Practical assessment of frictional heating effects and thermostat design on the performance of conventional (3μm and 5μm) columns in reversed-phase high-performance liquid chromatography
2009
Fallas, Morgane M. | Hadley, Mark R. | McCalley, David V.
A practical investigation of frictional heating effects in conventional C18 columns was undertaken, to investigate whether problems found for sub-2μm columns were also present for those of particle size 3μm and 5μm and different internal diameter. The influence of a water bath, a still air heater, and a forced air heater on performance was investigated. Heating effects were substantial, with a decrease in k of almost 15% for toluene over the flow rate range ~0.4-2.3mL/min with a 15cmx0.46cm ID column packed with 3μm particles. Heating effects on retention increased with increasing solute k, with increase in the column ID, with decrease in the column particle size, and with decrease in the set column oven temperature. While the water bath minimised axial temperature gradients and thus its effect on k, radial temperature gradients were potentially serious with this system, especially at high mobile phase velocity, even with columns containing 5μm particles. In contrast to the effects of axial temperature gradients in 4.6mm columns, very little difference in Van Deemter plots was noted between the three different thermostats with 2mm ID columns, even when 3μm particles were used. However, the efficiency of 2mm columns for peaks of low or moderate k (k <4) can be compromised by the extra dead volume introduced by the heating systems, even with conventional HPLC systems with otherwise minimised extra column volume.
Показать больше [+] Меньше [-]Ключевые слова АГРОВОК
Библиографическая информация
Эту запись предоставил National Agricultural Library