This study aims to assess the pollution of honey by heavy metals based on the efforts of an urbanization gradient in the city of Annaba (Northeast Algeria) where the dosage of five heavy metals (Fe, Cr, Ni, Cu, Cd) was carried out in four sites.The level of heavy metals was determined by atomic absorption spectrophotometer. The results obtained indicated that even when all the samples were contaminated they were of good quality since the concentrations did not exceed the international standards.According to the results of heavy metal concentrations in the honeys studied, the most abundant element is Fe with an average concentration of 6.956 ± 2.045 (mg/kg), Cr 0.765 ± 0.197 (mg/kg), Ni 0.6005 ± 0.159 (mg/kg), Cu 0.21025 ± 0.065 (mg/kg) and Cd 0.01425 ± 0.005 (mg/kg).The heavy metals studied are present in all samples but trace amounts. Moreover, the comparison of the honey from the four sites indicates to us that the healthiest honey is that of the urban site.

Increasing the pollution rate of water sources is one of the most severe issues that the world faces. This issue has stimulated researchers to investigate different treatment methods such as adsorption, chemical precipitation, membrane filtration, flocculation, ion exchange, flotation, and electrochemical methods. Among them, adsorption has gained broad interest due to its ease of operation, low cost, and high efficiency. The critical factor of the successful adsorption treatment process is finding attractive adsorbents with attractive criteria such as low cost and high adsorption capacity. In the last few decades, nanotechnology has attracted much attention, and numerous nanomaterials have been synthesized for water and wastewater treatment. This work provides a quick overview of nanomaterials, which have been investigated for water remediation as adsorbent and photocatalyst. This work reviewed more than 100 articles to provide a critical review that would determine the limitation of using nanomaterials in water treatment at the commercial scale.

The current research study the comprehensive health and environmental hazard levels of Particulate matters originating from natural radionuclides sources collected from different Qassim region locations, Saudi Arabia. Activity concentration for 226Ra, 232Th, and 40K was assessed using a Sodium Iodide detector. Gamma-ray parameters as the Radium equivalent, Gamma level index, absorbed dose, annual effective dose, and lifetime risk were measured to predict the growth of radiological dangers. The average activity concentration for 226Ra, 232Th, and 40K is 35±0.06, 32.6±0.4, and 294.99±1.31 Bq/kg. Ra(eq) ranges from38.3 to 143.1 with an average of 104.37 Bq/kg, absorbed dose ranges from 18 to 66.49 with an average of 48.18 nGy/h, and annual effective dose ranges from 22.09 to 81.58 with an average of 59.11 μSv/y. The relative contribution was 26%, 33%, and 41% for 40K, 226Ra, and 232Th, respectively. The obtained results do not cause apprehensions from the radiation population compatible with permissible public limits. The obtained database helps the investigators follow the future pollution exchange due to Scientific progress in the use of radioactive materials.

The effect of ceramic filter composition on improving the quality of produced water by reducing total dissolved solids (TDS), barium, and phenol for reverse osmosis (RO) treatment was investigated in the present work. The ceramic filters were fabricated using a residue catalytic cracking (RCC) unit spent catalyst with and without activation, clay, and Dioscorea hispida starch (DHS), at various compositions.  The result showed that the optimum removal of TDS, barium, and phenol in produced water was achieved at a flow rate of sample 7 L/min and an operating time of 90 min. Ceramic filter with the composition of 60% spent catalyst without activation: 37.5% clay: 2.5% DHS reduced 34.84% TDS, 27.97% barium, and 71.11% phenol. While, the ceramic filter with a composition of 37.5% activated spent catalyst: 60% clay: 2.5% DHS was removed 51.44% TDS, 27.93% barium, and 85.29% phenol from produced water. The next steps of treatment of filtrates of the ceramic filter using reverse osmosis (RO) membrane showed that the permeate met the Indonesian standard for oil and gas wastewater. In addition, adsorption of TDS, barium, and phenol from produced water was dominated by clay composition in the ceramic filter.

A mathematical model is presented to simulate the photocatalytic degradation of terbuthylazine in a continuous stirred tank reactor. The flow field is described by the continuity equation and the momentum equation. An advection-diffusion-reaction equation is used to simulate the transport of terbuthylazine.  The chemical reactions take place on the inner wall surface coated with the catalyst, which is described by a third-kind boundary condition.  A transient differential equation is used to describe the variation of inlet concentration with time. All governing equations are solved using the commercial computational fluid software ANSYS Fluent. The simulation results agree with the experimental data at different temperatures and different flow rates. The radial distribution of terbuthylazine in the reactor is discussed in detail. The velocity depicts a parabolic curve with a maximum velocity of  0.0005 m s-1, 0.001 m s-1, 0.00022 m s-1 and 0.0032 m s-1 for 50 mL min-1, 100 mL min-1, 200 mL min-1, and 300 mL min-1, respectively. At the flow rate of 300 mL min-1, concentration of terbuthylazine decreases from 3.6 mg dm-3 to 0.8 mg dm-3 whereas concentration of cyanuric acid increases from 0.05 mg dm-3 to 0.28 mg dm-3. It shows that the radial effect of velocity and concentration should be taken into account. The mathematical model used in this study is suitable for simulating the photocatalytic degradation process of terbuthylazine in continuous stirred tank reactors.

The soil of many places of eastern India contains high amount of arsenic, due to several geogenic activities in this area. In the specific regions of the country where there is no such type of Geogenic activities, the soil is found to be almost free of arsenic. In such places where there are industries, the soil is being contaminated with the arsenic due to anthropogenic activities. One of such site which was selected for the study was in close vicinity to the textile industries in Jaipur, Rajasthan, India discharging their effluents having 423 µg/g arsenic. While the soil sample collected from the far eastern part of Tezpur Assam, India, contaminated by Geogenic sources contained 443µg/g arsenic. Four arsenite resistant bacterial strains were isolated from each of the samples. Strains SE-3 and TB-1 isolated from Jaipur and Tezpur, respectively showed highest minimum inhibitory concentration of 46.5mM and 38.7mM sodium arsenite. Based on 16S rDNA sequencing and nucleotide homology and Phylogenetics analysis strain, SE-3 was identified as Pseudomonas sp. SE-3 (accession no. KP730605) and TB-1 as Bacterium TB-1 (accession no KP866680). Complete oxidation of arsenite to less toxic form arsenate was observed in Pseudomonas sp. SE-3, while 64.6% by Bacterium TB-1. The arsenite oxidation was supported on the molecular level by confirming the presence of aox gene by PCR amplification. The enzyme activity of arsenite oxidase was also established. Arsenic hyper tolerant bacteria isolated from these soils having arsenite oxidizing ability show a promising way for the bioremediation of arsenic in contaminated soil.

This work investigates the possibility of using constructed wetland system for the management of municipal wastewaters with reuse strategies for the irrigation of landscapes in Ouled Djellal city of Biskra, Algeria. The design of this system was based on the characteristics (volume and physico-chemical properties) of wastewaters and the urban plan of the studied city. Results showed that studied effluent is easily biodegradable with COD/BOD5 of  1.84 (< 3), BOD5 (325 - 365 mg/L), COD (620-644 mg/L) and TSS (120-250mg/l). The peak of raw wastewater flow was found to be 32.4 m3 /h, which was used for the calculation of drip network for the landscape irrigation. The selected variant for the configuration of the CW system is HF-VF-HF, which occupies an area of 11.580 m2 and will reduce significantly the water pollution. The treated wastewater will be reused for the irrigation of landscapes via the dimensioned drip network. Results of this study showed that the proposed design for the system (treatment and reuse) would be effective in reducing pollution in the urban environment by ensuring possibility of the reuse of the treated water for irrigation. This gives also a great opportunity for using this strategy in small neighborhoods in other cities.

This article is devoted to the study of the impact of the development of the Lomonosov diamond deposit on the pollution of watercourses with trace metals. The high water cut of the exposed rock strata and the presence of groundwater require the constant pumping of wastewater into the filtration fields, and then to the nearby river. This work shows a significant contribution of discharge processes and drainage waters to the trace metal contents in the surface waters of the Zolotitsa river; an increase in the concentrations of Mg, Sr, Zn, Cu, Cd, As , and Se was noted. The seasonal variations of physicochemical parameters, the trace metal contents, as well as the total uranium and U isotope 234U, 238U, and 235U were analysed. Calculations of water quality indices (HMEI, HMPI, and HMTL) and public health risks (HI and CR) revealed a high level of pollution of certain sections of watercourses. Radiological studies of polluted rivers in the area showed a satisfactory situation. The results of this study can provide a basis for the subsequent monitoring of the impact of anthropogenic activities on nearby watercourses in the development of diamond deposits.

In recent times, the brick kiln contributes to air pollution is one of the most emerging issues worldwide. In this research work, the Peshawar city, ambient air quality was measured, using a fixed air monitoring station to evaluate the impact of gaseous emission from brick kilns on ground level. In this study, the portable gas analyzer (PG-250) was used to quantify brick-based emitting carbon monoxide (CO), sulfur dioxide (SO2) and nitrogen oxide (NOx) from 3 brick kilns in the city of Peshawar. It was noticed that the average concentration of SO2 and NOx exceeds the National Environmental Quality Standards (NEQS) of Pakistan specifically, in terms of air quality. The brick kilns in District Peshawar have shown negative effects on the environment. It is necessary to take various measures to monitor the brick kiln embosom regularly before it becomes a significant risk for individuals. In conclusion, the impact of air pollution on physical activity and sedentary behavior at a specific time may be different.

In this research, the capability of vermiculite in arsenic extraction, associated with characterizing its main properties was evaluated. To address this purpose, vermiculite was artificially contaminated with arsenic at 7 and 28-day intervals. Then, arsenic was extracted from contaminated soils by different extractants. Various physical and mechanical tests were performed to investigate the effect of arsenic as an anionic contaminant on the properties of the vermiculite, as well as to evaluate how the properties of the contaminated soil were altered by the extraction process. The carbonate bonding phase was probably mainly responsible for the adsorption and fixation of arsenic with more than 50% portion among measured fractions at different curing times. Based on the vermiculite condition, hydrochloric acid was the best extractant for removing arsenic in all studied samples (around 3 -18 % more than other extractants). The clay soil demonstrated few changes due to arsenic contamination and modification. In general, the most promising characteristics of vermiculite as clay liner are its stability after contamination due to high CEC and SSA; however, its workability and strength (UCS between 110 to 220 kPa at different soil conditions) is a challenge and must be improved by adding coarser fractions like silt particles. In general, the results of this study regarding the effects of arsenic contamination and extraction onto vermiculite’s physical properties can provide appropriate information for researchers and geo-environmental engineers.