The study represents results of theoretical evaluation of forest biomass available for solid biofuel production in pre-commercial thinning in Latvia. The study is based on the National forest inventory (NFI) data; calculations are done for each NFI plot separately. The calculation is done in three steps – selection of the NFI sample plots, which fulfils criteria for the pre-commercial thinning, development of the diameter distribution table, setting the criteria of the thinning intensity, calculation of extractable biomass. Thinning from below (removal of the smallest trees) is considered in calculation. Two types of biomass are accounted – full tree (aboveground biomass) and stem-wood (stem biomass). The study demonstrates that pre-commercial thinning could become an important source of forest biomass in Latvia (15400 GWh of primary energy according to current situation in forests); however, dimensions of trees and harvesting conditions might be challenging for production. The most of the potential biofuel resources are located in stands with average tree higher than 8 m; therefore, it is reasonably to develop and introduce technologies applicable for production of partially delimbed trees.

The stump lifting trials were implemented in 5 forest compartments of the JSC ‘’Latvia state forest’’ Vidusdaugava, Rietumvidzeme, Zemgale and Ziemeļkurzeme forestries in autumn, 2012. Total extracted area was 3.5 ha, excluding control. Two stump extraction buckets were compared in these trials – CBI (made in Canada) and MCR-500 (made in Latvia). The scope of the study was to estimate if the prototype of the MCR-500 can compete with stump lifting buckets having positive feedback from industry. Considering that the CBI head cannot prepare soil, this operation was not done by the MCR-500 either. In total 1796 stumps were marked and their main parameters were taken in all trial areas. Extracted biomass was estimated theoretically using biomass expansion factors elaborated in Nordic countries. Allegro CX field computers with SDI software were used in time studies to obtain information about productivity and distribution of productive time in a work cycle. The study demonstrated that productivity of stump extraction with both stump lifting buckets did not differ significantly in 6 cases out of total 10 comparisons.

Machining of wood of soft deciduous trees is currently based on the knowledge about cutting of wood of hard deciduous and coniferous trees and has not developed a comprehensive research methodology of cutting processes. Therefore, the objective of the study is a development of methodology for longitudinal sawing with circular saw and straight milling that would be utilized with a purpose of acquiring further knowledge on wood cutting and the improvement of cutting tool designs. Sub-objective of the study is determination of duration of cutter’s wear periods when using developed methodology. For the purpose of solving problems regarding cutting process of soft deciduous wood, the optimization of cutting tools and cutting modes were carried out in conditions that comply with the tendencies of the practise. The cutting process was carried out by a computer numerical control machine and the data acquisition by electronic measuring instruments. Aspen (Populus tremula L.) wood was used for wood samples. The methodology was developed for sawing, which complements the authors previously described methodology of the milling process investigations. Initially, only the results of periods of cutter wear and cutting velocity effects on these periods when milling process is used were obtained. It was concluded that the methodology can be used for further investigations and the critical wear period begins two times later when cutting velocity increases twice.

The properties of the transverse section surface of the wood are crucial when using it as an adhesive in finger joints. Contact angles of three test liquids sessile drops - water, diiodomethane and ethylene glycol - with known characteristics of surface free energy were measured on wood surface with the grain orientation 45 ° against the plane. Acid–base approach was used to calculate surface free energy and its characteristics of Scots pine (Pinus sylvestris L.) with moisture content of 21% and Norway spruce (Picea abies L. Karst) with moisture content of 10% wood samples from values of the contact angle. The wetting behavior of the wood samples was examined with the contact angle method (goniometer technique) in the Laboratory of the Department of Chemistry of Latvia University of Agriculture at the beginning of 2013. The aim of this study was to verify possibility of determining the contact angle values of the wood and calculate the surface free energy and its components of wood from the obtained contact angle values using acid-base theory. At the end of this study it was concluded that the acid–base approach is a suitable method to calculate surface free energy and its characteristics of wood from the values of the contact angle. Nevertheless, indirect methods of liquid drop contact angle value estimation must be used because direct determination is not feasible on wood surfaces with open capillaries.

There are about 3,000-4,000 heavy metal contaminated sites across Lithuania. According to Lithuanian legal framework, the only way to manage this pollution is ex-situ cleaning which requires excavation, transporting, storage place and later monitoring. This indicates the urgent need of innovative technologies that would be not only costeffective but also environmentally friendly and have a public acceptance. Such technologies are natural and chemically enhanced phytoextractions. Both technologies incorporate plants that can accumulate excessive amounts of heavy metals. During continuous phytoextraction plants accumulate heavy metals throughout all vegetation period and are harvested together with heavy metals when desired biomass is gained. At chemically assisted phytoextraction metal binding chelates are added to increase heavy metal uptake by plants. Since phytoextraction is considered as promising green technology, many efforts are laid to find the most suitable hyperaccumulator plants as well as ecologically safe chelating agents. This paper intends to overview latest researches done at phytoextraction field and look over this kind of remediation possibilities in Lithuania.

The research topic is sensory, healing, rehabilitation and horticultural gardens, and the related discourses. The first part of the paper describes the historic development of the rehabilitation and health gardens in Latvia. Then he research paper takes a look at the main aspects which dominate in the rehabilitation and sensory visual and functional garden sites in the world. The quest to create contemporary landscape sites for health reasons is still one of the main subjects to explore and find definitions for. The methodology used in this paper is descriptive, from the perspective of historical relaxation gardens and health sites. The aim of this research is to define the main development lines of health sites in Latvia, trying to answer such questions as: How we can start developing sensory gardens and what is needed for their development in the future? To achieve the goal, it is necessary to absorb the world experience and exchange best practices, find innovative solutions, and adapt advanced rehabilitation center area landscapes to individual needs. When creating the healing gardens, the aesthetic and functional criteria have to be applied. Depending on the availability of the natural environment, health and satisfaction will be enhanced.

The article presents the natural and regulated stream bed stability and self-regulation issues. River beds equilibrium patterns are defined by Lane principle, observed in natural beds, while this balance is disturbed in regulated ones which has been confirmed by research. Natural and regulated rivers stability was evaluated by beds hydrodynamic stability criteria. It showed that the investigated natural rivers bed is stable enough. Under accumulated silt particle sizes in natural river beds, the formation regularities of meanders were determined. The investigated river meanders patterns confirmed the formation of natural river meanders characterizing patterns. It was found that regulated Lithuanian streams through self-beds meandering are useful not only for the natural diversity formation, but also increase meandering bed sediments conveyance capacity and stability from 3 to 3.5 times. Adapting to these naturally occurring processes and using the extensive channel maintenance techniques, it is possible to force the disruption of regulated streams hydrodynamic equilibrium self-recovery and biodiversity. The aim of research - according to the selected river bed hydrodynamic stability criteria to perform comparative analysis of stability of regulated and natural streams.

The first independent career related decisions are made during the ninth grade of the elementary school when the further educational institution is selected. The concept of possible selves can be used in career education to help students increase self-awareness, explore and generate options, and formulate plans to achieve future goals. The aim of the article is to examine rural adolescents’ ability to generate career-related possible selves and plausible strategies to attain these possible selves. On the basis of the Possible Selves Theory, the open-ended measure was developed by the author. The pilot research was carried out in Latvia in January 2013. Forty six nine-graders from two rural elementary schools and two rural secondary schools participated in the research. Next year and adult possible selves generated by rural adolescents include such domains as education, employment, leisure activities, physical and personal development, as well as interpersonal relationships and lifestyle. The most important ones are domains of education and employment. Statistically significant differences of the results among the gender subgroups are not found in the research, statistically significant differences exist between the possible selves and their attaining strategies generated by rural secondary school students and rural elementary school students.

Chemical composition of crops before winter is important for successful overwintering of plants. The aim of the research, carried out from 2007/2008 till 2009/2010 at the Research and Study farm ‘Vecauce’, was to investigate the influence of agricultural practices (sowing date, sowing rate, and fungicide application) and meteorological conditions during winter on the content of sugar in apical bud and root of two types of winter oilseed rape (Brassica napus L.) cultivars. The content of sugars (monosaccharides) in apical bud and root in autumn and following spring was analysed using the Luff–Schoorl method. Sugar content in apical bud and root of winter oilseed rape in autumn and spring differed depending on the trial year, because of different, even contrary (in season 2009/2010), meteorological conditions. Sugar content was higher in plant parts developed when rape was sowed on earlier sowing dates, but it was substantially influenced by the sowing date only on some occasions. Sowing rate had no impact on sugar content in apical bud and root. Application of a fungicide as a growth regulator had no significant impact on the result, but sugar content decrease during winter 2009/2010 in the root of winter oilseed rape was smaller when fungicide as growth regulator was applied.

Products of organic origin used in agriculture to reduce the application of artificial pesticides and fertilizers are investigated world-wide now. Composting organic fertilizers, plant residue and household waste, results in new products of organic origin. In several countries (USA, Russia, Belorussia, and some others), the role of earthworms in organic waste processing and the possible further use of this processed product have been investigated. In Latvia, similar investigations are few but they are needed. A goal of our investigation was to investigate the impact of extracts made from the products of organic origin on potato (Solanum tuberosum) tuber yield in biological crop production system. A field experiment was established at the State Stende Cereals Breeding Institute in 2011, using an early-maturing potato variety ‘Borodjanskij Rozovij’ suitable for growing both in conventional and organic production systems. Tubers or plants were treated with peat elixir and earthworm bio-humus extract obtained at different temperatures: +45 °C and +95 °C, and their mixtures. In total, 18 treatments and untreated control variant were included in the experiment. Tubers were treated just prior to planting, but potato plants were treated three times in season. In the first production year, the obtained potato tuber yield ranged 26.16-45.38 t haE-1 in treated plots, and 35.27 t haE-1 in untreated control plot. Data were subjected to analysis of variance. In 2011, tuber yield was significantly dependent on organic extracts applied, which increased the yield significantly (p is lee than 0.05) in four treatments, but in the rest of them significantly decreased if compared to control.