Understanding the colloidal stability of graphene is essential for predicting its transport and ecological risks in aquatic environments. We investigated the agglomeration of ¹⁴C-labeled few-layer graphene (FLG) at concentrations spanning nearly four orders of magnitude (2 μg/L to 10 mg/L) using dynamic light scattering and sedimentation measurements. FLG agglomerates formed rapidly in deionized water at concentrations >3 mg/L. From 1 mg/L to 3 mg/L, salt-induced agglomeration was decreased with dilution of FLG suspensions; the critical coagulation concentration of the more concentrated suspension (3 mg/L) was significantly lower than the dilute suspension (1 mg/L) in the presence of NaCl (1.6 mmol/L and 10 mmol/L, respectively). In contrast, FLG underwent slow agglomeration and settling at concentrations ≤0.1 mg/L in NaCl solutions and ambient waters with low ionic strength (<10 mmol/L). FLG nanoparticles with smaller lateral sizes (25 nm–75 nm) were shown to agglomerate more slowly than larger FLG, and these small FLG particles exhibited greater bioaccumulation in zebrafish embryo and stronger chorion penetration ability than larger FLG particles. These findings suggest that FLG at more environmentally relevant concentration is relatively stable and may have implications for exposure of small FLG to ecological receptors.

Colloid-sized microplastics (MPs) are ubiquitous in aquatic environments and can share the same transport route together with various crystalline, poorly crystalline and freshly formed iron oxides. However, the colloidal interactions between these colloid constituents are not fully understood. This study was designed to investigate the colloidal properties of polystyrene microplastics (PSMPs) under the influence of haematite, goethite, ferrihydrite and freshly formed Fe oxide (FFFO). Dynamic light scattering was coupled with a test tube method to observe changes in the surface charge and colloidal dynamics of suspensions of PSMPs and Fe oxides. The overall effects on the aggregation of PSMPs are found to decrease in the following order: FFFO > ferrihydrite > goethite > haematite. The effects of these Fe oxides are found to strongly depend on pH. While the crystalline oxides play a dominant role in the acidic environment, poorly crystalline oxides show greater effects on PSMP aggregation in an alkaline environment. Heteroaggregation due to decreasing electrostatic interactions is the major mechanism that governs the colloidal dynamics of PSMPs and Fe oxides. It can be inferred that the copresence of Fe oxides and MPs can delay the transport of MPs or even change the destination for MPs.

Currently, there is little comparative data on the colloidal stability and the toxicity of ultraviolet (UV)- and visible-light (VL)-transformed graphene oxide (GO). In order to identify this knowledge gap, the physicochemical properties of UV/VL-transformed GO are investigated in detail. Attempts are made to correlate the physicochemical alterations of UV/VL-transformed GO to the observed changes in its colloidal properties and toxicity. The results show that both UV and VL irradiations induce the significant change in the color, UV–vis absorbance, morphology, surface charge, size, oxygen containing functional groups, total of carbon, and photoluminescence properties of GO. The photo-reaction behavior of GO under UV exposure is different from that under VL irradiation in terms of reaction rate, order, and extent. Finally, the UV and VL irradiations show different effects not only on the colloidal stability of GO in the City water and Dongpu Lake water, but also on the toxicity of GO to Gram-negative Escherichia coli and Gram-positive Staphylococcus aureus bacteria. This study clearly shows how the environmental fate and risk of GO are modified by UV and VL irradiations.

We conducted batch adsorption experiments to understand the adsorptive properties of colloidal graphene oxide nanoparticles (GONPs) for a range of environmentally relevant aromatics and substituted aromatics, including model nonpolar compounds (pyrene, phenanthrene, naphthalene, and 1,3-dichlorobenzene) and model polar compounds (1-naphthol, 1-naphthylamine, 2,4-dichlorophenol, and 2,4-dinitrotoluene). GONPs exhibited strong adsorption affinities for all the test compounds, with distribution coefficients on the order of 103–106 L/kg. Adsorption to GONPs is much more linear than to carbon nanotubes (CNTs) and C60, likely because GO nanoflakes are essentially individually dispersed (rendering adsorption sites of similar adsorption energy) whereas CNT/C60 are prone to bundling/aggregation. For a given compound GONPs and CNTs often exhibit different adsorption affinities, which is attributable to the differences in both the morphology and surface chemistry between the two nanomaterials. Particularly, the high surface O-content of GONPs enables strong H-bonding and Lewis acid–base interactions with hydroxyl- and amino-substituted aromatics.

C60 forms colloidally stable nanoparticles (nC60) via extended mixing or solvent exchange. Many studies on the environmental impacts of nC60 use aliquots from a large batch of nC60 suspension and either dilute them or subject them to other modifications under the assumption that the properties of the parent suspension remain stable over time and are unaltered by these manipulations. In the present study, nC60 produced via stirring in the presence of sodium citrate (cit/nC60) was characterized with respect to particle size, surface charge, and morphology following dilution. Counter-intuitively, the results show that the colloidal properties of diluted cit/nC60 are not fixed despite constant solution chemistry and are dependent upon the ratios of [C60] to [Na+] and [citrate]. In some cases, diluted nC60 had significantly different morphology. This study suggests that any experiment involving modifications of stock nC60 suspensions must take the altered colloidal properties of the diluted nC60 into consideration.

The objective of this study is to obtain information on the behaviour of carbon nanotubes (CNTs) as potential carriers of pollutants in the case of accidental CNT release to the environment and on the properties of CNTs as a potential adsorbent material in water purification. The effects of acid treatment of CNTs on (i) the surface properties, (ii) the colloidal stability and (iii) heavy metal sorption are investigated, the latter being exemplified by uranium(VI) sorption. There is a pronounced influence of surface treatment on the behaviour of the CNTs in aqueous suspension. Results showed that acid treatment increases the amount of acidic surface groups on the CNTs. Therefore, acid treatment has an increasing effect on the colloidal stability of the CNTs and on their adsorption capacity for U(VI). Another way to stabilise colloids of pristine CNTs in aqueous suspension is the addition of humic acid. Acid treatment of carbon nanotubes has an increasing effect on their colloidal stability and on their adsorption capacity for U(VI).