The present study evaluates the water quality of Dez River, a river 23 km long, via QUAL2Kw model, based on simulation of DO and BOD5 p98arameters, through considering water quality standards during six months in three stations of Kashefieh, Pole-Panjom, and Hamidabad. To determine the model’s validity and compare the observational data, the paper uses the square mean square error (RMES) and the squared mean square error coefficient (CV). The achieved results of the model largely indicate the actual conditions of the river, which represent the ability of QUAL2Kw model to simulate qualitative parameters. The main contamination of Dez River comes from municipal wastewater, either directly imported by river residents or collected by urban canals. It, then, enters the river at a certain point. Based on the simulation and observational results of DO at two stations of 5th and Hamidabad Bridge in all months of sampling, it is below 5 mg/L, regarded a threat to aquatic life. In addition, BOD5 parameter goes beyond 6 mg/L in Hamidabad station, being a threatening factor for aquatic life in this station. Critical conditions of Dez River, low discharge, and high loading of pollutants have increased the concentration of water quality parameters. Given the results of RMSE and CV parameters, the model has had the best conformity for DO parameter, followed by BOD5.

Air pollution damages children’s health in many different ways, through both chronic and acute effects. The aims of our research are to reveal the indoor air quality levels in schools. Subject and indoor air measurements were performed in 34 primary schools located in the Central Anatolia region. PM10, PM2.5, CO2, CO, CH2O, relative humidity, temperature, and total bacteria and fungus levels were measured. In the urban region, mean PM1 was higher than the other regions(p=0.029). PM10 and PM2.5 were higher in schools in rural areas. According to CO2 measurements, only one school was identified to be below the upper limit recommended by the WHO. Total microorganism concentration was exceeded in 44.1% of classrooms. Indoor PM1, PM2.5, PM10, CO2, total bacteria and fungus levels were high and above recommended limits. Human activities, movements of students could be considered the most important indoor factors for particle matter increase. Indoor parameters could be lowered by organizing the school environment.

Both noise and shift work generate oxidative stress, independently; however, in some work places workers are exposed to both at the same time, where their combined effect might increase the oxidative damage. This research is based on the question whether noise and shift work have a synergistic effect on oxidative stress or not. It tries to investigate the effects of these two factors simultaneously, at the biggest cement factory of Iran. For so doing, it enrols 88 male workers, equally in four groups, with one group serving as the control (i.e., Group 1 with 8 hours of fixed shift, exposed to less than 85 dB sound level) and three groups as the cases (Group 2 with 12 hours of rotational shifts, exposed to less than 85 dB sound level; Group 3 with 8 hours of fixed shift, exposed to more than 85 dB sound level; and Group 4 with 12 hours of rotational shifts, exposed to more than 85 dB sound level). Stress oxidative is evaluated by Malondialdehyde (MDA) and Superoxide dismutase (SOD).  Finally, the results show that SOD levels (p<0.001) are significantly decreased in Group 4 and Group 3, compared to the control. Also, MDA levels are significantly increased in Group 4 (in which, the workers are exposed to noise and shift work simultaneously) compared to the control (p < 0.001). The current study shows that co-exposure to noise and shift work has a combined effect (a synergistic role) in MDA. Thereore, more attention should be paid to shift workers, who are exposure to noise simultaneously.

Environmental pollution, caused by traditional plastic packaging, has recently become more severe due to non-biodegradable nature of petroleum-based plastics. The present research studies the preparation of polyvinyl alcohol (PVOH)/Starch (ST)/Humic Acid (HA) contained sodium montmorillonite clay (MMT) as a plastic packaging method. It also investigates biodegradability of films in terms of microbial and thermal degradation and their residual effect on plant growth. For doing so, the research utilizes Broido Technique to obtain the activation energy of the films’ thermal degradation. The influence of HA/MMT ratio on the surface morphology and physical characteristics has also been assessed, using the Fourier Transform Infrared (FTIR) spectroscopy, Scanning Electron Microscope (SEM), and thermogravimetric analysis (TA). After 12 days of microbial degradation, the total remaining solids are 32.12 wt% (PVOH/ST/HA (3%)/MMT (1%)); 48.17 wt% (PVOH/ST/HA (3%)/MMT (3%)), and 58.82 wt% (PVOH/ST/HA (1%)/MMT (3%)). The research shows that the highest activation energy for PVOH/ST/HA (3%)/MMT (3%) is 75 kJ/mol.

Organophosphates are one of the most common pesticides in the world. Among them, one can find malathion that is classified as carcinogenesis, and, as a result, should be appropriately removed since it is highly consumed and possesses a lot of pathogenicity. So far, several processes have been used to remove malathion from aqueous media. The present study investigates its removal by means of Fe3O4 iron oxide nanoparticles. Based on experimental-laboratory studies, using the Response Surface Methodology (RSM), the impact of independent variables such as pH, iron oxide nanoparticle concentration, and contact time on malathion removal efficiency have been investigated. Results show that the pH of the solution is the most important and effective parameter in the process. Optimal conditions of malathion removal based on the appropriate model, obtained from RSM, include 0.4 g/L iron oxide nanoparticles, pH of about 5 (acidic conditions), and contact time of about 1 h with ultraviolet radiation being equal to 82% malathion removal. The process, used in this study, can remove malathion from aqueous solutions according to the so-called conditions, and changing the laboratory conditions can effectively remove it. This process can also be recommended as an economic and scientific method to remove malathion from drinking water.

Aerosols are tiny particles (liquid or solid) suspended in the atmosphere. They play a significant rolein climate dynamics directly or indirectly. Aerosol Optical Depth (AOD) and Angstrom Exponent(AE) are significant parameters to study the concentration and size or type of aerosol over an area,respectively. In this article, we utilized three years of AOD and AE parameters derived from moderateresolution imaging spectroradiometer (MODIS) satellite during the period January, 2013 to December,2015 over Ethiopia. In order to study the spatiotemporal pattern of aerosols, we choose three areas(Debretabour, Gojjam and Addis Ababa) over Ethiopian highlands, which are representative of nonindustrial, agricultural and industrial areas respectively. Further we compare continental aerosols withmarine aerosols from Djibouti. Our results clearly depicts the aerosol distribution over Ethiopia ishighly variable spatially and temporally. The results indicates that the urban and biomass aerosols aredominate over Addis Ababa, and Gojjam respectively, whereas dust and biomass aerosols are presentover Debretabour, while Djibouti is loaded by sea spray aerosols. The seasonal variability of AOD isfound to be maximum during the kiremt (summer) and minimum during bega (winter) over all areas(continental and marine).

Industrial sector is understood to be one of the major offenders in polluting environment particularlywater among others. Sugar industry is one among the agro-based industry releasing high organicpollutants rich in BOD. Though conventional treatment methods have been employed in treating sugarindustry effluents at varied degrees, they come with their own setbacks. In this direction naturalcoagulants are explored and evaluated for their potential and efficiency towards treating sugar industryeffluents. The process of coagulation and flocculation removes impurities precisely colloidalimpurities through the phenomenon of destabilization, bridging and sweep coagulation. In order tohave an effective treatment factors governing coagulation are to be optimized to determine the dose,pH, mixing time etc. The prime objective of the present study is to characterize the sugar industryeffluents, test the efficiency of both chemical and natural coagulants to treat these effluents and bringout a comparison and potential of natural coagulants with that of chemical coagulants. Jar testapparatus was employed all coagulation studies and the results were promising with reduction inparameters like colour (99.28%), electrical conductivity (60.39%), turbidity (97.67%), chloride(69.23%) and total dissolved solids (60.42%) highest by ferric chloride followed by the naturalcoagulants. The findings of the study suggest that the lowest dose of 0.25g/l was optimum to removethe physico-chemical parameters both by chemical and natural coagulants and since natural coagulantswere equally competent with chemical coagulants these can be substituted towards achieving greentreatment options.

Air pollution is a global issue and meteorological factors play an important role in its transportationand regional concentration. The current research is aimed to analyse the variations in meteorologicalparameters in a seasonal and geographical location context in the Jiangsu province of China, and itscorrelation with the six criteria air pollutants, and air quality index (AQI). The present analysis willsupplement the limited understanding on the relation between the regions prevalent climatic conditionsand atmospheric pollution. The meteorological data analysis showed Suzhou city located in thesouthern region of the Jiangsu province with high average temperature, relative humidity, and rainfall.Maximum values of temperature, UV index, sunshine, relative humidity, and rainfall occurred duringsummer, while air pressure in winter. High values of all meteorological parameters occurred in thenorthern and southern region of the province. The data correlation study revealed AQI to havenegative correlation with most meteorological parameters, and positive correlation with air pressure inall cities.

The use of constructed wetland (CW) is a natural way of treating wastewater sustainably and economically. However, the implementation of these systems in freezing conditions is still a matter of research and development. The treatment capacity of CWs relies largely on the biological and biochemical processes which further depends on physical conditions such as temperature, solar radiations, etc. Application of wetland systems for treating wastewater faces many challenges in regions with cold climates, resolving which this review has been made. This paper presents a thorough understanding of the components of CWs and their role in contaminant removal. A comprehensive review of the different types of CWs has been done describing the treatment efficiency achieved by its implementation in the cold climate. Furthermore, various technologies which can be clubbed with CWs have also been listed along with the treatment efficiencies obtained. Literature survey indicates that the extent of removing organics (COD and BOD5) and total phosphorous (TP) are not likely to be affected, but total nitrogen (TN) removal appears to slow down at low temperatures. Despite several advantages of CW technology, further research is required to select suitable macrophytes and optimum design parameters to compensate for frigid conditions.

Chromium VI is a frequent pollutant of industrial liquid effluents. It is a substance classified as a carcinogen group I. In this study, a Cr VI sorption mechanism was developed by using nanocellulose spheroids (hydrogel) obtained from ivory nut. Cr VI was detected in water by a colorimetric method, using 1, 5-diphenylcarbazide at λ 540 nm. Then, the sorption capacity of nanocellulose spheroids was tested by varying the solution's pH and temperatures. The outcome of the experiment shows that the most efficient pollutant’s adsorption conditions are occur at pH 4 and 25 °C. Removal percentages of Cr VI reached 91.29% (+/-1.36) and 95.33% (+/- 0.86). Additionally, the sorption kinetics showed that the adsorption reaction on the material reaches its equilibrium 20 to 30 minutes after the reaction starts. Finally, an analysis of adsorption isotherms showed a high adjustment with the Langmuir and Freundlinch isotherms. In this frame, this work’s results show that nanocellulose beads are an interesting alternative to efficiently reduce Cr VI from industrial and drinking water.