Real-time analysis of volatile organic compounds (VOCs) in air is useful both for source identification and emissions compliance applications. In this work, two complementary triple quadrupole mass spectrometers, fitted with an atmospheric pressure chemical ionization (APCI) and a low pressure chemical ionization (LPCI) source, respectively, were deployed simultaneously to investigate emissions of VOCs associated with an Ontario-based chemical waste disposal facility. Mobile measurements performed upwind and downwind of the facility enabled selection of the best locations for stationary sampling. Seven separate field studies were undertaken between 2000 and 2016 to assess how emissions of VOCs have changed at the site as a function of time. Up to twenty-nine VOCs were successfully identified and quantified using MS/MS in each study. Simultaneous deployment of the two mass spectrometers enabled the detection of polar VOCs including alcohols, esters, amines and ketones as well as non-polar aromatic VOCs including benzene and naphthalene in real time. Concentrations of VOCs were found to decrease significantly in the vicinity of the facility over the sixteen year period, in particular since 2007. Concentration values for each year are compared with odour thresholds and provincial guidelines and implications of future expansion of on-site solid waste landfill volumes are also discussed.

Pesticides guarantee us high productivity in agriculture, but the long-term costs have proved too high. Acute and chronic intoxication of humans and animals, contamination of soil, water and food are the consequences of the current demand and sales of these products. In addition, pesticides such as glyphosate are sold in commercial formulations which have inert ingredients, substances with unknown composition and proportion. Facing this scenario, toxicological studies that investigate the interaction between the active principle and the inert ingredients are necessary. The following work proposed comparative toxicology studies between glyphosate and its commercial formulation using the alternative model Caenorhabditis elegans. Worms were exposed to different concentrations of the active ingredient (glyphosate in monoisopropylamine salt) and its commercial formulation. Reproductive capacity was evaluated through brood size, morphological analysis of oocytes and through the MD701 strain (bcIs39), which allows the visualization of germ cells in apoptosis. In addition, the metal composition in the commercial formulation was analyzed by ICP-MS. Only the commercial formulation of glyphosate showed significant negative effects on brood size, body length, oocyte size, and the number of apoptotic cells. Metal analysis showed the presence of Hg, Fe, Mn, Cu, Zn, As, Cd and Pb in the commercial formulation, which did not cause reprotoxicity at the concentrations found. However, metals can bioaccumulate in soil and water and cause environmental impacts. Finally, we demonstrated that the addition of inert ingredients increased the toxic profile of the active ingredient glyphosate in C. elegans, which reinforces the need of components description in the product labels.

Glyphosate-based herbicides include active matter and adjuvants (e.g. polyethoxylated tallow amines, POEAs). In addition to a previous investigation on the effect of glyphosate on oysters, the aim of the present study was to investigate the effects of sub-chronic exposures (35days) to three concentrations (0.1, 1 and 100μgL−1) of Roundup Express® (REX) and POEAs on oysters belonging to the same age group. Low mortality rates were calculated, and only few significant differences (i.e. shell length) between exposure conditions were observed at a given date. However, when comparing the biomarker's temporal variations, some different patterns (e.g. condition index, reproduction, parameters of oxidative stress) were observed depending on the molecules and concentrations. These results suggest that a longer exposure to an environmental concentration (0.1μgL−1) of REX and POEAs could induce harmful effects on oysters.

A field operable surface enhanced Raman scattering (SERS) sensor system was applied for the first time under real conditions for the detection of polycyclic aromatic hydrocarbons (PAHs) as markers for petroleum hydrocarbons in the Gulf of Gdańsk (Baltic Sea). At six stations, seawater samples were taken, and the sensor system was applied in situ simultaneously. These measurements were compared to the results of conventional GC/MS laboratory analysis of the PAH concentrations in the seawater samples. For a PAH concentration above 150ng(12PAH)l⁻¹, there was agreement between the SERS sensor and the GC/MS determinations. A standard addition experiment yielded a PAH concentration of 900ngl⁻¹ at the Gdańsk Harbor, which was of the same order as the GC/MS determinations of 12PAHs (200ng(12PAH)l⁻¹). The high SERS detection limit for seawater samples is explained by the competition for PAHs between the sensor membrane and particulate matter surfaces. Thus, the SERS sensor can be applied, e.g., as a non-quantitative alarm sensor for relatively high PAH concentrations in heavily polluted waters. The spectral unmixing procedure applied for Gdańsk Harbor water confirmed the presence of phenanthrene at the highest concentration ([Phe]=140ngl⁻¹) and of Chr (2.7ngl⁻¹), but it did not detect the other PAHs present in the Gdańsk Harbor water, as determined by GC/MS. When compared to the past literature and databases, the SERS spectra indicated the presence of a mixture of molecules consisting of carotenoids, n-alkanes, amines or fatty acids, and benzimidazoles at the coastal station ZN2. The spectra in the offshore direction indicated carboxylic acids. Interpretation of the farthest offshore in situ SERS measurements is difficult, principally due to the limited availability of reference spectra. The detection of the lower PAH concentrations commonly found in Baltic coastal water needs further research and development to obtain better sensitivity of the SERS sensor. However, the high analytical specificity of the SERS sensor also allows the detection of other chemical species that require the development of a SERS/Raman library for specific in situ spectral interpretation.

Chloramination of drinking water and wastewater can generate carcinogenic nitrosamines, among which, nitrosodipropylamine (NDPA) with large molecular weight and weak polarity has been commonly found. However, knowledge on the formation of NDPA remains highly limited. Laboratory tests were conducted to quantify NDPA formation during chloramination of nitrogenous precursors, including dipropylamine and methyldipropylamine, and pesticides such as trifluralin, oryzalin, and vernolat. Results showed that all precursors exhibited > 10.0% NDPA yields after 24 h. Oryzalin and trifluralin accomplished the highest (13.63%) and lowest (11.31%) yield, respectively. Maximal yields of all precursors were observed at pH 9.0 and temperature 288 K. Maximums of NDPA yield from oryzalin (18.27%) and vernolat (19.54%) were formed at Cl:N of 0.7:1.0, but maximal yields of dipropylamine (18.44%), methyldipropylamine (22.98%), and trifluralin (33.06%) were achieved at Cl:N of 1.2:1.0. Maximal NDPA yields of dipropylamine (37.14%), methyldipropylamine (32.84%), and vernolat (49.02%) were observed at [NH₂Cl]₀:[precursor]₀ = 500, but highest yields of trifluralin (30.24%) and oryzalin (25.53%) were accomplished at [NH₂Cl]₀:[precursor]₀ = 50. Bromide and organic contents in tap and raw water reduced NDPA due to competition for NH₂Cl. Chloramination of water impacted by amines and pesticides should be careful of NDPA formation.

This study investigates pentachlorophenol (PCP) adsorption by the white-rot fungus Anthracophyllum discolor in a fixed-bed column reactor. PCP adsorption at different concentrations (20, 30, and 50 mg L−1) and pH values (5.0, 5.5, and 6.0) was determined and modeled using the Thomas model. Fourier transform infrared spectroscopy (FTIR) was used to identify functional groups of biomass that may participate in the interaction of PCP. The biosorption capacity of A. discolor was pH-dependent, and the PCP adsorbed increased with the decrease in the pH solution. Acid pH values of the influent gave an increase in saturation time in all PCP concentrations. By contrast, the increase in PCP concentration caused that the binding sites were filled quickly, resulting in a decrease in saturation time. The Thomas model was found suitable for describing the entire dynamic of the column with respect to the PCP concentration and pH of the solution. FTIR results showed that amines, carboxylates, alkanes, and C–O groups might participate in the PCP adsorption on the biomass surface. It was concluded that A. discolor biomass was a good adsorbent for PCP removal from influent with mainly acidic pH.

A directly amine-functionalized mesoporous silica (AMS) was prepared via an anionic surfactant-mediated synthesis method and used as adsorbents for deep removal of Cu ions from aqueous solution at room temperature. The synthesized AMS had been characterized by X-ray diffraction, nitrogen physisorption measurement, and thermogravimetric analysis. The amine groups prefer to position to the surface of AMS material due to the SN ∼ I mechanism. Copper adsorption process had been studied from both kinetic and equilibrium points of view for AMS material. Experiments proved that the aqueous Cu adsorption rates were fast and adsorption capacity was about 53.3 mg/g.

Quantitative structural activity relationship (QSAR) models are receiving wide use because of new regulations and public scrutiny regarding new compounds entered into commerce. Accordingly, the US Department of Defense (DoD) supported this study to evaluate QSAR modeling for energetic compounds. Four compounds proposed to replace ammonium perchlorate were examined: ammonium di(nitramido)amine (ADNA); 1,3,5,5-tetranitrohexahydropyrimidine (DNNC); 1,3,3,5,7,7-hexanitro-1,5-diazacyclooctane (HCO); and diammonium di(nitramido)dinitroethylene (ADNDNE). Currently used compounds were evaluated as analogues for those under development. Ammonium dinitramide (ADN) was the analogue for ADNA; hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) for DNNC; octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine (HMX) for HCO; and 1,1-diamino-2,2-dinitroethene (FOX-7) for ADNDNE. QSAR analysis was performed with the US Environmental Protection Agency's Estimation Program Interface (EPI) Suite[trade mark sign]. The comparison of model estimates to literature values ranged from good-to-poor. Results suggested the proposed replacement compounds have low aquatic toxicities and little potential to bioaccummulate, but the uncertainty in the predictions indicates QSAR modeling with EPI Suite[trade mark sign] is only useful for qualitative assessments of these proposed energetic compounds.

There are several possible methods by which amine groups can be grafted on the surface of activated carbon (AC) to improve their capacity for CO2 adsorption. Ethylenediamine and diethylenetriamine were selected as amino compounds for anchoring on the surface of an oxidized AC. Oxidation of AC was carried out by concentrated nitric acid. For each amino compound, two “in-solvent” and “solvent-free” methods with a number of grafting times were studied. Nitrogen adsorption–desorption at 77 K and proximate and ultimate analysis were used to determine physical and chemical characteristics of the samples. Temperature-programmed (TP) CO2 adsorption test from 30°C to 120°C were performed to investigate the effect of modification on CO2 capture. The modification clearly had a negative effect on the textural characteristics of the samples, so the samples showed a less CO2 uptake at lower temperatures. However, the decrease of capture capacity with increasing temperature is to somewhat softer for amine-grafted samples, so that they have a capacity comparable to the parent sample or even more than that at elevated temperatures. This property may give the new adsorbents this opportunity to be used at flue gas temperature with a higher efficiency. CO2 capture capacity per unit surface area of all the amine-modified samples, however, was significantly improved, compared to the parent sample presenting a great influence of amino groups on the CO2 capture capacity. Moreover, the used amine compounds and grafting methods were compared in terms of adsorbent characteristics and CO2 uptake curves. Cyclic adsorption–desorption tests showed a satisfactory regeneration for the modified samples.