Ozone is a hazardous gas for the environment and negatively affects plant and human health. These days, phytoextracts are commonly used as a source of bioactive compounds for reducing the detrimental environmental effects on plants. In the presented study, soybean cultivar JS-335 was used to assess the protective role of synthetic ascorbic acid (SAA) and orange juice (25% orange juice, enriched ascorbic acid) under ozone stress conditions. The results showed that under ozone stress, soybean cultivar JS-335 reduced growth and biomass and negatively affected the biochemical properties of plants due to these changes, finally causing yield losses. Foliar-applied OJ >and SAA improved plant growth and development and increased crop yield. It was discovered that a 25% OJ coupled with ascorbic acid and other essential nutrients and biomolecules was almost as effective as a 100 ppm SAA in reducing the harmful effects of ozone stress on soybean plants. As a result, it was determined that OJ, a less expensive source of ascorbic acid, can improve ozone resistance in plants in ozone-prone areas.

Nickel laterite mining is one of the sources of nickel-iron material used for producing steel and various materials. This mining activity leaves waste in the mine, including rocks, overburden, silt, and dust. Characterization is an important primary step in understanding waste for proper management, utilization, and disposal. The pH, organic matter, and elemental composition are analyzed in this study. The pH of nickel laterite mine waste is neutral to moderately alkaline, which makes it unlikely to cause acid mine drainage, which is one of the most prevailing environmental problems of mines. The organic matter content also showed favorable results for plant growth. However, the macronutrients necessary for the plant are too high, making it less favorable for agricultural utilization. Elemental composition shows the presence of nickel and other elements lower than the economically acceptable level. However, processing the lower grade can be the best option when all higher-grade resources are exhausted. The nickel laterite mine waste can be reused to further extract the metals when sources of higher grades are depleted, repurposed such as in the production of bricks and ceramics, or mined-out mines can be repurposed for renewable energy sources such as solar and wind farms.

Levrier Bay, located in the western part of Mauritanian Cost, has a strategic position in Mauritania’s fish economy and reproduction environment. Recently, fishmeal factories have multiplied in the bay. This study was carried out in Levrier Bay. It is the first one in this area which is interested in assessing the environmental impact of fishmeal factory discharges by measuring several parameters such as suspended matter, chemical oxygen demand (COD), biological oxygen demand (BOD), conductivity, turbidity, and salinity. A total of 27 samples were collected at 9 sites distributed on the link between effluents from factories and the Atlantic Ocean (discharge site). Results show that some parameters are over permissible values, like suspended matter content (SS), which reached 2020 mg. L.-1 level. The turbidity measure shows excessively high values (50 to 961 mg.L.-1); impacted by effluents at the reject point, the seawater conductivity and salinity are particularly low (4.53 to 188.2 and 13 to 56.4, respectively). The total organic carbon (TOC) values ranged from 200 to 780 mg/L, whereas the highest measured level of chemical oxygen demand was 4010 mg.L.-1 Biochemical oxygen demand content ranged from 685 to 961 mg/L. The biodegradability index (COD/BOD) shows that these effluents are not easily biodegradable because the index > 3.

Air pollution has become a major issue in cities due to urbanization, population growth, industrial development, and increasing number of vehicles. The study used Gmelina arborea tree leaves as a bioindicator to determine the Air Pollution Tolerance Index (APTI) as a simple and effective compositional index of environmental health in three cities in the Caraga Region, Philippines. To calculate the APTI, four biochemical parameters of tree leaves were calculated: relative water content, total chlorophyll content, leaf-extract pH, and ascorbic acid content. In terms of the APTI category, results showed that all G. arborea species collected in all sample sites are classified as sensitive to air pollution, with the sample collected in Bayugan City being the most sensitive, with an APTI value of 7.66, and the samples collected in Butuan and Cabadbaran City being the least sensitive, with APTI values of 9.54 and 9.11, respectively. A Kruskal-Wallis test revealed a significant difference between the APTI values of G. arborea trees in the three sampling areas in the Caraga region. Based on the APTI computed values of the tree leaves determined in all sites, it is concluded that G. arborea species can be used as a bioindicator of air pollution, classified as sensitive.

Environmental policy plays a major role in integrating environmental protection goals into economic policy areas. Environmental deterioration will proceed rapidly until this intersection is successfully achieved. The paper uses European Green Deal as a reference for fostering sustainable development goals through competition laws. This paper discusses sustainability in the context of the competition laws of various jurisdictions such as the European Union (EU), the United States (US), the United Kingdom (UK), and India. While highlighting conflicts around the intersection of competition law and environmental policies, this paper also provides their solution for making competition law environment-friendly. It suggests implementing such laws to promote sustainability and progress toward climate neutrality.

In the present study, we studied the concentrations and proportions. We identified the potential sources and health risks of 12 probably carcinogenic polycyclic aromatic hydrocarbons (PAHs) in rice grain from 31 sites in Thailand and Myanmar. The findings showed that PAH concentrations in rice grain samples from Thailand and Myanmar were in the range of 0.09 to 37.15 ng.g-1 with an average value of 18.22 ± 11.76 ng.g-1 and 0.07 to 150.73 ng.g-1 with an average value of 34.70 ± 40.57 ng.g-1, respectively. The majority group of PAHs in the rice grain samples from Thailand were the five-ring PAHs (78%), followed by four-rings (12%) and three-ring PAHs (9.5%), respectively, while for Myanmar was the five-ring PAHs were the majority (64.02%), followed by six-rings (15.22%) and four-ring PAHs (13.58%), respectively. The diagnostic ratio analysis suggested that pyrogenic origin is a major source of PAHs, and principal component analysis (PCA) identifies the incomplete combustion of fuel as likely the primary source of emissions source of PAHs contamination in rice grain samples. The total values of incremental lifetime cancer risk (ILCR) of PAH content of rice grain for children and adults were 1.95 × 10-8 and 1.44 × 10-8, respectively, for Thailand and 1.83×10-7 and 1.35×10-7 for Myanmar, which showed that the incremental lifetime cancer risk from rice grain was lower than the baseline set is considered to be safe levels.

The amount of plastic waste produced yearly is significantly increasing. Approximately 300-400 million metric tons of plastic waste are produced yearly. One of the dominant plastic wastes is a metalized film, a shiny, non-homogeneous polymer used in packaging that is considered the least recycled. Meanwhile, partition walls in buildings are traditionally made of concrete masonry, one of the most utilized materials in the construction industry globally, consumed yearly by about 11 billion metric tons. Because of the excessive use of concrete, the necessary raw materials are undeniably depleting, therefore demanding some alternatives. Polymethyl methacrylate (PMMA) is one option that can be utilized as an alternative because of its remarkable characteristics better than that of the traditional. This paper proposed the utilization of PMMA in fabricating the hollow panel filled with shredded waste metalized film packaging resulting in the lightweight wall panel being used as an alternative to concrete masonry for constructing partition walls. After the experiment, PMMA produced compressive strength of 75.30-84.30MPa, a tensile strength of 52.00-59.10MPa, a flexural strength of 102.00-107.00MPa, and water absorption of 0.80-0.90%. Also, shredded waste metalized films add aesthetic to the panel and are complemented by the remarkable transparency of PMMA. In conclusion, using this lightweight wall panel instead of traditional concrete masonry partition walls will reduce plastic waste in landfills and the raw materials necessary to produce concrete.

Pollutants like arsenic, chromium, or other toxic heavy metals have the most dreadful impact on humans or animals and also become a threat worldwide. Introducing these contaminants into the environment is not just due to the chemical industry but also coexists in combined form in underground rocks, contaminating groundwater during breakdown. Epidemics are now largely blamed on toxic pollution in many different nations worldwide. The issue has gotten worse in underdeveloped nations, where metal contamination of the groundwater affects more than a million people. Different techniques are used to remove toxic pollutants from water, but most are expensive and energy intensive. Adsorption is preferable for removing contaminants such as heavy metals or chemical dyes. As nanomaterials have been demonstrated to be more effective as nanocomposites, we used an adsorbent of nanomaterial to use the adsorption approach. These materials have become more well-liked because of their useful applications and improved characteristics. Magnetic synthesized nanocomposites have magnetic properties, which become beneficial for adsorption as it enhances adsorption capacity. The insertion of the plant or aggregate waste material for nanocomposite synthesis inhibits the growth of bacteria or other microorganisms, preventing the material from getting infected if it is in the environment. In this review paper, we have focused on the green synthesis of nanomaterials used for water treatment.

The reduction of oily sludge and scum with high water content by hot washing and analysis of the main factors that affect the reduction and oil recovery rate of oily sludge and scum in hot washing were investigated. Best process conditions for the reduction of tank bottom sludge, refining sludge, and oily scum were carried out, which can make the oil recovery rate and reduction rate of tank bottom sludge after reduction reach 96.30% and 93.00%, respectively, the oil recovery rate and reduction rate of refining sludge after reduction reach 95.36% and 92.60% respectively, and the oil recovery rate and reduction rate of oily scum after reduction reach 95.92% and 93.60% respectively. After treatment, the oil content of the residue is reduced to below 5.1%, and the water content is reduced to below 59.0%. Oil content in the separated water is lower than 200 mg.L-1, and the water content in the separated oil is lower than 0.2%, far below the requirement of 0.5% in the oilfield’s crude oil gathering and transportation standard.

The neurotoxic effects of exposure to low levels of the pesticide imidacloprid (IMI) and the effect of curcumin are of current interest when exposure occurs during early development. Male weanlings of Swiss albino mice (21 days old) were given 1 mg.kg-1 body weight (1/130 of LD50 and 2 mg.kg-1 body weight (1/65 of LD50) of imidacloprid and Curcumin (100 mg/kg body wt.) by oral gavage from postnatal day 21 to postnatal day 60. Young adult offspring were studied for behavioral parameters and learning ability using open field and Morris water maze. After completing the behavioral test, brains were processed for acetylcholine esterase activity and antioxidant enzyme estimation. The level of lipid peroxidation and activity of catalase, superoxide dismutase, and glutathione were assayed. In the present study, parameters such as locomotor activities and cognitive skills were not affected compared to lower doses of imidacloprid in the open field and Morris water test. However, activities and levels of antioxidant enzymes such as catalase and lipid peroxidation were found to be altered. In contrast, superoxide dismutase, acetylcholine esterase activity, and glutathione remained unchanged compared to the control. This suggests that subchronic exposure to low doses of IMI can lead to significant alterations in the enzymes of antioxidant protective systems such as catalase and lipid peroxidation. Co-treatment with curcumin was able to restore the activities of the affected enzymes in comparison with the control.