The health risk induced by metal(loid)s in crops are becoming increasingly serious. In this study, eight major vegetables and rhizosphere soils were collected in a peri-urban area with intense electronic information manufacturing activities. The source, distribution and bioaccumulation of six typical metal(loid)s in different vegetable species were analyzed, and exposure risk through vegetable ingestion was estimated. Results showed that vegetables and agricultural soils in the study area suffered from serious metal(loid)s pollution, especially for Cd and Pb. The bioaccumulation capacity differed greatly among individual metal(loid)s and vegetable categories. In general, the highest transfer factors (TF) for Cd, Pb, and As were found in leafy vegetables, while leguminous vegetables had the highest TF of Cu and Zn and root vegetables had the highest TF for Cr. Significant correlations were found between concentrations in vegetables and rhizosphere soils for most metal(loid)s, the exceptions being Pb and Zn. The enrichment of Pb, Cd, Cr and As was mainly attributed to electronic information manufacturing activities, while the enrichment of Zn, Cu and Cd was associated with the application of commercial fertilizers and pesticides. The health risk associated with vegetable intake decreased in the order of leafy > fruit > leguminous > root vegetables. Leafy vegetables were identified as the category with the highest risk, with the mean risk value of 1.26. Cd was the major risk element for leafy vegetables. The non-carcinogenic risks estimated for leguminous and root vegetables were under the acceptable level. In conclusion, special attention should be paid to the health risks of toxic metal(loid)s in leafy vegetables in peri-urban areas with intense electronic information manufacturing activities. In order to minimize health risk, it is necessary to identify low-risk crops based on a comprehensive consideration of the metal(loid)s’ pollution characteristics, transfer factors and local people's consumption behaviors.

Facing the challenge of global microplastics (MPs) pollution, full characterization of MPs biohazards is urgent. Recent intensive studies revealed that the toxicity depends on the material, size, and exposure concentration of MP. To better elucidate MPs biohazards, we investigated the impact of polystyrene-MPs of size 0.1 μm at a low dose of 50 μg/L on the neuromuscular, retinal, and reproductive phenotypes of fruit fly model, by voltage-clamped electrophysiology, electroretinogram, and reproductive assay, respectively. We found that MPs decreased the frequency of spontaneous junction currents of synapse and altered the receptor potential amplitude of the retina. Furthermore, MPs lowered the rate of embryo-laying of fruit flies. The differential gene expression of ligand-receptor interaction, endocytosis, phototransduction, and Toll/Imd signaling pathways might underlie these MPs-induced phenotypes. These findings call for further investigation on the potential biohazards of low-dose MPs.

The accumulation of arsenic in crop plants has become a worldwide concern that affects millions of people. The major source of arsenic in crop plants is irrigation water and soil. In this study, Serendipita indica, an endophytic fungus, was used to investigate the protection against arsenic and its accumulation in the tomato plant. We found that inoculation of S. indica recovers seed germination, plant growth and improves overall plant health under arsenic stress. A hyper-colonization of fungus in the plant root was observed under arsenic stress, which results in reduced oxidative stress via modulation of antioxidative enzymes, glutathione, and proline levels. Furthermore, fungal colonization restricts arsenic mobilization from root to shoot and fruit by accumulating it exclusively in the root. We observed that fungal colonization enhances the arsenic bioaccumulation factor 1.48 times in root and reduces the arsenic translocation factor by 2.96 times from root to shoot and 13.6 times from root to fruit compared to non colonized plants. Further, investigation suggests that S. indica can tolerate arsenic by immobilizing it on the cell wall and accumulating it in the vacuole. This study shows that S. indica may be helpful for the reduction of arsenic accumulation in crops grown in arsenic-contaminated agriculture fields.

Methane (CH₄) production from anaerobic digestion of solid and liquid agro-industrial wastes is an attractive strategy to meet the growing need for renewable energy sources and promote environmentally appropriate disposal of organic wastes. This work aimed at determining the CH₄ production potential of six agro-industrial wastewaters (AWW), evaluating the most promising for methanization purposes. It also aims to provide kinetic parameters and stoichiometric coefficients of CH₄ production and define which kinetic models are most suitable for simulating the CH₄ production of the evaluated substrates. The AWW studied were swine wastewater (SW), slaughterhouse wastewater (SHW), dairy wastewater (DW), brewery wastewater (BW), fruit processing wastewater (FPW), and residual glycerol (RG) of biodiesel production. RG was the substrate that showed the highest methanization potential. Exponential kinetic models can be efficiently applied for describing CH₄ production of more soluble substrates. On the other hand, logistic models were more suitable to predict the CH₄ production of more complex substrates.

Microplastics (MPs) are becoming an environmental growing concern, being the sewage sludge applied to agriculture fields one of the most important inputs to the environment. To date, there is no standardized protocol for their extraction and changes in vegetative growth and fruit maturation on cultivated plants induced by sludge containing MPs have not been studied yet. Sewage sludge from three different wastewater treatment plants located in Murcia, Spain, were studied. First, the microplastic concentration was estimated and, then, the effects of the sewage sludge in the development of tomato plants and fruit production was analyzed. The measured parameters in tomato plants were both, biomass and length, for shoot and root part, as well as, stem diameter and tomato production. The present work has developed and validated a protocol for the extraction and quantification of MPs comprising several shapes, materials and sizes from samples of sewage sludges, which offers a good compromise for the extraction of different types of microplastic. The protocol used for MPs extraction had a recovery efficiency of 80 ± 3% (mean ± SE) and used bicarbonate, to maximize MPs extraction. The mean abundance of MPs in the studied sewage sludge samples was 30,940 ± 8589 particles kg⁻¹ dry weight. Soils with sludge containing MPs fostered the growth of tomato plants, while delaying and diminished fruit production. However, other factors or their interactions with MPs could have influenced the outcomes. Further studies are necessary to corroborate these findings and explain the mechanisms of possible effects of MPs on plants.

Agricultural plastic greenhouse (PG) production can extend the growing season of crops to satisfy domestic consumption in countries such as China. Workers in PGs have potential higher phthalate exposure risks than the general population as phthalate accumulation has been observed in greenhouse soil, air, and crops. To date, biomonitoring tests of phthalates for the working population have not been carried out. To address this shortage, we conducted a pilot study in Shaanxi Province, China, among 35 healthy PG workers by follow-up recording their seasonal dietary habits and work activities and urine sample collection and measurement between 2018 and 2019. The objectives were to uncover the association between phthalate metabolites and the population characteristics, seasonal and diurnal variations and causes, and to estimate exposure risks and contributions of exposure pathways from PG production systems. A total of 13 phthalate metabolite concentrations (Σ₁₃ phthalate metabolites) ranged from 102 to 781 (5th-95th) ng/mL (median: 300 ng/mL). Mono-n-butyl phthalate (MNBP) made up 51.3% of Σ₁₃ phthalate metabolites, followed by the sum of four di-2-ethylhexyl phthalate (DEHP) metabolites (24.2%), mono-2-isobutyl phthalate (MIBP) (13.4%), and mono-ethyl phthalate (MEP) (9.8%). The concentrations of MNBP and MIBP in summer were significantly higher than the levels in winter (p < 0.0001). A total of 62.3% of the PG worker population was shown to have exposure risks, and the proportion was as high as 79.4% in summer. Phthalate exposure of the workers from PG production systems constituted over 20% of the total creatinine-based daily intake, and consuming vegetables and fruit planted in PGs and inhalation in PGs were the two largest exposure pathways. Our findings demonstrate that it is important to protect workers in PGs from phthalate exposure risks, and phasing out the use of plastic materials containing phthalates in PGs is imperative, to guarantee food safety in PGs.

Neonicotinoid insecticides (NIIs) are extensively used worldwide and frequently detected in the environment. The human and ecological risks associated with the occurrence of NIIs in agricultural zones are of high importance. The present study highlights the regional occurrence and human exposure risks of NIIs in agricultural soil within the Pearl River Delta (PRD), South China. Six neonicotinoids, i.e., imidacloprid, clothianidin, acetamiprid, imidaclothiz, dinotefuran, and flonicamid, were measured in 351 soil samples from Zengcheng, a typical agricultural zone. The soil samples were categorized into three groups based on cultivated plants: vegetables, rice, and fruits. At least one of these neonicotinoid insecticides was detected in 95% of the soil samples. The levels of ∑₆NII (range (median)) were 0.26–390 (23), 0.26–280 (6.1), and 0.26–120 (5.0) ng g⁻¹ dry weight in soil samples from vegetable farms, rice paddies, and fruit farms, respectively. Neonicotinoids were detected more frequently and at statistically higher concentrations in vegetable farms than in both rice paddies and fruit farms. This is likely ascribed to higher application frequencies of NIIs in vegetable farms due to higher planting frequencies. The hazard index values for human exposure to NIIs in the agricultural soils were all below 1, suggesting negligible non-cancer risks. The current residual levels of NIIs in the soils could however pose sub-lethal or acute effects to non-target terrestrial organisms such as earthworms. The present study suggests that more information is needed regarding NIIs contamination in soils from agricultural regions of South China to ensure that human and ecological risk from exposure to these compounds can be fully addressed.

Composting is a solid waste management alternative that avoids the emission of methane associated with its disposal in landfill and reduces or eliminates the need for chemical fertilisers if compost is applied. The main objective of this study was to analyse the environmental burdens of composting as a way to achieve a more circular valorisation of wine waste. To do so, with the purpose of identifying optimal operational conditions and determining the “hotspots” of the process, the life cycle assessment (LCA) methodology was used. The consumption of diesel fuel in machinery was determined to be the main critical point in the environmental effects of the system, followed by the transport and distribution of the compost. After the application of compost instead of mineral fertilisers, corn, tomato and strawberry crops would have a better environmental performance in most impact categories. In this sense, a maximum improvement of 65% in terrestrial ecotoxicity is achieved in strawberry cultivation. In light of the results obtained, it is demonstrated that composting is a suitable way of organic waste valorisation according to Circular Economy principles.

Biofumigation is an effective, non-chemical method to control soil-borne pests and diseases and to maximize crop yield. We studied the responses of soil bacterial and fungal communities, the soil’s nutritional state and strawberry yield, when the soil was biofumigated each year for five consecutive years using fresh chicken manure (BioFum). BioFum significantly increased the soil’s NH4+-N, NO3−-N, available P and K and organic matter. Fusarium spp. and Phytophthora spp. which are known to cause plant disease, were significantly decreased after BioFum. In addition, Biofum increased the soil’s temperature, enhanced chlorophyll levels in the leaves of strawberry plants, and the soluble sugar and ascorbic acid content in strawberry fruit. We used high-throughput gene sequencing to monitor changes in the soil’s bacterial and fungal communities. Although BioFum significantly decreased the diversity of these communities, it increased the relative abundance of some biological control agents in the phylum Actinobacteria and the genera Pseudomonas, Bacillus and Chaetomium. An increase in these biological control agents would reduce the incidence of soil-borne pathogens and plant disease. Although strawberry marketable yield using BioFum was higher in the first three years, the decline in the final two years could be due to the accumulation of P and K which may have delayed flowering and fruiting. Methods to overcome yield losses using BioFum need to be developed in the future. Our research, however, showed that BioFum enhanced soil fertility, reduced the presence of soil pathogens, increased the relative abundance of beneficial bacteria and fungi and improved strawberry quality. Unlike chemical soil treatments that can cause pest and disease resistance when used continuously over many years, our multi-year research program on BioFum showed that this treatment provided significant benefits to the soil, plant and strawberry fruit.

One emerging problem that recently has become a vastly acknowledged topic of concern is the environmental contamination by pharmaceuticals. Diclofenac (DCF) is one of the most common pharmaceuticals found, due to its high utilization and low removal rate in wastewater treatment processes. In this work, Solanum lycopersicum L. was used as a model to unravel how DCF contamination can affect crops, focusing on the internal mechanisms triggered by this exposure. For this purpose, plants were exposed to two different DCF concentrations (0.5 mg L⁻¹ and 5 mg L⁻¹). Results obtained here point towards a loss of shoot performance when plants were exposed to very high concentrations of DCF, but no delay or loss of yield in the flowering and fruit stages were ascribed to DCF contamination. Our data shows that a state of oxidative stress due to high reactive oxygen species accumulation was associated with this contamination, with very high DCF levels leading to a rise of lipid peroxidation, possibly accentuated by the inhibition of ROS-scavenging enzymes and unable to be counteracted by the visible upregulation of proline and the thiol-based redox network. Overall, these results allow to infer that in the current environmental context, no noticeable negative effects should be associated with the presence of DCF in soils where this crop is cultivated. However, the oxidative stress and lower biomass associated with the highest concentration are alarming, since DCF levels in the environment are continuously increasing and further measures are necessary to assess this problematic.