In the Great East Japan Earthquake of 11 March 2011, a magnitude 9.0 earthquake and accompanying tsunami struck the Tohoku region of Japan. The tsunami washed away old equipment containing polychlorinated biphenyls (PCBs) stored in the region's factories, and these PCBs may have leaked out of their casings into the marine environment. In this study, we evaluate marine PCB contamination by comparing mussels collected before (in 2005) and after (June 2011) the tsunami. PCB contamination levels were significantly elevated in mussel samples collected after the tsunami in June 2011 (3 months after the tsunami). This indicates that PCBs (specifically, formulation KC-400) leaked out of old equipment swept away by the tsunami and accumulated in mussels. PCBs were estimated to have an environmental half-life (EHL) in mussels of 4 months. Our results show that an earthquake and subsequent tsunami can cause elevated PCB contamination in the marine environment.

To investigate the effects of the water-sediment regulation on the spatial variations of metals in the surface sediments of the Yellow River Estuary (YRE), sampling sites were set in 2015 (51 sites in June and 33 in October). The content of Cu, Pb, Cd, Cr, Zn, Ni and Mn was determined using inductively coupled plasma spectrometry and of Hg and As atomic fluorescence spectrometry. The results showed that the concentrations of metals in the sediments of YRE were lower after the regulation, while that of most metals increased in the tidal areas of the current estuary with fine particles. Environmental pollution and ecological risk of metals were mainly from Hg and Cd. Metals carried with the silt of the river should be focused. The findings were expected to update the current status of metal pollution of YRE and be helpful for the delicacy management of the regime and silt-laden rivers.

Contaminated sediments at a pulp mill and former chor-alkali effluent treatment facility in Nova Scotia, Canada will undergo remediation. However, baseline studies assessing contaminants in marine biota in the marine receiving environment are lacking. Historical qualitative and quantitative contaminant data in biota from Boat Harbour (a former tidal lagoon which was used to treat industrial effluent since 1967), and surrounding marine environment were reviewed to establish baseline pollution from industrial effluent and contaminated sediments. Elevated metal, dioxins and furan concentrations previously measured in marine biota needs updating to help inform pre-remediation monitoring. Selection of species, contaminants of concern and sampling locations were ad hoc and often inconsistent with environmental effects monitoring requirements under Canadian federal Pulp and Paper Effluent Regulations. These consolidated baseline data are required to determine historical impacts and to assist future monitoring during Boat Harbour sediment remediation to compare against.

Desalination has the potential to provide an important source of potable water to growing coastal populations but it also produces highly saline brines with chemical additives, posing a possible threat to benthic marine communities. The effects of brine (0%, 50%, 100%) were compared to seawater treatments with the same salinity (37, 46, 54 psu) for seagrass (Posidonia australis) in mesocosms over 2 weeks. There were significant differences between brine and salinity treatments for photosynthesis, water relations and growth. Germinating seedlings of P. australis were also tested in brine treatments (0%, 25%, 50%, 100%) over 7 weeks followed by 2.5 weeks recovery in seawater. Growth was severely inhibited only in 100% brine. These experiments demonstrated that brine increased the speed and symptoms of stress in adult plants compared to treatments with the same salinity, whereas seedlings tolerated far longer brine exposure, and so could potentially contribute to seagrass recovery through recruitment.

Concerns are growing about the presence of fluoxetine (FLX) in environmental matrices, as well as its harmful effects on non-target organisms. FLX in aquatic ecosystems has been detected in a range varying from pg/L to ng/L, while adverse effects have been reported in several organisms inhabiting freshwater and marine environments. The present study quantifies FLX concentrations in seawater samples from Santos Bay, Brazil and assesses metabolic responses and sublethal effects on the tropical brown mussel Perna perna. Levels of ethoxyresorufin‑O‑deethylase, dibenzylfluorescein dealkylase, glutathione S-transferase, glutathione peroxidase, cholinesterase, lipoperoxidation, and DNA damage were assessed in the gills and digestive gland of these animals, and lysosomal membrane stability was also assessed in hemocytes. FLX altered phase I and II enzyme activities, caused cytogenotoxic effects, and negatively impacted the overall health of mussels exposed to environmentally relevant concentrations. These findings contribute to characterize the risks of introducing this drug into the marine environment.

Over the past decades, overall ecological conditions in the Caspian Sea have deteriorated. However, a comprehensive understanding of lake-wide spatial differences in anthropogenic pressures is lacking and the biological consequences of human impacts are poorly understood. This paper therefore aims at assessing the individual and combined effects of critical anthropogenic pressures on the Caspian Sea ecoregions. First, cumulative pressure scores were calculated with a cumulative environmental assessment (CEA) analysis. Then, the individual contribution of anthropogenic pressures was quantified. Finally, ecoregion-specific differences were assessed. The analyses show that both cumulative and individual pressure scores are unevenly distributed across the Caspian Sea. The most important individual pressures are invasive species, chemical pollution and poaching. This uneven distribution of pressure scores across Caspian Sea ecoregions creates new challenges for future conservation strategies, as different ecoregions usually require different conservation measures.

This study utilizes suspended particles and seafloor sediments collected from the northern Gulf of Mexico (GOM) continental margin to study the fate, transport, residence times and accumulation rates of particle-bound polycyclic aromatic hydrocarbons (PAHs). Total particulate-PAHs and particulate organic carbon (POC) varied between 0.9 and 7.0 ng/L, and 4–131 μg/L, respectively. Particulate-PAHs were positively correlated with POC, while both particulate-PAHs and POC were negatively correlated with salinity (P-value < 0.05). These results show that the river-derived particle influx and associated POC are important vectors for transport and fate of particulate-PAHs in the river-dominated northern GOM continental ecosystems. The composition of underlying seafloor sediment-PAHs were not correlated to the water column particulate-PAHs, which is attributed to re-mineralization, sediment resuspension/redistribution and different timescales of comparison. The 210Pb-derived residence time of particles and associated particulate-PAHs in water column varied between 2 and 39 days. Residence times of particulate-PAHs were significantly correlated with seafloor sediment-PAHs accumulation rates, shorter water column residence times leading to higher PAHs accumulation rates.

Concentrations of polychlorinated dibenzo-para-dioxins and dibenzofurans (PCDD/Fs) were measured in sediment and bivalves at 25 locations along the Korean coasts during 2001–2012. Concentrations of PCDD/Fs in sediment and bivalves ranged from 0.15 to 18.9 pg TEQ/g dry weight and from 0.06 to 7.70 pg TEQ/g wet weight, respectively. Elevated PCDD/F concentrations were found at locations close to largest industrial complexes and commercial harbors. A significant decreasing trend of PCDD/Fs in sediment was associated with strong regulation of PCDD/Fs, whereas levels in bivalves did not show a decreasing trend. Octachlorinated dibenzo-p-dioxin (OCDD) was predominant in sediment, while tetrachlorinated dibenzofuran and OCDD were predominant in bivalves. Almost half (46%) of sediment samples exceeded the threshold effect level suggested by the US National Oceanic and Atmospheric Administration, implying ecotoxicological risks to benthic organisms. Our findings support the effectiveness of legislative action on PCDD/Fs for coastal environments of Korea.

Microplastics (plastic particles <5 mm) are an emerging concern in Arctic sea ice with measured concentrations orders of magnitude higher than in surface seawater. However, incorporation of microplastics into sea ice, and their impact on sea ice properties, is unknown. We added microplastic particles in a microcosm experiment to determine microplastic distributions and effects on sea ice properties. Microplastic additions did not affect sea ice growth, but high concentrations of microplastics at the ice surface resulted in high ice salinity and changes in sea ice albedo. Field studies in the Gulf of Bothnia (Baltic Sea) showed sea ice concentration of microplastics from 8 to 41 particles per liter of melted ice, wich were much lower than those found to impact sea ice properties in the microcosm experiments. However, should microplastic concentrations increase, microplastic incorporation in sea ice may impact sea ice albedo.

Recent technology developments have turned present-day unmanned systems into realistic alternatives to traditional marine animal survey methods. Benefits include longer survey durations, improved mission safety, mission repeatability, and reduced operational costs. We review the present status of unmanned vehicles suitable for marine animal monitoring conducted in relation to industrial offshore activities, highlighting which systems are suitable for three main monitoring types: population, mitigation, and focal animal monitoring. We describe the technical requirements for each of these monitoring types and discuss the operational aspects. The selection of a specific sensor/platform combination depends critically on the target species and its behaviour. The technical specifications of unmanned platforms and sensors also need to be selected based on the surrounding conditions of a particular offshore project, such as the area of interest, the survey requirements and operational constraints.