Formation of yield in crop cultivation is affected by influence of many factors. Simple summation of individual factors is quite rare occasion. Interaction among factors is a dynamic value. The effect of interactions varies depending on the crop development stages as well as by graduation of factors. The study aimed to evaluate the soil penetration resistance effect on winter wheat grain yield and development. It allows specifying recommendations for soil treatment difference criteria for use in site-specific soil tillage. Field trials were carried out at the Research and Study farm Vecauce of Latvia University of Agriculture during the years 2005-2007 to investigate factors influencing formation of winter wheat grain yield. Forty seven points (distributed as grid 50x50 m) were selected in the winter wheat Triticum aestivum L. field. All points were attached to their geographic coordinates. Data shows significant effect of soil resistance to grain yield - increase of soil penetration resistance by 100 kPa cmE-2 reduced yield of winter wheat by 0.37 to 0.48 t haE-1. By contrast in 2007 a significant linear regression relationship between soil penetration resistance and the yield was not detected. Differences of fresh weight of winter wheat plants in tillering stage and the beginning of stem elongation were insignificant compared to different groups of soil penetration resistance at soil layers 0.10-0.30 m in both experimental years. Higher impact of soil penetration resistance on flag leaf area difference had soil resistance at the layer of 0.20 - 0.30 m and differences were significant in both trial years.

By using analytical correlations derived as a result of theoretical research, a computer algorithm has been worked out for simulating the functions of the plough body and the forces exerted by soil upon the operating parts, as well as its draft resistance. These correlations allow to determine the draft resistance of the plough depending on the parameters of its body, as well as to evaluate the impact of the physical and mechanical properties of soil, such as friction upon it. The greatest influence upon the draft resistance is exerted by soil hardness, density and slip resistance along the surfaces of the operating parts. The latter is also affected by soil adhesion, which particularly manifests itself in wet clay soils at lower temperatures. It has been clarified that the friction resistance constitutes 46–62% of the total draft resistance of the plough body. The main ways of lowering the friction resistance and the total draft resistance of the plough are the introduction of a more rational design of its body having optimum parameters, decreasing the resistance of the share-mouldboard surface and the values of reactions of the supporting surfaces, as well as the application of antifriction materials and better modes of joining with tractors.

In the 30ies of the 20th century stump extraction was identified as one of the most prospective technologies of forest sector to secure deliveries of solid biofuel. Now we are returning to the same challenges having the same targets – to secure energy independence and competitiveness of forest sector. MCR 500 is the prototype of combined stump extraction and mounding bucket for caterpillar excavator produced in Latvia by the LSFRI Silava and engineering company Orvi SIA. The device is made for extraction of stumps with diameter up to 50 cm. Additional benefit of the device is its ability to prepare soil for the forest regeneration by making mounds. The article summarizes results of productivity trials of stump extraction using the MCR 500 head and following forwarding of the material. Data from earlier studies are used to characterize comminution and road transport of stumps and chips. In total 3.5 ha were extracted during the studies. A harvested amount of stumps was estimated using biomass equations. It will be updated in further comminution studies. Average stock of extractable biomass (stumps and coarse roots) on the experimental sites was 28 tons ha-1. Productivity of stump extraction was 2.4...3.4 tons per efficient hour. Consumption of efficient time for scarification of soil was 3.4...4.3 hours per ha. Forwarding took 30 min per load (2.6 tons per efficient working hour). Prime cost of chips according to biomass equations is 9.78 Ls LV mE-3, according to expert judgement based harvested stock is 6.38 Ls LV mE-3.

Wheat crown rot is a harmful disease that can be caused by different pathogens. The control of this disease is complicated because of the diversity of pathogens and an insufficient efficacy of fungicides; therefore, the agronomic practices of wheat production are an important tool for reducing the disease development. The aim of this study was to estimate the incidence of wheat crown rot depending on soil tillage system and on the pre-crop of wheat in the year 2016. The field experiment was carried out at the Research and Study farm ‘Peterlauki’ of the Latvia University of Agriculture in the autumn of 2008. The data obtained in 2016 are analysed in this study: A – soil tillage system: 1 – traditional soil tillage with ploughing at the depth of 22 – 24 cm, 2 – reduced soil tillage with disc harrowing up to the depth of 10 cm; B – pre-crop of winter wheat: 1 – wheat, 2 – oilseed rape, 3 – faba beans. The incidence of crown rot was not influenced by soil tillage system, but the impact of pre-crop was significant (p = 0.006). The level of disease was essentially higher in continuous wheat sowings. The experiments showed that the main causal agents of the disease were Fusarium spp. and Oculimacula spp. The spectrum of pathogens was not dependent on a particular agronomic practice.

Wheat (Triticum aestivum) is one of the main crops grown in Latvia. Nitrogen fertilizer is one of the most important factors affecting the acquired yield and its quality. The aim of this paper is to describe the nitrogen fertilization impact on winter wheat yield and yield components under two soil tillage systems and after two forecrops. Field trials were carried out at Research and Study farm ‘Peterlauki’ of Latvia University of Agriculture (56° 30.658°C N and 23° 41.580°C E) in 2014/2015 and 2015/2016. Researched factors were (1) crop rotation (continuous wheat and wheat/oilseed rape (Brassica napus ssp. oleifera), (2) soil tillage (traditional soil tillage with mould-board ploughing at a depth of 22 – 24 cm and reduced soil tillage with disc harrowing at a depth below 10 cm), and (3) nitrogen fertilizer rate (N0 or control, N60, N90, N120(90+30), N150(90+60), N180(90+60+30), N210(90+70+50), and N240(120+60+60). Results showed that the nitrogen fertilization significantly increased winter wheat grain yield after both forecrops and in both soil tillage variants. Grain yield significantly increased until the nitrogen fertilizer rate N180. Nitrogen fertilizer significantly affected all tested yield components. Values of yield components increased enhancing N-rate of N150 – N180. The forecrop had a significant impact on wheat yield and 1000 grain weight (both increased when wheat was sown after oilseed rape). Yield and grain number per ear were significantly higher when conventional tillage was used, but number of ears per square m – when the reduced tillage was used.

Wheat (Triticum) is one of the three most important field crops used for food in the world, as well as in Latvia. The two-factorial trial was conducted at the Research and Study farm ‘Pēterlauki’, Latvia, with the aim to find out the effect of soil tillage and crop rotation on winter wheat grain yield formation. Two soil tillage systems (conventional and reduced), and three crop rotations with different winter wheat (Triticum aestivum) proportion in it (100, 67 and 25%) and different fore-crops (wheat, oilseed rape (Brassica napus ssp. oleifera), faba bean (Vicia faba)) were used. Long-term trial was started in 2009, however, the data from 2016/2017, 2017/2018 and 2018/2019 growing seasons was used for this report. The highest average wheat yield was harvested in 2017 (7.17 t haE−1), and it was significantly (p is less than 0.001) higher than yields in 2018 and 2019 (on average 6.18 t haE−1 and 5.68 t haE−1, respectively). Crop rotation with winter wheat proportion 25%, in which faba bean was wheat fore-crop, showed the highest average grain yield (7.35 t haE−1), but the lowest yield was obtained in rotation with 100% wheat proportion (on average 5.52 t haE−1). Crop rotation scheme had a significant influence on the yield (p is less than 0.001) and 1000 grain weight (p is less than 0.001). Forecrop influenced the yield (p is less than 0.001), number of spikes per 1 square m (p is less than 0.001), and number of grain per spike (p=0.008) significantly. Soil tillage did not affect the studied parameters importantly. Conditions of the trial year affected all parameters significantly.

Wheat (Triticum) grain is generally used for food due to its grain quality. The two-factorial trial was conducted in the Research and Study farm ‘Pēterlauki’, Latvia, with an aim of finding out the soil tillage and crop diversification in rotation effect on winter wheat grain yield and quality. Two soil tillage systems (traditional and reduced) and three crop rotation schemes with different winter wheat (Triticum aestivum) fore-crops (wheat, oilseed rape (Brassica napus ssp. oleifera), faba bean (Vicia faba)) were used. The trial started in 2009. For this paper data from 2016/2017 and 2017/2018 growing seasons was used. Yields harvested in 2017 were significantly (p is less than 0.001) higher than those in 2018 (on average 7.17 t haE−1 in 2017, 6.18 t haE−1 in 2018). The highest yield (8.06 t haE−1) was gained in the variant where the fore-crop in 2017 had been faba bean. Crop rotation, including only repeated wheat sowings in both years, showed the lowest yield (on average 5.81 t ha E−1). Crop rotation with oilseed rape and wheat showed a significant wheat yield increase in the following two-year period in comparison to to repeated wheat sowings. A year as a factor had a significant (p is less than 0.05) impact on crude protein content (%), Zeleny index, volume weight (g LE−1) and 1000 grain weight (g). Both, volume weight (g LE−1) and 1000 grain weight, were influenced (p is less than 0.05) by the crop rotation and forecrop. Zeleny index depended on all researched factors. Crude protein content was influenced by soil tillage method (p is less than 0.0016) and fore-crop (p=0.0052). Hagberg falling number was not influenced by any of the investigated factors.

Theoretical and experimental investigations are carried out to estimating the impact of the plough body working width on its specific draft resistance, as well as the ploughing efficiency. By using analytical correlations derived as a result of theoretical research, a computer algorithm has been worked out for simulating the functions of the plough body and the forces exerted by soil upon the operating parts, as well as its draft resistance. Specific draft resistance of the plough body, energy consumption, as well as labour efficiency and ploughing costs depend considerably on the working width of the body. By increasing it, the energy capacity, specific fuel consumption and expenditure decrease, but labour efficiency increases.

Promotion of 'improved' conservation practiced in sub-Saharan Africa have rarely taken account of the practical, social and economic constraints faced by resource poor farmers. New technologies need to improve the supply and utilization of limited resources in these environments to satisfy the specific demands of the growing crop. At the same time they must not require costly inputs, unavailable skills or increase the demand on labour. Farmer uptake is therefore dependent upon the innovative use of existing implements, and thereby making the best use of what is generally available. This paper describes some of the lessons learned over the years and results from a five-year collaborative project between the Department of Research and Specialist Services (DRSS), Zimbabwe and Silsoe Research Institute, UK. The project aims to develop tillage systems that conserve water without increasing energy and labour requirements. Results of farmer managed trials sofar indicated that effective, low cost, conservation tillage practices can be achieved using existing implements to enhance water conservation, which will allow: i) earlier and more even crop establishment; ii) reduce effect of mid-season droughts and iii) extend the growing season where there is an early cut off to the rains. In order to identify whichh systems are appropriate and acceptable to dryland conditions, smallholder farmers have been fully involved in the selection and development of those technologies under investigation