Height at the centre of gravity is a part of mathematical model to interpret risk of lodging used for cereal crops. Because of the anatomical changes during vegetation period, several measured parameters in early milk stage (stem and panicle weight) will differ from over-ripe stage results in their values. The aim of this study was to define approximate values of calculated parameters describing oat (Avena sativa L.) height at the centre of gravity in early milk and over-ripe stages as well as determine connection with lodging risk. The trial was carried out at the State Stende Cereals Breeding Institute in 2013. There were 5 oat cultivars studied. At the investigated growing stages plant samples were taken from a field and in laboratory conditions stem/panicle weight and length measured. The height at the centre of gravity and gravity ratio were calculated using mathematical model by Berry (1998). Results showed that the value of the height at the centre of gravity in over-ripe stage was significantly higher (p is less than 0.01) than in early milk stage, but correlation with risk of lodging remained. Such lodging resistance describing mathematical model can be useful for oat as well as wheat cultivars.

During the controls for Trichinella in wild boar meat, Alaria spp. mesocercariae in the examined samples are diagnosed. There does not exist a routine veterinary inspection for diagnosis of alariosis (Alaria spp.) in Latvia. The aim of the study was to determine Alaria spp. mesocercariae distribution in wild boar (Sus scrofa) meat in Latvia. Laboratory examination was performed in Latvia University of Agriculture Faculty of Veterinary Medicine laboratory of Parasitology, from 2010 to 2013. Meat samples were examined using artificial digestion method, which in regulation No 2075/2005 is considered an official detection method for Trichinella. In total, 1233 wild boar meat samples from different hunting regions of Latvia were examined. The territory of Latvia was divided into four regions – Kurzeme, Zemgale, Vidzeme and Latgale. For examination we used meat samples from wild boar pillars of diaphragm. Samples were taken from wild boars of different age and gender. The prevalence of infection in the examined wild boar meat samples from all regions was 8.2%, but the intensity of infection 2.8.

Listeria monocytogenes is a pathogen that causes infectious diseases in animals and foodborne infection in humans. The aim of this retrospective study was to analyse L. monocytogenes caused abortions in cattle in Latvia in 2013, and to describe the potential reasons of these abortions. In total, 186 cattle abortion cases were investigated. The pathological material from aborted foetuses included samples of brain, heart, liver, spleen, kidneys and lung, liquid of stomach and liquid from thoracic and abdominal cavities. These samples were tested with bacteriological methods according to ISO 11290-1:2007. L. monocytogenes was found in 44 (23.7%) cases of cattle abortions. Positive cases were more distributed in the central and the south-eastern parts of Latvia, because in this territory winters tend to be wetter and colder than in other parts of Latvia. Seasonality was observed of L. monocytogenes caused abortions and the majority of cases occurred during spring and autumn, when the cattle were fed with silage. All abortion cases were observed in the second and the third trimester of the gestation. L. monocytogenes caused abortions occurred in cattle of different ages, but significantly (p is less than 0.05) more often – in 3 years old cattle.

Leaf morphology was assessed in Pajiesys and Seirijai field trials of oaks. Oaks in these trials are the progenies of oak trees (Quercus genus) that grow in the Trakas forest of Seirijai district of Alytus forest enterprise of Lithuania. The aim of the study was to determine the number of hybrid trees between the progenies of the Trakas forest in Pajiesys and Seirijai field trials. 251 oaks belonging to 40 half-sib families were sampled. Twenty three leaf morphological variables were measured on each of 5 leaves collected from each tree and analysed by principal component analysis (PCA) and discriminant analysis (DA). The study concluded that Q. robur and Q. petraea leaves are most clearly identified by six morphological traits. Discriminant function of two traits for oak species separation was proposed. The study has also revealed a high degree of interspecific hybridization in field trials. Study results were compared with earlier reports about hybridization occurring in mixed oak stands in other parts of Europe.

The study represents results of productivity studies of mechanized ditch cleaning using Ponsse Fox harvester adapted to multi-tree handling H6 head in forest drainage systems managed by Joint stock company “Latvia state forests”. The aim of the study is to evaluate productivity of extraction of biomass from ditches depending on working method and to estimate factors affecting prime-cost of biofuel in mechanized harvesting. The study results demonstrate that the 2nd method (mechanized extraction of roundwood and following motor-manual cleaning of remaining vegetation) is the most efficient solution for mechanized cleaning of ditches. Benefits of the 2nd method are smaller costs of undergrowth removal and bigger output of solid biofuel. Ponsse Fox harvester demonstrated sufficient work quality and productivity in the trials; however, it would be wise to use heavier harvesters or caterpillar excavator based harvesters in ditch cleaning. Using the 2nd method, a harvester can extract about 227 ha of ditches (23,000 m3 ) annually.

Thermal wood modification has been intensively studied in the recent decades because of the possibility to produce wood with improved biodurability and dimensional stability without use of harmful chemicals. Beside altered physical characteristics, wood colour is changed to lighter or darker brown as a result of thermal treatment. Growth of interest in thermal wood treatment has stimulated numerous researches concerned with discoloration of thermally modified wood which is subjected to light exposure. The objective of this study was to evaluate the colour stability of thermally modified hardwood during storage in the dark where wood discolouration is not photoinduced but rather a result of oxidative ageing. Three thermally modified hardwood species – aspen (Populus tremula L.), alder (Alnus incana Moench), birch (Betula pendula Roth.), where investigated. Wood discoloration was monitored by spectrophotometrical measurements of reflectance spectra and chromaticity parameter calculations using CIELAB colour system where L* is the lightness, and a* and b* are the chromatic coordinates. The colour stability of thermally modified wood as well as of untreated wood of the same species was examined by means of assessment of the colour parameter changes (ΔL*, Δa*, Δb*, ΔEab). All wood specimens under study discoloured during the experiment, but the colour change did not exceed two units that are common and accepted for wood products. Untreated and thermally modified wood showed different trends of discoloration during storage in the dark. The final colour changes that were fixed at the end of the experiment were greater for the thermally treated wood.

Cumulative air pollution – synergy between different pollutants and environmental factors is one of the hardest to evaluate factors in the air quality monitoring field. The evaluation of cumulative effects is hindered by a lack of verified analytical frameworks. Currently used methods are relatively simple and use statistical models with small fixed number of pollutants in association with different factors. There is almost no one solution for direct, on-site cumulative effect measurements. The alternative is the use of Cumulative Pollution Index (CPI) method – solution designed for cumulative effect calculation from bioindication and air quality measurement data. However, this method is completely new and has never been used in the air pollution evaluation activities. Therefore, the objective of this study was to evaluate the opportunity to use CPI method as a cumulative pollution evaluation tool in air quality monitoring by doing measurements of cumulative effect in several air quality measurement stations in two cities of Latvia – Liepaja and Riga. Results show that Cumulative Pollution Index method is not only usable in air quality monitoring as a tool for cumulative effect evaluation, but can reveal new facts about air pollution and ways how it affects human and ecosystem health, – such climatic and environmental factors as humidity and temperature are more important than interactions between individual pollutants and can be considered main elements in forming of cumulative pollution impact.

The research was conducted during the period of 2007-2011 in the fields fertilized by manure of pig breeding complex. According to the fertilization value of manure, the following total nitrogen levels reached the fields each year: 2007 – 169, 2008 – 167, 2009 - 168, 2010 - 168, 2011 – 168 kg haE-1. Ptotal reached the fertilized fields accordingly: 2007 – 9.4, 2008 – 18.9, 2009 – 12.0, 2010 – 10.8, 2011 – 13.5 kg haE-1. The aim of the research was to explore the impact of manure fertilized fields of a pig breeding complex on the water quality of streams. Streams, flowing through fields fertilized with manure, are usually polluted with nitrogen. The increase in Ntotal concentrations in streams’ water below fertilized fields was affected by precipitation (r = -0.31), fertilization rate (r = 0.41) as well as mineral nitrogen reserves in the soil (r = 0.20). Phosphorus concentrations in streams’ water were low and corresponded to a very good streams’ water ecological condition, except in times, when the water inflowing into the fertilized fields was already contaminated with this element. It was determined that an extremely high impact on streams’ water quality below fertilized fields comes from Ptotal concentration in streams’ water above fertilized fields (r = 0.91) as well as from the drainage water inflowing from fertilized fields into the streams (r = 0.71). Neither Ntotal, nor Ptotal pollution was observed in drainage water, because the highest concentrations during the research period were lower than the maximum allowable concentrations by 1.1 and 6.5 times respectively.

Plants are components of ecosystem that transfer elements from abiotic to biotic environments. Several elements, such as As, Cd, Hg, Pb, can be considered as food chain contaminants. Simultaneously, some essential micronutrients (e.g., Cu, Cr, Ni, Zn) at high concentrations may become toxic to both, plants and animals. To secure the aim to describe the uptake of metals by food crop species such vegetables, as radish Raphanus sativus L., leafy lettuce Lactuca sativa L. and dill Anethum graveolens L., were grown in soils of various grading composition and type. There were five soil types selected. A part of soils was contaminated with copper sulphate solution at different target concentrations, while another part was contaminated with mixture of metal (Pb, Cd, Cu, Zn) compounds. In half of treated soil samples the solution of humic substances was added. Harvested vegetables were dried, and after wet digestion with nitric acid quantitative analysis of metal concentrations was performed by use of atomic absorption spectrometry. The highest concentration of copper was detected in vegetable samples grown in soils with less organics, thereby indicating the importance of soil organic matter to metal transfer routes and accumulation rates in plants. Analysis of lettuce grown in soils contaminated with the mixture of metal compounds revealed that zinc was a metal absorbed more intensively, but metal uptake and accumulation was less intensive from peat if compared with other soils.

The properties of the transverse section surface of the wood are crucial when using it as an adhesive in finger joints. Contact angles of three test liquids sessile drops - water, diiodomethane and ethylene glycol - with known characteristics of surface free energy were measured on wood surface with the grain orientation 45 ° against the plane. Acid–base approach was used to calculate surface free energy and its characteristics of Scots pine (Pinus sylvestris L.) with moisture content of 21% and Norway spruce (Picea abies L. Karst) with moisture content of 10% wood samples from values of the contact angle. The wetting behavior of the wood samples was examined with the contact angle method (goniometer technique) in the Laboratory of the Department of Chemistry of Latvia University of Agriculture at the beginning of 2013. The aim of this study was to verify possibility of determining the contact angle values of the wood and calculate the surface free energy and its components of wood from the obtained contact angle values using acid-base theory. At the end of this study it was concluded that the acid–base approach is a suitable method to calculate surface free energy and its characteristics of wood from the values of the contact angle. Nevertheless, indirect methods of liquid drop contact angle value estimation must be used because direct determination is not feasible on wood surfaces with open capillaries.