A theoretical and experimental study of bisphenol A (BPA) degradation by the UV/H₂O₂ process in water is presented. The effects of the H₂O₂ concentration and the specific rate of photon emission (EP,₀) on BPA degradation were investigated. A kinetic model derived from a reaction sequence was employed to predict BPA and hydrogen peroxide concentrations over time using an annular photochemical reactor in batch recirculation mode. The local volumetric rate of photon absorption (LVRPA) inside the photoreactor was computed using a Line Source with Parallel Plane emission model (LSPP). From the proposed kinetic model and the experimental data, the second order rate constants of the reactions between hydroxyl radicals and the main reacting species (H₂O₂ and BPA) were estimated applying a nonlinear regression method. A good agreement between the kinetic model and experimental data, for a wide range of operating conditions, was obtained. For BPA, H₂O₂, and TOC concentrations, the calculated root means square errors (RMSE) were 2.3 × 10⁻ ², 9.8 × 10⁻ ¹, and 9.0 × 10⁻ ² mmol L⁻ ¹, respectively. The simplified kinetic model presented in this work can be directly applied to scaling-up and reactor design, since the estimated kinetic constants are independent of the reactor size, shape, and configuration. Further experiments were made by employing low BPA initial concentration (100 μg L⁻ ¹) in water and real wastewater. A lower degradation rate of BPA was observed in the real wastewater, although the UV/H₂O₂ process has also been able to completely degrade the target pollutant in less than 1 h.

This study used a formaldehyde detector tube with a gas-piston hand pump to assess ceiling levels of student breathing zone and gross laboratory environment across the 2018 academic year. The room dimension was 28.6 × 55.48 × 5.5 m. It contained 90 cadavers, each placed on a hinged cover table. We measured before and during nine body region dissections. There was a significant difference (p < 0.01) between student exposure and laboratory environment levels. The highest level was student exposure during body wall dissection (2.7 ppm), the first laboratory; students may accidentally enter body cavities. The latter two were in abdominal (1.85 ppm) and lower limb dissections (1.49 ppm). The three highest environment levels were in different regions; spinal cord removal (1.13 ppm), lower limb (0.72 ppm), and thorax (0.71 ppm) dissection. Only the perineum environment level (0.09 ppm) was below the NIOSH ceiling level (0.1 ppm), which may result from the table covers that had been opened for 2 weeks before measurement. This study finding signified the importance of student personal exposure monitoring and encouraged the academic year measurement. Because each laboratory has unique factors, those affect formaldehyde levels; dissection steps, dissection table design, cadaver storage protocol, and heating-ventilation-air conditioning system performance, for instance.

To ensure microbial activity and a reaction equilibrium with efficiency and energy saving, it is important to know the factors that influence microbiological nitrogen removal in wastewater. Thus, it was investigated the microorganisms and their products involved in the treatment of kennel effluents operated with different aeration times, phase 1 (7 h of continuous daily aeration), phase 2 (5 h of continuous daily aeration), and phase 3 (intermittent aeration every 2 h), monitoring chemical and physical parameters weekly, monthly microbiological, and qualitative and quantitative microbiological analyzes at the end of each applied aeration phase. The results showed a higher mean growth of nitrifying bacteria (NB) (10⁶) and denitrifying bacteria (DB) (10²²) in phase with intermittent aeration, in which better total nitrogen (TN) removal performance, with 33%, was achieved, against 21% in phase 1 and 17% in phase 2, due to the longer aeration time and lower carbon/nitrogen ratio (15.7), compared with the other phases. The presence of ammonia-oxidizing bacteria (AOB), the genus Nitrobacter nitrite–oxidizing bacteria (NOB), and DB were detected by PCR with specific primers at all phases. The analysis performed by 16S-rRNA DGGE revealed the genres Thauera at all phases; Betaproteobacteria and Acidovorax in phase 3; Azoarcus in phases 2 and 3; Clostridium, Bacillus, Lactobacillus, Turicibacter, Rhodopseudomonas, and Saccharibacteria in phase 1, which are related to the nitrogen removal, most of them by denitrifying. It is concluded that, with the characterization of the microbial community and the analysis of nitrogen compounds, it was determined, consistently, that the studied treatment system has microbiological capacity to remove TN, with the phase 3 aeration strategy, by simultaneous nitrification and denitrification (SND). Due to the high density of DB, most of the nitrification occurred by heterotrophic nitrification-aerobic. And denitrification occurred by heterotrophic and autotrophic forms, since the higher rate of oxygen application did not harm the DB. Therefore, the aeration and carbon conditions in phase 3 favored the activity of the microorganisms involved in these different routes. It is considered that, in order to increase autotrophic nitrification-aerobic, it is necessary to exhaust the volume of sludge in the secondary settlers (SD), further reducing the carbon/nitrogen ratio, through more frequent cleaning, whose periodicity should be the object of further studies. Graphical abstract

The objective of this study was to identify and evaluate the impact of exposure to mixtures of organochloride pesticides (OCPs) in agricultural workers by detecting their effects on the activity of the enzyme glutathione S-transferase (GST) and the presence of polymorphisms of the GSTT1 and GSTM1 genes. The presence of OCPs was identified and quantified by gas chromatography, while spectrophotometry was used to measure enzymatic GST activity. The frequencies of the GSTM1 genotypes were analyzed by multiplex PCR. A total of 18 metabolites of OCPs were identified in the workers’ blood, most of which are either prohibited (DDT and its metabolites p, p’DDD and p, p’DDE, dieldrin, endrin, aldrin) and/or restricted (δ hexachlorocyclohexane, cis chlordane, methoxychlor, and endosulfan). The results obtained indicate lower levels of GST activity at higher OCPs concentrations detected in blood from exposed workers, together with an increase in OCP levels in individuals who presented the GSTT1*0 and GSTM1*0 genotypes. These conditions place the detoxification process in agricultural workers with null polymorphisms in the GST genes and high concentrations of OCPs in the blood (especially DDT and its metabolites, DDD and DDE) at risk, and increase their susceptibility to develop serious diseases.

The aim of this research was to develop a simple and inexpensive process for reduction of Cr(VI) to Cr(III). Zinc oxide nanoparticles were synthesized with an easy co-precipitation procedure, and the addition of Cu²⁺ doping agent effectively enhanced the Cr(VI) reduction in the presence of ultrasound (US). XRD, FT-IR, FE-SEM, EDX, VSM, and XPS were used to determine the structural specifications of the zinc oxide nanoparticles. Under optimal conditions such as pH 3, initial Cr(VI) content of 20 mg/L, and catalyst dosage of 0.8 g/L, the ultrasonic/Cu–ZnO process showed a higher sonocatalytic activity (96.83%) than ultrasonic/ZnO (67.36%) after 60 min. By increasing pH and Cr(VI) concentration, the removal efficacy of Cr(VI) declined. The experimental data was well described with the first-order kinetic model. When initial Cr(VI) concentration increased from 10 to 50 mg/L, the first-order rate constant declined from 0.2326 to 0.0019 min⁻¹ and electrical energy per order (EEO) enhanced from 19.81 to 2425.26 kWh/m³. Also, the ultrasonic/Cu–ZnO system exhibited considerable sonocatalytic performance in Cr(VI) reduction in the presence of hydrogen peroxide and citric acid, and complete removal was achieved within 60 min. The presence of anions negatively affected Cr(VI) reduction. Complete reduction was attained when ultrasound was applied at a power of 100 W. The catalyst activity was well maintained up to six consecutive cycles. In addition, the removal efficiency was approximately 62 and 65% for field water and real electroplating wastewater samples, respectively.

Nanoparticles (NPs) are very small particles present in a wide range of materials. There is a dearth of knowledge regarding their potential secondary effects on the health of living organisms and the environment. Increasing research attention, however, has been directed toward determining the effects on humans exposed to NPs in the environment. Although the majority of studies focus on adult animals or populations, embryos of various species are considered more susceptible to environmental effects and pollutants. Hence, research studies dealing mainly with the impacts of NPs on embryogenesis have emerged recently, as this has become a major concern. Chicken embryos occupy a special place among animal models used in toxicity and developmental investigations and have also contributed significantly to the fields of genetics, virology, immunology, cell biology, and cancer. Their rapid development and easy accessibility for experimental observance and manipulation are just a few of the advantages that have made them the vertebrate model of choice for more than two millennia. The early stages of chicken embryogenesis, which are characterized by rapid embryonic growth, provide a sensitive model for studying the possible toxic effects on organ development, body weight, and oxidative stress. The objective of this review was to evaluate the toxicity of various types of carbon black nanomaterials administered at the beginning of embryogenesis in a chicken embryo model. In addition, the effects of diamond and graphene NPs and carbon nanotubes are reviewed.

Although toxicity of silver nanoparticles (AgNPs) has been well studied, the mixture toxicity of the combination of AgNPs and other environmental pollutants is still largely unknown. Here, we investigated the mixture toxicity of the combinations of AgNPs and common environmental pollutants such as arsenic (As), cadmium (Cd), and chromium (Cr) on human hepatoma cell line (HepG2) at noncytotoxic concentrations based on analyses of cytotoxicity, genotoxicity, reactive oxygen species (ROS) generation, and modes of cell death. In addition, DNA microarray analysis was performed to understand the cellular responses at a molecular level. AgNPs-As and AgNPs-Cd combinations exhibited synergistic effect on cytotoxicity while AgNPs-Cr showed additive effect. The AgNPs-Cd combination caused much stronger synergism than AgNPs-As combination. Based on cellular and molecular level analyses, the synergistic effect could be explained by overproduction of reactive oxygen species (ROS), which induced DNA damage and consequently apoptotic cell death. On the other hand, the additive effect caused by AgNPs-Cr could be attributed to reduction of the mixture toxicity by precipitation of Cr ions. Taken together, our results clearly demonstrated that the mixture toxicity of AgNPs with As, Cd, or Cr at noncytotoxic concentrations had different toxicity effects. Particularly, toxicogenomic approach using DNA microarray was useful to assess the mechanisms of the mixture toxicity.

In the present study, the occurrence of 40 pharmaceuticals belonging to several therapeutic groups was investigated for the first time in hospital effluent, wastewater treatment plant influent and effluent, and seawater in Mahdia, Tunisia. Forty-six samples were collected within a 6-month sampling period. Pharmaceuticals were analyzed using solid-phase extraction followed by ultra-performance liquid chromatography-triple quadrupole mass spectrometry. Thirty-three out of the forty target compounds were detected over a wide concentration of ranges, from nanograms per liter to micrograms per liter, depending on the type of sample. Maximum values were detected for caffeine at 902 μgL⁻¹ in hospital wastewater. This compound, as well as salicylic acid, sulfadiazine, and sulfamethizole, were detected in all samples. The average concentration of total pharmaceuticals in hospital wastewater (340 μgL⁻¹) was higher than those detected in influent and effluent wastewater and seawater (275.11 and 0.2 μgL⁻¹, respectively). Risk quotients (RQs) were also estimated to provide a preliminary environmental risk assessment and results revealed that sulfadiazine, sulfamethoxazole, and fluoxetine could pose medium/high risk to the tested aquatic organisms for maximum measured concentrations in wastewater (including hospital and WWTP samples). Although the measured environmental concentrations (MECs) detected in seawater samples might not pose a toxic effect to the aquatic organisms (except for salicylic acid, sulfamethoxazole and fluoxetine), further researches are needed due to the continuous release of wastewater in the environment and the limited efficiency of wastewater treatment processes.

Exposure to contaminants is one of the main threats to all living organisms. In this context, bats have been used to indicate environmental contaminants in urban and agricultural environments, since they are extremely sensitive to changes in the ecosystem and easily accumulate waste in their body tissues. Among bats, Sturnira lilium, is a frugivorous species widely distributed and abundant in Brazil that uses an extensive variety of habitats and shelters. In this study, we aimed to evaluate the oxidative state of S. lilium individuals in agricultural and urban areas in southern Brazil. Individuals were sampled in agricultural and urban areas from November 2017 to March 2018 through the mist-net method. Parameters of the superoxide dismutase (SOD) and catalase (CAT) enzyme activity, non-protein thiols (NPSH), and lipid peroxidation (TBARS) were determined based on liver tissue. A total of 46 individuals were captured, 29 of them in urban areas and 17 in agricultural areas. We found that S. lilium individuals from agricultural areas showed a significant increase in TBARS, NPSH, and SOD activity, compared to individuals from urban areas. The activity of the antioxidant enzyme CAT did not differ. The present findings suggest that the species S. lilium, which are widely distributed and abundant in Brazil in urban and agricultural areas, can usefully be employed in biomonitoring programs. Further studies are to be encouraged to refine our knowledge on the potential DNA damage caused by environmental contamination, as well as identify potential contaminants to bats.

The co-placement of mine tailings and fly ash (CMF) can reduce acid mine drainage (AMD) production and decrease metal mobilization. This aids in waste management construction. However, few people have studied a large number of tailing sand–fly ash mixtures under the condition of neutral saturated solution in tailing ponds, wherein the pozzolanic reaction is highly gradual. In this study, a series of tests were conducted to determine the monotonic and cyclic shear characteristics of a mixture of fly ash and tailings. In particular, the effects of the fly ash content on the monotonic shear peak, shear strength parameters, dynamic modulus, and damping ratio of the mixture were analyzed. The results reveal that in a monotonic shear test, the peak shear strength of the saturated CMF mixture decreases as the fly ash content increases. The shear strength parameters (cohesion c and internal friction angle φ) were observed to increase and decrease linearly, respectively, as the fly ash content increased. Furthermore, the maximum dynamic shear modulus was observed to decrease by 41.4% as the fly ash content increased from 0 to 50%, during the cyclic cutting process. Moreover, the experimental results fit well with the fitting formula for the variation in shear modulus in the cyclic shear process of the saturated CMF mixture with varying fly ash content. Meanwhile, the initial damping ratio of the cyclic shear was observed to increase from 10.3 to 13.6% as the fly ash content increased. Therefore, when the CMF method is used to treat AMD waste, it is necessary to consider the extent to which the design stability of the tailing pond may be reduced. These experimental results can be used as a reference for similar CMF projects.