Different lignocellulosic substrates consisting of modified barley husk, peanut shells and sawdust were entrapped in calcium alginate beads and used as adsorbents to remove dye compounds from vinasses. For comparative purposes, a biocomposite formulated with humus was also included in this work. Kinetic studies were carried out by applying pseudo-first-order, pseudo-second-order, Chien–Clayton and intraparticle diffusion models, observing a good agreement between theoretical and experimental results when the data were adjusted to pseudo-second-order kinetic model. The results of this study show that lignocellulosic-based biocomposites could be used as an effective and low-cost adsorbent for the removal of dyes from aqueous solutions. Among the heterogeneous biopolymers evaluated, the biocomposite based on barley husk gave the best capacity for dye removal. Moreover, in all cases, it was found that there exists a direct relationship between the capacity of the biocomposites to remove dyes and the percentage of carbon contained in the lignocellulosic residues.

Saplings of alder (Alnus glutinosa), birch (Betula pendula), hazel (Corylus avellana), beech (Fagus sylvatica), ash (Fraxinus excelsior) and oak (Quercus robur) were exposed to five episodic ozone regimes in solardomes, with treatment means between 16 and 72 ppb. All trees were kept fully watered for the first 5 weeks of exposure, after which half the trees continued to be well-watered, whereas the other half were subjected to a moderate drought by applying approximately 45 % of the amount of water. Species-specific reductions in growth in response to both ozone and drought were found, which could result in reduced potential carbon sequestration in future ozone climates. In well watered conditions, the ozone treatments resulted in total biomass reductions for oak (18 %), alder (16 %), beech (15 %), ash (14 %), birch (14 %) and hazel (7 %) in the 72 ppb compared with the 32 ppb treatment. For beech, there was a reduction in growth in response to ozone in the well-watered treatment, but an increase in growth in response to ozone in the drought treatment, in contrast to the decreased growth that would occur as a result of stomatal closure in response to either the ozone or drought treatment, and therefore assumed to result from changes in hormonal signalling which could result in stomatal opening in combined ozone and drought conditions. For alder, in addition to a decrease in root biomass, there was reduced biomass of root nodules with high compared with low ozone for both drought-treated and well-watered trees. There was also a large reduction in the biomass of nodules from drought trees compared with well-watered. It is therefore possible that changes in the nitrogen dynamics of alder could occur due to reduced nodulation in both drought and elevated ozone conditions.

Tropical coastal areas are sensitive ecosystems to climate change, mainly due to sea level rise and increasing water temperatures. Furthermore, they may be subject to numerous stresses, including heat releases from energy production. The Urias coastal lagoon (SE Gulf of California), a subtropical tidal estuary, receives cooling water releases from a thermoelectric power plant, urban and industrial wastes, and shrimp farm discharges. In order to evaluate the plant thermal impact, we measured synchronous temperature time series close to and far from the plant. Furthermore, in order to discriminate the thermal pollution impact from natural variability, we used a high-resolution hydrodynamic model forced by, amongst others, cooling water release as a continuous flow (7.78 m³ s⁻¹) at 6 °C overheating temperature. Model results and field data indicated that the main thermal impact was temporally restricted to the warmest months, spatially restricted to the surface layers (above 0.6 m) and distributed along the shoreline within ∼100 m of the release point. The methodology and results of this study can be extrapolated to tropical coastal lagoons that receive heat discharges.

In this study, 1-year greenhouse pot experiments were conducted to investigate the effect of Phyllobacterium myrsinacearum strain RC6b on the growth and phytoextraction efficiency of heavy metals by a Zn/Cd hyperaccumulator (Sedum alfredii) and alfalfa (Medicago sativa L.) in a co-cropping system. The treated soil sample was collected from a land reclamation site of Pb/Zn mine tailings in Hanzhong City, Shaanxi Province, China. Results showed that, with the inoculation of RC6b, shoot biomass yields of plants were significantly increased by 15.9–20.2 % and 17.2–19.9 % for alfalfa and S. alfredii, respectively, compared to the non-inoculated plants. Biomass yield of alfalfa was higher than that of S. alfredii. RC6b inoculation increased metal concentrations by 18.6–31.2 % (Pb), 23.8–37.5 % (Cd), and 26.4–38.3 % (Zn) in S. alfredii shoots, and by 13.8–24.7 % (Pb), 15.8–26.6 % (Cd), and 24.8–35.6 % (Zn) in alfalfa shoots, respectively. After six consecutive harvests of shoots, RC6b inoculation increased the phytoextraction efficiencies of Pb, Cd, and Zn by shoots of the co-planting system by 16.9, 46.3, and 60.9 %, respectively. Nevertheless, phytoextraction of Cu was not improved by RC6b inoculation. In the co-planting/inoculation system, the percentage removals of metals from soil by the plant shoots were 6.09, 30.97, 11.10, and 1.68 % for Pb, Cd, Zn, and Cu, respectively, after six harvests of shoots. Inoculation with RC6b significantly increased the soil microbial activity and the carbon utilization ability of the soil microbial community.

Surface and groundwater are often contaminated with toxic anions such as arsenic and selenium. Because of their large surface areas, selenium adsorption on carbon sorbents is considered an attractive water treatment technique. In this present work, selenium sorption on copper-impregnated activated carbon and fly ash-extracted char carbon was evaluated. Unburned carbon was extracted from fly ash using froth floatation techniques, and the carbon sorbents were modified using copper ions. Adsorption experiments confirmed the strong influence of electrostatic forces on equilibrium uptakes of selenite (Se (IV)) and selenate (Se (VI)). Selenium sorption on virgin char carbon was maximum only at acidic pH, i.e., at pH < pHₚzc (pH at point of zero charge). Upon copper modification of the carbon surface, the pHₚzc shifted towards the alkaline region, and as a result, the positive charge density on the carbon surface increased. At pH > pHₚzc, a two- to fourfold increase in sorption coverage and threefold increase in selenium percent removal was observed. Se (IV) sorption was higher compared to Se (VI) sorption. The effect of selenium concentrations and competing anions was studied to evaluate adsorbent performance. The order of maximum surface coverage followed the order: modified char carbon > modified activated carbon > char carbon. The main mechanism of selenium (Se) sorption appeared to be (1) electrostatic attraction of the Se ions to the modified carbon surface at acidic to neutral pH; (2) complexation of Se ions with the copper ions/oxides on the carbon surface; and (3) co-precipitation with copper hydroxides at alkaline pH.

Exposure to benzene has been associated with multiple severe impacts on health. This notwithstanding, at most monitoring stations, benzene is not monitored on a regular basis. Data were used from two different monitoring stations located on the eastern Mediterranean coast: (1) a traffic monitoring station in Tel Aviv located in an urban region with heavy traffic and (2) a general air quality monitoring station in Haifa Bay located in Israel’s main industrial region. At each station, hourly, daily, monthly, seasonal, and annual data of benzene, NO ₓ , mean temperature, relative humidity, inversion level, and temperature gradient were analyzed over 3 years: 2008, 2009, and 2010. A prediction model for benzene rates based on NO ₓ levels (which are monitored regularly) was developed to contribute to a better estimation of benzene. The severity of benzene pollution was found to be considerably higher at the traffic monitoring station than at the general air quality station, despite the location of the latter in an industrial area. Hourly, daily, monthly, seasonal, and annual patterns have been shown to coincide with anthropogenic activities (traffic), the day of the week, and atmospheric conditions. A strong correlation between NO ₓ and benzene allowed the development of a prediction model for benzene rates based on NO ₓ , the day of the week, and the month. The model succeeded in predicting the benzene values throughout the year. The prediction model suggested in this study might be useful for identifying potential risk of benzene in other urban environments.

Integrating vegetation into architecture has become widely recognized as a multi-beneficial practice in architecture and engineering design to combat an array of environmental issues. Urban areas have microclimates that are different than the climates of their surrounding rural areas. Patterns in these differences over the years have shown that urban microclimates tend to be significantly warmer in comparison. This phenomenon is now recognized as the urban “heat island” effect. While the associated consequences of this urban heating are far reaching, excess energy expenditure, air pollution emissions, and threats to human health are among the most critical for evaluation. The integration of vegetative green space in urban planning, coupled with highly reflective materials in place of conventional paved surfaces on roads and rooftops have proven to be effective methods of urban heat island mitigation. While as separate entities these methods are effective, innovative technology has brought forth greening roofs which allows vegetation to compensate where other roof-cooling strategies fall short. Substantially, vertical greenery systems compensate where greening roofs fall short. This paper explores both integrated vegetation as an optimal mitigation strategy for urban heat islands and vertical plant walls as an optimal design.

The reversible and resistant components of adsorption and desorption of munition constituents (MCs) on soils was studied to determine the environmental fate of these contaminants. The long-term desorption of MCs has applicability in formulating accurate risk assessments for operational military ranges. Batch experiments near 1:1 (w/v) soil-to-solution ratios reflecting field conditions using solutions containing mixtures of HMX, RDX, and nitroglycerine (NG) were conducted. The three soils used varied from 0.04 to 13.3 % organic matter. The experiment involved one adsorption step followed by four consecutive desorption steps. Adsorption times were 2, 5, 10, and 30 days. For each adsorption time, desorption times were carried out for 1, 12, 24 and 72 h and 30 days. The reversible/resistant component model was applied to the data. The model predicted the desorption concentrations of the MCs in the soil with root mean square errors of approximately 0.05 to 0.2 μg g soil⁻¹. The extent of desorption hysteresis is not changed by the length of desorption time, irrespective of the initial adsorption time.

Biochar is an organic carbon (OC) and plant nutrient-rich substance that may be an ideal amendment for bolstering soil organic matter and nutrient contents. Two biochars were produced by pyrolysis at 350 °C from pine chips (Pinus taeda) and swine manure solids (Sus scrofa domesticus). The biochar total elemental composition was quantified using inductively coupled plasma spectrometer and their surface chemical composition examined using a combination of scanning electron microscopy (SEM) and electron dispersive spectroscopy (EDS). The biochars were mixed into triplicate pots containing Lauderhill muck (Euic, hyperthermic Lithic Haplosaprist) at 0, 2.5, 5, and 10 % (dry mass). Four simulated water infiltration events were conducted during the 124-day incubation to assess the potential alteration in the leaching potential of soluble soil nutrients. At termination, the muck’s fertility characteristics were assessed, and dissolved cations were measured in water leachates. Neither biochars significantly increased the muck’s OC contents. Swine manure biochar contained higher K, Mg, Na, and P concentrations, and these differences were observable in SEM and EDS as differing amounts of surface-precipitated Mg and K salts. Correspondingly, swine manure biochar at all three applications rates significantly increased Mehlich 1-s K, P, Mg, and Na concentrations. Pine chip biochar only improved the Mehlich 1-extractable K concentration but did reduce soluble P concentrations. Water leachates from swine manure biochar treated wetland soil contained significantly higher soluble P concentrations that could create water quality issue in downstream ecosystems.

In this study, electrocoagulation (EC) with hybrid Fe–Al electrodes was used to remove antimony from contaminated surface water. Response surface methodology was applied to investigate the interactive effects of the operating parameters on antimony removal and optimize these variables. Results showed that the relationship between operating parameters and the response was well described by a second-order polynomial equation. Under the optimal conditions of current density 2.58 mA/cm², pH 5.24, initial concentration 521.3 μg/L, and time 89.17 min, more than 99 % antimony were removed. Besides, the antimony adsorption behavior in EC process was also investigated. Adsorption kinetics and isotherms studies suggested that the adsorption process followed well the pseudo-second-order kinetic model and the Langmuir adsorption model, respectively. Adsorption thermodynamics study revealed that the reaction was spontaneous, endothermic, and thermodynamically favorable. These results further proved that the main mechanism involved in antimony removal in EC process could be chemisorption.