PURPOSE: The purpose of this study was to evaluate the influences of volatile organic compounds (VOCs) emissions on hazardousness and photochemical reactivity and to propose efficient VOCs abatement strategies. METHODS: The atmospheric concentrations of 101 components of VOCs were measured at six sites which comprehend four urban areas, a roadside area, and an industrial area in Hyogo Prefecture. VOCs influence on hazardousness and photochemical reactivity were evaluated using VOCs measured data and the index on the health effect evaluation and ozone formation potential. The substances that require emissions reduction were selected from the evaluation results. The state and characteristics of environmental pollution were considered from the concentration trends of the selected substances. RESULTS: In industrial area, n-hexadecane, styrene, vinyl chloride monomer, and 1,2-dichloroethane showed a high concentration. In roadside area, n-hexane, n-undecane, n-dodecane, tetrachloroethylene, formaldehyde, acetaldehyde, and 1-butanol showed a high concentration. The excess cancer incidences for formaldehyde exceeded 10−5 of the level of concern for carcinogenic effect at all sites. Toluene had a high percentage of ozone production. The interannual and seasonal trends of toluene concentrations were different at a regional level and the formaldehyde concentrations in summer were significantly higher than those in winter at the urban sites. CONCLUSIONS: The results show the need to prepare the emission reduction plan for the major sources such as vehicle exhaust, solvent use, and industrial processes to diminish the concentration of toluene that contributes significantly to the formation of photochemical oxidant.

PURPOSE: With the aim of enhanced degradation of azo dye alizarin yellow R (AY) and further removal of the low-strength recalcitrant matter (LsRM) of the secondary effluent as much as possible, our research focused on the combination of aerobic bio-contact oxidation (ABO) with iron/carbon microelectrolysis (ICME) process. MATERIALS AND METHODS: The combined ABO (with effective volume of 2.4 l) and ICME (with effectively volume of 0.4 l) process were studied with relatively short hydraulic retention time (HRT) of 4 or 6 h. RESULTS: At the HRT of 6 h with the reflux ratio of 1 and 2, the AY degradation efficiency in the final effluent was >96.5%, and the total organic carbon (TOC) removal efficiency were 69.86% and 79.44%, respectively. At the HRT of 4 h and the reflux ratio of 2, TOC removal efficiency and AY degradation efficiency were 73.94% and 94.89%, respectively. The ICME process obviously enhanced the total AY removal and the generated micromolecule acids and aldehydes then that wastewater backflow to the ABO where they were further biodegraded. CONCLUSION: The present research might provide the potential options for the advanced treatment azo dyes wastewater with short HRT and acceptable running costs.

INTRODUCTION: The pollution of soil and environment as a result of human activity is a major problem. Nowadays, the determination of local contaminations is of interest for environmental remediation. These hotspots can have various toxic effects on plants, animals, humans, and the whole ecological system. However, economical and juridical consequences are also possible, e.g., high costs for remediation measures. MATERIALS AND METHODS: In this study three sampling strategies (simple random sampling, stratified sampling, and systematic sampling) were applied on randomly distributed hotspot contaminations to prove their efficiency in term of finding hotspots. The results were used for the validation of a computerized simulation. RESULTS AND CONCLUSION: This application can simulate the contamination on a field, the sampling pattern, and a virtual sampling. A constant hit rate showed that none of the sampling patterns could reach better results than others. Furthermore, the uncertainty associated with the results is described by confidence intervals. It is to be considered that the uncertainty during sampling is enormous and will decrease slightly, even the number of samples applied was increased to an unreasonable amount. It is hardly possible to identify the exact number of randomly distributed hotspot contaminations by statistical sampling. But a range of possible results could be calculated. Depending on various parameters such as shape and size of the area, number of hotspots, and sample quantity, optimal sampling strategies could be derived. Furthermore, an estimation of bias arising from sampling methodology is possible. The developed computerized simulation is an innovative tool for optimizing sampling strategies in terrestrial compartments for hotspot distributions.

This short review presents the procedures used to monitor PAHs, phthalates and psychotropic substances in the air, and the results of some measurements made in Italy and abroad. Organic contaminants are characterized by a variety of physical and chemical properties, including aggregation phase, concentration level, and life time. This variety widens the spectrum of procedures developed to assess their occurrence in the environment and biota, but prevents the complete speciation of the “organic fraction” of air, waters and particulates, and attention is paid to a few substances. The progress in health sciences stimulates the concern on contaminants and the development of new instrumental apparatuses and methods; new chemicals are continuously identified or recognized as capable of injuring the environment and organisms. Persistent organic pollutants and persistent biologically active toxicants are subject to regulation and extensively measured by means of standard procedures. For instance, polycyclic aromatic hydrocarbons, polychlorobiphenyls and polychlorodibenzodioxins are recovered from air through phase partition, thermal desorption or solvent extraction, then separated and detected through GC–MS or HPLC–MS procedures. By contrast, dedicated methods must be still optimized to monitor candidates or possible candidates as emerging organic pollutants, e.g. phthalates, flame retardants and perfluoroalkanes. Also, psychotropic substances appear of potential concern. Legal and illicit substances are commonly detected in the urban air besides waste and surface waters. If nicotine, caffeine and cocaine will result to enough persistence in the air, their monitoring will become an important issue of global chemical watching in the next future.

PURPOSE: Biodesulfurization (BDS) has the potential to desulfurize dibenzothiophene (DBT) and its alkylated derivatives, the compounds that are otherwise refractory to hydrodesulfurization (HDS). Thermophilic microorganisms are more appropriate to be used for BDS applications following HDS. The aim of the present study was to isolate a thermophilic microorganism and to explore its commercial relevance for BDS process. METHODS: The desulfurizing thermophilic strain was isolated and enriched from various soil and water samples using sulfur free medium (SFM) supplemented with DBT. Microbiological and genomic approach was used to characterize the strain. Desulfurization reactions were carried out using DBT and petroleum oils at 45°C followed by different analytical procedures. RESULTS: We report the isolation of a thermophilic bacterium Klebsiella sp. 13T from contaminated soils collected from petroleum refinery. HPLC analysis revealed that Klebsiella sp. 13T could desulfurize DBT to 2-hydroxybiphenyl (2-HBP) at 45°C through 4S pathway. In addition, adapted cells of Klebsiella sp. 13T were found to remove 22–53% of sulfur from different petroleum oils with highest sulfur removal from light crude oil. CONCLUSION: Klebsiella sp. 13T is a potential candidate for BDS because of its thermophilic nature and capability to desulfurize petroleum oils.

INTRODUCTION: Efficient immobilization of TiO2 nanoparticles on the surface of Mg2Al-LDH nanosheets was performed by delamination/restacking process. EXPERIMENTAL PART: The structural and textural properties of as-prepared nanocomposite were deeply analyzed using different solid-state characterization techniques such as: X-ray powder diffraction, Fourier transform infrared spectroscopy, and Raman spectroscopies, chemical analysis, X-ray photoelecton spectroscopy, N2 adsorption–desorption, and electronic microscopy. RESULTS AND DISCUSSION: The photocatalytic properties of immobilized TiO2 nanoparticles on Mg2Al were investigated using the photodegradation of two model pollutants: Orange II and 4-chlorophenol, and compared with pure colloidal TiO2 solution. CONCLUSION: It appears that Orange II photodegradation was systematically faster and more efficient than 4-chlorophenol photodegradation regardless of the medium pH. Moreover under slightly basic conditions, even if the TiO2 photocatalytic efficiency decreases, photodegradation performed in presence of easily recovered TiO2/Mg2Al1.5 nanocomposite gives rise to comparable or better results than pure TiO2.

BACKGROUND, AIMS AND SCOPE: Current studies have paid little attention to the dynamism in urban spatial expansion and its possible environmental and health effects or to the health effects of rapid urban environmental change at different points along the urbanisation gradient. This study adopts a public health ecology approach to systematically understand the relationship between urbanisation, urban environmental change and human health in China. METHOD: Remote sensing image analysis, based on night light data at five different time periods in recent decades, was used to determine changes to the overall urban area. Through a review of the evidence on the relationships between environmental health, urbanisation and health, we advance a pathway framework for explaining urban human health ecology. The Spearman rank correlation coefficient was used to measure the correlation between disease prevalence and urbanisation level, adding a further dimension to a systemic understanding of urban health. RESULTS AND CONCLUSIONS: Urban areas have been increasing spatially, but unevenly, in recent decades, with medium and small cities also expanding rapidly in the past decade. Urbanisation and urban expansion result in changes to land use/coverage change, the urban environment and the residents’ lifestyle, which result in human health problems. Regions with the highest urbanisation level were more inclined to have a high prevalence of chronic disease in recent decades. An ecological public health approach provides insights into the multiple types of data which need to be routinely collected if human disease is not to become a barrier to social and economic development.

After entry into force of the Stockholm Convention and Aarhus Protocol and in order to implement the upcoming European legal background, the European countries are asked to apply control measures to reduce the release of persistent organic pollutants (POPs) such as dioxins and furans (PCDD/PCDF) and polychlorinated biphenyls as well as to establish POPs release inventories. In this perspective, development of measuring techniques of emissions is a focal issue in acquiring useful information. In this paper, results of various measurement campaigns at different municipal waste incineration (MWI) plants using long-term automated sampling of PCDD/PCDF are presented. The samples collected from both manual and automated campaigns were analyzed following the European Standard EN-1948:2006 by high-resolution gas chromatograph/high-resolution mass spectrometer. Performances of two different commercial systems have been investigated. Anomalous values occurred during one long-term campaign (22.16 pg I-toxic equivalent (TEQ)/Nm3), compared to average values (4–5 pg I-TEQ/Nm3) of the MWI. At this maximum value, a main occurrence of abnormal and instable operating conditions has been found. Sampling based on long-term basis was found to be more reliable to monitor PCDD/PCDF emissions than occasional short-term sampling. Nevertheless, the results of long-term campaigns demonstrate that emission levels detected in 15–30 days campaigns, when unsteady operating conditions can occur, as start-up and shut down, are not immediately comparable to the typical levels in a 6–8 h, when operating conditions are generally stable. Moreover, there are often differences observed in the congener profiles between short- and long-term campaigns.

BACKGROUND AND PURPOSE: China's environmental problems and pollution control have global implications. China’s water pollution has been increasing with its urbanization and industrialization. Although great efforts have been taken to keep its wastewater discharge standards in pace with the water pollution development and technological advances, many challenges remain. A summary of the past achievements and lessons as well as the current problems in water pollution may provide a basis for future improvements in China and a reference for other countries. METHODS: Statistical data are summarized to reveal the evolution of China’s population, wastewater discharge and corresponding discharge standards over the past four decades. In particular, the specific control indexes and number of controlled items are discussed in details. The present water pollution situation is clearly illustrated by the water pollution map and the water quality distribution diagram. A comparison between China’s present wastewater discharge standards and those in the USA and the EU are also presented to find the possibilities for future improvement. RESULTS: The historical origins, major challenges and future perspectives of China’s wastewater discharge standards are overviewed. The barriers and ongoing efforts for standards formulation and implementation are highlighted. Some suggestions for future endeavors are given. CONCLUSIONS: China’s wastewater discharge standard system has seen significant improvement over the past decades, but it still has many defects and limitations. Nonetheless, unprecedented great efforts are underway to address all these challenges. More stringent standards and subsequently a cleaner water environment in China can be expected in the near future.

Caps and stipes of 141 fruiting bodies of Parasol Mushroom (Macrolepiota procera) and surface layer of soils collected from 11 spatially distant and background (pristine) areas in Northern Poland were analyzed for Ag, Al, Ba, Ca, Cd, Co, Cr, Cu, Fe, Hg, K, Mg, Mn, Na, Ni, P, Pb, Rb, Sr, and Zn by inductively coupled plasma optical emission spectroscopy and cold vapor atomic absorption spectroscopy. In terms of bioconcentration and bioexclusion concept, K, Ag, Cu, Rb, and P were highly bioconcentrated in caps, and their bioconcentration factor values varied for the 11 sites between 120 and 500—67–420, 70–220, 10–170, and 45–100, respectively. Cd, Zn, Mg, and Na showed bioconcentration factors (BCFs) between 3.3 and 36, 3.7–15, 0.92–6.3, and 1.4–44 while Al, Ba, Ca, Co, Cr, Mn, Ni, Pb, and Sr were excluded (BCF < 1). The Parasol Mushroom is a species harvested in the wild, and its caps are of unique taste and can contain a spectrum of essential and hazardous mineral compounds accumulated at elevated concentrations, even if collected at the background (pristine) areas. These elevated mineral concentrations of the caps are due to the efficient bioconcentration potential of the species (K, Ag, Cu, Rb, P, Cd, Zn, Mg, and Na) and abundance in the soil substrates (Al, Ca, Fe, Mn). The estimated intake rates of Cd, Hg, and Pb contained in Parasol Mushroom’s caps show a cause for concern associated with these metals resulting from the consumption of between 300- and 500-g caps daily, on a frequent basis in the mushrooming season.