Insoluble calcium content and rheological properties of Colby cheese during ripening
2010
Lee, M.R. | Johnson, M.E. | Govindasamy-Lucey, S. | Jaeggi, J.J. | Lucey, J.A.
Colby cheese was made using different manufacturing conditions (i.e., varying the lactose content of milk and pH values at critical steps in the cheesemaking process) to alter the extent of acid development and the insoluble and total Ca contents of cheese. Milk was concentrated by reverse osmosis (RO) to increase the lactose content. Extent of acid development was modified by using high (HPM) and low (LPM) pH values at coagulant addition, whey drainage, and curd milling. Total Ca content was determined by atomic absorption spectroscopy, and the insoluble (INSOL) Ca content of cheese was measured by the cheese juice method. The rheological and melting properties of cheese were measured by small amplitude oscillatory rheometry and UW-Melt Profiler, respectively. There was very little change in pH during ripening even in cheese made from milk with high lactose content. The initial (d 1) cheese pH was in the range of 4.9 to 5.1. The INSOL Ca content of cheese decreased during the first 4 wk of ripening. Cheeses made with the LPM had lower INSOL Ca content during ripening compared with cheese made with HPM. There was an increase in melt and maximum loss tangent values during ripening except for LPM cheeses made with RO-concentrated milk, as this cheese had pH <4.9 and exhibited limited melt. Curd washing reduced the levels of lactic acid produced during ripening and resulted in significantly higher INSOL Ca content. The use of curd washing for cheeses made from high lactose milk prevented a large pH decrease during ripening; high rennet and draining pH values also retained more buffering constituents (i.e., INSOL Ca phosphate), which helped prevent a large pH decrease.
Показать больше [+] Меньше [-]Ключевые слова АГРОВОК
Библиографическая информация
Эту запись предоставил National Agricultural Library
