Tree species (including Eucalyptus camaldulensis, Ziziphus spina-christi, Albizia lebbeck, Prosopis juliflora, Pithecellobium dulce, and Ficus altissima) were investigated to elucidate their appropriates for green belt application. Leaf samples were collected from four different locations in Riyadh: (1) residential; (2) dense traffic; (3) industrial; and (4) reference sites located approximately 20 km away from the city of Riyadh. Leaves collected from the industrial site showed the highest leaf area reduction. The smallest reduction of leaf areas was observed for F. altissima (11.6%), while the highest reduction was observed for P. juliflora (34.8%). Variations in the air pollution tolerance index (APTI) coupled with the anticipated performance index (API) for each species were examined. The APTI value of Z. spina-christi was highest (58.5) at the industrial site while the lowest APTI value was for P. juliflora (14) at the reference site. Correlation coefficient and linear regression analyses determined that the correlation between the ascorbic acid content and APTI is positive and significantly strong. Our findings indicate that urban green planning in Riyadh should include growing F. altissima on roadsides as well as in heavy industrial locations followed by Z. spina-christi and A. lebbeck according to their API and APTI performances.

The disodium salt of Rose Bengal [4, 5, 6, 7-tetrachloro-2′, 4′, 5′, 7′-tetraiodofluorescein] commonly finds application in medical procedures and its removal from aqueous solution is difficult owing to its high molecular weight of 1017.67 g/mol. Activated carbon was prepared from Prosopis juliflora and immobilized into sodium alginate beads and doped with aniline for enhanced adsorption of Rose Bengal. The effect of initial dye concentration, beads’ dosage, contact time, and the temperature over the adsorption of Rose Bengal dye were studied. The optimum conditions derived for maximum dye uptake capacity were 4 mg/L of initial dye concentration, contact time of 60 min with the adsorbent dosage of 0.2 g, and temperature of 303 K at neutral pH. The equilibrium data were found to be best fitted for Langmuir −1 model, whereas the kinetics were interpreted through Ho-Mckay’s pseudo-second-order equation. The adsorbents were subjected to thermo-gravimetric studies to determine the activation energy under a heating rate of 20 °C/min. The activation energy was computed using Broido’s plot and was found to be 35.21 ± 0.84 kJ/mol for the activated carbon, and 16.77 ± 2.19 kJ/mol for the dye-adsorbed beads. The heat capacity was determined through differential scanning calorimetry and was calculated to be 19.41 J/g °C for activated carbon and 39.43 J/g °C for beads post-adsorption of Rose Bengal dye.

The objective of this study was to evaluate the effects of alkaloid extracts of Prosopis juliflora (Sw.) D.C. pods obtained by two extraction methods as compared with sodium monensin on the gas production kinetic, mitigation of methane, and rumen fermentation products using wheat bran or Tifton 85 hay as substrates, by the semi-automatic in vitro gas production technique. A completely randomized design was adopted, and two natural additives were tested made from mesquite pod (alkaloid extract I and alkaloid extract II) at three levels (3.9, 7.9, and 12 μg), sodium monensin 5 μM (positive control), and no inclusion of additives (negative control). The volume of gases produced by the degradation of the fibrous fraction of wheat bran was influenced by the concentration of the extract I added to the medium, and the amounts of 7.9 and 12 μg were equal to monensin at the lowest value. The degradation rate of the fibrous carbohydrates with additive extract I at 12 μg was lower in relation to monensin. When Tifton 85 hay was utilized, alkaloid extract I provided a shorter colonization time as compared with monensin at the added amounts of 7.9 and 12 μg and higher production of gases from the fibrous fraction but without interfering with the total volume of gases produced during 96 h of fermentation of carbohydrates. In the periods of 12 and 24 h of incubation, utilizing alkaloid extract I, the mean values of methane production with wheat bran and Tifton 85 hay were lower than monensin (p < 0.05) when the respective amounts of 7.9 and 12 μg were added. Alkaloid extract I has similar potential to sodium in reducing production of total gases, methane, and the acetate/propionate ratio.

Proliferation of fly ash (FA) deposits and its toxicity have become a global concern, which contaminate the ecosystems of our Earth. In this regard, identification of potential plant species for FA deposits’ restoration is the main concern. Keeping this view in mind, the present study was conducted to identify potential plant species naturally growing on FA deposits for the restoration purposes. Six intensive surveys were made during 2010–2014 to collect naturally growing plant species during different seasons from two FA deposits in Unchahar of Raebareli district, Uttar Pradesh, India. The plant species having potential for FA deposits’ restoration were identified on the basis of their ecological importance, dominance at the study sites and socio-economic importance for rural livelihoods. Typha latifolia L., Cynodon dactylon (L.) Pers., Saccharum spontaneum L., Saccharum bengalense Retz. (syn. Saccharum munja), Prosopis juliflora (Sw.) DC., Ipomoea carnea Jacq. and Acacia nelotica L. are identified as potential plant species for FA deposits’ restoration. Furthermore, the characteristics of naturally colonized species can be used for the phytorestoration during a revegetation plan of new FA deposits for multiple benefits.