Polycyclic Aromatic Hydrocarbon profile of Kpite oil spill impacted site in Rivers state, Nigeria was evaluated to determine the level of contamination of the soil. Four composite oil impacted soil samples were collected at different depths; surface (0-15cm) and subsurface (15-30cm) after a field reconnaissance. Extraction of the oil was carried out on the soil samples and the Polycyclic Aromatic Hydrocarbons were quantified using the Gas Chromatography- flame ionization detector. Results showed that Naphthalene was the most abundant in the range of 0.25 to 1.49 mg kg-1. Fluoranthene followed closely with concentrations in the range of 0.01 to 1.28 mg kg-1. PAHs like Benzo (k) fluoranthene, Benzo (e) pyrene, Dibenzo (a, h)anthracene, Indeno (1, 2, 3-cd) pyrene and Benzo (g, h, i) showed low concentrations of less than 0.01 indicating that strong weathering had occurred. The diagnostic ratios such as Phenanthrene/Anthracene (Phen/Anth), Benzo (a) anthracene Chrysene ((BaA)/Chry) and Fluoranthene/Pyrene (Flth/Py) and sum of chrysene/Phenanthrene ΣChry/ΣPhen were calculated and used to unravel the source of hydrocarbons. Results showed ratios of Flth/Py >1.0 and Phen/Anth ranges from 1.19 to 2.03 (< 10) which denote contamination sources, implying that the hydrocarbon sources are not just petrogenic but rather may due to contamination sources of combustion processes or the area was exposed to bush burning.

In the present investigation, coagulation-flocculation and fenton process in conjunction with phytoremediation by water hyacinth (Eicchornia crassipes) were applied to treat the most frequently occurred contaminants in textile wastewater. The mean values of EC, TDS, turbidity, pH, DO, BOD, COD and TOC in the raw effluents were 2300 μSCm-1, 1260 mgL-1, 48.28 FTU, 10.5, 1.2 mgL-1, 265 mgL-1, 522 mgL-1 and 12.8 mgL-1, respectively whereas the average concentration of Cr, Pb, Mg, Cu, Ni and Zn was 0.86, 1.21, 10.97, 0.47, 2.85 and 0.52 mg/L, correspondingly which evidently indicated that the effluents were highly contaminated compared to Bangladeshi standard. The results demonstrated that the values of EC, TDS, turbidity, pH, BOD, COD and TOC reduced significantly compared to raw effluents by both coagulation-flocculation and fenton processes and meet the standards set by BDS-ECR except BOD and DO. After being treated the COD value reduced to 70 mg/L (86.56%) and 188 mg/L (63.985%) from its initial concentration by coagulation-flocculation and fenton process, respectively on the other hand TOC removal efficiency by coagulation- flocculation process was 97.8125%, significantly greater than fenton methods where removal efficiency was 63.9%. However, the BOD removal efficiency by both treatment processes was ~50% which was not satisfactory compared to local standard. Interestingly, the concentration of DO increased substantially by both coagulation-flocculation (1.2 to 4.4 mg/L) and fenton process (1.2 to 3.85 mg/L). In case of trace elements removal, the combination of coagulation-flocculation-water hyacinth and fenton-water hyacinth show promising results where the removal efficiency of coagulation-flocculation-water hyacinth and fenton-water hyacinth was 24%-76% and 17%-76.36%, respectively. Therefore, it can be concluded that coagulation-flocculation-water hyacinth combination is better than fenton-water hyacinth combination in terms of trace metals removal. Textile effluents treatment and management is considered as one of the most significant issues in Bangladesh herein based on the this study, combination of chemical and phytoremediation technologies could be a promising sustainable low cost alternative for Bangladesh’s textile industrial sector.

The advent of advanced features of soft computing can be used to solve complex problems which are more non-linear and messy. Many of the applications have been analysed and validated by the researchers through soft computing approach in the past.Neural Networks (NN) with appropriate selection of training parameters is implemented apart from conventional mathematical model. In this paper, analysis is made on the estimation of PM10 air quality in selected regions of Chennai district by wavelet approach with energy spectrograms. After analysing the results, NN of multilayer feed forward back propagation algorithm forecasts the air quality of selected regions. Discrepancies in selecting the training parameters of NN’s have been overcome by trial and error basis. This work will be helpful in proving the powerful tool of NN to forecast short term nonlinear parameters and the predicted results will give us the clear design of existing problem and thecontrol measures need to be implemented.

The heavy metal pollution in soil caused by mining area development is a global problem. In order to screen the ecological restoration plants of copper silver tailings in arid and high saline alkali areas, and evaluate their economic value, nine kinds of plants naturally growing in the northwest copper silver tailings pond were selected, the enrichment and transfer characteristics of eight heavy metals by this plants was analyzed, and potential health risks for humans of plants were focused. The results showed that the heavy metals such as Cd, As, Cu, Hg and Ag are all from the open-air accumulation of tailings slag. Translocation factors of Cu, Ni and Cr by C. tragacanthoides are 2.1205, 53.1548 and 13.7622, bioconcentration factor of Cu, Ni and Cr by C. tragacanthoides are 1.8888, 7.1979, 7.4653, C. tragacanthoides is the hyperaccumulator for Cu, Ni and Cr. Hazard index in roots of S. collina, C. virgata and A. splendens to adults is more than 1, it has a potential non-cancer effects for more than half of adults, and for over 86.23% of children. Ag, Cr and As contribute the best to HI, and the cumulative contribution rate of the three elements can reach 85.59% to 96.39%. It is necessary to improve the treatment of tail slag to reduce environmental pollution, C. tragacanthoides can be considered as heavy metal remediation plants in arid and high saline copper tailing areas, but there is no medicinal value for these plants as ecological reconstruction in tailings area.

Because of the pinch of air pollution on human health and its environment, it has become necessary to monitor and map out the peaks and lows threat places of air pollution in different land use across a city. In this regard, air pollution exposure mapping of Kano metropolis based on land use classifications namely industrial, residential, commercial and institutional was carried out for interpretive and assessment of health hazard associated with the selected pollutants. The observations for ambient air quality parameters (CO, SO2, H2S, NO2, and PM10) monitored with portable digital air pollution detecting devices for creation of data. Geographic Information Systems (GIS) technique was applied to create spatial distribution maps of urban air quality of the metropolitan area. The results of pollution index map of ArcGIS extrapolation indicated that neighbourhoods in the vicinity of Bompai and Sabon Gari industrial and commercial zones, respectively were found to be highly exposed and liable to ailments associated with air pollution, while places nearby Dorawa and School of Technology were air pollution-ease zones but could experience bioaccumulation over long exposure time. Therefore, the study reveals that variability of air quality was strongly related to predominant land use in particular areas within the metropolis and could help in estimate and valuation of likely health challenges associated with poor air quality due to air pollution. Besides, the observed spatial variation for air quality could serve as hot spot identifier and as an informant for rational decision on air quality control strategies for environmental management.

Manufactured nanoparticles (NP) have caused extreme concern about their ecotoxicological effects on the marine systems. In this study, we investigated the biological effects (oxidative stress and genotoxic response) of TiO2-NP at predicted environmental relevant concentrations (0.2 mg/l and 1 mg/l) on marine mussel Mytilus trossulus a dominant member of the far eastern coastal community. The results of the experiment revealed that TiO2-NP when suspended in seawater, formed agglomerates ranging from 400 nm to several μm in diameter. However, TiO2-NP caused obviously oxidative damage on the mussel as evidenced by the significant elevated levels of malondialdehyde (MDA) in the gill and digestive gland. The genotoxic potential of TiO2-NP was assessed by comet assay, which detect primary DNA damage. The gill and digestive gland cells showed significantly enhanced DNA damage for both concentrations of TiO2-NP compared to the control group. These results propose that the TiO2-NP are entering the marine coastal waters can cause genotoxic effect on mollusks and comet assay can be successfully applied as an effective tool for risk assessment of NP on the marine invertebrates. The findings of this study demonstrate that the aggregation of TiO2-NP does not reduced of NP ecotoxicity, but only changes the biological responses.

This study assesses heavy metal levels in water, soil, and vegetables (swiss chard, lettuce, cabbage, collard green, tomato, green pepper and carrot) irrigated with waste water in Gamo, Ethiopia. The samples of soils, water, and vegetables were randomly collected, processed, and analyzed for heavy metals using atomic absorption spectrophotometry. The results obtained show that the irrigational water is profoundly contaminated with heavy metals Cd, Cr and Ni and Pb, Zn and Cu had the lowest concentration in irrigation water. The levels of Cd in Kulfo river area and Chamo Lake area and Ni in most of the farm soils were also found to be higher than the guideline values. The study also revealed that the mean levels of Cd in most vegetables and Cr and Pb in some vegetables were higher than the maximum recommended limits set by WHO/FAO. In general the results show that the highest concentration of the heavy metals was obtained from Kulfo river area compared to the Arbaminch textile share company area, Abaya Lake area, and Chamo Lake area. Cabbage was maximally contaminated with potential toxic elements followed by Swiss-chard, carrot, tomato, collard green, green pepper and lettuce. Hence, from kulfo river area frequent consumption of cabbage and Swiss chard may cause serious health risks to consumers. The levels of many elements were found to vary with location, suggesting localized inputs of the various contaminants related to industrial and other activities that generate wastewater. This study recommends regular monitoring of heavy metals in soils, waters, and foodstuffs to prevent excessive accrual in food chain.

With growing global warming issues, the association between technological innovation and environmental pollution has created significant debate in recent years. This paper examines the long-run and causal impact of technological innovation, economic growth, and renewable energy on consumption-based carbon emissions in Japan. The study utilized quarterly data spanning between 1990 and 2015. The study utilized recent econometrics techniques such as Maki co-integration, ARDL bunds test, FMOLS, DOLS, and frequency domain causality techniques. To the author's understanding, no prior studies have been conducted in Japan using consumption-based carbon emissions as a proxy of environmental degradation. Thus, this empirical analysis contributes to the literature. The findings from the ARDL bounds and Maki co-integration tests revealed evidence of co-integration among the series. The results of FMOLS and DOLS reveal that both renewable energy and technological innovation improve the environmental quality, while economic growth harms the quality of the environment. The results of the frequency-domain causality technique reveal that technological innovation, renewable energy, and economic growth can significantly predict consumption-based carbon emissions in Japan. Based on these outcomes, we suggested that Japan's government should be careful when formulating policies that trigger growth, which will have a detrimental impact on the environmental quality. Our empirical outcome also revealed that any policy that encourages renewable energy should be encouraged since it enhances environmental quality.

The present study attempts to investigate some blood parameters of Otolithes ruber during different seasons in terms of both temperature and pollution. For so doing it uses 10 specimens, for each station and season, collected from 5 polluted stations, including Petrochemical, Ghanam, Zangi, Douragh, Patil, and Sajafi as the control group, away from pollution in Musa Creek. The fish are anesthetized with 1ml of clove extract per liter. Their blood samples are taken immediately from the caudal vein, using a heparinized syringe. Afterwards, the serum is separated in a centrifuge with a speed of 6000 rpm for 2 minutes. The desired factors are measured by the Mindray BS200 auto-analyzer and the total protein level, by Bradford's usual laboratory methods. Results show that AST, ALT, ALP, Glucose, and Triglycerides have increased in more polluted stations (P≤0.05). In sheer contrast, total protein and Albumin have decreased as pollution grows (P≥0.05). According to this study, environmental water pollution of the fish has a large impact on the concentration of measured blood parameters, whereas the influence of seasonal changes on most of them is low.

The production rate of industrial and agricultural waste is increasing due to population growth. Soil is the most important receiver of industrial and agricultural waste. Contaminants such as heavy metals in various waste after reception by the soil, immediately become part of the cycle that has different impacts on the environment. Geopolymer, as a chemical stabilizer has the potential to stabilize heavy metals in the soil. In this research, several geopolymers for the stabilization of heavy metals in soil were synthesized. Silicon dioxide (SiO2) and aluminosilicate (Al2SiO4) must be used to produce the geopolymers. Rice husk ash was used as the SiO2 source. Also, Iranian zeolite and sepiolite, and red clay soil were utilized as the source of Al2SiO4. The synthesized geopolymers were investigated for the adsorption of nickel and cadmium. Also, batch and column studies of using geopolymers for the chemical stabilization of heavy metals in soil were conducted. The results revealed a high adsorption capacity of the geopolymers. The zeolite, sepiolite, and red clay geopolymer-soil samples adsorbed 100% of the heavy metals (i.e., Ni and Cd) at a concentration of 100 ppm. The zeolite geopolymer adsorbent adsorbed 57% and 96% of Ni and Cd at a concentration of 1000 ppm, respectively. In general, it was concluded that the use of geopolymer compounds in soils with high heavy metal adsorption capacity could be an efficient approach to prevent groundwater resource pollution.