Evaluation of UV-C Radiation Efficiency in the Decontamination of Inanimate Surfaces and Personal Protective Equipment Contaminated with Phage ϕ6

To help halt the global spread of the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2), appropriate disinfection techniques are required. Over the last years, the interest in Ultraviolet-C (UV-C) radiation as a method to disinfect inanimate surfaces and personal protective equipment (PPE) has increased, mainly to efficiently disinfect and prevent SARS-CoV-2 from spreading and allow for the safe reuse of said equipment. The bacteriophage &#981:6 (or simply phage &#981:6) is an RNA virus with a phospholipid envelope and is commonly used in environmental studies as a surrogate for human RNA-enveloped viruses, including SARS-CoV-2. The present study investigated the use of two new UV irradiation systems ((2)2.4W and (8)5.5W)) constituted by conventional mercury UV-C lamps with a strong emission peak at ~254 nm to potentially inactivate phage &#981:6 on different surfaces (glass, plastic, stainless steel, and wood) and personal protective equipment, PPE, (surgical and filtering facepiece 2, FFP2, masks, a clear acetate visor, and disposable protective clothing). The results showed that both UV-C systems were effective in inactivating phage &#981:6, but the UV-C sterilizing chamber (8)5.5W had the best disinfection performance on the tested surfaces. The inactivation effectiveness is material-dependent on all surfaces, reaching the detection limit of the method at different times (between 60 and 240 s of irradiation). The glass surface needed less time to reduce the virus (30 s) when compared with plastic, stainless, and wood surfaces (60 s). The virus inactivation was more effective in the disposable surgical and FFP2 masks (60 and 120 s, respectively) than in the disposable vest and clear acetate visor (240 s). Overall, this study suggests that UV-C lamps with peak emission at ~254 nm could provide rapid, efficient, and sustainable sanitization procedures to different materials and surfaces. However, dosage and irradiation time are important parameters to be considered during their implementation as a tool in the fight against human coronaviruses, namely against SARS-CoV-2.