Biogas production from organic wastes is gaining popularity, especially in agriculture, which produces high quantities of organic wastes suitable for anaerobic digestion. Digestate is the valuable by-product of the biogas production that is considered as a valuable fertilizer. The objectives of the experiment conducted from 2012 to 2013 at the Estonian University of Life Sciences were to compare the impact of biogas digestate, undigested (raw) cattle slurry, and inorganic nitrogen fertilizer on grass yield and to assess the fertilizer value of digestate produced from different feedstock. Fertilizers were applied to the grassland rich in low grasses by broadcasting in quantities according to the nitrogen rate of 180 kg haE-1 in three split applications. The application rate of organic fertilizers was calculated based on NH4 -N content. Grassland yield was determined on four treatments: (i) control (no fertilizer was applied), (ii) mineral N-fertilizer (NH4 NO3), (iii) cattle slurry and (iv) cattle slurry digestate. Grass yield was measured three times during the growing period. Our research showed that digestate when applied based on its NH4 -N content is effective fertilizer in grassland. It could be used as a substitute for mineral-N fertilizer, but its efficiency is slightly lower when compared to cattle slurry, due to its lower application amount resulting in lower nutrient and organic matter amount applied to the grassland. Co-digestion of cattle slurry with solid manure, hay and silage does not decrease digestate fertilizer value in grassland, because the addition of other substrate increases digestate DM content.

One of most important traits in dairy farming is cow (Bos primigenius taurus) longevity. In last few years the length of productive life in Latvian dairy cow population significantly decreased. Cow longevity depends on a large amount of genetic and non-genetic factors. Data from 1037 excluded Latvian brown (LB) breed cows were included in the analysis. Cows were born in the period from the year 2002 to 2006 and a farm size was 9 – 163 cows per farm. Farms were dislocated in all main regions of Latvia. Average life length of cows excluded from the herd was 2463.0 days in small farms, 2234.6 days in medium size farms and 2089.5 days in large farms. Cows’ productivity in one life day in small farms was 5.9 kg energy corrected milk (ECM), in medium size farms 6.2 kg ECM and in large farms 6.5 kg ECM. Large farm cows had longer life length in days (p is less than 0.05), but higher productivity in one productive day (p is less than 0.05) and productivity in one life day.

The present study was undertaken to estimate enzymatically hydrolysed and non–hydrolysed wheat (Triticum aestivum) and rye (Secale cereale) bran microflora. Enzymatic hydrolysis was accomplished by α – amylase from Bacillus amyloliquefaciens and by Viscozyme L which contain a wide range of enzymes responsible for the breakdown of carbohydrates into simple sugars. Wheat and rye bran samples were collected from native mills, namely Stock Company (SC) ‘Rigas dzirnavnieks’ wheat bran with large particle size (WLSR), SC ‘Jelgavas dzirnavas’ rye bran with small particle size (RSSJ), SC ‘Dobeles dzirnavnieks’ wheat bran with small particle size (WSSD) and wheat bran with large particle size (WLSD). Gained results indicate that before enzymatic hydrolysis all of the bran samples showed similar microbiological contamination with total plate count (TPC), yeasts and lactic acid bacteria. Enzymatic hydrolysis of bran gives the possibility to partially eliminate the microbiological contamination with TPC, yeasts and lactic acid bacteria. The amount of microorganisms after enzymatic hydrolysis (before storage) were decreased and ranged from 5.26 ± 0.04 to 5.45 ± 0.01 log CFU gE-1, from 4.81 ± 0.01 to 5.60 ± 0.05 log CFU gE-1, and from 4.09 ± 0.01 to 5.10 ± 0.05 log CFU gE-1, respectively. After eight weeks of storage (temperature – 20 ± 1 °C, relative humidity – 40 ± 1%) enumeration of microorganisms showed significant decrease of colony–forming units in all bran samples. The amount of TPC, yeasts and lactic acid bacteria in the control bran samples fluctuated in a range from 4.84 ± 0.04 to 5.49 ± 0.05 log CFU gE-1, from 4.86 ± 0.03 to 5.25 ± 0.03 log CFU g-1, 3.53 ± 0.03 to 4.21 ± 0.02 log CFU gE-1 respectively.

The purpose of the current research was to investigate the total protein content and amino acid composition of flour blend made from several types of whole grain flour for pasta production. Conventional rye, hull-less barley, triticale and wheat grain was used in the experiments. For the flour blend obtaining white wheat flour type 550 was used. Using standard methods the following quality parameters were analysed: protein content in grain and flour samples by using InfratecTM model 1241 Grain Analyzer, in flour blend – by AACC 46–20, amino acid content by LVS ISO 13903:2005. In the present research it was determined that it is possible to increase the total protein content in wheat flour type 550 by 11% if adding whole wheat or whole triticale flour, and by 7% if adding whole grain flour of hull-less barley. Higher total amino acid content was obtained for whole wheat flour sample; lower – for whole rye flour sample. Significantly lower total amino acid content was obtained in whole rye, hull-less barley and triticale flour comparing with whole grain wheat flour. No significant differences (p=0.779) were found in the analysed essential amino acid content made of different flour blend – the content of essential amino acids in the analysed flour blend samples was very similar.

A lot of different EU directives and regulations set the targets to decrease greenhouse gas emissions, to increase the share of renewable energy, and to improve energy efficiency. Biofuel usage is directly linked to all of these problems. Since the first generation food-based biofuels should not receive public support after 2020, investigations of next generation biofuels are topical. Hydrotreated vegetable oil (HVO) is one of the most promising next generation biofuels in the near future. This article deals with the results of mathematical modelling to determine the main diesel engine operating parameters (power, torque and fuel consumption) running them on HVO and its blends with fossil diesel fuel. The modelling results of the car Opel Insignia 2.0 CDTi show that every 5% of HVO in fuel blend reduces maximum power and torque of around 0.38% while raising specific fuel consumption by volume of around 0.10%. Analyzing the most realistic scenario in the near future – 7% HVO and 93% fossil diesel blend, the predicted fuel consumption increase (0.14%) and power and torque decrease (0.54%) is inconsiderable for vehicle exploitation, and HVO seems to be a promising biofuel to replace biodiesel in fuel blends and to promote reaching the EU targets.

This experimental study assesses the influence of ignition timing on emissions from a production four cylinder port injection spark ignition engine. The aim of this research was to evaluate the necessity of ignition timing correction when the regular gasoline vehicle is being adapted for the use of E85 fuel. Tests were conducted in the Alternative Fuels Research Laboratory of Latvia University of Agriculture in December 2013. The engine was fuelled with the ethanol-gasoline blend E85 or the commercial gasoline A95. The engine was tested within a vehicle in a chassis dynamometer in steady state conditions, which resemble driving at 50 km hE-1 and 90 km hE-1. The original engine control unit was replaced with a programmable one. Engine-out and tailpipe exhaust gas samples were taken and analysed with a FTIR-type analyser AVL SESAM. Carbon monoxide (CO), unburned hydrocarbons (HC), nitrogen oxides (NOx), acetaldehyde and unburned ethanol emission volumetric share is presented. CO, HC and acetaldehyde emissions were not affected by variation of the ignition timing within the tested range. NOx and ethanol emissions were reduced with the ignition timing retard. The emissions of CO, HC and NOx were reduced, when the engine was fuelled with the E85 fuel, comparing with the gasoline use. Ignition timing, optimized for the gasoline, was found suitable for the E85 fuel from the emission analyses point.

The paper covers spatial analysis of the Measure “Afforestation of agricultural and other than agricultural lands” implemented in Poland within the framework of the Rural Development Programme 2007 – 2013 (RDP 2007 – 2013). Beneficiaries obtained payments for afforestation based on the commitments made during the programming perspective of 2004 – 2006 or they joined the programme during the perspective of 2007 – 2013. Data obtained from the Department for Direct Payments of the Ministry of Agriculture and Rural Development as of 31 December 2012 formed the base of the analysis. Payments made in the country to the beneficiaries considering their activity and absorption of funds within the framework of the measure are presented. Next, given the disbursements made in voivodships and counties of Poland, the activity of beneficiaries was indicated and average disbursements per beneficiary were determined. The analysis aims at investigating the consistency of the afforestation policy implemented in Poland as of 2004 and showing the role of afforestation projects implemented within the RDP framework. The aim of the article is to show spatial changes in the intensity and dynamics of agricultural land afforestation projects implemented within the framework of the RDP 2007 – 2013 considering natural conditions. The afforestation rate and the ownership structure of the forestland in Poland is diverse. Afforestation allows and rationally manages agricultural land, which is of little use for agricultural production. The utilization of EU funds supporting afforestation of agricultural land in Poland is characterized by spatial variability.

An important factor in the development of forest ecosystem is the ability to regenerate. Natural intensity of self thinning of a forest depends on the tree species and environmental conditions. Due to abiotic and biotic factors in a continuous forest tract, there appears a clearing, which, depending on the size, forms new growth conditions. Over time, the resulting new space is occupied by herbaceous and woody vegetation. Most often regeneration of a new forest depends on the size of the plot. The study was conducted in 2013 during the growing season in a typical broadleaf forest stand. During the study woody vegetation and projection coverage of herbaceous vegetation was registered in large clearings. Light conditions in the plots and under tree canopies, as well as soil parameters were ascertained. Based on the collected data, the view of the structure of woody vegetation, projection coverage of herbaceous vegetation, light conditions, temperature, soil moisture content and pH changes were obtained. In order to clarify the influence of microclimatic conditions on natural forest regeneration, the data on light and soil characteristics were analyzed. The aim of the study - was to determine the changes of woody and herbaceous vegetation in spruce stand clearings and to assess the impact of microclimate. During the study it was found out that in large plots dominated species demanding higher amount of light, while herbaceous vegetation was attributed to the third, fourth groups of aggressiveness. Naturally regenerated seedlings condition was mostly influenced by light conditions and soil moisture content.

This brief review of the recent birch studies is focused on different aspects, such as species distribution, growing conditions, species identification, changes due to environmental factors. All mentioned investigations were carried out in Lithuania. This analytical study summarises the results and increases knowledge dissemination to the international audience. When reviewed and summarized considerable part of relevant literature sources, we realised new problems and challenges; for example, aiming to clarify the peculiarities of the growth and crown condition of the dominant birch species (Betula pendula Roth. and B. pubescens Ehrh.) under the changing climate and anthropogenic pollution.

The aim of the study is to ascertain how different compositions of stand species affect the work of the harvester in commercial thinning under Latvia’s conditions. The data of the harvester – time-tracking files (*.drf) have been used as a basis for the study, where productivity is expressed as the prepared amount of round timber in cubic meters in a unit of time – an hour (m**3 hE-1). The data were collected from 100 commercial thinning areas which were divided into three types depending on the composition of the species: pure pine stands, pure spruce stands and deciduous tree mixed stands (mixed with coniferous trees). All the data for the study were collected in the forests managed by JSC ‘Latvia`s State Forests’. By summarizing the data, it has been established that in pure pine stands the average volume of the stem to be removed is 0.092 m**3, in mixed stands – 0.085 m**3 and in pure spruce stands - 0.068 m**3. The research demonstrates that the harvester showed its highest productivity while working in pure pine stands – 3.96 m**3 hE-1, the second best result was achieved in the mixed stands – 3.67 m**3 hE-1, but the lowest rate was demonstrated in pure spruce stands – 3.09 m**3 hE-1. Significant differences were observed in the productivity of the harvester between pure pine and pure spruce stands. Comparing the calculations of standard deviations in the harvester productivity, it can be seen that they are the biggest in mixed stands, while the lowest rate is demonstrated in pure spruce stands.