Batch adsorption process was employed to remove copper(II) and cadmium(II) ions from contaminated water using dried orange peel powder as a cellulosic adsorbent, which supports circular economy and sustainability. Metal ion concentrations were determined using a flame atomic absorption spectroscopy (FAAS). Effects of pH, sorbate-sorbent contact time, metal ion concentration and adsorbent dose on the removal efficiency of the metal ions was investigated. The adsorption equilibrium was reached at 120 and 150 minutes for Cu(II) ions and Cd(II) ions, respectively. At optimized pH and biosorbent load, 10 mg L-1 of Cu(II) and Cd(II)  ions could be removed to the extent 96.9% and 98.1%, respectively, within 2 hrs. However, the percentage removal of metal ions decreased with increasing their initial concentrations. The observed adsorption data was also interpreted in terms of Langmuir and Freundlich adsorption isotherm models. The calculated equilibrium data fitted more adequately with Freundlich model (higher correlation coefficient, R2) than Langmuir model, indicating heterogeneity of adsorption sites due to different functional groups in cellulose. Cd(II) ions showed less binding affinity and less desorption than Cu(II) ions. The maximum adsorption capacity (qmax) of dried orange peel were 2.78 mg/g and 2.57 mg/g for copper(II) and cadmium(II) ions, respectively.

Targeting the removal of Pb²⁺ in wastewater, cellulosic materials were carbonized in an aerobic environment and activated via ion exchange. The maximum adsorption capacity reached 243.5 mg/g on an MCC-derived adsorbent activated with sodium acetate. The modified porous properties improved the adsorption capacity. The capacity could be completely recovered five times through elution with EDTA. Because of the negative effects of Ni, Mg, and Ca elements, the adsorption capacities of activated carbonized natural materials were lower than that of pure cellulose. N₂ adsorption measurement showed that the adsorbent had a large specific surface area as well as abundant micropores and 4-nm-sized mesopores. FTIR and surface potential results proved that carboxyl group was generated in the aerobic carbonization, and was deprotonated during ion exchange. This adsorbent consisted of C–C bonds as the building blocks and hydrophilic groups on the surface. XPS results demonstrated that the Pb 4f binding energies were reduced by 0.7–0.8 eV due to the interaction between Pb²⁺ and the activated adsorbent, indicating that the carboxylate groups bonded with Pb²⁺ through coordination interactions. Pseudo-second-order and Elovich kinetic models were well fitted with the adsorption processes on the pristine and activated carbonized adsorbents, indicative of chemisorption on heterogeneous surfaces. The Freundlich expression agreed well with the data measured, and the pristine and activated adsorbents had weak and strong affinities for Pb²⁺, respectively. The Pb²⁺ adsorption process was exothermic and spontaneous, and heat release determined the spontaneity. The adsorption capacity is attributed to the carboxylate groups and pores generated in the aerobic oxidation and ion exchange procedures.

Aquatic plant biomass like Iris pseudacorus can be used as electron donor to improve denitrification performance in subsurface constructed wetlands. However, the phenomenon that the nitrogen removal rate declined in the terminal stage restricted the utilization of litters. In terms of this problem, this study investigated the performance of the used biomass through alkali treatment on nitrogen removal and analyzed the effect of alkali treatment on the component and structure of biomass and microbial community. The results showed that the alkali-treated biomass could further enhance the nitrogen removal by nearly 15% compared with used ones. The significant damage of cell walls and compact fibers containing cellulose and lignin through alkali treatment mainly resulted in the improvement of carbon release and nitrogen removal. With the addition of alkali-treated biomass, the richness index of microbes was higher compared with other biomass materials. Furthermore, the abundance of denitrification related genera increased and the abundance of genera for nitrification was maintained. Based on these finds, a mode of a more efficient Iris pseudacorus self-consumed subsurface flow constructed wetlands was designed. In this mode, the effluent total nitrogen could be stabilized below 5 mg L⁻¹ for nine months and the weight of litters could be further cut down by 75%. These findings would contribute to efficient utilization of plant biomass for nitrogen removal enhancement and final residue reduction in the wetlands.

Plastics are globally distributed in oceans and can pose a threat to the environment and organisms. In this study, plastic pollution in surface water and sediments of the Bohai Sea was assessed based on plastic abundance, distribution and characteristics (shape, polymer, size and color). Water and sediment samples were collected across the sea using a plankton net (330 μm) and a grab sampler, respectively. The following conclusions were reached. 1) In surface water, large plastics were less abundant (0.14 items/m³) and showed less diverse characteristics than microplastics (0.79 items/m³) but did not significantly differ in spatial distribution. 2) Microplastics in water were more abundant (1.95 items/m³) with more diverse characteristics in Liaodong Bay than in other regions of the sea (0.26–0.59 items/m³). Plastic waste from highly concentrated agricultural, industrial and fishery activities could make large contributions to microplastics in Liaodong Bay. Additionally, low hydrodynamics and long distance to Bohai Strait are unfavorable for diffusion of particles, facilitating the retention of microplastics and increasing the abundance in this bay. 3) Microplastics in sediments were smaller in terms of dominant sizes (<0.5 mm) with less diverse characteristics than particles in water (0.5–1.5 mm). Specifically, fragments, foams and lines dominated among the microplastics in water, whereas fibers and fragments were dominant particles in sediments; alkyd resin, polyethylene, polystyrene and polypropylene (PP) predominated among the particles in water, but rayon, cellulose and PP were dominant particles in sediments. 4) Neither abundance nor size of microplastics in the two media was proportionally correlated and showed low similarity indexes of polymer (0.16), shape (0.29) or color (0.38). This could be related to mismatch in spatiotemporal distributions and variations in the characteristics, fate and behavior of microplastics in the two media. The findings provide knowledge for tracing the sources of plastics in the Bohai Sea.

Natural organic matter (NOM) affects the environmental behaviors of AgNPs, which may change their phytotoxicity to plants. However, more evidence can be provided to illustrate how NOM influences AgNPs-induced phytotoxicity. In this study, using rice (Oryza sativa) as a model, the effects of NOM, Suwannee River humic acid (SRHA) and fulvic acid (FA), on the dissolution and phytotoxicity of AgNPs were investigated. Silver ions decreased in both AgNPs and AgNO₃ solution in the presence of NOM, and the effect of SRHA was stronger than FA. Image-XRF (iXRF) results showed that Ag mainly remained in the root rather than the shoot of rice seedling exposed to AgNPs. NOM mitigated the negative effects of AgNPs and AgNO₃ on rice with lower germination inhibition rate, less chlorophyll reduction, more relative biomass and less O₂•⁻ content. Moreover, NOM improved root cell viability according to FDA fluorescent dye as well as maintained the normal root morphology. Interestingly, the neutral sugars content from pectin, hemicellulose 1, hemicellulose 2 and cellulose of root cell wall in AgNPs and AgNO₃ treatments differed from the control, while it was close to the regular content in AgNPs/AgNO₃+SRHA/FA groups, which implied that NOM regulated the changes. Besides, SRHA led to less germination and less relative biomass than FA due to different chemical characters. Thus, NOM needs to be considered when studying the phytotoxicity of AgNPs.

Proper management of waste crop residues has been an environmental concern for years. Yellow mealworms (larvae of Tenebrio molitor Linnaeus, 1758) are major insect protein source. In comparison with normal feed wheat bran (WB), we tested five common lignocellulose-rich crop residues as feedstock to rear mealworms, including wheat straw (WS), rice straw (RS), rice bran (RB), rice husk (RH), and corn straw (CS). We then used egested frass for the production of biochar in order to achieve clean production. Except for WS and RH, the crop residues supported mealworms’ life activity and growth with consumption of the residues by 90% or higher and degraded lignin, hemicellulose and cellulose over 32 day period. The sequence of degradability of the feedstocks is RS > RB > CS > WS > RH. Egested frass was converted to biochar which was tested for metal removal including Pb(II), Cd(II), Cu(II), Zn(II), and Cr(VI). Biochar via pyrolysis at 600 °C from RS fed frass (FRSBC) showed the best adsorption performance. The adsorption isotherm fits the Langmuir model, and kinetic analysis fits the Pseudo-Second Order Reaction. The heavy metal adsorption process was well-described using the Intra-Particle Diffusion model. Complexation, cation exchange, precipitation, reduction, deposition, and chelation dominated the adsorption of the metals onto FRSBC. The results indicated that crop residues (WS, RS, RB, and CS) can be utilized as supplementary feedstock along with biochar generated from egested frass to rear mealworms and achieve clean production while generating high-quality bioadsorbent for environment remediation and soil conditioning.

Aluminum (Al) phytotoxicity is a major limitation in the production of crops in the soils with pH ≤ 5. Boron (B) is indispensable nutrient for the development of higher plants and B role has been reported in the alleviation Al toxicity. Trifoliate orange rootstock was grown in two B and two Al concentrations. The results of the present study showed that Al toxicity adversely inhibited root elongation and exhibited higher oxidative stress in terms of H2O2 and O2− under B-deficiency. Additionally, the X-ray diffraction (XRD) analysis confirmed the increase of the cellulose crystallinity in the cell wall (CW). Al-induced remarkable variations in the CW components were prominent in terms of alkali-soluble pectin, 2-keto-3-deoxyoctonic acid (KDO) and the degree of methyl-esterification (DME) of pectin. Interesting, B supply reduced the pectin (alkali-soluble) under Al toxicity. Moreover, the results of FTIR (Fourier transform infrared spectroscopy) and 13C-NMR (13C nuclear magnetic resonance) spectra revealed the decrease of carboxyl groups and cellulose by B application during Al exposure. Furthermore, B supply tended to decrease the Al uptake, CW thickness and callose formation. The study concluded that B could mitigate Al phytotoxicity by shielding potential Al binding sites and by reducing Al induced alterations in the CW cellulose and pectin components.

Knowledge of adsorption behavior of organic contaminants on high heat temperature treated biochars is essential for application of biochars as adsorbents in wastewater treatment and soil remediation. In this study, isotherms of 25 aromatic compounds adsorption on biochars pyrolyzed at 700 °C from biomass including wood chips, rice straw, bamboo chips, cellulose, lignin and chitin were investigated to establish correlations between adsorption behavior and physicochemical properties of biochars. Isotherms were well fitted by Polanyi theory-based Dubinin-Ashtakhov (DA) model with three parameters, i.e., adsorption capacity (Q⁰) and adsorption affinity (E and b). Besides the negative correlation of Q⁰ with molecular maximum cross-sectional areas (σ) of organic compounds, positive correlations of Q⁰ with total pore volume (Vₜₒₜₐₗ) and average diameter of micropore (D) of biochars were observed, indicating that adsorption by biochars is captured by the pore-filling mechanism with molecular sieving effect in biochar pores. Linear solvation energy relationships (LSERs) of adsorption affinity (E) with solvatochromic parameters of organic compounds (i. e., αₘ and π∗) were established, suggesting that hydrophobic effect, π-π interaction and hydrogen-bonding interaction are the main forces responsible for adsorption. The regression coefficient (π₁) and intercept (C) of obtained LSERs are correlated with biochar H/C and Rₘᵢcᵣₒ, respectively, implying that biochars with higher aromaticity and more micropores have stronger π-π bonding potential and hydrophobic effect potential with aromatic molecule, respectively. However, hydrogen-bonding potential of biochars for organic molecules is not changed significantly with properties of biochars. A negative correlation of b with biochar H/C is also obtained. These correlations could be used to predict the adsorption behavior of organic compounds on high heat temperature treated biochars from various biomass for the application of biochars as sorbents and for the estimating of environmental risks of organic compounds in the present of biochars.

Coupling with triolein-embedded cellulose acetate membrane (TECAM) technique, hydroxypropyl β-cyclodextrins (HPCD) extraction method, and the greenhouse pot experiments, the influences of biochars on polychlorinated biphenyls (PCBs) bioavailability in soil to plant (Brassica chinensis L. and Daucus carota) were investigated. Addition of 2% biochars to soils significantly reduced the uptake of PCBs in plant, especially for di-, tri- and tetra-chlorobiphenyls. PCBs concentrations in the roots of B. chinensis and D. carota were reduced for 61.5–93.7%, and 12.7–62.4%, respectively in the presence of biochars. The kinetic study showed that in the soils amended with/without biochars, PCBs concentrations accumulated in TECAM, as well as in the HPCD extraction solution, followed significant linear relationships with those in plant roots. Application of biochars to soil is a potentially promising method to reduce PCBs bioavailability whereas TECAM technique can be a useful tool to predict the bioavailability of PCBs in soil.

Triolein embedded cellulose acetate membrane (TECAM) was used for passive sampling of the fraction of naphthalene, phenanthrene, pyrene and benzo[a]pyrene in 18 field-contaminated soils. The sampling process of PAHs by TECAM fitted well with a first-order kinetics model and PAHs reached 95% of equilibrium in TECAM within 20 h. Concentrations of PAHs in TECAM (CTECAM) correlated well with the concentrations in soils (r2 = 0.693-0.962, p < 0.001). Furthermore, concentrations of PAHs determined in the soil solution were very close to the values estimated by CTECAM and the partition coefficient between TECAM and water (KTECAM-w). After lipid normalization nearly 1:1 relationships were observed between PAH concentrations in TECAMs and earthworms exposed to the soils (r2 = 0.591–0.824, n = 18, p < 0.01). These results suggest that TECAM can be a useful tool to predict bioavailability of PAHs in field-contaminated soils.