In the present investigation, coagulation-flocculation and fenton process in conjunction with phytoremediation by water hyacinth (Eicchornia crassipes) were applied to treat the most frequently occurred contaminants in textile wastewater. The mean values of EC, TDS, turbidity, pH, DO, BOD, COD and TOC in the raw effluents were 2300 μSCm-1, 1260 mgL-1, 48.28 FTU, 10.5, 1.2 mgL-1, 265 mgL-1, 522 mgL-1 and 12.8 mgL-1, respectively whereas the average concentration of Cr, Pb, Mg, Cu, Ni and Zn was 0.86, 1.21, 10.97, 0.47, 2.85 and 0.52 mg/L, correspondingly which evidently indicated that the effluents were highly contaminated compared to Bangladeshi standard. The results demonstrated that the values of EC, TDS, turbidity, pH, BOD, COD and TOC reduced significantly compared to raw effluents by both coagulation-flocculation and fenton processes and meet the standards set by BDS-ECR except BOD and DO. After being treated the COD value reduced to 70 mg/L (86.56%) and 188 mg/L (63.985%) from its initial concentration by coagulation-flocculation and fenton process, respectively on the other hand TOC removal efficiency by coagulation- flocculation process was 97.8125%, significantly greater than fenton methods where removal efficiency was 63.9%. However, the BOD removal efficiency by both treatment processes was ~50% which was not satisfactory compared to local standard. Interestingly, the concentration of DO increased substantially by both coagulation-flocculation (1.2 to 4.4 mg/L) and fenton process (1.2 to 3.85 mg/L). In case of trace elements removal, the combination of coagulation-flocculation-water hyacinth and fenton-water hyacinth show promising results where the removal efficiency of coagulation-flocculation-water hyacinth and fenton-water hyacinth was 24%-76% and 17%-76.36%, respectively. Therefore, it can be concluded that coagulation-flocculation-water hyacinth combination is better than fenton-water hyacinth combination in terms of trace metals removal. Textile effluents treatment and management is considered as one of the most significant issues in Bangladesh herein based on the this study, combination of chemical and phytoremediation technologies could be a promising sustainable low cost alternative for Bangladesh’s textile industrial sector.

Heavy metal concentrations in water, fish, and sediments from Bangladesh's haor region were investigated. Fish and sediment samples were taken once a season and evaluated using standard methods, while water samples were collected monthly. Results showed that metals in water (mg/L) were found in order of Mn (0.1694) > Cu (0.0189) > Zn (0.0045) > Pb (0.0040) > Cd (0.0028) within the maximum permissible level of Environment Conservation Rules (ECR). Mean concentrations of metal in fish (mg/kg–dry wt.) found in order of Zn (56.16) > Cu (25.47) > Mn (4.36) > Pb (2.19) > Cd (1.27) that were higher than maximum allowable level of Food and Agricultural Organization (FAO) except Cu. Metal in sediments (mg/kg) found in order of Mn (127.61) > Zn (32.51) > Pb (10.09) > Cu (5.40) > Cd (0.43), and except Cu all metal concentrations were lower than the Environmental Protection Agency's (EPA) probable effect concentrations. In water and sediments, pollution indices revealed a critical pollution threshold for water, and a range of unpolluted to highly polluted for sediments. Sampling sites had low potential ecological risk, despite the fact that metals were showing signs of a negative impact on people' health. Furthermore, bio-concentration factor for fish and water was low to extremely high, but for fish and sediment was low. The level of heavy metal contamination in haor shows the situation is alarming for biota and residents of the region. The relevant authority should control and monitor the aquatic ecology in order to protect it.

Technology has made the life of Bangladeshi people very flexible with new inventions. In most cases, here the people depend on these technological devices. These devices, along with various facilities, have also invited a series of problems mostly due to the lack of proper management. The Bangladeshi citizens often leave electronic devices that went bad or became unusable, in landfills, rivers, canals, and open spaces. As these devices possess a variety of toxic substances, dumping huge amounts of electronic waste can pollute the environment and threaten human health. Around 2.7 million metric tons of e-waste are generated each year in Bangladesh. Only 20-30% of this waste is recycled while the rest amount is released in landfills, rivers, canals, and open spaces posing a serious threat to the health and environment. Bangladesh has experienced rapid advancement in the technological sectors over the years. Therefore, it is a must to take steps necessary for avoiding the future jeopardized situation because of e-waste. The present e-waste management in Bangladesh experiences a number of drawbacks such as challenges in incentivization, unhygienic conditions of informal recycling, insufficient law and policy, less awareness, and lack of enthusiasm on part of the corporate to address the critical issues. In spite of the alarming levels of e-pollution in the country, the concerned authorities are yet to take any effective step or formulate any legislation to prevent the existing e-pollution. Moreover, the prevailing environmental laws are not adequate to address the issue and its application is still largely absent.