Lake Donuzlav, located in the western part of the Crimean Peninsula is a water body undergoing anthropogenic load, which cannot but affect the state of its bottom sediments.  The content and composition of polycyclic aromatic hydrocarbons (PAH) are representative indicators of the degree and character of an anthropogenic impact in natural habitats. The aim of the work was to assess the level of PAH content in the bottom sediments, to identify potential sources and to assess the toxicity of bottom sediments. It was established that the average content of ∑PAH in the sediments amounted to 806±380 ng/g, with the values of this parameter ranging over 34–4036 ng/g. At five out of ten stations in Lake Donuzlav, PAH values, average for the Black Sea, were exceeded. These stations were grouped along both banks in the inner part of the reservoir. Fourteen PAHs were identified: Nap, 2mNap, Flu, Phe, Ant, Fla, Py, TrPhe, Chr, BbF, BkF, BaP, DBA, BghiP. The main share falls on the binuclear Nap and 2mNap, which indicate the presence of fresh oil pollution. The average share of these compounds over the water area was 60±5%, and at stations with elevated levels of ∑PAH it was 74±4%. There was a close correlation between the content of all polyarenes, which coefficient averaged 0,88. The presence of geochemical relationships between polyarenes entering from different sources was probably due to the functioning of natural mechanisms aimed at the transformation of pollutants, which served to restore the dynamic balance of the system.

International audience | Polycyclic aromatic hydrocarbon (PAH) concentrations and N, C stable isotope signatures were determined in mosses Hypnum cupressiforme Hedw. from 61 sites of 3 European regions: Île-de-France (France); Navarra (Spain); the Swiss Plateau and Basel area (Switzerland). Total PAH concentrations of 100-700 ng g-1, as well as δ13C values of -32 to -29‰ and δ15N values of -11 to -3‰ were measured. Pearson correlation tests revealed opposite trends between high molecular weight PAH (4-6 aromatic rings) content and δ13C values. Partial Least Square regressions explained the very significant correlations (r > 0.91, p < 0.001) between high molecular weight PAH concentrations by local urban land use (<10 km) and environmental factors such as elevation and pluviometry. Finally, specific correlations between heavy metal and PAH concentrations were attributed to industrial emissions in Switzerland and road traffic emissions in Spain.

peer reviewed | Polycyclic aromatic hydrocarbons (PAHs) are pollutants that occur in mangrove sediments. Their removal by bacteria often depends on specific characteristics as the number of benzene rings they possess and their solubility. Their removal also depends on environmental factors, such as pH, temperature, oxygen, and the ability of the endogenous or exogenous microflora to metabolize hydrocarbons.With the aim of treating mangrove sediments polluted by hydrocarbons in a biological way, a biodegradation experiment was conducted using mangrove sediments artificially contaminated with a mixture of four PAHs. The study used Rhodococcus erythropolis as an exogenous bacterial strain in order to assess the biodegradation of the PAH mixture by natural attenuation, biostimulation, bioaugmentation, and a combination of biostimulation and bioaugmentation. The results showed that the last three treatments were more efficient than natural attenuation. The biostimulation/bioaugmentation combination proved to be the most effective PAH degradation treatment.

International audience | Polycyclic aromatic hydrocarbons (PAHs) have been shown to influence endogenous hormones levels in animal models, but little is known about the effects of their mixtures. For hormone measurements, hair analysis is a promising approach to provide information on long-term status of hormones. Herein we used hair analysis to assess the combined effects of 13 PAHs on steroid and thyroid hormones levels in a rat model. The PAH mixture was administered orally three times per week to female rats at doses of 0, 10, 20, 40, 80, 200, 400 and 800 μg/kg of body weight for each compound over a 90-day exposure period. Fourteen out of 36 analyzed hormones were detected in rat hair, including pregnenolone (P5), 17α-hydroxyprogesterone (17-OHP4), corticosterone (CORT), dehydroepiandrosterone (DHEA), androstenedione (AD), 3,3'-diiodo-L-thyronine (T2), 3,3',5-triiodo-L-thyronine (T3), and 3,5,3',5'-triiodo-L-thyronine (T4). The PAH mixture significantly elevated P5 and DHEA levels at the doses of 200 and 400 μg/kg but reduced T2 and T3 levels at the highest dose as compared to the control. While P5, DHEA, 17-OHP4 and AD concentrations exhibited inverted U-shaped dose responses, T2, T3 and T4 concentrations exhibited inverse linear dose responses, which are further confirmed by their relationships with hair hydroxylated PAHs (OH-PAHs) concentrations. Likewise, there were significant nonmonotonic relationships of hormone molar ratios (e.g., AD/17-OHP4 and DHEA/CORT ratios) with exposure intensity and OH-PAHs. Overall, our results demonstrate the capability of PAH mixtures to interfere with steroid and thyroid hormones in female rats.

International audience | Polycyclic aromatic hydrocarbons (PAHs) have been shown to influence endogenous hormones levels in animal models, but little is known about the effects of their mixtures. For hormone measurements, hair analysis is a promising approach to provide information on long-term status of hormones. Herein we used hair analysis to assess the combined effects of 13 PAHs on steroid and thyroid hormones levels in a rat model. The PAH mixture was administered orally three times per week to female rats at doses of 0, 10, 20, 40, 80, 200, 400 and 800 μg/kg of body weight for each compound over a 90-day exposure period. Fourteen out of 36 analyzed hormones were detected in rat hair, including pregnenolone (P5), 17α-hydroxyprogesterone (17-OHP4), corticosterone (CORT), dehydroepiandrosterone (DHEA), androstenedione (AD), 3,3'-diiodo-L-thyronine (T2), 3,3',5-triiodo-L-thyronine (T3), and 3,5,3',5'-triiodo-L-thyronine (T4). The PAH mixture significantly elevated P5 and DHEA levels at the doses of 200 and 400 μg/kg but reduced T2 and T3 levels at the highest dose as compared to the control. While P5, DHEA, 17-OHP4 and AD concentrations exhibited inverted U-shaped dose responses, T2, T3 and T4 concentrations exhibited inverse linear dose responses, which are further confirmed by their relationships with hair hydroxylated PAHs (OH-PAHs) concentrations. Likewise, there were significant nonmonotonic relationships of hormone molar ratios (e.g., AD/17-OHP4 and DHEA/CORT ratios) with exposure intensity and OH-PAHs. Overall, our results demonstrate the capability of PAH mixtures to interfere with steroid and thyroid hormones in female rats.

A number of methods have been reported for determining hydrophobic organic compound adsorption to dispersed carbon nanotubes (CNTs), but their accuracy and reliability remain uncertain. We have evaluated three methods to investigate the adsorption of phenanthrene (a model polycyclic aromatic hydrocarbon, PAH) to CNTs with different physicochemical properties: dialysis tube (DT) protected negligible depletion solid phase microextraction (DT-nd-SPME), ultracentrifugation, and filtration using various types of filters. Dispersed CNTs adhered to the unprotected polydimethylsiloxane (PDMS)-coated fibers used in nd-SPME. Protection of the fibers from CNT adherence was investigated with hydrophilic DT, but high PAH sorption to the DT was observed. The efficiency of ultracentrifugation and filtration to separate CNTs from the water phase depended on CNT physicochemical properties. While non-functionalized CNTs were efficiently separated from the water phase using ultracentrifugation, incomplete separation of carboxyl functionalized CNTs was observed. Filtration efficiency varied with different filter types (composition and pore size), and non-functionalized CNTs were more easily separated from the water phase than functionalized CNTs. Sorption of phenanthrene was high (< 70%) for three of the filters tested, making them unsuitable for the assessment of phenanthrene adsorption to CNTs. Filtration using a hydrophilic polytetrafluoroethylene (PTFE) filter membrane (0.1 μm) was found to be a simple and precise technique for the determination of phenanthrene adsorption to a range of CNTs, efficiently separating all types of CNTs and exhibiting a good and highly reproducible recovery of phenanthrene (82%) over the concentration range tested (70–735 μg/L). | acceptedVersion

International audience | Worldwide there is concern about the continuing release of persistent organic pollutants (POPs) into the environment. In this study we review the application of mosses as biomonitors of atmospheric deposition of POPs. Examples in the literature show that mosses are suitable organisms to monitor spatial patterns and temporal trends of atmospheric concentrations or deposition of POPs. These examples include polycyclic aromatic hydrocarbons (PAHs), polychlorobiphenyls (PCBs), dioxins and furans (PCDD/Fs), and polybrominated diphenyl ethers (PBDEs). The majority of studies report on PAHs concentrations in mosses and relative few studies have been conducted on other POPs. So far, many studies have focused on spatial patterns around pollution sources or the concentration in mosses in remote areas such as the polar regions, as an indication of long-range transport of POPs. Very few studies have determined temporal trends or have directly related the concentrations in mosses with measured atmospheric concentrations and/or deposition fluxes.

International audience | Worldwide there is concern about the continuing release of persistent organic pollutants (POPs) into the environment. In this study we review the application of mosses as biomonitors of atmospheric deposition of POPs. Examples in the literature show that mosses are suitable organisms to monitor spatial patterns and temporal trends of atmospheric concentrations or deposition of POPs. These examples include polycyclic aromatic hydrocarbons (PAHs), polychlorobiphenyls (PCBs), dioxins and furans (PCDD/Fs), and polybrominated diphenyl ethers (PBDEs). The majority of studies report on PAHs concentrations in mosses and relative few studies have been conducted on other POPs. So far, many studies have focused on spatial patterns around pollution sources or the concentration in mosses in remote areas such as the polar regions, as an indication of long-range transport of POPs. Very few studies have determined temporal trends or have directly related the concentrations in mosses with measured atmospheric concentrations and/or deposition fluxes.

Polycyclic aromatic hydrocarbons (PAHs) are hardly biodegradable carcinogenic organic compounds. Bioremediation is a commonly used method for treating PAH contaminated environments such as soils, sediment, water bodies and wastewater. However, bioremediation has various drawbacks including the low abundance, diversity and activity of indigenous hydrocarbon degrading bacteria, their slow growth rates and especially a limited bioavailability of PAHs in the aqueous phase. Addition of nutrients, electron acceptors or co-substrates to enhance indigenous microbial activity is costly and added chemicals often diffuse away from the target compound, thus pointing out an impasse for the bioremediation of PAHs. A promising solution is the adoption of bioelectrochemical systems. They guarantee a permanent electron supply and withdrawal for microorganisms, thereby circumventing the traditional shortcomings of bioremediation. These systems combine biological treatment with electrochemical oxidation/reduction by supplying an anode and a cathode that serve as an electron exchange facility for the biocatalyst. Here, recent achievements in polycyclic aromatic hydrocarbon removal using bioelectrochemical systems have been reviewed. This also concerns PAH precursors: total petroleum hydrocarbons and diesel. Removal performances of PAH biodegradation in bioelectrochemical systems are discussed, focussing on configurational parameters such as anode and cathode designs as well as environmental parameters like porosity, salinity, adsorption and conductivity of soil and sediment that affect PAH biodegradation in BESs. The still scarcely available information on microbiological aspects of bioelectrochemical PAH removal is summarised here. This comprehensive review offers a better understanding of the parameters that affect the removal of PAHs within bioelectrochemical systems. In addition, future experimental setups are proposed in order to study syntrophic relationships between PAH degraders and exoelectrogens. This synopsis can help as guide for researchers in their choices for future experimental designs aiming at increasing the power densities and PAH biodegradation rates using microbial bioelectrochemistry.

A number of methods have been reported for determining hydrophobic organic compound adsorption to dispersed carbon nanotubes (CNTs), but their accuracy and reliability remain uncertain. We have evaluated three methods to investigate the adsorption of phenanthrene (a model polycyclic aromatic hydrocarbon; PAH) to CNTs with different physicochemical properties; dialysis tube (DT) protected negligible depletion solid phase microextraction (DT-nd-SPME), ultracentrifugation and filtration using various types of filters. Dispersed CNTs adhered to the unprotected PDMS-coated fibers used in nd-SPME. Protection of the fibers from CNT adherence was investigated with hydrophilic DT, but high PAH sorption to the DT was observed. The efficiency of ultracentrifugation and filtration to separate CNTs from the water phase depended on CNT physicochemical properties. While non-functionalized CNTs were efficiently separated from the water phase using ultracentrifugation, incomplete separation of carboxyl functionalized CNTs was observed. Filtration efficiency varied with different filter types (composition and pore size), and non-functionalized CNTs were more easily separated from the water phase than functionalized CNTs. Sorption of phenanthrene was high (<70%) for three of the filters tested, making them unsuitable for the assessment of phenanthrene adsorption to CNTs. Filtration using a hydrophilic polytetrafluoroethylene (PTFE) filter membrane (0.1 µm) was found to be a simple and precise technique for the determination of phenanthrene adsorption to a range of CNTs, efficiently separating all types of CNTs and exhibiting a good and highly reproducible recovery of phenanthrene (82%) over the concentration range tested (70-735 µg/L). | acceptedVersion