Centrifugal mother liquid (CML) is one of the main sources of wastewater produced during the production of polyvinyl chloride in chlor-alkali industry. CML is a typical poorly biodegradable organic wastewater, containing many kinds of refractory pollutants. Specifically, it contains dissolved refractory polymers, especially polyvinyl alcohol (PVA), which can pass though the biotreatment processes and clog the membranes used for further treatment. In this study, to ensure the CML applicable to biotreatment and membrane treatment, a novel efficient and mild technique, air-Fenton treatment, was employed as a pretreatment technique to improve biodegradability of the CML and to break down the polymers in the CML. Firstly, the technique was optimized for the CML treatment by optimizing the main parameters, including the dosage of ferrous sulfate, initial pH of the wastewater, [H2O2]/[Fe(2+)], aeration rate, reaction time, and temperature, based on removal efficiency of COD and PVA from the CML. Then, the optimized technique was tested and evaluated. The results indicated that under the optimized conditions, the air-Fenton treatment could remove 66, 98, and 55 % of the COD, PVA, and TOC, respectively, from the CML. After the treatment, biodegradability of the wastewater increased significantly (BOD/COD increased from 0.31 to 0.68), and almost all of the PVA polymers were removed or broken down. Meanwhile, concentration of the remaining iron ions, which were added during the treatment, was also quite low (only 2.9 mg/L). Furthermore, most of the suspended materials and ammonia nitrogen, and some of the phosphorus in the wastewater were removed simultaneously.

This work evaluated surfactant-enhanced in situ chemical oxidation (S-ISCO) in a hydrocarbon-contaminated soil. Surfactants and efficacy of oxidant activation as well as the treatability of contaminated soil were assessed. The surfactant VeruSOL-3 with a critical micelle concentration (CMC) of 5.5 g/L was selected. Based on the results, activated oxidations by sodium persulphate and hydrogen peroxide were able to effectively destroy target organic compounds in emulsion and soil. The destruction of total petroleum hydrocarbon (TPH) in emulsion was completed in 14 days and polycyclic aromatic hydrocarbons (PAHs) in excess of 96 %. Green nanoiron was much more active than other activators in emulsion. The data also indicates that oxidation using activators was much less pronounced in soil matrices. However, it is expected that given sufficient dose and treatment time, a higher destruction rate in the contaminated soil can be achieved. The study showed that the remediation of target organic contaminants (TPH, PAH) in soil by S-ISCO using activated sodium persulphate is feasible. © 2013 Springer Science+Business Media Dordrecht.

Pressure gradients during uniform fluid flow in porous media are traditionally assumed to be linear. Thus, pressure loss across a sample of porous medium is assumed directly proportional to the thickness of the sample. In this study, measurements of pressure gradients inside coarse granular (2-18 mm particle size) porous media during steady gas flow were carried out. The results showed that pressure variation with distance in the porous media was nonlinear near the inlet (where pressure gradients were higher) but became linear at greater distances (with a lower gradient). This indicates that the pressure loss in porous media consists of two components: (1) a linear pressure gradient and (2) an initial pressure loss near the inlet. This initial pressure loss is also known from hydraulics in tubes as a minor loss and is associated with abrupt changes in the flow field such as narrowings and bends. The results further indicated that the minor loss depends on the particle size and particle size distribution in a manner similar to that of the linear pressure gradient. There is, thus, a close relation between these two components. In porous media, the minor loss is not instantaneous at the inlet point but happens over some distance starting upstream from the inlet and ending some distance downstream. © 2013 Springer Science+Business Media Dordrecht.

Zamioculcas zamiifolia has the potential to reduce the concentration of benzene, toluene, ethylbenzene, and xylene (BTEX) from contaminated indoor air. It can remove all four pollutant gases. Benzene, toluene, ethylbenzene, and xylene uptake per unit area of Z. zamiifolia leaf were about 0.96 ± 0.01, 0.93 ± 0.02, 0.92 ± 0.02, and 0.86 ± 0.07 mmol m -2 at 72 h of exposure, respectively. The physicochemical properties of each BTEX may affect its removal. Benzene, a smaller molecule, is taken up by plants faster than toluene, ethylbenzene, and xylene. The toxicity of BTEX on plant leaves and roots was not found. The chlorophyll fluorescence measurement (F v/F m) showed no significantly difference between controlled and treated plants, indicating that a concentration of 20 ppm of each gas is not high enough to affect the photosynthesis of the plants. The ratio of stomata and cuticles showed that 80 % of benzene, 76 % of toluene, 75 % of ethylbenzene, and 73 % of xylene were removed by stomata pathways, while 20, 23, 25, and 26 % of them were removed by cuticles. The BTEX removal efficiency by well-watered Z. zamiifolia was involved with day stomata opening and night closing, while the BTEX removal efficiency by water-stressed Z. zamiifolia can occur both day and night at a slightly lower rate than well-watered plants. © 2013 Springer Science+Business Media Dordrecht.

Accumulation of metals in aquatic organisms is influenced by several factors, including the presence of other metals; therefore, there is a need to study the effects of mixtures of other metals on the accumulation of a particular metal on the organisms. In this study, the capacity for nickel (Ni) regulation by the juvenile decapod crustacean Penaeus vannamei was analyzed. The effects of both solely Ni exposure and in the presence of other metals such as zinc (Zn), lead (Pb), and cadmium (Cd) in a mixture were analyzed to determine any possible synergism. A previous study revealed that a metal mixture of Zn, Cd, and Pb without Ni induces a higher metal uptake in P. vannamei for all three metals, but in this study, no effect was observed for Ni. The results showed no change in the regulatory capacitance for Ni, even in the presence of other metals. The observed capacity of P. vannamei to regulate body concentrations of nickel prevents its use as a suitable biomonitor for this metal.

Direct ultrafiltration and its combination with pretreatment by coagulation/flocculation/sedimentation using Moringa oleifera as coagulant to treat dairy industry wastewater were investigated. A single-channel tubular ceramic membrane with an average porosity of 0.1 μm was used at transmembrane pressures of 1, 2, and 3 bars, using the cross-flow filtration principle in a membrane filtration unit. Process efficiency was evaluated in terms of chemical oxygen demand (COD), apparent color, and turbidity removal, along with major requirements such as average permeate flux, percentage of fouling, and contribution of different resistances (resistances in series model) to the total resistance of the membrane. The highest removals for the evaluated parameters occurred in the combined coagulation/flocculation/sedimentation/ultrafiltration process. At a pressure of 2 bar, the removal of turbidity and apparent color was 99.9 % and that of COD was 98.5 %. For the combined process, the lowest percentage of fouling was 59.8 %, which occurred at 1 bar. The fraction of resistance due to fouling, which may indicate irreversible damage of the membrane, was lower in the process of coagulation/flocculation/sedimentation using M. oleifera as coagulant followed by ultrafiltration than in the process that treated dairy wastewater with direct ultrafiltration for all pressures. © 2013 Springer Science+Business Media Dordrecht.

Average and 75 % biochemical oxygen demand (BOD) in the Yamato-gawa River, Japan, in 1963 were smaller than the criteria determined in 1970 (5 mg l⁻¹); however, they were deteriorated up to 22–32 mg l⁻¹ in 1970. The deterioration was caused by the population increase and economic and urban development. The national-level regulations on ambient water quality and pollutant discharge have been established in 1970. Municipal wastewater is the major contributor in pollutant discharges in the river basin. Estimated BOD discharge (PD(BOD)) in the river basin reduced to the level of 1963 in 2000; however, average and 75 % BOD were more than the criteria. Analysis on the relationship between BOD and PD(BOD) resulted in the five phases in 1963–2009. The equilibrium conditions changed from phase I to II because of the perturbation caused by the excess BOD discharge, self-correcting mechanisms were found in phase III, and equilibrium conditions changed from phase III to IV and V. The comparison of estimated BOD based on pollutant generation (PG) without measures and monitored BOD represented the following situations in 47 years: (1) It took several years before the effects of centralised WWTPs were observed, (2) PD(BOD) was less than 35 t-BOD day⁻¹ for the linear relationship of PD(BOD) and BOD, and (3) combined effects of wastewater treatment, river water purification facilities and soft measures were estimated to be about 10 mg-BOD l⁻¹ in 2010.

Soil contamination by crude oil is a major environmental and health hazard. Extraction of the total petroleum hydrocarbons (TPH) sorbed to the clay soil (kaolin) was carried out using synthetic sorbent (Desmopan®) and 2-propanol as a mobilizing agent. The crude oil-loaded polymer beads were bioregenerated in a solid–liquid two-phase partitioning bioreactor (TPPB). A central composite design under response surface methodology was employed for the experimental design and analysis of the results. The independent variables were extraction phase to soil ratio, mobilizing agent to soil ratio, and initial concentration of crude oil in polluted soil. The influences of three independent variables on the TPH reduction efficiency were determined using a statistically significant quadratic model (R ² = 0.9673). Remediation was more efficient when the mobilizing agent to the soil ratio was equal to 3.00 ml g⁻¹, compared to the higher (4.00 ml g⁻¹) and lower (2.00 ml g⁻¹) levels. The results exhibited that the interaction between the extraction phase ratio and the initial concentration of crude oil in kaolin had significantly influenced the TPH removal. The bioregeneration studies showed a significant reduction (72.07 ± 0.63 %) of low-molecular-weight (two- to three-ring) polycyclic aromatic hydrocarbons and n-alkanes (97.75 ± 0.26 %) present in the crude oil-loaded solid polymers within a 10-day experiment. These findings show that solid polymer extraction followed by bioregeneration of sorbents in a TPPB is applicable to treat crude oil-contaminated kaolin.

Lanthanum/aluminum-modified zeolite adsorbent (La/Al-ZA) was prepared and investigated for their ability to remove phosphorus from wastewater. Various batch adsorption conditions, e.g., pH, ionic strength, temperature, contact time, initial phosphorus concentration, and the dosage of adsorbent were tested. The results showed that the adsorption amount increased with the increase of temperature, contact time, and initial phosphorus concentration and decreased with the increase of adsorbent dosage and initial anion concentration. The adsorption amount first increased with increasing pH from 2.0 to 4.0 and reached a plateau over the pH range from 4.0 to 8.0, then significantly decreased from 8.0 to 12.0, and the suitable adsorption was achieved with the pH range 4–9. The phosphorus removal efficiency decreased slightly from 95.86 to 93.39 and 92.53 %, respectively, in the presence of Cl⁻ and SO₄²⁻ at the lower concentration of 0.1 mmol/L, while they decreased significantly from 95.86 % to the ranges of 85.02–88.80 % and 83.77–87.45 %, respectively, in the presence of Cl⁻ and SO₄²⁻ at higher concentrations ranging from 0.5 to 2.0 mmol/L, and the effects on adsorption of La/Al-ZA follow the order: Cl⁻ > SO₄²⁻. Phosphorus adsorption matched with both Langmuir and Freundlich isotherms. The results presented here supported the potential use of the new La/Al-ZA as a material for the treatment of phosphorus in wastewater.

Rapid expansion of natural gas drilling in Sublette County, WY (1999-present), has raised concerns about the potential ecological effects of enhanced atmospheric nitrogen (N) deposition to the Wind River Range (WRR) including the Class I Bridger Wilderness. We sampled annual throughfall (TF) N deposition and lichen thalli N concentrations under forest canopies in four different drainages of the WRR. Measurements of TF N deposition and N concentrations in lichen thalli were highest at plots closest to drilling operations (<30 km). N concentrations in lichens decreased exponentially with distance from drilling activity. Highest TF N deposition, 4.1 kg ha -1 year-1, coincided with clear evidence of damage to lichen thalli. This deposition value is above estimated preindustrial deposition conditions (0.9 kg N ha-1 year-1) and regional critical loads (a deposition value below which ecosystem harm is prevented) of N deposition for sensitive ecosystem components. N concentrations in Usnea lapponica were strongly correlated (r = 0.96) with TF N deposition, demonstrating that elemental analysis of lichen material can be used to estimate TF N deposition. N concentrations below 1.35 % in U. lapponica and 1.12 % in Letharia vulpina were associated with estimated background conditions of 0.9 kg N ha-1 year-1. Additional lichen sampling in the Bridger Wilderness is recommended to further quantify and monitor spatial patterns of N deposition and to define areas of elevated N deposition. © 2013 Springer Science+Business Media Dordrecht (outside the USA).