were grouped according to the populations of chironomids and the main environmental variables. Finally, the Spearman correlation was made to determine which of these variables were significant. In total, 13 chironomid taxa were found in 36 samples during the study period. The greatest density registered belongs to Rheotanytarsus and Cricotopus. The ANOVA detected the greatest Chironomidae density and taxonomic richness in the sites with agricultural-urban impact. The changes in the distribution of Rheotanytarsus, Thienemanniella, and Polypedilum were mainly explained by the increase in current velocity, organic matter, and hardness, and the decrease of NH3 and BOD. On the other hand, Goeldichironomus, Chironomus, Parachironomus, Dicrotendipes, and Cricotopus were explained by the increase in conductivity, dissolved oxygen, and temperature, and the decrease of the variables NO3, BOD, and Cu. In addition to this, the sites with urban-agricultural impact were clearly separated from sites with urban-industrial impact. The last one was more related to the increase in BOD, Cu, and NO3 that indicates moderate to poor water quality. In conclusion, we can infer that the physical and chemical variables are correlated with changes in the structure and distribution of the chironomid community and there are genera that respond differently at high and intermediate situations of disturbances. This knowledge contributes to the execution of strategies for the conservation and restoration of the lotic ecosystems.