To develop an internationally standardized protocol for the moss bag technique application, the research team participating in the FP7 European project “MOSSclone” focused on the optimization of the moss bags exposure in terms of bag characteristics (shape of the bags, mesh size, weight/surface ratio), duration and height of exposure by comparing traditional moss bags to a new concept bag, “Mossphere”. In particular, the effects of each variable on the metal uptake from the air were evaluated by a systematic experimental design carried out in urban, industrial, agricultural and background areas of three European countries with oceanic, Mediterranean and continental climate. The results evidenced that the shape, the mesh size of the bags and the exposure height (in the tested ranges), did not significantly influence the uptake capacity of the transplanted moss. The aspects more affecting the element uptake were represented by the density of the moss inside the bags and the relative ratio between its weight and the surface area of the bag. We found that, the lower the density, the higher the uptake recorded. Moreover, three weeks of exposure were not enough to have a consistent uptake signal in all the environments tested, thus we suggest an exposure period not shorter than 6 weeks, which is appropriate in most situations. The above results were confirmed in all the countries and scenarios tested. The adoption of a shared exposure protocol by the research community is strongly recommended since it is a key aspect to make biomonitoring surveys directly comparable, also in view of its recognition as a monitoring method by the EU legislation.

Microbial transformation of polyfluoroalkyl phosphate esters (PAPs) into perfluorocarboxylic acids (PFCAs) has recently been confirmed to occur in activated sludge and soil. However, there lacks quantitative information about the half-lives of the PAPs and their significance as the precursors to PFCAs. In the present study, the biotransformation of 6:2 and 8:2 diPAP in aerobic soil was investigated in semi-dynamics reactors using improved sample preparation methods. To develop an efficient extraction method for PAPs, six different extraction solvents were compared, and the phenomenon of solvent-enhanced hydrolysis was investigated. It was found that adding acetic acid could enhance the recoveries of the diPAPs and inhibit undesirable hydrolysis during solvent extraction of soil. However 6:2 and 8:2 monoPAPs, which are the first breakdown products from diPAPs, were found to be unstable in the six solvents tested and quickly hydrolyzed to form fluorotelomer alcohols. Therefore reliable measurement of the monoPAPs from a live soil was not achievable. The apparent DT50 values of 6:2 diPAP and 8:2 diPAP biotransformation were estimated to be 12 and > 1000 days, respectively, using a double first-order in parallel model. At the end of incubation of day 112, the major degradation products of 6:2 diPAP were 5:3 fluorotelomer carboxylic acid (5:3 acid, 9.3% by mole), perfluoropentanoic acid (PFPeA, 6.4%) and perfluorohexanoic acid (PFHxA, 6.0%). The primary product of 8:2 diPAP was perfluorooctanoic acid (PFOA, 2.1%). The approximately linear relationship between the half-lives of eleven polyfluoroalkyl and perfluoroalkyl substances (PFASs, including 6:2 and 8:2 diPAPs) that biotransform in aerobic soils and their molecular weights suggested that the molecular weight is a good indicator of the general stability of low-molecular-weight PFAS-based compounds in aerobic soils.

In situ assays based on feeding depression can be powerful ecotoxicological tools that can link physiological organism-level responses to population and/or community-level effects. Amphipods are traditional target species for toxicity tests due to their high sensitivity to contaminants, availability in the field and ease of handling. However, cost-effective in situ assays based on feeding depression are not yet available for amphipods that inhabit estuarine ecosystems. The aim of this work was to assess a short-term in situ assay based on postexposure feeding rates on easily quantifiable food items with an estuarine amphipod.Experiments were carried out under laboratory conditions using juvenile Echinogammarus marinus as the target individual. When 60 Artemia franciscana nauplii (as prey) were provided per individual for a period of 30 min in dark conditions, feeding rates could be easily quantified. As an endpoint, postexposure feeding inhibition in E. marinus was more sensitive to cadmium contamination than mortality. Assay calibration under field conditions demonstrated the relevance of sediment particle size in explaining individual feeding rates in uncontaminated water bodies. An evaluation of the 48-h in situ bioassay based on postexposure feeding rates indicated that it is able to discriminate between unpolluted and polluted estuarine sites. Using the harmonized protocol described here, the in situ postexposure feeding assay with E. marinus was found to be a potentially useful, cost-effective tool for assessing estuarine sediment and water quality.

This study investigated the potential use of elemental S (S0) to convert Cr-VI to Cr-III which should decrease the bio-availability hence, toxicity of Cr-VI in soils. The bio-available fraction of Cr in soil was measured by phosphate buffer extraction (PBE) and the results showed that the fraction is about 10% of the total Cr-VI and varied from 12.8 to 42.5 mg kg−1. The addition of 4.0 mg g−1 S0 decreased PBE Cr-VI to <0.4 mg kg−1 limit established for Cr-VI toxicity in soils. Synchrotron-based X-ray absorption near-edge structure (XANES), X-ray fluorescence (XRF) and micro-XRD revealed that Cr-III was the dominant species (99% of total Cr) and Cr was retained by hematite and goethite in soil. Fe-containing minerals may have provided sufficient protection to render the dominant Cr-III species biochemically inert to redox processes in soils. It is concluded that S0amendment is a promising approach to remediate Cr-VI contaminated soils.

Three instrumented bicycles were used to measure black carbon (BC) and PM2.5 concentrations in a midsized city in southern Brazil. The objective of this study was to map the spatial distribution of BC and PM2.5, to identify air pollution hotspots and to assess factors that may affect the concentrations of these pollutants, e.g. traffic volume, number of heavy-duty diesel vehicles (HDDV), position of traffic signals and street incline. The cyclists collected data in the city centre along streets of different traffic density during nine sampling sessions in the weekday morning and afternoon rush hours, between March 13 and April 28, 2015. The sampling by bicycle covered an area of 2.70 km2, over variable elevation, and travelled a total distance of 215 km. BC and PM2.5 exhibited a large spatial variability on a scale of tens of metres and the concentrations were positively correlated with traffic counts, but exhibited a stronger relationship with the number of HDDV. These results imply that older buses and diesel-powered trucks may be the main driver behind the high pollution levels in the city's inner core. We observed a strong relationship between BC concentrations at junctions managed by traffic signals and the quantity of HDDV. The mean BC concentration was found to be 8.10 μg m−3 near traffic signals located on an inclined street (HDDV > 100 vehicles h−1) compared to traffic signals on flat terrain (6.00 μg m−3), which can be attributed to the higher acceleration required at the start of motion. This pattern was less evident for PM2.5 concentrations.

The growing use of lithium (Li) in industrial and energetic applications and the inability to completely recycle the alkali metal will most likely increase anthropogenic emissions and environmental concentrations in the future. Although non-essential to plants, Li+ is an important ultra-trace element in the animal and human diet and is also used in the treatment of e.g. mental disorders. Most of the lithium is consumed with the drinking water and vegetables, but concentrations in foodstuffs vary with the geochemistry of the element. In order to identify potential risks and to avoid an overmedication due to consumption of Li rich or Li contaminated foods it is advisable to identify background levels and to derive recommended Daily Allowances (RDAs) for the element. Although Germany does not possess large amounts of primary or secondary resources of lithium, geochemical investigations (mineral and ground waters and soils) in this country confirm a wide variation of environmental concentrations with generally higher levels in the southwest. Despite the large number of soil and water data, only very few data exist on lithium concentrations in plants and its phytotoxicity. Within the scope of present study common grassland plant species were sampled in regions of SW-Germany with reportedly high geogenic levels of Li. The data are discussed with regard to literature surveys and existing reference values. Since lithium has phytotoxic effects a greenhouse experiment was performed with different Li salts (LiCl and Li2CO3) and plant species (maize, bean and buckwheat) to derive dose-response relationships for the endpoint shoot growth. While corn growth was not reduced significantly by soil concentrations of 118 ppm, EC50 values in buckwheat were 47 and 16 ppm for lithium derived from LiCl and Li2CO3, respectively.

Results from coastal water pollution monitoring (Lesvos Island, Greece) are presented. In total, 53 samples were analyzed for 58 polar organic micropollutants such as selected herbicides, biocides, corrosion inhibitors, stimulants, artificial sweeteners, and pharmaceuticals. Main focus is the application of a proposed wastewater indicator quartet (acesulfame, caffeine, valsartan, and valsartan acid) to detect point sources and contamination hot-spots with untreated and treated wastewater. The derived conclusions are compared with the state of knowledge regarding local land use and infrastructure. The artificial sweetener acesulfame and the stimulant caffeine were used as indicators for treated and untreated wastewater, respectively. In case of a contamination with untreated wastewater the concentration ratio of the antihypertensive valsartan and its transformation product valsartan acid was used to further refine the estimation of the residence time of the contamination. The median/maximum concentrations of acesulfame and caffeine were 5.3/178 ng L⁻¹ and 6.1/522 ng L⁻¹, respectively. Their detection frequency was 100%. Highest concentrations were detected within the urban area of the capital of the island (Mytilene). The indicator quartet in the gulfs of Gera and Kalloni (two semi-enclosed embayments on the island) demonstrated different concentration patterns. A comparatively higher proportion of untreated wastewater was detected in the gulf of Gera, which is in agreement with data on the wastewater infrastructure. The indicator quality of the micropollutants to detect wastewater was compared with electrical conductivity (EC) data. Due to their anthropogenic nature and low detection limits, the micropollutants are superior to EC regarding both sensitivity and selectivity. The concentrations of atrazine, diuron, and isoproturon did not exceed the annual average of their environmental quality standards (EQS) defined by the European Commission. At two sampling locations irgarol 1051 exceeded its annual average EQS value but not the maximum allowable concentration of 16 ng L⁻¹.

Estimating the burden of mortality associated with particulates requires knowledge of exposure-response associations. However, the evidence on exposure-response associations is limited in many cities, especially in developing countries. In this study, we predicted associations of particulates smaller than 10 μm in aerodynamic diameter (PM10) with mortality in 73 Chinese cities. The meta-regression model was used to test and quantify which city-specific characteristics contributed significantly to the heterogeneity of PM10-mortality associations for 16 Chinese cities. Then, those city-specific characteristics with statistically significant regression coefficients were treated as independent variables to build multivariate meta-regression models. The model with the best fitness was used to predict PM10-mortality associations in 73 Chinese cities in 2010. Mean temperature, PM10 concentration and green space per capita could best explain the heterogeneity in PM10-mortality associations. Based on city-specific characteristics, we were able to develop multivariate meta-regression models to predict associations between air pollutants and health outcomes reasonably well.

In situ remediation of contaminated sediment using microbes is a promising environmental treatment method. This study used bioaugmentation to investigate the biodegradation of tetrabromobisphenol A (TBBPA) in sediment microcosms collected from an electronic-waste recycling site. Treatments included adding possible biodegradation intermediates of TBBPA, including 2,4-dibromophenol (2,4-DBP), 2,4,6-tribromophenol (TBP), and bisphenol A (BPA) as co-substrates. Bioaugmentation was done with Ochrobactrum sp. T (TBBPA-degrader) and a mixed culture of Ochrobactrum sp. T, Bacillus sp. GZT (TBP-degrader) and Bacillus sp. GZB (BPA-degrader). Results showed that bioaugmentation with Ochrobactrum sp. T significantly improved TBBPA degradation efficiencies in sediment microcosms (P < 0.01); aerobic conditions increased the microbes' degradation activities. Co-substrates 2,4-DBP, TBP and BPA inhibited biodegradation of TBBPA. A metagenomic analysis of total 16S rRNA genes from the treated sediment microcosms showed that the following dominant genera: Ochrobactrum, Parasegetibacter, Thermithiobacillus, Phenylobacterium and Sphingomonas. The genus level of Ochrobactrum increased with increased degradation time, within 10-week of incubation. Microbes from genus Ochrobactrum are mainly linked to enhance the TBBPA biodegradation.

Soils are the largest terrestrial sink for methane (CH4). However, heavy metals may exert toxicity to soil microorganisms, including methanotrophic bacteria. We tested the effect of lead (Pb), zinc (Zn) and nickel (Ni) on CH4 oxidation (1% v/v) and dehydrogenase activity, an index of the activity of the total soil microbial community in Mollic Gleysol soil in oxic and hypoxic conditions (oxia and hypoxia, 20% and 10% v/v O2, respectively). Metals were added in doses corresponding to the amounts permitted of Pb, Zn, Ni in agricultural soils (60, 120, 35 mg kg−1, respectively), and half and double of these doses. Relatively low metal contents and O2 status reflect the conditions of most agricultural soils of temperate regions. Methane consumption showed high tolerance to heavy metals. The effect of O2 status was stronger than that of metals. CH4 consumption was enhanced under hypoxia, where both the start and the completion of the control and contaminated treatment were faster than under oxic conditions. Dehydrogenase activity, showed higher sensitivity to the contamination (except for low Ni dose), with a stronger effect of heavy metals, than that of the O2 status.