publishedVersion | Paid Open Access

Development of a flux DMT with integrated adsorptive stripping voltammetry for free metal ions detection in solution. Interfaces Against Pollution

Microplastic (MP) contamination is ubiquitous in the environment and many species worldwide have been shown to contain MP. The ecological impact of MP pollution is still unknown, thus there is an urgent need for more knowledge. One key task is to identify species suitable as sentinels for monitoring in key eco-compartments, such as coastal waters. In Norway, mussels (Mytilus spp.) have been monitored for hazardous contaminants through OSPAR since 1981. Norway has the longest coastline in Europe and adding MP to the Norwegian Mussel Watch is therefore important in a European and global context. The present study reports MP data in mussels (332 specimens) collected from multiple sites (n = 15) spanning the whole Norwegian coastline. MPs were detected at all locations, except at one site on the west coast. Among the most surprising findings, mussels from the Barents Sea coastline in the Finnmark region, contained significantly more MPs than mussels from most of the southern part of the country, despite the latter sites being located much closer to major urban areas. Only mussels from a site located very close to Oslo, the capital, contained levels similar to those observed in the remote site in Finnmark. In total an average of 1.5 (±2.3) particles ind−1 and 0.97 (±2.61) particles w.w. g−1 was found. The most common MPs were <1 mm in size, and fibres accounted for 83% of particles identified, although there was inter-site variability. Thirteen different polymeric groups were identified; cellulosic being the most common and black rubbery particles being the second. This study suggests Mytilus spp. are suitable for semi-quantitative and qualitatively monitoring of MPs in coastal waters. However, some uncertainties remain including mussel size as a confounding factor that may influence ingestion, the role of depuration and other fate related processes, and this call for further research. | publishedVersion

Contrasting soil profiles (coarse-textured and fine-textured) treated with brilliant blue (BB) dye tracer, inorganic nitrogen (N) and phosphorus (P) concentrations along and between stained preferential flow pathways were examined for an irrigated and overfertilised maize monoculture system at the Mediterranean central Chile. The PO4-P concentrations were 2- to 10-fold higher in areas with BB than in areas without BB below 0.5-m soil depth in both soils. This elevated concentration was attributed to transport through cracks in fine-textured soil and finger flow in coarse-textured soil. The highest PO4-P value (13 mg kg(-1)) was found in areas with BB at the fine-textured soil. There were no significant differences in inorganic N concentration between areas with and without BB for both soils, which suggest that the effects of preferential flow are less important for inorganic N forms. There was a strong significant (p < 0.01) positive correlation between PO4-P and NH4-N concentrations in the fine-textured soil, and the amounts retained were clearly proportional to the clay content. Strategies for reducing N and P losses must be placed on good agronomic management of irrigated maize cropping system including accurate calculation of N and P fertiliser rates and establishment of suitable mitigation measures such as cover cropping. | FONDECYT 1150572

peer reviewed | Copper and zinc are metals that have been traditionally thought of as past contamination legacies. However, their industrial use is still extensive and current applications (e.g. nanoparticles and antifouling paints) have become additional marine environment delivery routes. Determining a pollutant's genotoxicity is an ecotoxicological priority, but in marine benthic systems putative substances responsible for sediment genotoxicity have rarely been identified. Studies that use sediment as the delivery matrix combined with exposures over life-history relevant timescales are also missing for metals. Here we assess copper and zinc's genotoxicity by exposing the ecologically important polychaete Alitta virens to sediment spiked with environmentally relevant concentrations for 9 months. Target bioavailable sediment and subsequent porewater concentrations reflect the global contamination range for coasts, whilst tissue concentrations, although elevated, were comparable with other polychaetes. Survival generally reduced as concentrations increased, but monthly analyses show that growth was not significantly different between treatments. The differential treatment mortality may have enabled the surviving worms in the high concentration treatments to capture more food thus removing any concentration treatment effects for biomass. Using the alkaline comet assay we confirm that both metals via the sediment are genotoxic at concentrations routinely found in coastal regions and this is supported by elevated DNA damage in worms from field sites. However, combined with the growth data it also highlights the tolerance of A. virens to DNA damage. Finally, using long term (decadal) monitoring data we show stable or increasing sediment concentrations of these metals for many areas. This will potentially mean coastal sediment is a significant mutagenic hazard to the benthic community for decades to come. An urgent reappraisal of the current input sources for these ‘old pollutants’ is, therefore, required. Chronic exposure of zinc and copper via sediment at environmentally relevant concentrations induces DNA damage in a marine polychaete. © 2018 Elsevier Ltd

International audience | he aim of this study is to bring to light the influence on firewood emissions and performance of several parameters like the moisture content of the fuel, the presence of bark, the caliber of the fuel but also the ignition mode. Many results emerge from this study. First of all, all these parameters significantly impact the emissions of the firewood at the nominal thermal heat output, especially the particles emissions. The presence of bark modifies the particles composition in total carbon. Moreover, the presence of bark induces the emissions of a new family of particles: the nanocrystal. A high moisture of the fuel led to a lower temperature in the combustion chamber. Then, the emissions of unburned gases, like the Volatile Organic Compounds, will considerably increase. The particles emissions and the composition of those particles were also significantly impacted by the moisture of the fuel. Two ignition modes were also studied. It appears that the top-down ignition against the traditional ignition allowed a significant decrease of all the emissions. Nevertheless, the elemental carbon emissions were more important with a top-down ignition. | L’objectif de cette étude est de mettre en évidence l’influence sur les émissions et les performances d’un appareil de différents paramètres, comme l’humidité du bois, la présence d’écorce ou non, le calibre utilisé ainsi que le mode d’allumage. De nombreux résultats ressortent de cette étude. Tout d’abord, tous ces paramètres influent de manière considérable sur les émissions des appareils, notamment les émissions de particules, et ce, même à régime nominal. La présence d’écorce modifie la composition en carbone total des particules totales et implique l’émission d’un nouveau type de particule : les nano-cristaux. Une humidité élevée induit des niveaux de températures plus faibles. Ainsi, les émissions d’imbrûlés gazeux tels que les Composés Organiques Volatils vont augmenter de manière importante. Les émissions de particules, en quantité et en composition chimique, sont aussi significativement impactées par l’humidité du combustible. Deux modes d’allumage ont aussi été étudiés. Il s’avère qu’un allumage inversé permet de réduire de manière significative la globalité des émissions par rapport à un allumage classique. En effet, seules les émissions de Carbone Elémentaire sont plus importantes avec un allumage inversé.

Embargo until 23 November 2019 | China's coastal environment has been heavily affected by the loading of terrestrial pollutants in recent decades, and quantitative risk assessment is urgently needed to assess the ecological risks of China's coastal environment. We assessed the ecological risks induced by five heavy metals (including Cu, Zn, Pb, Hg and As) in China's coastal waters for three groups of marine organisms (including crustacean, fish and mollusc) based on data obtained from a nationwide unified coastal environment monitoring program consisting of 301 sampling sites. The results show that higher heavy metal concentrations occurred more frequently in the Bohai Sea and in the estuaries of major sea-going rivers. The ecological risks decreased in the following order: Bohai Sea > Yellow Sea > South China Sea > East China Sea. There was generally low ecological risk, but certain hotspots existed near Tianjin and Jinzhou, which had relatively high ecological risks caused by Cu and Zn. | acceptedVersion

Oil-related aggregates (ORAs) may contribute to the fate of oil spilled offshore. However, our understanding about the impact of diatoms and associated bacteria involved in the formation of ORAs and the fate of oil compounds in these aggregates is still limited. We investigated these processes in microcosm experiments with defined oil dispersions in seawater at 5 °C, employing the Arctic diatom Fragilariopsis cylindrus and its associated bacterial assemblage to promote ORA formation. Accumulation of oil compounds, as well as biodegradation of naphthalenes in ORAs and corresponding water phases, was enhanced in the presence of diatoms. Interestingly, the genus Nonlabens was predominating the bacterial communities in diatom-supplemented microcosms, while this genus was not abundant in other samples. This work elucidates the relevance of diatom biomass for the formation of ORAs, microbial community structures and biodegradation processes in chemically dispersed oil at low temperatures relevant for Arctic conditions. | acceptedVersion

The objective of this paper is to provide a simple extension of the much-used gravity spreading model for oil on calm water to account for the spreading behavior of waxy crude oils in cold waters – including the observed retardation and eventual termination of spreading at certain oil film thicknesses. This peculiar behavior is not predicted by traditional spreading models for oil on calm water (i.e. viscous-gravity spreading models), but may occur due to non-Newtonian oil properties caused by precipitation of wax at low temperatures. To clarify the spreading behavior of such oils, SINTEF has conducted a series of laboratory experiments with a range of waxy oil mixtures. The present paper contains analyses of data from these experiments, including favorable comparisons with calculations by a proposed improved surface spreading model. | Spreading of waxy Crude Oils on calm weather | acceptedVersion

Subsea blowouts have the potential to spread oil across large geographical areas, and subsea dispersant injection (SSDI) is a response option targeted at reducing the impact of a blowout, especially reducing persistent surface oil slicks. Modified Weber scaling was used to predict oil droplet sizes with the OSCAR oil spill model, and to evaluate the surface oil volume and area when using SSDI under different conditions. Generally, SSDI reduces the amount of oil on the surface, and creates wider and thinner surface oil slicks. It was found that the reduction of surface oil area and volume with SSDI was enhanced for higher wind speeds. Overall, given the effect of SSDI on oil volume and weathering, it may be suggested that tar ball formation, requiring thick and weathered oil, could possibly be reduced when SSDI is used. | acceptedVersion