Short-chain chlorinated paraffins (SCCPs) are widely used chemicals in household products and might cause adverse human health effects. However, limited information is available on the occurrence of SCCPs in indoor environments and their exposure risks on humans. In this study the concentrations, profiles and human exposure of SCCPs in indoor dust from five different indoor environments, including commercial stores, residential apartments, dormitories, offices and laboratories were characterized. The SCCPs levels ranged from 10.1 to 173.0 μg/g, with the median and mean concentration of 47.2 and 53.6 μg/g, respectively. No significant difference was found on concentrations among the five microenvironments. The most abundant compounds in indoor dust samples were homologues of C13 group, Cl7 group and N20 (N is the total number of C and Cl) group. In the five microenvironments, commercial stores were more frequently exposed to shorter carbon chained and higher chlorinated homologues. Three potential sources for SCCPs were identified by the multiple linear regression of factor score model and correspondence analysis. The major sources of SCCPs in indoor dust were technical mixtures of CP–42 (42% chlorine, w/w) and CP–52 b (52% chlorine, w/w). The total daily exposure doses and hazard quotients (HQ) were calculated by the human exposure models, and they were all below the reference doses and threshold values, respectively. Monte Carlo simulation was applied to predict the human exposure risk of SCCPs. Infants and toddlers were at risk of SCCPs based on predicted HQ values, which were exceeded the threshold for neoplastic effects in the worst case. Our results on the occurrences, sources and human exposures of SCCPs will be useful to provide a better understanding of SCCPs behaviors in indoor environment in China, and to support environmental risk evaluation and regulation of SCCPs in the world.

The accumulation of 134Cs and 85Sr within different parts of spring oilseed rape and spring wheat plants was investigated, with a particular focus on transfer to seeds after artificial wet deposition at different growth stages during a two-year field trial. In general, the accumulation of radionuclides in plant parts increased when deposition was closer to harvest. The seed of spring oilseed rape had lower concentrations of 85Sr than spring wheat grain. The plants accumulated more 134Cs than 85Sr. We conclude that radionuclides can be transferred into human food chain at all growing stages, especially at the later stages. The variation in transfer factors during the investigation, and in comparison to previous results, implies the estimation of the risk for possible transfer of radionuclides to seeds in the event of future fallout during a growing season is still subject to considerable uncertainty.

Atmospheric bioaerosols contain live and dead biological components that can enter the human respiratory tract (HRT) and affect human health. Here, the total microorganisms in a coastal megacity, Qingdao, were characterized on the basis of long-term observations from October 2013 to January 2021. Particular attention was given to the size dependence of inhalable bioaerosols in concentration and respiratory deposition in different populations on foggy and hazy days. Bioaerosol samples stained with 4,6-diamidino-2-phenylindole (DAPI) were selected to measure the total airborne microbe (TAM) concentrations with an epifluorescence microscope, while a multiple-path particle dosimetry model was employed to calculate respiratory deposition. The mean TAM concentrations in the particle size range of 0.65–1.1 μm (TAM₀.₆₅–₁.₁) were 1.23, 2.02, 1.60 and 2.33 times those on sunny reference days relative to the corresponding values on days with slight, mild, moderate and severe levels of haze, respectively. The mean concentration of TAMs in the particle size range of 0.65–2.1 μm (TAM₀.₆₅–₂.₁) on severely hazy days was (2.02 ± 3.28) × 10⁵ cells/m³, with a reduction of 4.16% relative to that on the reference days. The mean TAM₀.₆₅–₂.₁ concentration changed from (1.50 ± 1.37) × 10⁵ cells/m³ to (1.76 ± 1.36) × 10⁵ cells/m³, with TAM₀.₆₅–₁.₁ increasing from (7.91 ± 7.97) × 10⁴ cells/m³ to (1.76 ± 1.33) × 10⁵ cells/m³ on days with light fog days and medium fog, respectively. The modeling results showed that the majority of TAM₀.₆₅–₂.₁ deposition occurred in the extrathoracic (ET) region, followed by the alveolar (AL) region. When different populations were examined separately, the deposition doses (DDs) in adult females and in children ranked at the minimum value (6.19 × 10³ cells/h) and maximum value (1.08 × 10⁴ cells/h), respectively. However, the inhalation risks on polluted days, such as hazy, foggy and mixed hazy–foggy (HF) days, were still below the threshold for adverse impacts on human health.

Volatile organic compounds (VOCs) are an important factor affecting ambient air quality, and furniture production is one of the important sources of VOC pollution. High VOC concentrations have adverse effects on the environment and worker welfare in furniture factories. In order to control VOC emissions in a furniture workshop, the VOC species and concentration distributions were examined. Qualitative analysis of VOC species was carried out by headspace gas chromatography/mass spectrometry. The results showed that VOCs from a furniture workshop were mainly 12 substances including acetate, toluene, and xylene compounds. The heights and representative positions of VOCs released during the coating process were determined, and the results showed that VOC concentrations depended on environmental and height factors. The concentration of VOCs decreased with increasing altitude and reached a maximum concentration at 0.4 m above the ground. Because the concentration of VOCs varied with temperature, humidity, air pressure, and amount of spray paint, this paper established functional relationships between VOC concentrations and temperature, humidity, air pressure, and amount of spray paint. These results provide a theoretical basis for furniture workshops to automatically monitor and control VOCs.VOCs from the furniture workshop were mainly composed of 10 substances including acetate, toluene, and xylene compounds.

Nitrous oxide (N2O) is a potent greenhouse gas that contributes to climate change and stratospheric ozone destruction. Nitrogen-enriched rivers are significant sources of atmospheric N2O. This study conducted a one-year field campaign in seven N-enriched rivers draining urban, rural, and agricultural land to determine the link between the production, concentrations, and emissions of N2O and land use. Estimated N2O fluxes varied between 1.30 and 1164.38 μg N2O-N m−2 h−1 with a mean value of 154.90 μg N2O-N m−2 h−1, indicating that rivers were the net sources of atmospheric N2O. Concentrations of N2O ranged between 0.23 and 29.21 μg N2O-N L−1 with an overall mean value of 3.81 μg N2O-N L−1. Concentrations of ammonium and nitrate in urban and rural rivers were high in the cold season. The concentrations were also high in agricultural rivers in the wet season. N2O concentrations and emissions in rural and urban rivers followed a similar pattern to ammonium and a similar pattern to nitrate in agricultural rivers. A strong link between the concentrations and emissions of N2O and land use was observed. N2O concentrations in and emissions from the rivers draining the urban and rural areas were significantly higher than the rivers draining the agricultural areas (P < 0.01). Stepwise regression analysis indicated that dissolved N2O were primarily influenced by NH4+ in agricultural rivers and by NO3− in rural rivers; while dissolved N2O in urban rivers was primarily predicted by temperature and reflected the integrated impact of sewage input and river hydrology. Nitrate-N and NO3--O isotope data and linear regression of N2O and river water variables strongly indicated that dissolved N2O was mainly derived from nitrification in agricultural rivers and denitrification in rural and urban rivers.

[Departement_IRSTEA]Eaux [TR1_IRSTEA]ARCEAU [TR2_IRSTEA]BELCA | International audience | Passive samplers are theoretically capable of integrating variations of concentrations of micropollutants in freshwater and providing accurate average values. However, this property is rarely verified and quantified experimentally. In this study, we investigated, in controlled conditions, how the polydimethylsiloxane-coated stir bars (passive Twisters) can integrate fluctuating concentrations of 20 moderately hydrophilic to hydrophobic pesticides.

The heavy metals (HMs) concentration range, the metal/Al and metal/Fe value were determined in the sediment in order to evaluate the correlation coefficient of HMs at the regions of South East Mediterranean Sea, Cyprus. The results showed that the mean concentrations of the HMs in the sediment samples followed the order Al > Fe > Mn > Cr > Ni > Zn > Cu > Pb > As>Hg, respectively. The pollution indices of contamination factor (CF), geoaccumulation index (Igeo), enrichment factor (EF), and soil pollution index (SPI) were calculated. The Igeo, CF and EF values for Cu were obtained moderately to strongly polluted, moderate contamination and moderately severe enrichment, respectively. The remaining elements indicated unpolluted or low contamination results. Also, SPI indicated a low level of contamination for the all of the metals. The cluster analysis of data set indicates that the HMs are separated with 50% similarity in two categories of Al category (As, Pb, Cr, Ni) and Fe category (Mn, Zn, Cu, Hg).

Microplastics in shoreline sediments were investigated from Da Nang beach for the first time. Sediment samples at the two depth strata (0–5 cm and 5–10 cm) at eight sites along the entire coast were collected for identifying the characteristics of microplastics, including their concentration, size, shape, color, and nature. The synthetic fiber was the predominant type of microplastics, accounting for 99.2% of the total items. Blue (59.9%) and white (22.9%) were the most common colors of the fibers. Synthetic fibers showed a homogenous distribution at all sampling sites with a mean concentration of 9238 ± 2097 items kg⁻¹ d.w. Meanwhile, the fibers tended to concentrate much more at the surface stratum than the deeper stratum. A large number of synthetic fibers (81.9%) were in the size range of 300–2600 μm, which might pose a threat to marine biota and human health.

A preliminary report on the abundance of microplastic in the coastal waters in the depth zone 5 to 20 m in the surface waters, sediment and in selected fishes occurring off Kochi, India is presented. Spatial and temporal variation in microplastic abundance was observed with higher abundance in surface water indicating threats to pelagic ecosystem. The relative concentration of microplastic was highest during monsoon season. The major microplastics were fragments of 1-5 mm in white and blue colours. Gut content analysis of 16 species (653 individuals) comprising pelagic (8 species) and demersal (8 species) indicated occurrence (4.6%) of microplastics (fragment>filament>pellet) of size 0.27mm to 3.2 mm in Sardinella longiceps, S. gibbosa, Stolephorus indicus Rastrelliger kanagurta and Cyanoglossus macrostomus. Raman spectroscopy indicated that Polyethylene (PE) and Polypropylene (PP) were the polymer types of microplastics from the fish gut.

A field survey to collect microplastics with sizes <5mm was conducted in the Southern Ocean in 2016. We performed five net-tows and collected 44 pieces of plastic. Total particle counts of the entire water column, which is free of vertical mixing, were computed using the surface concentration (particle count per unit seawater volume) of microplastics, wind speed, and significant wave height during the observation period. Total particle counts at two stations near Antarctica were estimated to be in the order of 100,000pieceskm−2.