The effect of ceramic filter composition on improving the quality of produced water by reducing total dissolved solids (TDS), barium, and phenol for reverse osmosis (RO) treatment was investigated in the present work. The ceramic filters were fabricated using a residue catalytic cracking (RCC) unit spent catalyst with and without activation, clay, and Dioscorea hispida starch (DHS), at various compositions.  The result showed that the optimum removal of TDS, barium, and phenol in produced water was achieved at a flow rate of sample 7 L/min and an operating time of 90 min. Ceramic filter with the composition of 60% spent catalyst without activation: 37.5% clay: 2.5% DHS reduced 34.84% TDS, 27.97% barium, and 71.11% phenol. While, the ceramic filter with a composition of 37.5% activated spent catalyst: 60% clay: 2.5% DHS was removed 51.44% TDS, 27.93% barium, and 85.29% phenol from produced water. The next steps of treatment of filtrates of the ceramic filter using reverse osmosis (RO) membrane showed that the permeate met the Indonesian standard for oil and gas wastewater. In addition, adsorption of TDS, barium, and phenol from produced water was dominated by clay composition in the ceramic filter.

Partie B | International audience | Incidental zinc sulfide nanoparticles (nano-ZnS) are spread on soils through organic waste (OW) recycling. Here we performed soil incubations with synthetic nano-ZnS (3 nm crystallite size), representative of the form found in OW. We used an original set of techniques to reveal the fate of nano-ZnS in two soils with different properties. 68 Zn tracing and nano-DGT were combined during soil incubation to discriminate the available natural Zn from the soil, and the available Zn from the dissolved nano-68 ZnS. This combination was crucial to highlight the dissolution of nano-68 ZnS as of the third day of incubation. Based on the extended X-ray absorption fine structure, we revealed faster dissolution of nano-ZnS in clayey soil (82% within 1 month) than in sandy soil (2% within 1 month). However, the nano-DGT results showed limited availability of Zn released by nano-ZnS dissolution after 1 month in the clayey soil compared with the sandy soil. These results highlighted: (i) the key role of soil properties for nano-ZnS fate, and (ii) fast dissolution of nano-ZnS in clayey soil. Finally, the higher availability of Zn in the sandy soil despite the lower nano-ZnS dissolution rate is counterintuitive. This study demonstrated that, in addition to nanoparticle dissolution, it is also essential to take the availability of released ions into account when studying the fate of nanoparticles in soil.

Widespread soil contamination threatens living standards and weakens global efforts towards the Sustainable Development Goals (SDGs). Detailed soil mapping is needed to guide effective countermeasures and sustainable remediation operations. Here, we review visible and infrared reflectance spectroscopy (VIRS) based detection methods in combination with machine learning. To date, proximal, airborne and spaceborne carrier devices have been employed for soil contamination detection, allowing large areas to be covered at low cost and with minimal secondary environmental impact. In this way, soil contaminants can be monitored remotely, either directly or through correlation with soil components (e.g. Fe-oxides, soil organic matter, clay minerals). Observed vegetation reflectance spectra has also been proven an effective indicator for mapping soil pollution. Calibration models based on machine learning are used to interpret spectral data and predict soil contamination levels. The algorithms used for this include partial least squares regression, neural networks, and random forest. The processes underlying each of these approaches are outlined in this review. Finally, current challenges and future research directions are explored and discussed.

Southwestern China contains the largest and most well-developed karst region in the world, and the potentially toxic elements (PTEs) content in the soils of the region is remarkably high. To explore the internal and external control factors and sources of soil PTEs enrichment in this area and to provide a basis for the treatment of PTE pollution, 113 soil samples were collected from Hengxian County, a karst region in Guangxi Province, southwestern China. The importance of eighteen influencing factors including parent material, weathering, physicochemical properties, topography and human activities were quantitatively analyzed by (partial) redundancy analysis. The sources of PTEs were identified using the Pb isotope ratio and absolute principal component score/multiple linear regression (APCS-MLR) model. The contents of all soil PTEs were higher than the corresponding background values of Guangxi soils. The contents in Cu, Zn, Cd, Hg and Pb were the highest in the soil from carbonate rock. The factor group of geological background and weathering explained 26.5% for the accumulation and distribution of soil PTEs and the influence of physicochemical properties was less than 2% but increased to 25.6% through interaction with weathering. Fe (47.1%), Al (42.1%), Mn (22%), chemical index of alteration (12.8%) and clay (11.9%) were the key factors affecting the soil PTEs, while the influence of human activities was weak. Pb isotope ratio and APCS-MLR classified 62.8–74% of soil PTEs as derived from natural sources, whereas 18.23% and 18.95% were derived from industrial activities and agricultural practice/traffic emissions, respectively. The Pb isotope ratio showed that the natural sources account for up to 90% of the Pb in the soil from carbonate rock, the highest contribution among the studied soils. The results of the study can provide background information on the soil PTEs contamination in the karst areas of China and other areas worldwide.

Multi-layered engineered landfill consists of the bottom liner layer (mainly bentonite clay (B)) upon which the hazardous wastes are dumped. In current practice, sand (S) is mixed with bentonite to mitigate the adverse effects of using bentonite alone in the liner layer. Incorporation of waste and unutilized fly ash (FA) as an amendment material to B has been explored in terms of its hydro-mechanical properties, but not gauged its adsorption potential. Indian subcontinent primarily relies on the thermal power source, and FA dumps have already reached its full capacity. The objective of this study is to explore the adsorption characteristics of four B-FA composite mixes sourced within India, considering Pb²⁺ as a model contaminant. The effect of fly ash type, fly ash amendment rate and adsorbate concentration was explored in the current study and juxtaposed with B-S mixes, based on 960 batch adsorption tests. Both B-FA and B-S mixes reached equilibrium adsorption capacity within 65 min. At higher adsorbate concentrations (commonly observed in the liner), B-FA mixes exhibited superior adsorption capacity, mainly one mixed with Neyvelli fly ash (NFA). The effect of higher amendment rate had little impact on the adsorption capacity at different concentration, but gradually decreased the percentage removal of Pb²⁺. The B-S mix showed a drastic decrease in percentage removal at higher adsorbate concentration among all tested mixes. Systematic characterization including geotechnical properties, microstructure and chemical analysis was also done to interpret the obtained results. Both Freundlich and Langmuir models fitted the isotherm data well for all B-FA mixes. The maximum adsorption capacity from the isotherm was correlated to easily measurable Atterberg limits by two empirical relationships.

Condensed organic matters (COM) with black carbon-like structures are considered as long-term carbon sinks because of their high stability. It is difficult to distinguish COM from general organic matter by conventional chemical analysis, thus the contribution by and interaction mechanisms of organo-mineral complexes in COM stabilization are unclear and generally neglected. Molecular markers related to black carbon-like structures, such as benzene polycarboxylic acids (BPCAs), are promising tools for the qualitative and quantitative analysis of COM. In this study, one natural soil and two cultivated soils with 25 y- or 55 y-tillage activities were collected and the distribution characteristics of BPCAs were detected. All the investigated soils showed similar BPCA distribution pattern, and over 60% of BPCAs were detected in clay fraction. The extractable BPCA contents were substantially increased after mineral removal. The ratios of BPCA contents before and after mineral removal indicate the extent of COM-mineral particle interactions, and our results suggested that up to 73% COM were protected by mineral particles, and more stronger interactions were noted on clay than on silt. The initial cultivation dramatically decreased COM-clay interactions, and this interaction was recovered only slowly after 55-y cultivation. Kaolinite and muscovite are important for COM protection. But a possible negative correlation between BPCAs and reactive iron oxides of the cultivated soils suggested that iron may promote COM degradation when disturbed by tillage activities. This study provided a new angle to study the stabilization of COM and emphasized the importance of organo-mineral complexes for COM stabilization.

Fluoxastrobin is one of the most widely used strobilurin fungicides, however, application of the fungicides may result in soil residues leading to environmental damage including oxidative stress and damage to sentinel organisms (i.e. earthworms). While this has been demonstrated in artificial soil, the biochemical response of Eisenia fetida exposed to fluoxastrobin in natural soils is unclear. This study utilized three typical natural soils (fluvo-aquic soils, red clay, and black soils) to evaluate the biochemical response of Eisenia fetida exposed to fluoxastrobin (0.1, 1.0, 2.5 mg/kg) including the production of reactive oxygen species, impact on three enzyme activities, lipid peroxidation, and 8-hydroxydeoxyguanosine after a 4-week exposure. The effects of fluoxastrobin on Eisenia fetida in different soils were assessed using an integrated biomarker response (IBR). The findings may be possible to state that the toxic effects of fluoxastrobin in artificial cannot exactly represent that in natural soils. Specifically, the fluoxastrobin subchronic toxicity was highest in red clay and lowest in black soil among the three natural soils. Furthermore, the 8-OHdG content was more sensitive to fluoxastrobin in all six environmental indicators of the present study.

Mangroves act as sinks for terrigenous pollutants to alleviate their influence on offshore marine ecosystem. The nationwide study of PBDEs contamination in mangrove wetlands of China has not been explored, and their risk for human health lack quantitative analysis. In this study, sediment samples were collected in six mangrove wetlands along coastal area of South China to evaluate the levels, congener distributions and ecological risks of eight PBDEs, including BDE-28, -47, −99, −100, −153, −154, −183, and −209. Levels of ∑PBDEs (the sum of seven PBDEs except BDE-209) and BDE-209 were 0.13–2.18 ng g−1 and 1.44–120.28 ng g−1, respectively. In particular, mean level of BDE-209 was highest in Futian, followed by Yunxiao, Fangchenggang, Zhanjiang, Dongzhaigang, and Dongfang. As dominant PBDE congener, BDE-209 accounted for 63.6%–99.1% of the total PBDEs, suggesting the major sources of commercial deca-BDE mixtures. Among seven PBDE congeners except BDE-209, slightly different percentages of PBDE congeners were detected, with BDE-154, -47, and −100 being predominant congeners. Positive relationship was observed for total organic matter (TOM) with BDE-209, with no such relationships found for particle size compositions (clay, silt and sand). As for sediment-dwelling organism, the ecological risks from tri-, tera-, and hexa-BDE congeners could be negligible, and those from penta- and deca-BDE congeners were low or moderate, indicating major ecological risk drivers of penta- and deca-BDE congeners in mangrove wetlands in China. The ecological risk of PBDEs in mangrove sediments for human health was thought to be consumption of fish which would bioaccumulate PBDEs from the contaminated sediment. As for human health, the levels of non-cancer risks of PBDEs were all lower than 1, and the cancer risk was far less than the threshold level (10−6), demonstrating low risk for human health.

Tetracycline (TC) can enter the human body via the soil-vegetable-human food chain; therefore, it is necessary to understand the toxicity of TC to humans through vegetables grown on contaminated soils. The present study combined an enzyme-linked immunosorbent assay method and an HL-7702 cell model and assessed the bioavailability and toxicity of TC from pak choi (Brassica campestris L. ssp. chinensis) grown on TC-contaminated soils. The results showed that the degradation rate of TC in black soil was significantly higher than that in purplish clay, while the results for TC uptake in pak choi were opposite. The bioaccessibility of TC was found to be higher in pak choi grown on purplish clay (5.67–7.59%) than in that grown on black soil (5.22–6.77%). It is suggested that soil properties contribute to the uptake of TC by pak choi. More fertile soil contained lower TC concentrations and thus mediated lower TC toxicity to humans. It may seem comforting that TC concentrations in the edible parts of pak choi are often found to be below safe limits. However, the TC diagnosis method showed that even moderate increases in TC concentrations in pak choi may induce oxidative stress, liver injury, mitochondrial cristae and rough endoplasmic reticulum swelling, and early apoptosis in liver cells HL-7702. The pak choi grown in purplish clay showed higher TC cytotoxicity than that grown in black soil. The TC cytotoxicity of raw pak choi was found to be higher than that of cooked pak choi. These results provide direct evidence of effective ways to prevent TC toxicity in humans.

Copper oxide nanoparticles (CuO NPs) is one of the most commonly used metal oxide nanoparticles for commercial and industrial products. An increase in the manufacturing and use of the CuO NPs based products has increased the likelihood of their release into the aquatic environment. This has attracted major attention among researchers to explore their impact in human as well as environmental systems. CuO NPs, once released into the environment interact with the biotic and abiotic constituents of the ecosystem. Hence the objective of the study was to provide a holistic understanding of the effect of abiotic factors on the stability and aggregation of CuO NPs and its correlation with their effect on the development of zebrafish embryo. It has been observed that the bioavailability of CuO NPs decrease in presence of humic acid (HA) and heteroagglomeration of CuO NPs occurs with clay minerals. CuO NPs, CuO NPs + HA and CuO NPs + Clay significantly altered the expression of genes involved in development of dorsoventral axis and neural network of zebrafish embryos. However, the presence of HA with clay showed protective effect on zebrafish embryo development. These findings provide new insights into the interaction of NPs with abiotic factors and combined effects of such complexes on developing zebrafish embryos genetic markers.