In this study, conducted on the selection of the most suitable method of determining the available sulfur content of soils where cotton is grown in the Coastal Aegean Region of Türkiye, soil and leaf samples were taken from a total of 40 cotton plantations in five different locations in the Coastal Aegean Region and Gediz Basin. Various physical and chemical characteristics of the soil’s samples, which were taken from a depth of 0-30 cm, were determined, and the available sulfur contents were determined with the use of seven different extraction solutions. The extraction method or methods by which the highest correlation or correlations were obtained between the available sulfur content of the soils and leaf sulfur contents of the plants in the same plantation were assessed as the most suitable methods. According to the results of the study, the highest soil-leaf correlation was obtained by soil extraction with Ca(H2PO4)2 solution, followed, in order, by the NH4OAc, KH2PO4, cold water and NaCl methods. No significant correlation was found between the amounts of sulfur determined by extraction with CaCl2 and KCl solutions and leaf sulfur contents. It was concluded that the most suitable methods for the determination of available sulfur in the soils of the Aegean Coastal Region where cotton is grown were the extraction methods using Ca(H2PO4)2 and NH4OAc solutions.

In this study carried out in 2015 under conditions of Kahramanmaraş province of Turkey, it was aimed at determining the effects of sawgin and rollergin methods on fiber quality in some cotton (Gossypium hirsutum L.) cultivars. In the study varieties of Lydia, Carisma, PG 2018, Flash, BA 440, BA 119 Maraş-92 and Erşan-92 were used as experimental materials. The trial was established according to factorial randomized block design with four replications. Seed cottons obtained from the trial were ginned in the rollergin and sawgin machines. In the obtained lint cotton samples, a number of fiber characteristics were determined by using HVI and AFIS fiber analysis devices. Ginnig outturn (38.6%), fiber length (30.21 mm), uniformity index (86.02%), fiber strength (31.76 g tex-1), spinning consistency index (SCI) (104.68) determined by using rollergin system were found higher than ones determined by using sawgin system (respectivelly 37.2%, 29.78 mm, 84.61%, 30.97 g tex-1, 94.50). Short fiber index (3.47%) and nep count (59.40 number g-1) obtained from rollergin system were found lower than ones obtained from sawgin system (respectivelly 4.38% and 119.34 number g-1). As a result it can be said that the rollergin method has positive effect on ginnig outturn, fiber length, uniformity index, fiber strength, spinning consistency index, short fiber index and nep count. When fiber length, fiber strength, spinning consistency index, nep size are considered together the best variety was Lydia cv. (respectivelly 30.87 mm, 32.56 g tex-1, 104.25, 675.63 μm). Ginning outturn, uniformity index, short fiber index, total particule number, dust particule number and trash count are considered together the best variety was Erşan-92 cv. (respectivelly 39.4%, 86.02%, 3.48%, 231.4 number g-1, 206.3 number g-1, 25.13 number g-1). For fiber fineness the best varieties were BA 119 and Maraş-92 cv. (respectivelly 4.78 mic. and 4.80 mic.).

Verticillium Wilt Disease is one of the most important diseases affecting the rate of cotton yield. There is no economic chemical control for Verticillium wilt, but it is recommended to use resistant varieties to control this disease. This experiment was carried out in a randomized plot design with four replications in the growth chamber to determine the response of some cotton cultivars against a defoliating and non-defoliating pathotypes of Verticilllium dahliae Kleb. In the study, a total of twenty cotton cultivars i.e. the resistant control GIZA 75, the tolerant control CARMEN and the susceptible control ACALA SJ2, defoliating (PYDV6 isolate) and non-defoliating (Vd 11 isolate) pathotypes were used, and cotton varieties were tested using conidial suspension technique. Analysis of variance showed significantly (P

This study was conducted in the Aegean region conditions of Turkey in 2020. It was carried out on May-505, a local cotton variety. The study examined the variation of seed yield, water use efficiency (WUE), and irrigation water use efficiency (IWUE) of cotton with different irrigation programs and water levels. The field trial, which was designed as two factors and three replications, was designed according to the randomized complete block trial design. Four different irrigation levels (IL) (100%, 67%, 33%, and 0%) and two different irrigation scheduling approaches (gravimetric and pan evaporation) were investigated in the study. Seasonal water use values in treatments varied between 215 (0%) and 746 (100% - Pan evaporation approach) mm during the production period. The average yield values obtained with irrigation levels, which have essential effects on cotton seed yield, are listed as follows; 2057 kg ha-1 (IL-0%), 3471 kg ha-1 (IL-33%), 3771 kg ha-1 (IL-67%), and 5083 kg ha-1 (IL-100%). It was determined pan evaporation applications performed higher yields than gravimetric applications. WUE values were between 0.63 – 1.04 kg m-3. The gravimetric method’s yield response factor (ky) was 0.73, and the pan evaporation method’s yield response factor (ky) was 0.89. These results show that cotton is tolerant of water stress. In conclusion, although the pan evaporation approach with 100% treatment is suggested for cotton production in the parts of the Aegean region within the semi-arid climate zone, while water resources are sufficient. When the results are evaluated in terms of seed cotton yield for a deficit irrigation strategy, IL-67% treatment with a gravimetric approach can be used.

In this research, it is aimed to investigate the economic performance of cotton farms and to reveal the profitability and competitiveness of cotton production in Founia district of Kita province. The research data were obtained from the questionnaires conducted with 55 farms determined according to the stratified random sampling method. Policy Analysis Matrix was used to determine profitability and competitiveness in cotton production. The results of the research showed that the farms in Founia county have an average of 10.44 da farm land. Gross production value per farm is $3519.89, agricultural income is $2197.42. According to the result obtained from PAM, private profit of cotton production in Founia district was 58.97 $/ton social profit was 1017.38 $/ton. Within the scope of the research, Specific Cost Ratio (PCR) coefficients of 0.77 and Cost Ratio of Domestic Resources (DRC) of 0.19 obtained from PAM were found. However, according to the Nominal Protection Coefficient on Output (NPCO) (0.30), Nominal Protection Coefficient on Tradable Inputs (NPCI) (0.87) and Effective Protection Coefficient (EPC) (0.20) coefficients, it is seen that the cotton price is lower than the comparable world prices and the producer earns less profit from free trade. Therefore, in the short term, incentive premiums, direct financial support, protection of cotton prices, good communication with farms and extension policies should be implemented. The increase in yield with the introduction of irrigation systems will increase competitiveness.The government and the Compagnie Malienne pour le Développement des Textiles (CMDT) should assist in the leasing and long-term purchase of modern farm machinery, which is one of the fixed capitals, in order to increase productivity.

This study investigates the impact of varying planting densities on cotton plants’ morphological traits and yield. As planting density increases, there is a reduction in monopodial and sympodial branches, resulting in a more compact plant structure. The study highlights the highest yield achieved with specific planting densities, endorsing the viability of both holl and row planting methods. It suggests adopting narrow or ultra-narrow row systems to enhance yield and economize input costs. The study was conducted in 2017 at the experimental field of Aydın Adnan Menderes University in the Faculty of Agriculture’s Department of Field Crops. The material used in this study was the widely cultivated cotton variety “Gloria” in the Aegean region. The investigation was conducted using a randomized block design with 4 replications. In evaluating cotton yield and related parameters, it was observed that D1 and D2 (14.285 plants/da) achieved the highest yield concerning plant density, emphasizing the viability of both holl and row planting methods. The study concluded that augmenting the number of plants within a specific area of production significantly contributes to higher seed cotton yields. To enhance yield and economize cotton input costs, the adoption of a narrow or ultra-narrow row production system is suggested as an alternative strategy to conventional methods.