Wastewater treatment plants (WWTPs) are almost the only place where plastic fragments are artificially removed, resulting in mass accumulation of nanoplastics (NPs). In this research, four different concentrations (0 mg/L, 0.1 mg/L, 1 mg/L, 10 mg/L) of polystyrene nanoplastics (PS-NPs) were used to investigate the cell damage and nitrogen inhibition of activated sludge, exposed in a self-assembled SBR reactor for 30 days. Intracellular reactive oxides (ROS) and extracellular lactate dehydrogenase (LDH) increased with the rise of exposure concentration, and morphological analysis disclosed the creases, collapse, and even rupture of cell membranes. However, exposure damage (PS-NPs ≤ 1 mg/L) appeared to be reversible, attributed to that extracellular polymeric substances (EPS) secretion can thicken the three protective layers outside the membrane. PS-NPs did not disrupt the EPS chemical structure, but increased humic acid content. Prolonged exposure time (from 15 to 30 days) was directly related to the nitrogen inhibition. Due to the habitat changes under PS-NPs exposure, abundance and diversity of microorganisms in the original activated sludge decreased significantly, and the dominant phylum was occupied by Patescibacteria (PS-NPs = 10 mg/L). Changes in enzyme activities of AMO, NR, NIR, and NOR with exposure concentration may explain the conversion of nitrogen in SBR. This research broadens our horizons to understand the response mechanism of activated sludge bacteria to PS-NPs exposure individually and collectively.

The on-going and extensive use of neonicotinoids occur in orchards. However, it is still unknown whether and how orchard management affects soil properties, especially the contents and structure of soil organic matter during orchard development, and their further influences on neonicotinoid persistence. Here, surface soil samples were collected from the citrus orchards with different cultivation ages (1, 10, 14, and 20 years), and their physicochemical properties were determined. Changes in the chemical structure of soil organic matter (SOM) were furtherly examined using solid-state CP/TOSS ¹³C NMR. Then, the sorption isotherms of imidacloprid in these soils were investigated. The sorption coefficient (Kd) of imidacloprid at Cₑ of 0.05 mg/L in the orchard soils increased by 19.4–23.3%, along a 20-year chronosequence of cultivation, which should be mainly ascribed to the increase of SOM. However, the organic carbon-normalized sorption coefficient (Kₒc, sorption per unit mass of OM) of imidacloprid declined with increasing cultivation ages. Moreover, the polar and aliphatic domains of SOM had a significantly positive relation to the Kₒc of imidacloprid, suggesting its key role in governing imidacloprid sorption. The results highlighted that reasonable management measures could be adopted to control the occurrence and fate of neonicotinoids in soils, mainly by affecting the content and quality of SOM.

Carbazole in source water is a potential precursor for toxic chlorocarbazoles in drinking water when chlorine is used as a disinfection agent in drinking water treatment plants. However, the reactivity of carbazole and the specific structures and predominant analogues of chlorocarbazoles produced during aqueous chlorination remain unknown. In this study, the aqueous chlorination of carbazole was performed to characterize its reactivity and the chlorinated products. Chlorocarbazoles generated from carbazole were identified by a comprehensive two-dimensional gas chromatography-mass spectrometry method, and their molecular structures were predicted by the Fukui index of electrophilic attack, f−1(r). As a result, the comprehensive chlorination pathway of carbazole was extrapolated with a total of nine chlorocarbazoles identified, including two monochlorocarbazoles (3-chlorocarbazole and 1-chlorocarbazole), four dichlorocarbazoles (3,6-dichlorocarbazole, 1,6-dichlorocarbazole, 1,3-dichlorocarbazole and 1,8-dichlorocarbazole), two trichlorocarbazoles (1,3,6-trichlorocarbazole and 1,3,8-trichlorocarbazole) and one tetrachlorocarbazole (1,3,6,8-tetrachlorocarbazole). The f−1(r) value indicates that the C1, C3, C6 and C8 atoms of carbazole were the favored positions for electrophilic attack, with the C3 and C6 atoms being the predominant sites for chlorine substitution. 3-Chlorocarbazole, 3,6-dichlorocarbazole, 1,3,6-trichlorocarbazole and 1,3,6,8-tetrachlorocarbazole were the major analogues of each chlorocarbazole group; however, the production of minor analogues such as 1-chlorocarbazole and 1,6-dichlorocarbazole should not be overlooked. The chlorination of carbazole was a pseudo first order reaction with a reaction rate of 0.1836 nmol/(L· h) and half-life of 3.77 h (pH = 6.4, Cl2 = 4.7 mg/L), and the chlorination rate of carbazole was approximately 5 times faster than that of an known chlorination precursor pyrene. These results showed that Fukui index was efficacious to predict the chlorination sites of aromatic compounds, and that carbazole is readily transformed into toxic chlorocarbazoles in drinking water treatment plants that use chlorine as a disinfection agent.

Many antibiotics, including sulfonamides, are being frequently detected in soil and groundwater. Livestock waste is an important source of antibiotic pollution, and sulfonamides may be present along with organic-rich substances. This study aims to investigate the sorption reaction of two sulfonamides, sulfamethoxazole (SMZ) and sulfapyridine (SPY) in two organic-rich sorbents: a commercial peat soil (38.41% carbon content) and a composted manure (24.33% carbon content). Batch reactions were conducted to evaluate the impacts of pH (4.5–9.5) and background ions (0.001 M–0.1 M CaCl2) on their sorption. Both linear partitioning and Freundlich sorption isotherms fit the reaction well. The n values of Freundlich isotherm were close to 1 in most conditions suggesting that the hydrophobic partition is the major adsorption mechanism. In terms of SMZ, Kd declined with increases in the pH. SPY has a pyridine group that is responsible for adsorption at high pH values, and thus, no significant trend between Kd and pH was observed. At high pH ranges, SPY sorption deviated significantly from linear partitioning. The results suggested the sorption mechanism of these two sulfonamide antibiotics tended to be hydrophobic partitioning under most of the experimental conditions, especially at pH values lower than their corresponding pKa2. The fluorescence excitation emission matrix and dissolved organic carbon leaching test suggested composted manure has higher fulvic acid organics and that peat soil has higher humus-like organics. Small organic molecules showed stronger affinity toward sulfonamide antibiotics and cause the composted manure to exhibit higher sorption capacity. Overall, this study suggests that the chemical structure and properties of sulfonamides antibiotics and the type of organic matter in soils will greatly influence the fate and transport of these contaminants into the environment.

Among urban stormwater pollutants, hydrocarbons are a significant environmental concern due to their toxicity and relatively stable chemical structure. This study focused on the identification of hydrocarbon contributing sources to urban road dust and approaches for the quantification of pollutant loads to enhance the design of source control measures. The study confirmed the validity of the use of mathematical techniques of principal component analysis (PCA) and hierarchical cluster analysis (HCA) for source identification and principal component analysis/absolute principal component scores (PCA/APCS) receptor model for pollutant load quantification. Study outcomes identified non-combusted lubrication oils, non-combusted diesel fuels and tyre and asphalt wear as the three most critical urban hydrocarbon sources. The site specific variabilities of contributions from sources were replicated using three mathematical models. The models employed predictor variables of daily traffic volume (DTV), road surface texture depth (TD), slope of the road section (SLP), effective population (EPOP) and effective impervious fraction (EIF), which can be considered as the five governing parameters of pollutant generation, deposition and redistribution. Models were developed such that they can be applicable in determining hydrocarbon contributions from urban sites enabling effective design of source control measures.

Bioavailability of Cu in the soil is a function of its speciation. In this paper we investigated Cu speciation in six soils using X-ray absorption near edge structure (XANES), extended X-ray absorption fine structure (EXAFS), and synchrotron-based micro X-ray fluorescence (μ-XRF). The XANES and EXAFS spectra in all of the soils were the same. μ-XRF results indicated that the majority of the Cu particles in the soils were not associated with calcium carbonates, Fe oxides, or Cu sulfates. Principal component analysis and target transform of the XANES and EXAFS spectra suggested that Cu adsorbed on humic acid (HA) was an acceptable match. Thus it appears that Cu in all of the soils is primarily associated with soil organic matter (SOM). Theoretical fitting of the molecular structure in the soil EXAFS spectra revealed that the Cu in the soils existed as Cu atoms bound in a bidentate complex to O or N functional groups.

Little information is available on the environmental occurrence and ecotoxicological effects of pharmaceutical gestagens released in the aquatic environment. Since eighteen different gestagens were found to be used in France, preliminary exposure and hazard assessment were done. Predicted environmental concentrations (PECs) suggest that if parent gestagens are expected to be found in the ng l−1 range, some active metabolites could be present at higher concentrations, although limited data on metabolism and environmental fate limit the relevance of PECs. The biological effects are not expected to be restricted to progestagenic activity. Both anti-androgenic activity (mainly for cyproterone acetate, chlormadinone acetate and their metabolites) and estrogenic activity (mainly for reduced metabolites of levonorgestrel and norethisterone) should also occur. All these molecules are likely to have a cumulative effect among themselves or with other xenoestrogens. Studies on occurrence, toxicity and degradation time are therefore needed for several of these compounds. Gestagens exposure and hazard assessment for the aquatic environment.

Residential coal combustion is a prominent source of brown carbon (BrC) aerosols, but knowledge of their molecular structures and optical absorption were limited, which have notable used in ambient BrC source identification and radiative forcing calculation. In this study, the Fourier transform–ion cyclotron resonance mass spectrometry combined with partial least squares regression analysis as well as Fourier transform infrared spectroscopy analysis were used to insight the molecular compounds and structures of BrC from anthracite and bituminous coal combustions between traditional and improved stoves. The absorption Ångström exponents (AAE) and mass absorption efficiency (MAE) values for the BrC emitted from the combinations of bituminous were both 1.2–2.5 times lower than those of anthracite, interpreting that the BrC from the anthracite emissions had greater light-absorbing capacity. In contrast, the emission factor of light absorption (EFAbₛ) at 365 nm for the bituminous coal combusted in the traditional stove was the highest among all the tested scenarios, which revealed that the incomplete combustion of bituminous coal could emit more BrC. It was noted that primary BrC emitted from the coal combustion with traditional stoves contains higher aromaticity groups of C–C and C＝O and higher S containing organics, whereas more aliphatic groups were found in BrC using the improved stoves. N-containing (CHON and CHONS) compounds were dominated in the total molecular formula of BrC, whereas the sum of CHON and CHO groups had high double-bond equivalent (DBE) values contributed 53.5%–87.1% to the total BrC absorption. Moreover, for CHOS, the lowest of estimated molecular absorption, DBE, and DBE/C should attribute to the non-chromophoric or weak absorptive S-containing compounds. This study supplied an effective evaluation method to compare BrC emissions and their absorption for coal combustion on regional scale.

Distribution in ice is regarded as one of important transport modes for pollutants in seasonal freeze-up waters in cold regions. However, the distribution characteristics and mechanisms of fluorinated antibiotics as emerging contaminants during the water freezing process remain unclear. Here, florfenicol and norfloxacin were selected as model fluorinated antibiotics to investigate their ice-water distribution. Effects of antibiotic molecular structure on the distribution were explored through comparative studies with their non-fluorinated structural analogs. Results showed that phase changes during the ice growth process redistributed the antibiotics, with antibiotic concentrations in water 3.0–6.4 times higher than those in ice. The solute-rich boundary layer with a concentration gradient was presented at the ice-water interface and controlled by constitutional supercooling during the freezing process. The ice-water distribution coefficient (KIW) values of antibiotics increased by 34.8%–38.0% with a doubling of the cooling area. The solute distribution coefficient (Kbₛ) values of antibiotics at −20 °C were 65.6%–70.3% higher than at −10 °C. The KIW and Kbₛ values of all antibiotics were negatively correlated with their water solubilities. The fluorine substituents influenced the binding energies between antibiotics and ice, resulting in a 1.1-fold increase in the binding energy of norfloxacin on the ice surface relative to its structural analog pipemidic acid. The results provide a new insight into the transport behaviors of fluorinated pharmaceuticals in ice-water systems.

In this critical review, we explored the most recent advances about the fate of antibiotics on biological wastewater treatment plants (WWTP). Although the occurrence of these pollutants in wastewater and natural streams has been investigated previously, some recent publications still expose the need to improve the detection strategies and the lack of information about their transformation products. The role of the antibiotic properties and the process operating conditions were also analyzed. The pieces of evidence in the literature associate several molecular properties to the antibiotic removal pathway, like hydrophobicity, chemical structure, and electrostatic interactions. Nonetheless, the influence of operating conditions is still unclear, and solid retention time stands out as a key factor. Additionally, the efficiencies and pathways of antibiotic removals on conventional (activated sludge, membrane bioreactor, anaerobic digestion, and nitrogen removal) and emerging bioprocesses (bioelectrochemical systems, fungi, and enzymes) were assessed, and our concern about potential research gaps was raised. The combination of different bioprocess can efficiently mitigate the impacts generated by these pollutants. Thus, to plan and design a process to remove and mineralize antibiotics from wastewater, all aspects must be addressed, the pollutant and process characteristics and how it is the best way to operate it to reduce the impact of antibiotics in the environment.