The concentrations of heavy metals in water, sediments, soil, roots, and shoots of five aquatic macrophytes species (Oenanthe sp., Juncus sp., Typha sp., Callitriche sp.1, and Callitriche sp.2) collected from a detention pond receiving stormwater runoff coming from a highway were measured to ascertain whether plants organs are characterized by differential accumulations and to evaluate the potential of the plant species as bioindicators of heavy metal pollution in urban stormwater runoff. Heavy metals considered for water and sediment analysis were Cd, Cr, Cu, Ni, Pb, Zn, and As. Heavy metals considered for plant and soil analysis were Cd, Ni, and Zn. The metal concentrations in water, sediments, plants, and corresponding soil showed that the studied site is contaminated by heavy metals, probably due to the road traffic. Results also showed that plant roots had higher metal content than aboveground tissues. The floating plants displayed higher metal accumulation than the three other rooted plants. Heavy metal concentrations measured in the organs of the rooted plants increased when metal concentrations measured in the soil increased. The highest metal bioconcentration factors (BCF) were obtained for cadmium and nickel accumulation by Typha sp. (BCF = 1.3 and 0.8, respectively) and zinc accumulation by Juncus sp. (BCF = 4.8). Our results underline the potential use of such plant species for heavy metal biomonitoring in water, sediments, and soil.

One of the main environmental impacts of concentrated animal feeding operations is the soil degradation in vicinity with the livestock breeding facilities due to substances such as ammonia emitted from the various stages of the process. Owing to the high temperatures of the Mediterranean ecosystems, the evolution of gasses is more extensive and the soil degradation is consequently more severe than those obtained in northern Europe. In this research, the soil degradation effects of a large meat-producing, processing, and packaging unit have been investigated. The investigated intensive hog farming operation (IHFO) is located at a limestone soil coastal area with sea to the north and hills to the south. Soil samples of the upper mineral soil were taken in various distances and directions from the IHFO boundaries. Thirteen experimental cycles were carried out in the duration of 1.5 years starting in March 2009 until October 2010. The soil samples were analyzed on pH and electrical conductivity (EC) values as well as NH4 + and NO3 − concentrations. Significantly higher concentrations of the two nitrogen forms were observed on samples at increasing proximity downwind from the farm (south). Southern soil average NH4 + and NO3 − concentrations ranged between 0.4–118 μg NH4 +-N g−1 soil and 6.1–88.4 μg NO3 −-N g−1 soil, respectively. The variation of emitted gasses depositions was clearly reflected in the average pH and EC values. Average pH and EC values downwind from IHFO boundaries varied between 7.1–8.2 and 140–268 μS/cm, respectively.

Hydrophobic organic compounds are common in the environment, especially in water bodies like rivers and lakes. Generally, due to their physico-chemical characteristics, mainly to hydrophobicity, these compounds are adsorbed by suspended material or other compartments which provide compatibility. Thus, compounds such as polycyclic aromatic hydrocarbons (PAHs) are rapidly adsorbed onto suspended material or even naturally occurring biofilms in water bodies. Biofilms can be defined as complex structures with cells and aggregates of cells. The extracellular polymers present empty spaces that can be filled by water. The biofilm is a sessile microbial community with several kinds of organisms such as bacteria, protozoa, fungi, algae, and extracellular polymeric substances, which may be found on almost any surface exposed to water. Here, biofilms were used to monitor the presence of PAHs in the Barigui River in Curitiba, Brazil. For the measurements and collection of representative microcoenoses, a biofilm sampling device was designed consisting of six glass plates installed in an open polyvinyl chloride pipe of 30 cm diameter and 60 cm length. The sampling device was exposed in the Barigui River for 2 weeks campaigns. The formed biofilm was treated and chemical analysis was performed for PAHs determination. The results showed that biofilms can trap most of the PAHs, especially those with high K ₒw values (octanol–water partition coefficient). Four campaigns were conducted. The total PAHs concentration ranged from 11,204.34 ± 560.12 to 45,846.90 ± 2,290.45 ng/g. According to the isomers ratio, the main source of PAHs in the first and second campaign was of pyrolytic origin, in other words, the PAHs were by-products from burning of light-refined oil products (gasoline and diesel oil). Meanwhile, the other campaigns revealed that the main source is of petrogenic origin. However, the possibility of both sources is not discarded considering the scenario studied and the records of sediments samples. Most of the investigations carried out focused on the loading of river sediments and suspended solids, but the biofilms might detect the amount that could be taken up by benthic organisms, for instance.

Water treatment for wastewater containing phenols and their chlorinated variations has attracted important research efforts. Phenol’s high toxicity makes them a good model to test possible water treatment based on biological and/or chemical methods. High concentrations of phenols may be treated by pure biological schemes. However, chlorinated phenols are very toxic for many microorganisms. Therefore, mixed treatment trains can be proposed to solve the treatment of this class of organics. In this study, the ozonation was used as pretreatment to decompose chlorinated phenols. Besides, this study describes how the microbial consortiums were adapted to handle ozonation by-products. The biodegradation of different phenol concentrations from 50 to 1,500 mg/L was evaluated using preadapted microbial consortia in batch and in a trickling packed-bed reactor (TPBR). Under batch conditions, phenol was efficiently removed up to 500 mg/L. For every phenol concentration evaluated, higher degradation rates were obtained in TPBR. The chlorophenols were found to be poorly degraded by the pure biological treatment, 4-CPh was not degraded during the biological process and 2,4-DCPh was only 40 % degraded after 250 h of culture. By combining the chemical (as pretreatment) and the biological processes, 85 % of 4-CPh was removed, while the degradation of the 2,4-DCPh was enhanced from 40 to 87 %. The predominant bacteria found in the preadapted cultures were Xanthomonas sp., Ancylobacter sp., and Rhodopseudomonas. Total treatment period was reduced from several weeks to some days. This information reflects the benefits offered by the mixed water treatment train proposed in this paper.

A laboratory study was conducted to assess the feasibility of remediating diesel-contaminated soils using sodium persulfate (SPS) oxidation under an alkaline pH. Lime (CaO) and sodium hydroxide (NaOH) were used as the alkaline sources, and various factors, including temperature, reaction time and concentration level, were investigated. Moreover, the combined usage of hydrogen peroxide (HP) and SPS in the presence or absence of NaOH was also studied. It was found that lime hydration resulted in rapid increases in pH (>12) and temperature (75 °C maximum) at a CaO/H₂O mass ratio of 3/20. In the NaOH or CaO/SPS system, the maximum diesel degradation achieved was approximately 30 %. It was observed that using a larger amount of alkaline increased SPS decomposition and had almost no effect on diesel degradation. Limited solubilization of contaminants may have inhibited the effectiveness of alkaline-activated persulfate oxidation during the aqueous phase and hence resulted in incomplete diesel degradation. The highest rate of diesel degradation (i.e., 56 % in 7 days) was achieved using the dual oxidation system, in which a HP/SPS molar ratio of 3.3/0.5 was used. An aggressive oxidation process, coupled with HP, may enhance desorption of diesel from soils and allow oxidation to occur during the aqueous phase.

The petroleum industry activities provide potential risks to the environment because they can contaminate ecosystems with different organic compounds in the production chain. Several accidents with transport and handling of petroleum and related products occurred in urban areas with harmful effects to the quality of life and economy. In the 1990s, bioremediation and phytoremediation technologies as economically feasible alternatives to repair the environmental damage were developed. In this study, the potential of the willows Salix rubens and Salix triandra were evaluated with regard to the phytoremediation of soils contaminated with petroleum-derived hydrocarbons (total hydrocarbons and polycyclic aromatic hydrocarbons (PAHs)). The PAHs were quantified by extraction from soils and plants using dichloromethane under ultrasonication. The HPLC analysis was performed with GC/MSD equipment. The total hydrocarbons present in uncontaminated soil were quantified by the sum of animal/vegetable oils and greases and mineral oils and greases according to Standard Methods 5520 (1997). The two willows species S. rubens and S. triandra were resistant during the project development. In the contaminated soil, in which both species were planted, the total hydrocarbons concentration was reduced near 98 %. The PAHs content was remarkably reduced as well. Pyrene showed an initial concentration of 23.06 μg kg⁻¹, decreasing in most cases to 0.1 μg kg⁻¹ or to undetectable levels. Chrysene decreased from 126.27 μg kg⁻¹ to undetectable levels. Benzo[k]fluoranthene and benzo[a]pyrene concentrations had also showed a decrease from 28.44 and 3.82 μg kg⁻¹, respectively, to undetectable levels.

This study compared the tolerance limits of selected bacterial (Bacillus licheniformis, Brevibacillus lactosporus and Pseudomonas putida) and protozoan (Aspidisca, Trachelophyllum and Peranema) species to V5+ in wastewater systems. The isolates were exposed to various concentrations of V5+ (from 10 to 240 ppm), and their tolerance limits to this heavy metal were assessed at different temperatures (25, 30, 35 and 40°C) and pHs (4, 6, 7, 8 and 10) for 5 days. Chemical oxygen demand (COD), dissolved oxygen (DO) and die-off rate of the isolates were measured using standard methods. The results indicated that test isolates were tolerant to V5+, with a gradual decrease in their colony/cell counts when V5+ concentration gradually increased. Bacterial species were found to be more significantly tolerant (MIC: 110–230 ppm V5+) to V5+ than protozoan species which showed an earlier total inhibition/die-off rate (100%) at 60–100 ppm V5+ (MIC) (p < 0.001). P. putida was the most tolerant bacterial species (MIC: 230 ppm V5+) and Aspidisca sp. the most sensitive protozoan species (MIC: 60 ppm V5+). An increase in COD and DO removal was observed throughout the experimental period. The highest COD increase (up to 237.11%) and DO removal (almost 100%) were observed in mixed liquor inoculated with P. putida after exposure to 10 ppm V5+. Changes in pH and temperature affected the tolerance limits of all isolates. This study suggests the use of these tolerant bacterial and protozoan species in the bioremediation of V5+ from domestic and industrial wastewater under the control of pH and temperature.

For a bioremediation process to be effective, we suggest to perform preliminary studies in laboratory to describe and characterize physicochemical and biological parameters (type and concentration of nutrients, type and number of microorganisms, temperature) of the environment concerned. We consider that these studies should be done by taking into account the simultaneous interaction between different factors. By knowing the response capacity to pollutants, it is possible to select and modify the right treatment conditions to enhance bioremediation.

Microbiologically contaminated water severely impacts public health in low-income countries, where treated water supplies are often inaccessible to much of the population. Groundwater represents a water source that commonly has better microbiological quality than surface water. A 2-month intensive flow and quality monitoring programme of a spring in a densely settled, unsewered parish of Kampala, Uganda, revealed the persistent presence of high chloride and nitrate concentrations that reflect intense loading of sewage in the spring’s catchment. Conversely, thermotolerant coliform bacteria counts in spring water samples remained very low outside of periods of intense rainfall. Laboratory investigations of mechanisms responsible for this behavior, achieved by injecting a pulse of H40/1 bacteriophage tracer into a column packed with locally derived granular laterite, resulted in near-total tracer adsorption. X-ray diffraction (XRD) analysis showed the laterite to consist predominantly of quartz and kaolinite, with minor amounts (<5%) of haematite. Batch studies comparing laterite adsorption capacity with a soil having comparable mineralogy, but with amorphous iron oxide rather than haematite, showed the laterite to have a significantly greater capacity to adsorb bacteriophage. Batch study results using pure haematite confirmed that its occurrence in laterite contributes substantially to micro-organism attenuation observed and serves to protect underlying groundwater.

Synechocysis sp. PCC6803 is a unicellular blue alga which ubiquitously exists in aquatic system and is considered to play a role in arsenic cycling. Our results showed that Synechocysis can accumulate arsenic as much as 1.0 and 0.9 g kg−1 DW when exposed to 0.5 mM arsenate and arsenite for 14 days, respectively. In addition, arsenic species in cells were assayed under different exposure conditions and it was found that inorganic arsenic, including arsenate and arsenite, is the dominant species. Organic methylated arsenicals can only be detected exposed to higher arsenic concentration range (100–500 μM). Arsenate is the dominant arsenic species and presents more than 80% of the total arsenic in cells. Efflux of both arsenate and arsenite was observed. When treated with 2.67 μM arsenite, Synechocysis can rapidly oxidize arsenite to arsenate and accumulate As rapidly. The observed arsenic oxidation in solute is solely caused by cellular oxidation. Given the robust ability of As accumulation, it can serve as a phytoremediation organism to efficiently remove arsenic from aquatic environments.