Ozone treatment of process water from a dry-mill ethanol plant
2008
Singh, Shilpi | Fan, Maohong | Brown, Robert C.
Fuel ethanol production in corn dry milling plants is a rapidly expanding industrial sector. Whole stillage, the residue from the distillation of the fermented corn, is centrifuged and the concentrate, thin stillage, is found to have a chemical oxygen demand (COD) of approximately 75,000mg/L. This thin stillage is partly recycled, but much of it needs to be evaporated to concentrate the solubles for addition to the animal feed coproduct from corn dry milling. This research is an exploration into lowering COD from thin stillage using ozonation as a simple single-step unit process to facilitate a larger reusable fraction. The ozonation would usually be a pretreatment before additional flocculation or biological treatment. Also, COD removal by ozonation with and without a catalyst has been studied. Three different application rates of ozone O₃,₁ =7mg/min, O₃,₂ =21mg/min, and O₃,₃ =33mg/min were used for 8h into samples of 2L each of three dilutions 20x, 30x and 40x. COD removal of 85% was observed with an ozone dosage of 4000mg/L into a 40x-diluted sample. This would correspond to about 0.5mg COD removed per mg ozone dosed. However, at lower dosages and smaller dilutions, more than 1mg COD removal was achieved per mg ozone dosed. Two different catalysts, Fe(II) and Fe(III), were used and the samples were ozonated for 4h. Five different dosages of each of the two catalysts were used and better COD removal was observed compared to ozonation alone with all 5 dosages. COD removal rate was increased from 45% to 74% with Fe(III) and was increased to 77% with Fe(II). Up to 10mg/L COD was removed per mg O₃ dosed well below the maximum dosage. Both the catalysts resulted in almost the same improved COD removal rates when compared to ozonation alone.
Показать больше [+] Меньше [-]Ключевые слова АГРОВОК
Библиографическая информация
Эту запись предоставил National Agricultural Library