Physicochemical and biological characterisation of different dredged sediment deposit sites in France

International audience | In the context of biosolids utilisation in forestry, effects of sludge application on mushroom metal concentration were studied in six sites of maritime pine forests in the South-West of France. Municipal sludge were applied at a rate of 6 T dry matter per hectare. Edible mushrooms were collected two years after sludge application. As, Cd, Cu, Hg, Pb, Se and Zn concentrations were determined. Results showed a high variability for trace element concentrations in mushrooms collected from control areas. No significant correlation was found between soil parameters (pH and trace elements concentrations) and mushroom trace element concentrations. Even if the concentration of trace metals increased in the soils, sludge application did not affect As, Cu, Se and Zn concentrations in carpophores but slightly increased Cd, Pb and Hg concentrations on some sites. This effect is dependent on sludge type and sites

International audience

Concerns about the use of residues from municipal solid waste incinerators (MSWI) in construction materials usually focus on the potential for heavy metals and organic chemicals to leach into drainage waters under the influence of rain.We hypothesised that high level of salts in the MSWI leachates may cause more of a problem, particularly on soil physico-chemical properties. Both bottom ash (BA) and Solidified Air Pollution Control residue (SAPCr) leachates were added to experimental grassland plots. The amounts of Na+ increased by up to 13% in soils supplemented with each leachate. A decrease of the soil total porosity (−14%) was evidence of a subsequent adverse physical effect of this strong salinity. The potential for the grass cover type (species composition or density) to limit this adverse effect was discussed. Laboratory tests allowed us to determine that undiluted SAPCr induced slaking of aggregates accompanied by a strong decrease of aggregate stability, to 49% of control values. Undiluted BA induced dispersion of clays and others fine particles, which are then dislodged and transported into pores, causing blockage and decreasing total porosity. Clay dispersion followed by aggregate collapse occurred when soil solution contaminated by SAPCr was diluted by rainwater. This work stressed the importance of accounting for mineral contaminants, such as salts, when conducting an assessment of waste reuse scenarios.

Les changements de productivité des forêts ont été étudiés intensément à partir des années 1990, à la suite des événements relatifs au dépérissement des forêts européennes. Dans cette contribution, on analyse les problèmes méthodologiques soulevés par ce type d'étude, les sources de données disponibles pour l'analyse, et les éléments de diagnostic acquis sur plusieurs espèces forestières du territoire français. Les implications pour le cadre théorique qui prévalait dans les années 1980 concernant la productivité des peuplements forestiers sont enfin discutées. problèmes méthodologiques, sources de données, cadre théorique, éléments du diagnostic

absent

Canopy leaf area index (LAI) is an important structural parameter of the vegetation controlling pollutant uptake by terrestrial ecosystems. This paper presents a computationally efficient algorithm for retrieval of vegetation LAI and canopy clumping factor from satellite data using observed Simple Ratios (SR) of near-infrared to red reflectance. The method employs numerical inversion of a physics-based analytical canopy radiative transfer model that simulates the bi-directional reflectance distribution function (BRDF). The algorithm is independent of ecosystem type. The method is applied to 1-km resolution AVHRR satellite images to retrieve a geo-referenced data set of monthly LAI values for the conterminous USA. Satellite-based LAI estimates are compared against independent ground LAI measurements over a range of ecosystem types. Verification results suggest that the new algorithm represents a viable approach to LAI retrieval at continental scale, and can facilitate spatially explicit studies of regional pollutant deposition and trace gas exchange. The paper presents a physics-based algorithm for retrieval of vegetation LAI and canopy-clumping factor from satellite data to assist research of pollutant deposition and trace-gas exchange. The method is employed to derive a monthly LAI dataset for the conterminous USA and verified at a continental scale.

An integrative passive sampler consisting of a C18 Empore® disk receiving phase saturated with n-octanol and fitted with low-density polyethylene diffusion membrane was calibrated for the measurement of time-weighted average concentrations of hydrophobic micropollutants, including polyaromatic hydrocarbons and organochlorine pesticides, in water. The effect of temperature and water turbulence on kinetic and thermodynamic parameters characterising the exchange of analytes between the sampler and water was studied in a flow-through system under controlled conditions. It was found that the absorption of test analytes from water to the sampler is related to their desorption to water. This allows for the in situ calibration of the uptake of pollutants using offload kinetics of performance reference compounds. The sampling kinetics are dependent on temperature, and for most of the tested analytes also on the flow velocity. Sampler–water partition coefficients did not significantly change with temperature.

Interest in selenium pollution and remediation technology has escalated during the past two decades. Although not known to be essential for plants, selenium is essential but could be toxic for humans and animals, depending on its concentration. A major selenium controversy in the 1980's emerged in California when the general public and scientific community became aware of selenium's potential as an environmental contaminant. After extensive research on several strategies to reduce loads of mobile Se for entering the agricultural ecosystem a plant-based technology, defined as 'phytoremediation' received increasing recognition, as a low-cost environmentally friendly approach for managing soluble Se in the soil and water environment. Successful long-term field remediation of Se by plants is, however, dependent upon acceptance and widespread use by growers, who are also concerned about potential commercial value from using the plant-based technology. Obtaining products with economic value from plants used in the cleanup of soil would certainly be an additional benefit to phytoremediation, which could help sustain its long-term use.

A pesticide runoff event was simulated on two 10 m x 50 m constructed wetlands (one non-vegetated, one vegetated) to evaluate the fate of methyl parathion (MeP) (Penncap-M). Water, sediment, and plant samples were collected at five sites downstream of the inflow for 120 d. Semi-permeable membrane devices (SPMDs) were deployed at each wetland outflow to determine exiting pesticide load. MeP was detected in water at all locations of the non-vegetated wetland (50 m), 30 min post-exposure. MeP was detected 20 m from the vegetated wetland inflow 30 min post-exposure, while after 10d it was detected only at 10 m. MeP was measured only in SPMDs deployed in non-vegetated wetland cells, suggesting detectable levels were not present near the vegetated wetland outflow. Furthermore, mass balance calculations indicated vegetated wetlands were more effective in reducing aqueous loadings of MeP introduced into the wetland systems. This demonstrates the importance of vegetation as sorption sites for pesticides in constructed wetlands.