The purpose of this research is to quantify the potential of waste recycling in the form of participatory scenarios for separation from the source and to study the factors of minimization (reduction) of waste production in a district of Tehran. Amount of waste minimization was determined with considering a couple of citizens' participation scenarios. Source separation of valuable wastes including paper and cardboard, plastic, plastic bags, aluminum cans, bread, PET, waste metal and glass were considered in this procedure. Among 250 tons of generated dry waste within the district, 150 tons (60%) goes directly to landfill instead of getting recycled. Considering the successful experiences regarding the use of reverse vending machine (RVM) in recycling of beverage containers, this research takes RVM as a reasonable method to promote the recycling activities by citizens. In the 10% scenario, the participation for the separation of the total amount of daily materials is about 4,300 USD per day and in the 25% scenario, 10,800 USD of added value have been calculated. Also, for the participation of 10 and 25 percent during a month, 15 and 30 waste disposal services to the disposal and processing complex could get less.

Plastic usage increases year by year, and the growing trend is projected to continue. However as of 2017, only 9% of the 9 billion tons of plastic ever produced had been recycled leaving large amounts of plastics to contaminate the environment, resulting in important negative health and economic impacts. Curbing this trend is a major challenge that requires urgent and multifaceted action. Based on scientific and gray literature mainly published during the last 10 years, this review summarizes key solutions currently in use globally that have the potential to address at scale the plastic and microplastic contaminations from source to sea. They include technologies to control plastics in solid wastes (i.e. mechanical and chemical plastic recycling or incineration), in-stream (i.e. booms and clean-up boats, trash racks, and sea bins), and microplastics (i.e. stormwater, municipal wastewater and drinking water treatment), as well as general policy measures (i.e. measures to support the informal sector, bans, enforcement of levies, voluntary measures, extended producer responsibility, measures to enhance recycling and guidelines, standards and protocols to guide activities and interventions) to reduce use, reuse, and recycle plastics and microplastics in support of the technological options. The review discusses the effectiveness, capital expenditure, and operation and maintenance costs of the different technologies, the cost of implementation of policy measures, and the suitability of each solution under various conditions. This guidance is expected to help policymakers and practitioners address, in a sustainable and cost-efficient way, the plastic and microplastic management problem using technologies and policy instruments suitable in their local context.

International audience | Copper (Cu) contamination of soils may alter the functioning and sustainability of vineyard ecosystems. Cultivating Cu-extracting plants in vineyard inter-rows, or phytoextraction, is one possible way currently under consideration in agroecology to reduce Cu contamination of vineyard topsoils. This option is rarely used, mainly because Cu phytoextraction yields are too low to significantly reduce contamination due to the relatively "low" phytoavailability of Cu in the soil (compared to other trace metals) and its preferential accumulation in the roots of most extracting plants. This article describes the main practices and associated constraints that could theoretically be used to maximize Cu phytoextraction at field scale, including the use of Cu-accumulating plants grown (i) with acidifying plants (e.g., leguminous plants), and/or (ii) in the presence of acidifying fertilizers (ammonium, elemental sulfur), or (iii) with soluble "biochelators" added to the soil such as natural humic substances or metabolites produced by rhizospheric bacteria such as siderophores, in the inter-rows. This discussion article also provides an overview of the possible ways to exploit Cu-enriched biomass, notably through ecocatalysis or biofortification of animal feed.

With the acceleration of economic development and urbanization in China, sewage sludge generation has sharply increased. To maximize energy regeneration and resource recovery, it is crucial to analyze the environmental impact and sustainability of different sewage sludge recycling systems based on life cycle assessment. This study analyzed four sewage sludge recycling systems in China through life cycle assessment using the ReCipe method, namely aerobic composting, anaerobic digestion and biomass utilization, incineration, and heat utilization and using for building materials. In particular, the key pollution processes and pollutants in sewage sludge recycling systems were analyzed. The results demonstrated that aerobic composting is the most environmentally optimal scenario for reducing emissions and energy consumption. The lowest environmental impact and operating costs were achieved by making bricks and using them as building materials; this was the optimal scenario for sludge treatment and recycling. In contrast, incineration and heat utilization had the highest impact on health and marine toxicity. Anaerobic digestion and biomass utilization had the highest impact on climate change, terrestrial acidification, photochemical oxidant formation, and particulate matter formation. In the future, policy designers should prioritize building material creation for sludge treatment and recycling.

Environmental distribution and concentration of tetrabromobisphenol A bis- (2-hydroxyethyl) ether (TBBPA-DHEE) and tetrabromobisphenol A mono- (hydroxyethyl) ether (TBBPA-MHEE), are obscure due to the lack of available analytical methods. Here two novel immunoassays were established to systematically investigate their distributions in Taizhou, Eastern China. Five monoclonal antibodies against pollutants were generated with two designed haptens through animal immunization. After matched with different coating antigens/antibodies, ELISAs were established (LOD for TBBPA-DHEE, 0.12 ng/mL, based on OVA-M3/mAb-D4G6; LOD for TBBPA-MHEE, 0.79 ng/mL, based on OVA-M3/mAb-D2G6) and applied for investigation of their occurrences at a typical e-waste recycling area after 2-year samples collection, where the total 33 water, 32 soil and 16 biological samples were collected with the highest concentrations of 3.46 ng/mL, 2.76 ng/g (dry weight, dw) and 5.01 ng/g (dw), respectively. Meanwhile, our study also indicated that at the centralizing e-waste recycling sites the serious pollution for both chemicals still existed despite of various efforts. Besides, obvious improvements were observed at an abandoned e-waste recycling region treated and remedied for many years by the local Chinese government. These findings highlight the importance of policy decisions in treatment of pollutants to reduce organic pollutant-related health risks.

One of the most important reasons for the controversy over the development of nuclear energy is the proper disposal of spent fuel. Separation of actinide and lanthanide ions is an important part of safe long-term storage of radioactive waste. Herein, a three-dimensional (3D) graphene-based macrostructure (GOCS) was utilized to remove actinide thorium and lanthanide europium ions from aqueous solutions. The adsorption of Eu(III) and Th(IV) on the GOCS was evaluated as a function of adsorption time, solution pH, initial ion concentrations, and ionic strength. The experimentally determined maximum adsorption capacities of this GOCS for Eu(III) (pH 6.0) and Th(IV) (pH 3.0) are as high as 150 and 220 mg/g, respectively. By using Fourier transformation infrared (FT-IR), X-ray photoelectron (XPS), and extended X-ray absorption fine structure (EXAFS) spectroscopy, we concluded that the Eu(III) and Th(IV) adsorption was predominantly attributed to the inner-sphere coordination with various oxygen- and nitrogen-containing functional groups on GOCS surfaces. Our selective adsorption results demonstrate that the actinide and lanthanide ions can be effectively separated from transition metal ions. This study provides new clues to the overall recycling of actinide and lanthanide ions in radioactive environmental pollution treatments.

The decontamination of U(VI) on graphene oxide/nano-alumina (GO/Al₂O₃) composites were investigated by batch, XRD, FT-IR and XPS techniques. The characterization results showed that GO/Al₂O₃ composites presented a variety of oxygen-containing functional groups, which provided the more surface reactive sites. The batch experiments indicated that sorption equilibrium of U(VI) on GO/Al₂O₃ composites was achieved within 30 min, and the maximum sorption capacity derived from Langmuir model was 142.8 mg/g at pH 6.5. In addition, the slight decrease of sorption capacity was observed even after fifth recycling times. These results indicated that GO/Al₂O₃ composites displayed the fast sorption rate, high sorption capacity and good regeneration performance. No effect of ionic strength revealed the inner-sphere surface complexation of U(VI) on GO/Al₂O₃ composites. FT-IR and XPS analysis demonstrated that the high adsorption of U(VI) on GO/Al₂O₃ was attributed to the various oxygen-bearing functional groups. In addition, the nano Al₂O₃ was transferred to amorphous AlO(OH) mineral phase by XRD pattern, which provided the additional reactive sorption sites. These observations indicated that GO-based composites can be regarded as a promising adsorbent for immobilization and pre-concentration of U(VI) from aqueous solutions in the environmental remediation.

High-efficiency nanophotocatalysts with large specific surface areas have a broad range of application prospects in the catalytic oxidation treatment of organic pollutants in wastewater. A chemical method was used to synthesize a TiO₂ nanophotocatalyst with a mesoporous structure upon which a rare earth metal (Nd) was deposited, namely Nd-TiO₂-SBA-15 (NTS). The prepared NTS was characterized using X-ray diffractometry, transmission electron microscopy, Raman spectroscopy, and X-ray photoelectron spectrometry. The photocatalytic mechanism was explored using scavenger experiments with photoinduced carriers combined with total organic carbon and UV–Vis measurements. At the same time, the kinetic properties of the NTS photocatalytic degradation of methyl orange (MO) were evaluated. The results showed that the deposition of TiO₂ nanoparticles on the surface of the SBA-15 molecular sieve did not change the mesoporous structure, and Nd was uniformly distributed on the surface of the nanophotocatalyst. The photogenerated holes of the NTS played an important role in the photocatalysis process. In addition, the synthesized NTS had good adaptability in the range of pH 2–10. At pH 4, the reaction rate constant (k) of the MO photocatalytic degradation by NTS was 0.011825 mg·(L·min)⁻¹, and the adsorption equilibrium constant (K) was 0.051359 L mg⁻¹. In addition, the photocatalytic degradation rate of MO by NTS remained above 70%, even when the NTS was recycled four times. The NTS showed a good performance after recycling. This work provides a good foundation for the large-scale application of NTS.