Bulk density of a sandy loam: traffic, tillage, and irrigation-method effects.
1992
Meek B.D. | Rechel E.R. | Carter L.M. | DeTar W.R.
Modern crop production creates a cycle between soil compaction caused by traffic and alleviation of this condition by tillage or natural processes such as freezing and thawing. The objective of this study was to evaluate important management practices as they relate to changes in bulk density of a tilled sandy loam soil. Practices evaluated were irrigation method, time between tillage and traffic, tire pressure and wheel load of applied traffic, and controlled traffic. Relationships among bulk density, penetration resistance, and infiltration rate were determined. Experiments were conducted in the San Joaquin Valley of California, on a sandy loam soil (Entisol) with an organic-matter content of < 1%. After tillage, settling and trafficking of a soil resulted in rapid changes in its bulk density until a new equilibrium was reached. Tire pressure of 408 kPa and wheel weight of 2724 kg applied at moisture contents near field capacity resulted in a bulk density of 1.92 Mg m-3, compared with a value of 1.67 for no traffic. The time interval between tillage and traffic did not affect final bulk density. Drip irrigation, which did not saturate the soil, resulted in a bulk density of approximately 0.1 Mg m-3 lower than flood irrigation, which saturated the soil surface. Wheel traffic in the furrow resulted in only small changes in the bulk density within the row. When tillage did not occur between cropping seasons, traffic caused high bulk densities in the furrow but only small changes in the row. An increase in bulk density from 1.7 to 1.89 Mg m-3 decreased the infiltration rate by four times and increased resistance to penetration at the end of the season by three times. Knowledge of how management practices affect bulk density can aid growers in reducing recompaction following tillage.
显示更多 [+] 显示较少 [-]