Field trials were carried out at Jõgeva Plant Breeding Institute in 2008 – 2011 to identify the possibilities of using early red clover (Trifolium pratense L.) ‘Jõgeva 433’ (diploid), Washington lupine (Lupinus polyphyllus Lind.) ‘Lupi’ and crimson clover (Trifolium incarnatum L.) as green manure. Fresh material of the above species was ploughed into the soil in autumn of the sowing year. Fertilizer value was quantified through yield and grain quality of spring wheat ‘Vinjett’ and barley ‘Inari’. The composition and amount of ploughed biomass were recorded. By the time of ploughing, Washington lupine had produced the most abundant biomass. >From studied species crimson clover had the lowest fertilizer value – only by 6–7% extra yield of spring wheat in the following year. Crimson clover had no residual effect of fertilization in the second year. The fertilizer values of red clover and Washington lupine were approximately equal. Their effect on yield increase of spring wheat and barley lasted for three years, on grain quality for two years. Red clover, ploughed into the soil in the year of sowing, resulted in maximum spring wheat yield increase of 23.9%, compared with N 0 treatments; that of Washington lupine was 21.3%. The residual positive effect in the second year quantified as barley production increased by 6.2% in Washington lupine and 7.9% in red clover. The yield increase in the third year was 3.9% and 12.1%, respectively. Green manure increased the contents of crude protein and gluten in spring wheat and crude protein content in barley.

Theoretical and experimental investigations are carried out to estimating the impact of the plough body working width on its specific draft resistance, as well as the ploughing efficiency. By using analytical correlations derived as a result of theoretical research, a computer algorithm has been worked out for simulating the functions of the plough body and the forces exerted by soil upon the operating parts, as well as its draft resistance. Specific draft resistance of the plough body, energy consumption, as well as labour efficiency and ploughing costs depend considerably on the working width of the body. By increasing it, the energy capacity, specific fuel consumption and expenditure decrease, but labour efficiency increases.

Results of various studies show that the most prevailing risk factors on workers of agricultural sector are noise and vibration. These hazards are especially important in transportation and most field works. Results from previous studies show that vibro-acoustic environment in tractors operated in Lithuania usually cannot be attributed as acceptable, but technical solutions implemented by manufacturers had definitely positive influence on working conditions. Noise level reduced from 90 dB(A) (tractors of 1980 – 1990 years of manufacture) to 73 dB(A) (tractors manufactured from year 2000). As renewal of tractors is not sufficient, there is still a large number of old machinery i.e. noise levels might be as high as 92 dB(A) which allows to work safely only one hour per day without personal protection. It was found that values of whole body vibration (WBV) during ploughing operation might be as high as 1.5 m∙sE-2 which excess the vibration limit value of 1.15 m•sE-2, while hand-arm vibration (HAV) did not exceed the vibration action value of 2.5 m•sE-2. Significant effect of tyre pressure was noticed on vibration values measured on driver’s seat. Vibration acceleration values may be reduced to safe 0.5 m•s-2 by selecting appropriate tyre pressure.