The present study has been undertaken in a laboratory scale to characterize and investigate pollution potential of textile effluents from DEPZ area in Dhaka, Bangladesh. Collected effluent samples from five different industries were analyzed for physico-chemical parameters using field kits and Standard Methods, and for metals using Flame Atomic Absorption Spectrophotometer (FAAS). The average physico-chemical parameters such as temperature, color, pH, DO, EC, BOD, COD, TS, total alkalinity and total hardness were found 52.4 ºC, 2646 PCU, 9.788, 1.492 mg/L, 7473.2 μS/cm, 157 mg/L, 508.8 mg/L, 9140.8 mg/L, 761.2 mg/L and 189.6 mg/L, respectively. The average concentrations of metal found in the textile effluents were in the order of Na (4611.762 mg/L) > Ca (9.166 mg/L) > Mg (3.578 mg/L) > Zn (0.113 mg/L) > Ni (0.0074 mg/L) > Cu (0.0032 mg/L). All the measured physico-chemical parameter values are negatively deviated but metal concentrations (except Na) are positively deviated from standard limits of wastewater discharge set by Department of Environment and US Environmental Protection Agency. In view of those characteristics, the textile industry effluents should be considered to be treated by setting eco-friendly effluent treatment plant (ETP) before directly discharging into the water bodies.

The aim of this study was to identify primary flow paths involved in the chlordecone (CLD) river contamination and quantify the CLD fluxes to assess CLD pollution levels and duration according to a typical catchment of the banana cropping area in the French Indies (Guadeloupe): the Perou Catchment (12 km(2)) characterized by heavy rainfall (5686 mm year(-1)). Three sub-catchments (SC1, SC2 and SC3) were studied during the hydrological year 2009-2010: a pedological survey combined with a spatialized hydrochemical approach was conducted. The average soil concentration is higher in the Perou Catchment (3400 mu g kg(-1)) than in the entire banana cropping area in Guadeloupe (2100 mu g kg(-1)). The results showed that CLD stocks in soils vary largely among soil types and farming systems: the weakest stocks are located upstream in SC1 (5 kg ha(-1)), where a majority of the area is non-cultivated; medium stocks are located in Nitisols downstream in SC3 (9 kg ha(-1)); and the greatest stocks are observed in SC2 on Andosols (12 kg ha(-1)) characterized by large farms. The annual water balance and the hydro-chemical analysis revealed that the three sub-catchments exhibited different behaviors. Perou River contamination was high during low flows, which highlighted that contamination primarily originated from groundwater contributions. The results showed that only a small part of the catchment (SC2), contributing little to the water flow, comprises a major CLD contribution, which is in agreement with the highly contaminated andosol soils observed there. Another significant result considers that at least 50 years would be required to export the totality of the actual CLD soil stocks retained in the topsoil layer. The actual time for soil remediation will however be much longer considering (i) the necessary time for the chlordecone to percolate and be stored in the shallow aquifers and (ii) its travel time to reach the river.rights reserved.

peer reviewed | The northern fulmar Fulmarus glacialis ingests a larger number of (micro)plastics than many other seabirds due to its feeding habits and gut morphology. Since 2002, they are bioindicators of marine plastics in the North Sea region, and data are needed to extend the programme to other parts of their distribution areas, such as the Arctic. In this study, we provide data on ingested plastics by fulmars collected in 1997 in Kongsfjorden, Svalbard. An extraction protocol with KOH was used and for half of the birds, the gizzard and the proventricular contents were analysed separately. Ninety-one percent of the birds had ingested at least one piece of plastic with an average of 10.3 (±11.9 SD) pieces. The gizzards contained significantly more plastics than the proventriculus. Hard fragments and polyethylene were the most common characteristics. Twelve percent of the birds exceeded the EcoQO value of 0.1 g.

peer reviewed | Microplastic contamination is an emerging issue in the marine environment including the Arctic. However, the occurrence of microplastics in the Arctic fjords remains less understood. Sample collections were conducted by trawling horizontally in surface water (0-0.4-m depth) and trawling vertically in the water column (0-200-m depth) to investigate the abundance, composition, and distribution of microplastics in the Rijpfjorden, Northern Svalbard, in the summer of 2017. Laser Direct Infrared chemical imaging technique was applied for the counting and identification of microplastic particles. A total of 1010 microplastic particles and 14 mesoplastics were identified from 41,038 particles in eight samples from the Rijpfjorden. The abundance of microplastics larger than 300 µm was 0.15 ± 0.19 n/m3 in surface water, and 0.15 ± 0.03 n/m3 in the water column of the Rijpfjorden. The microplastic particles identified in Rijpfjorden water consisted of 10 types of polymers. The dominant microplastics are polyurethane, polyethylene, polyvinyl acetate, polystyrene, polypropylene, and alkyd varnish. Historical ship activities and newly melted sea ice might be major sources of microplastics in the seawater of Rijpfjorden. In general, contamination of microplastics larger than 300 µm in Rijpfjorden water is at a low level in comparison to other polar waters. Further research is needed to confirm the origin and fate of microplastics below 300 µm in Arctic fjords.

In this study, a novel in situ sampling method was utilized to investigate the concentrations of trace metals and Pb isotope compositions among different particle size fractions in soil dust, bulk surface soil, and corresponding road dust samples collected within an urban environment. The aim of the current study was to evaluate the feasibility of using soil dust samples to determine trace metal contamination and potential risks in urban areas in comparison with related bulk surface soil and road dust. The results of total metal loadings and Pb isotope ratios revealed that soil dust is more sensitive than bulk surface soil to anthropogenic contamination in urban areas. The new in situ method is effective at collecting different particle size fractions of soil dust from the surface of urban soils, and that soil dust is a critical indicator of anthropogenic contamination and potential human exposure in urban settings.

Passive steady-state chlorophyll fluorescence (Fs) provides a direct diagnosis of the functional status of vegetation photosynthesis. With the prospect of mapping Fs using remote sensing techniques, field measurements are mandatory to understand to which extent Fs allows detecting plant stress in different environments. Trees of four common species in Valencia were classified in either a low or a high local traffic exposure class based on their leaf magnetic value. Upward and downward hyperspectral fluorescence yield (FY) and indices based on the two Fs peaks (at 687 and 741 nm) were calculated. FY indices of P. canariensis and P. x acerifolia were significantly different between the two traffic exposure classes defined, but not for C. australis nor M. alba. While chlorophyll content could not indicate the difference between low and high traffic exposure, the FY(687)/FY(741) peak ratio increased significantly (p < 0.05) for both leaf sides for the higher traffic exposure class.

This study assessed concentrations and investigated potential source regions for PCBs, PBDEs, and organochlorine pesticides in Acadia National Park, Maine, USA. Back-trajectories and potential source contribution function (PSCF) values were used to map potential source areas for total-PCBs, BDE-47, and 10 organochlorine pesticides. The constructed PSCF maps showed that ANP receives high pollutant concentrations in air masses that travel along four main pathways: (1) from the SW along the eastern Atlantic seaboard, (2) from the WSW over St. Louis, and Columbus regions, (3) from the west over Chicago, and Toronto regions, and (4) from WNW to NNW over the Great Lakes, and Quebec regions. Transport of all studied pollutants were equally distributed between the first three pathways, with only minor contributions from the last pathway. This study concludes that the high-pollutant concentrations arriving at ANP do not exclusively originate from the major urban centers along the eastern Atlantic seaboard.

We examined the consequences of the spatial heterogeneity of atmospheric ammonia (NH3) by measuring and modelling NH3 concentrations and deposition at 25 m grid resolution for a rural landscape containing intensive poultry farming, agricultural grassland, woodland and moorland. The emission pattern gave rise to a high spatial variability of modelled mean annual NH3 concentrations and dry deposition. Largest impacts were predicted for woodland patches located within the agricultural area, while larger moorland areas were at low risk, due to atmospheric dispersion, prevailing wind direction and low NH3 background. These high resolution spatial details are lost in national scale estimates at 1 km resolution due to less detailed emission input maps. The results demonstrate how the spatial arrangement of sources and sinks is critical to defining the NH3 risk to semi-natural ecosystems. These spatial relationships provide the foundation for local spatial planning approaches to reduce environmental impacts of atmospheric NH3.

We hypothesized that the photosynthetic performance of mangrove stands restored by the single planting of mangroves species would be lowered due to residual stressors. The photosynthetic parameters of the vegetation of three planted mangrove stands, each with a different disturbance history, were compared to reference sites and correlated with edaphic environmental variables. A permutational analysis of variance showed significant interaction when the factors were compared, indicating that the photosynthetic parameters of the restoration areas differed from the reference sites. A univariate analysis of variance showed that all the photosynthetic parameters differed between sites and treatments, except for photosynthetic efficiency (αETR). The combination of environmental variables that best explained the variations observed in the photosynthetic performance indicators were Cu, Pb and elevation disruptions. Fluorescence techniques proved efficient in revealing important physiological differences, representing a powerful tool for rapid analysis of the effectiveness of initiatives aimed at restoring coastal environments.

More than 2300 sediment pore water distribution coefficients (KPCBi ds) of 93 polychlorinated biphenyls (PCBs) were measured and modeled from sediments from Indiana Harbor and Ship Canal. KPCBi ds were calculated from previously reported bulk sediment values and newly analyzed pore water. PCBs in pore waters were measured using SPME PDMS-fiber and ∑PCB ranged from 41 to 1500 ng L−1. The resulting KPCBi ds were ∼1 log unit lower in comparison to other reported values. A simple model for the KPCBi d consisted of the product of the organic carbon fraction and the octanol–water partition coefficient and provided an excellent prediction for the measured values, with a mean square error of 0.09 ± 0.06. Although black carbon content is very high in these sediments and was expected to play an important role in the distribution of PCBs, no improvement was obtained when a two-carbon model was used.