It has been hypothesised that, if ingested, plastic debris could act as vector for the transfer of chemical contaminants from seawater to organisms, yet modelling suggest that, in the natural environment, chemical transfer would be negligible compared to other routes of uptake. However, to date, the models have not incorporated consideration of the role of gut surfactants, or the influence of pH or temperature on desorption, whilst experimental work has shown that these factors can enhance desorption of sorbed contaminants several fold. Here, we modelled the transfer of sorbed organic contaminants dichlorodiphenyltrichloroethane (DDT), phenanthrene (Phe) and bis-2-ethylhexyl phthalate (DEHP) from microscopic particles of polyvinylchloride (PVC) and polyethylene (PE) to a benthic invertebrate, a fish and a seabird using a one-compartment model OMEGA (Optimal Modelling for EcotoxicoloGical Applications) with different conditions of pH, temperature and gut surfactants. Environmental concentrations of contaminants at the bottom and the top of published ranges were considered, in combination with ingestion of either 1 or 5% by weight of plastic. For all organisms, the combined intake from food and water was the main route of exposure for Phe, DEHP and DDT with a negligible input from plastic. For the benthic invertebrate, predictions including the presence of contaminated plastic resulted in very small increases in the internal concentrations of DDT and DEHP, while the net change in the transfer of Phe was negligible. While there may be scenarios in which the presence of plastic makes a more important contribution, our modelling study suggests that ingestion of microplastic does not provide a quantitatively important additional pathway for the transfer of adsorbed chemicals from seawater to biota via the gut.

Oxidative potential (OP) of particulate matter (PM) − defined as the capacity of PM to oxidize target molecules generating reactive oxygen species (ROS) − has been proposed as a more health relevant metric than PM mass. In this study two cell-free methods were used to assess the OP of PM filters collected at an urban site and to evaluate correlation with PM mass and PM composition.Among the different assays existing, two inexpensive and user-friendly methods were used both based on spectrophotometric measurements of depletion rate of target reagents oxidized by redox-active species present in PM. One assay measures the consumption of dithiothreitol (OPDTT) and the other the ascorbate (OPAA).Although both assays respond to the same redox-active species, i.e., quinones and transition metals, no correlations were found between OPDTT and OPAA responses to compounds standard solutions as well as to ambient samples. When expressed in relation to air volume, OPDTT m−3 strongly correlates with PM2.5 mass whereas no correlation was found for OPAA m−3 with PM2.5. When expressed on mass basis, both OPDTT μg−1 and OPAA μg−1 show a strong dependence on the sample composition, with higher OP for summer samples. OPDTT m−3 were highly correlated with the determined metals (Cu, Zn, Cr, Fe, Ni, Mn) whereas OPAA m−3 showed only moderate correlation with Cu and Mn.Thus, the two assays could potentially provide complementary information on oxidative potential characteristic of PM. Consequently, the combination of the two approaches can strengthen each other in giving insight into the contribution of chemical composition to oxidative properties of PM, which can subsequently be used to study health effects.

Modified clay-based solid-phase phosphorous (P) sorbents are increasingly used as lake geoengineering materials for lake eutrophication control. However, some still dispute the feasibility of using these materials to control internal P loading from shallow eutrophic lakes. The lack of information about P behavior while undergoing frequent sediment resuspension greatly inhibits the modified minerals’ use. In this study, a sediment resuspension generating system was used to simulate the effect of both moderate winds (5.1 m/s) and strong winds (8.7 m/s) on the stability of sediment treated by two geoengineering materials, Phoslock® (a lanthanum modified bentonite) and thermally-treated calcium-rich attapulgite. This study also presents an analysis of the P dynamics across the sediment-water interface of two shallow eutrophic lakes. In addition, the effect of wind velocity on P forms and P supply from the treated sediment were studied using chemical extraction and diffusive gradients in thin films (DGT) technique, respectively. Results showed that adding geoengineering materials can enhance the stability of surface sediment and reduce the erosion depth caused by wind accordingly. All treatments can effectively reduce soluble reactive phosphorus (SRP) concentration in overlying water when sediment is capped with thermally-treated calcium-rich attapulgite, which performs better than sediment mixed with modified attapulgite but not as well as sediment treated with Phoslock®. However, their efficiency decreased with the increase in occurrences of sediment resuspension. The addition of the selected geoengineering materials effectively reduced the P fluxes across sediment-water interface and lowered P supply ability from the treated sediment during sediment resuspension. The reduction of mobile P and enhancement of calcium bound P and residual P fraction in the treated sediment was beneficial to the long-term lake internal P loading management. All of the results indicated that the studied geoengineering materials are suitable for application in shallow eutrophic lakes with frequent sediment resuspension activity.

Offshore oil and gas activities can result in the discharge of large amounts of drilling muds. While these materials have generally been regarded as non-toxic to marine organisms, recent studies have demonstrated negative impacts to suspension feeding organisms. We exposed the arctic-boreal sponge Geodia barretti to the primary particulate components of two water-based drilling muds; barite and bentonite. Sponges were exposed to barite, bentonite and a natural reference sediment at a range of total suspended solid concentrations (TSS = 0, 10, 50 or 100 mg/L) for 12 h after which we measured a suite of biomarker responses (lysosomal membrane stability, lipid peroxidation and glutathione). In addition, we compared biomarker responses, organic energy content and metal accumulation in sponges, which had been continuously or intermittently exposed to suspended barite and natural sediment for 14 d at relevant concentrations (10 and 30 mg TSS/L). Lysosomal membrane stability was reduced in the sponges exposed to barite at 50 and 100 mg TSS/L after just 12 h and at 30 mg TSS/L for both continuous and intermittent exposures over 14 d. Evidence of compromised cellular viability was accompanied by barite analysis revealing concentrations of Cu and Pb well above reference sediments and Norwegian sediment quality guidelines. Metal bioaccumulation in sponge tissues was low and the total organic energy content (determined by the elemental composition of organic tissue) was not affected. Intermittent exposures to barite resulted in less toxicity than continuous exposure to barite. Short term exposures to bentonite did not alter any biomarker responses. This is the first time that these biomarkers have been used to indicate contaminant exposure in an arctic-boreal sponge. Our results illustrate the potential toxicity of barite and the importance of assessments that reflect the ways in which these contaminants are delivered under environmentally realistic conditions.

Many heavy metals in sediments and water have potential adverse effects on aquatic organisms such as Corbicula fluminea (O.F. Müller, 1774), a bivalve species frequently used as a biomonitor for metal pollution. Studies over the past decades examining the heavy metal uptake by C. fluminea, very few has investigated the effect of hydrodynamic conditions on accumulation of heavy metal by C. fluminea. Therefore, in this study, to investigate the mechanism of intracellular and extracellular accumulation of metal, individuals of C. fluminea were exposed to cadmium (Cd)-treated water under three different hydrodynamic conditions. These included exposures in two set ups: three rates of rotation (500, 350, 200 r/min) in beakers for 10 days, and then exposure to Cd-treated sediment under two naturally turbulent water conditions (14 cm/s and 3.2 cm/s) in experimental flumes for 23 days. Hydrodynamic force increased the burrowing rate but decreased the activity of C. fluminea. After 10 days of exposure, the extracellular concentrations of Cd in the tissues of C. fluminea in the sand group were significantly higher than that in the gravel groups. The intracellular and extracellular concentrations of Cd in the tissues of C. fluminea dramatically increased in the Cd-treated sediment test. Moreover, the concentration of the extracellular Cd adsorbed on the tissues of C. fluminea in the 14 cm/s and 3.2 cm/s groups was significantly higher than that in the control group, whereas the effect of hydrodynamic force on absorption of Cd by C. fluminea was not obvious. These results suggest that hydrodynamic condition plays an important role in extracellular accumulation of Cd by C. fluminea. In future study, when using C. fluminea to assess Cd pollution in aquatic environment, extracellular Cd adsorbed on the tissue should be removed to avoid the influence of hydrodynamics.

Fullerenes are carbon based nanoparticles that may enter the environment as a consequence of both natural processes and human activities. Although little is known about the presence of these chemicals in the environment, recent studies suggested that soil may act as a sink. The aim of the present work was to investigate the presence of fullerenes in soils collected in The Netherlands. Samples (n = 91) were taken from 6 locations and analyzed using a new developed LC-QTOF-MS method. The locations included highly trafficked and industrialized as well as urban and natural areas. In general, C60 was the most abundant fullerene found in the environment, detected in almost a half of the samples and at concentrations in the range of ng/kg. Other fullerenes such as C70 and an unknown structure containing a C60 cage were detected to a lower extent. The highest concentrations were found in the proximity of combustion sites such as a coal power plant and an incinerator, suggesting that the nanoparticles were unintentionally produced during combustions processes and reached the soil through atmospheric deposition. Consistent with other recent studies, these results show that fullerenes are widely present in the environment and that the main route for their entrance may be due to human activities. These data will be helpful in the understanding of the distribution of fullerenes in the environment and for the study of their behavior and fate in soil.

Unmanned aerial vehicles (UAVs) offer new opportunities to monitor pollution and provide valuable information to support remediation. Their low-cost, ease of use, and rapid deployment capability make them ideal for environmental emergency response. Here we present a UAV-based study of the third largest coal ash spill in the United States. Coal ash from coal combustion is a toxic industrial waste material present worldwide. Typically stored in settling ponds in close proximity to waterways, coal ash poses significant risk to the environment and drinking water supplies from both chronic contamination of surface and ground water and catastrophic pond failure. We sought to provide an independent estimate of the volume of coal ash and contaminated water lost during the rupture of the primary coal ash pond at the Dan River Steam Station in Eden, NC, USA and to demonstrate the feasibility of using UAVs to rapidly respond to and measure the volume of spills from ponds or containers that are open to the air. Using structure-from-motion (SfM) imagery analysis techniques, we reconstructed the 3D structure of the pond bottom after the spill, used historical imagery to estimate the pre-spill waterline, and calculated the volume of material lost. We estimated a loss of 66,245 ± 5678 m3 of ash and contaminated water. The technique used here allows rapid response to environmental emergencies and quantification of their impacts at low cost, and these capabilities will make UAVs a central tool in environmental planning, monitoring, and disaster response.

Proteomics technology is an attractive biomarker candidate discovery tool that can be applied to study large sets of biological molecules. To identify novel biomarkers and molecular targets in arsenic-induced skin lesions, we have determined the protein profile of arsenic-affected human epidermal stratum corneum by shotgun proteomics. Samples of palm and foot sole from healthy subjects were analyzed, demonstrating similar protein patterns in palm and sole. Samples were collected from the palms of subjects with arsenic keratosis (lesional and adjacent non-lesional samples) and arsenic-exposed subjects without lesions (normal). Samples from non-exposed healthy individuals served as controls. We found that three proteins in arsenic-exposed lesional epidermis were consistently distinguishably expressed from the unaffected epidermis. One of these proteins, the cadherin-like transmembrane glycoprotein, desmoglein 1 (DSG1) was suppressed. Down-regulation of DSG1 may lead to reduced cell-cell adhesion, resulting in abnormal epidermal differentiation. The expression of keratin 6c (KRT6C) and fatty acid binding protein 5 (FABP5) were significantly increased. FABP5 is an intracellular lipid chaperone that plays an essential role in fatty acid metabolism in human skin. This raises a possibility that overexpression of FABP5 may affect the proliferation or differentiation of keratinocytes by altering lipid metabolism. KRT6C is a constituent of the cytoskeleton that maintains epidermal integrity and cohesion. Abnormal expression of KRT6C may affect its structural role in the epidermis. Our findings suggest an important approach for future studies of arsenic-mediated toxicity and skin cancer, where certain proteins may represent useful biomarkers of early diagnoses in high-risk populations and hopefully new treatment targets. Further studies are required to understand the biological role of these markers in skin pathogenesis from arsenic exposure.

In comparison with marine environments, the occurrence of microplastics in freshwater environments is less understood. In the present study, we investigated microplastic pollution levels during 2015 in Taihu Lake, the third largest Chinese lake located in one of the most developed areas of China. The abundance of microplastics reached 0.01 × 106–6.8 × 106 items/km2 in plankton net samples, 3.4–25.8 items/L in surface water, 11.0–234.6 items/kg dw in sediments and 0.2–12.5 items/g ww in Asian clams (Corbicula fluminea). The average abundance of microplastics was the highest in plankton net samples from the southeast area of the lake and in the sediments from the northwest area of the lake. The northwest area of the lake was the most heavily contaminated area of the lake, as indicated by chlorophyll-α and total phosphorus. The microplastics were dominated by fiber, 100–1000 μm in size and cellophane in composition. To our best knowledge, the microplastic levels measured in plankton net samples collected from Taihu Lake were the highest found in freshwater lakes worldwide. The ratio of the microplastics in clams to each sediment sample ranged from 38 to 3810 and was negatively correlated to the microplastic level in sediments. In brief, our results strongly suggest that high levels of microplastics occurred not only in water but also in organisms in Taihu Lake.

The urban environment holds numerous emission sources for air and noise pollution, creating optimum conditions for environmental multi-exposure situations. Evaluation of the joint-exposure levels is the main obstacle for multi-exposure studies and one of the biggest challenges of the next decade. The present study aims to describe the noise/NO2 multi-exposure situations in the urban environment by exploring the possible discordant and concordant situations of both exposures. Fine-scale diffusion models were developed in the European medium-sized city of Besançon (France), and a classification method was used to evaluate the multi-exposure situations in the façade perimeter of 10,825 buildings. Although correlated (Pearson's r = 0.64, p < 0.01), urban spatial distributions of the noise and NO2 around buildings do not overlap, and 30% of the buildings were considered to be discordant in terms of the noise and NO2 exposure levels. This discrepancy is spatially structured and associated with variables describing the building's environment. Our results support the presence of several co-existing, multi-exposure situations across the city impacted by both the urban morphology and the emission and diffusion/propagation phases of each pollutant. Identifying the mechanisms of discrepancy and convergence of multi-exposure situations could help improve the health risk assessment and public health.