Fish meal (FM) is an industrial product, mainly obtained from whole wild-caught fish, that is used as a high protein feedstuff component in aquaculture and intensive animal farming. Contamination of FM by microplastics (MPs), the synthetic polymer particles known to be nearly ubiquitous in the marine environment, is a likely consequence of their ingestion by zooplankton and other small marine animals that through the food chain end up in the fish commercialized not only for direct human consumption but also for the industrial production of FM. Unfortunately, analytical tools for quantifying contamination of FM by synthetic polymers are not available. A newly developed procedure described here allows quantification of the total amounts of polyolefins (including ethene and propene homo- and copolymers), polystyrene (PS), and poly(ethylene terephthalate) (PET), respectively, in FM. The multi-step procedure involves a sequence of solvent extractions, hydrolytic treatments to remove the biogenic matrix mainly consisting of proteins and some lipids, and selective depolymerization for PET. The gravimetric and SEC-UV techniques employed for the quantification of polyolefins and PS, respectively, only allowed to estimate their concentration in FM at around or below 100 mg/kg each, a more accurate quantification being prevented by the interference from the organic matrix and, in the case of polyolefins, by the limited sensitivity of the quantification by gravimetry. On the other hand, the contamination by PET MPs could accurately be quantified at 12.9 mg/kg based on the dry FM mass. Ways to overcome the sensitivity limitations for PS and polyolefins by using e.g. pyrolysis-GC/MS are highlighted.

Nitrogen (N) runoff loss from croplands due to excessive anthropogenic N additions is a principal cause of non-point source water pollution worldwide. Quantitative knowledge of regional-scale N runoff loss from croplands is essential for developing sustainable agricultural N management and efficient water N pollution control strategies. This meta-analysis quantifies N runoff loss rates and identifies the primary factors regulating N runoff loss from uplands (n = 570) and paddy (n = 434) fields in the Yangtze River Basin (YRB). Results indicated that total N (TN) runoff loss rates from uplands and paddy fields consistently increased from upstream to downstream regions. Runoff depth, soil N content and fertilizer addition rate (chemical fertilizer + manure) were the major factors regulating variability of TN runoff loss from uplands, while runoff depth and fertilizer addition rate were the main controls for paddy fields. Multiple regression models incorporating these influencing factors effectively predicted TN runoff loss rates from uplands (calibration: R² = 0.60, n = 242; validation: R² = 0.55, n = 104) and paddy fields (calibration: R² = 0.70, n = 189; validation: R² = 0.85, n = 82). Models estimated total cropland TN runoff loss load in YRB of 0.54 (95% Cl: 0.23–1.33) Tg, with 0.30 (95% Cl: 0.15–0.56) Tg from uplands and 0.24 (95% Cl: 0.08–0.77) Tg from paddy fields in 2017. Guangxi, Jiangxi, Fujian, Hunan and Henan provinces within the YRB were identified as cropland TN runoff loss hotspots. Models predicted that TN runoff loss loads from croplands in YRB would decrease by 0.8–13.7% for five scenarios, with higher TN load reductions occurring from scenarios with decreased runoff amounts. Reducing upland TN runoff loss should focus primarily on soil N utilization and runoff management, while reducing N fertilizer addition and runoff provided the most sensitive strategies for paddy fields. Integrated management of water, soil and fertilizer is required to effectively reduce cropland N runoff loss.

Coastal harmful algal blooms (HABs) in China’s seas have attracted researchers’ attention for decades. Among the four seas of China, the HAB frequency is the highest in the East China Sea (ECS). The impact of climate change and anthropogenic dominant factors on HABs is not well quantified and the response of HABs to the changing climate is also not clear. Here, we compiled a time series of observation-based HAB events since the 1980s and performed a regional assessment to elucidate the dominant drivers of HAB events in the ECS. The results showed that the increase in the frequency of HAB events in the ECS between 2000 and 2003 was associated with increases in dissolved inorganic phosphorus and sea surface temperature anomalies as well as decreasing summer precipitation. The declining annual frequency in HAB events in the ECS after 2003 was associated with the two climatological factors, most notably, precipitation. Under the “business-as-usual” scenario, climate change will increase the annual HAB events in the ECS from the historical frequency (1985–2013) by more than five-fold by the end of 21st century. These findings demonstrated that management strategies based on reducing nutrient loading also need to consider the effects of climate change in the future.

Studies on the effects of trace elements (TEs) (e.g. Cu, Cd, Zn) on soil microbial communities have provided useful information on the toxicity of TEs to microbes. However, previous studies mainly focused on the effects of TEs on microbial community structure in intact soil, while there are few studies on the impact of TEs on microbial community structure in soil aggregates. In this study, soils previously polluted for 20 years, and now containing low and high TE concentrations derived from, now abandoned, metal smelters were sampled from the surface layer (0–15 cm) of two adjacent Chinese paddy fields. The aim was to determine the effects of TEs on the soil microbial biomass and community structure in different sized soil aggregates. Long-term high TE pollution decreased microbial biomass concentration and species, changed the proportion of bacteria and fungi and decreased the diversity of bacteria in the different sized aggregates. The microbial communities in soil aggregates became clustered with increasing TE concentrations.

The thyroperoxidase (TPO) enzyme is expressed by the thyroid follicular cells and is required for thyroid hormone synthesis. In turn, thyroid hormones are essential for brain development, thus inhibition of TPO in early life can have life-long consequences for brain function. If environmental chemicals with the capacity to inhibit TPO in vitro can also alter brain development in vivo through thyroid hormone dependent mechanisms, however, remains unknown. In this study we show that the in vitro TPO inhibiting pesticide amitrole alters neuronal migration and induces periventricular heterotopia; a thyroid hormone dependent brain malformation. Perinatal exposure to amitrole reduced pup serum thyroxine (T4) concentrations to less than 50% of control animals and this insufficiency led to heterotopia formation in the 16-day old pup’s brain. Two other in vitro TPO inhibitors, 2-mercaptobenzimidazole and cyanamide, caused reproductive toxicity and had only minor sporadic effects on the thyroid hormone system; consequently, they did not cause heterotopia. This is the first demonstration of an environmental chemical causing heterotopia, a brain malformation until now only reported for rodent studies with the anti-thyroid drugs propylthiouracil and methimazole. Our results highlight that certain TPO-inhibiting environmental chemicals can alter brain development through thyroid hormone dependent mechanisms. Improved understanding of the effects on the brain as well as the conditions under which chemicals can perturb brain development will be key to protect human health.

The co-contamination by perfluoroalkyl acids (PFAAs) and heavy metals (HMs) is ubiquitous in the surface environment subjected to sewage irrigation and land application of sludge. However, the joint effects of HMs and PFAAs on plant roots are not well clarified. This study explored the root uptake and acropetal translocation behaviors of C2–C8 PFAAs by wheat (Triticum acstivnm L.) under the co-exposure of copper (Cu). The underlying uptake mechanisms of PFAAs were verified in a defective root system. The results showed that excessive Cu (100–400 μmol/L) damaged the cell membrane of wheat root to increase electrolytic leakage. In the defective root system, the root concentrations of PFAAs decreased by 6%–73% and the decrease rates were negatively associated with the carbon chain length of PFAAs. Along with the decrease in root concentrations of PFAAs, the amount of ultrashort-chain (C2–C3) and short-chain (C4–C6) PFAAs translocated to the shoot also decreased by 45%–84%. In contrast, the acropetal translocation of long-chain (C8) PFAAs, perfluorooctanoic acid (PFOA) and perfluorooctane sulfonic acid (PFOS), was enhanced under Cu exposure due to the increase in root permeability as observed by increased electrolytic leakage. The shoot concentrations of PFOA and PFOS under Cu exposure were up to 5.5 and 11 times higher than those in the control, respectively. These results suggested that PFOA and PFOS could enter wheat root more easily through the breaks caused by Cu exposure and thereby their acropetal transportation to shoot was enhanced. Therefore, the risk of plant accumulation of long-chain PFAAs can be potentially underestimated if without considering the co-contamination with HMs in the environment.

Biochar has been widely used in the mitigation of soil potentially toxic metals due to its high efficiency and low cost. Crayfish shell biochar (CSBC) was prepared at 300, 500, and 700 °C (referred to as CS300, CS500, and CS700, respectively) and the performance and mechanism of CSBC for mitigating Pb polluted water and soil was investigated. The results indicated that CSBC prepared at higher temperatures possessed higher pH value and ash content, more abundant pore structure, and higher stability. Pb²⁺ adsorption onto CSBC fitted well with the pseudo second order and intraparticle diffusion models. The maximum adsorption capacity of Pb²⁺ increased with the pyrolysis temperature, being 599.70, 1114.53, and 1166.44 mg·g⁻¹ for CS300, CS500 and CS700, respectively. Compared with the control soil samples, the content of available Pb after applying 0.05%–5% CSBC was reduced by 1.87%–16.48% in acidic soils and 1.00%–11.09% in alkaline soils. Moreover, the fractionation of exchangeable Pb was converted to stable organic matter bound, Fe-Mn oxide bound, and residue fractions. XRD, SEM-EDS, and FTIR analysis showed that ion exchange, complexation, precipitation, and C−π interaction are the dominant interaction mechanisms. Therefore, CSBC can employ as an effective immobilizing agent for the mitigation of Pb contaminated water and soil.

There must be some uncertainty in the remediation areas delineated based on limited sample points, and resampling in the high-uncertainty areas is particularly necessary. In situ field portable X-ray fluorescence spectrometry (FPXRF), a rapid and cheap analysis method for soil heavy metals, is strongly affected by many spatially non-stationary soil factors. This study first delineated the high-uncertainty area (threshold-exceeding probabilities (PTE) between 30% and 70%) of soil Pb based on the 1000 realizations produced by sequential Gaussian simulation (SGS) with 93 ICP-MS Pb concentrations measured in a peri-urban agriculture area, China. Next, in situ FPXRF was used to increase sample density in this high-uncertainty area. Then, robust geographically weighted regression (RGWR) was used to correct the in situ FPXRF Pb, and the correction accuracies of RGWR, basic GWR, and traditionally-used ordinary least squares regression (OLSR) were compared. Finally, to explore the best way to combine these corrected in situ FPXRF concentrations in delineating the remediation area, we compared the following spatial simulation methods: basic SGS, sequential Gaussian co-simulation (CoSGS) with the RGWR-corrected in situ FPXRF Pb as auxiliary soft data (CoSGS-CorFPXRF), and SGS with the RGWR-corrected in situ FPXRF Pb as part of hard data (SGS-CorFPXRF). Results showed that (i) RGWR produced higher correction accuracy (RI = 71.5%) than GWR (RI = 59.68%) and OLSR (RI = 25.58%) for the in situ FPXRF Pb; (ii) SGS-CorFPXRF produced less uncertainty (G = 0.97) than CoSGS-CorFPXRF (G = 0.95) and SGS (G = 0.91) in the spatial simulation; (iii) High-uncertainty area (30%<PTE<70%) was reduced from 36.55% to 8.7% of the whole study area. It is concluded that the recommended methods are cost-effective to reduce the uncertainty in delineating the remediation areas of soil heavy metals.

Biochar substrates and tidal flow (TF) and intermittent aeration (IA) operation modes have recently been applied to improve the treatment performance of constructed wetlands (CWs), but their roles in regulating greenhouse gas (GHG) emissions from CWs are still unclear. In this preliminary study, CO₂, CH₄ and N₂O fluxes and associated microbial characteristics in four groups of subsurface-flow CWs, i.e., ceramsite CWs (C-CWs), biochar-amended CWs (B-CWs), intermittently aerated B-CWs (AB-CWs) and tide-flow B-CWs (TB-CWs), were comparatively investigated. The results showed that biochar amendment significantly mitigated CH₄ and N₂O fluxes from the CWs by supporting higher abundances of mcrA and nosZ genes and higher ratios of pmoA/mcrA and nosZ/(nirK + nirS), thus reducing global warming potential (GWP, a decrease of 55.8%), in addition to promoting total nitrogen (TN) removal by 41.3%, mainly by increasing the abundances and activities of nitrifiers and denitrifiers. The TF mode efficiently improved nitrogen removal, but it greatly increased GHG fluxes since large amounts of GHGs escaped from the empty CW matrix after water draining. IA abated GHG emissions from the CWs, mainly after aeration. TF and IA decreased the abundances of functional bacteria and archaea related to C and N transformation, except nitrifiers, and shaped the microbial community structures. The application of a biochar substrate and IA mode can facilitate the design and operation of CWs in a more ecologically sustainable way.

Marine debris and plastic pollution affect all coastal habitats, however coastal debris studies are predominantly performed on sandy beaches. Other coastal habitats, such as mangroves, remain understudied. Eighteen of the top twenty rivers that contribute the most plastic to the ocean are associated with mangroves, but very few of those forests were investigated in terms of plastic debris pollution. Here we discuss the results of the few available studies on macrodebris conducted in mangroves, which show that mangrove debris research is still in its early stages, with many areas of study to be further investigated. Indeed, the distinct structural complexity of mangroves increases their ability to trap debris from both terrestrial, freshwater and marine sources, resulting in impacts unique to the mangrove ecosystem. Our review highlights a significant lack in standardisation across the performed surveys. Here we suggest standardised guidelines for future integrated macrodebris and microplastic studies in mangroves to facilitate comparisons between studies. Such standardisation should prioritize the use of stratified random sampling, the measurement of the area covered by the debris and the abundance and type of macrodebris and microplastics found, in order to assess the ecological impact of macrodebris and its role as source of microplastics for adjacent ecosystems. We also advocate the use of standard categories across studies, based on those identified for surveying other coastal habitats. This review highlights an alarming knowledge gap in extent, sources and overall impacts of marine macrodebris, mainly constituted by plastic, on mangrove forests, which hinders policy making to address this issue. Standardised, reliable and extended research on this aspect of mangrove pollution is needed to manage and protect these endangered vegetated coastal ecosystems.