In this research, gasoline vapours including Benzene, Toluene, Xylene (BTX) and Total Volatile Organic Compounds (TVOCs) emitted from vent pipes of underground storage tanks (USTs) were measured at six gas stations in Tehran. Thereafter, gas station No. 29 was selected as a pilot station and equipped with a vapour control system. The vapours were measured during the summer of 2013 and winter of 2014 in two states, before and at the time of gasoline discharge from a petrol tanker to the UST. The results reveal that the average of BTX and TVOCs are 161.22, 200.81, 229 and 647.01 ppm, respectively, higher than the World Health Organisation (WHO) guidelines. The average of TVOCs and BTX in the situation in which the control system is inactive at the pilot station, are 259.13, 55.9, 73.03 and 96.88 ppm, respectively. After activating the control system at the pilot station, the VOCs were reduced by 0.01 ppm. Almost 99.99% control was obtained for this system and 87% of the people living around the pilot station were satisfied and no longer had any complaints about the bad odour of VOCs. It can be concluded that gasoline discharge from the petrol tanker to UST, is the main reason behind the overproduction of VOCs in Tehran's gas stations (P<0.001). So, the most important element is to reduce VOCs at Tehran's gas stations by installing a vapour control systems in all the stations and activating the systems at the time of gasoline discharge.

Ozone(O3), and its precursors, Benzene (C6H6), Nitrogen Dioxide(NO2), Carbon Monoxide (CO) and meteorological parameters Temperature, Relative Humidity and Wind Speed were measured in urban air of two sites of significant spatial variations, Delhi Milk Scheme (DMS), Sadipur and Netaji Subhash Chander Institute of Technology(NSIT) Dwarka, during 2017–2018. Samples collected by Central Pollution Control Board (CPCB) has been analysed. The concentrations of Benzene, Nitrogen dioxide and Carbon monoxide were found to be more at DMS than NSIT site in winter season (11.137±3.258, 5.540±1.441, 55.333±12.741, 44.667±10.066μg/m3, 1.433±0.058, 1.033±0.287mg/m3 respectively) and summer season (3.167±1.222, 2.233±0.929, 50.333±2.082, 31.333±6.658μg/m3, 0.743±0.151, 0.443±0.051mg/m3 respectively) while Ozone was found to be more at NSIT than DMS site (40.333±3.215, 34.433±2.503μg/m3 respectively). The maximum concentrations of Benzene for the DMS and NSIT sites, respectively, were 32.4μg/m3 and 17.7μg/m3 and was observed in the month of November while minimum were 1.0μg/m3 and 0.6μg/m3 and was observed in the month of June. For Ozone, the maximum concentrations for the DMS and NSIT sites, respectively, were 100μg/m3 and 101μg/m3 and was observed in the month of June while minimum were 33.0μg/m3 and 28.0μg/m3 and was observed in the month of February and December respectively. Regression analyses were performed to correlate O3 concentrations with C6H6, NO2 and CO in order to infer their possible sources. The study reveals that there is significant correlation of O3 with C6H6 (r2=0.475) and CO (r2=0.985) in summer at DMS and with C6H6 (r2=0.902) &amp; NO2(r2=0.728) in winter at NSIT. The correlation of O3, C6H6, NO2 and CO with Temperature, Relative Humidity and Wind Speed has also been investigated to understand their influence on these pollutants.

The resource intensive human activities (such as mining and extraction of mineral oils for betterment of life and modernization of society) have increased environmental pollution several folds. Products of mining and petrochemical industries are advantageous for the modern society. But waste generated such as BTEX from such industries are carcinogenic, toxic and causes adverse effects on environment and human health. These wastes are classified as hazardous waste which cannot be used further. Pollution of soil-water interface due to the release of hydrocarbons in environment is a major public health concern, and therefore, remediation of these pollutants is needed to reduce risk to human and environment. Various methods such as biological, chemical and physical method are used to degrade these pollutants from wastewater. In the present works photochemical degradation of toluene and benzene in wastewater are studied using activated Carbon−TiO2 composites as catalysts in the presence of UV irradiation in photochemical reactor. Composites are prepared by sol-gel method and further characterized by X-ray diffractometry (XRD), scanning electron microscope (SEM) and Fourier transformed-Infrared spectroscopy (FT-IR). The Photocatalytic efficiencies of the synthesized composites were determined by the mineralization of toluene and benzene under UV irradiation in photochemical reactor.

A waste-oil contaminated site situated near a river is supposed to be cleaned-up by means of different but complementary methods. On the basis of a research project, target values have been developed in close cooperation between the participant parties for the saturated and the unsaturated soil layers. The clean-up targets are introduced and discussed.

Benzene, toluene, ethylbenzene, xylenes, naphthalene and n-hexane evaporating from a thin oil film was measured for 30 min in a small-scale test system at 2 and 13 °C and the impact of physicochemical properties on airborne benzene with time after bulk oil release was studied. Linear mixed-effects models for airborne benzene in three time periods; first 5, first 15 and last 15 min of sampling, indicated that benzene content in fresh oil, oil group (condensate/light crude oil) and pour point were significant determinants explaining 63–73% of the total variance in the outcome variables. Oils with a high pour point evaporated considerably slower than oils with a low pour point. The mean air concentration of total volatile organic compounds was significatly higher at 13 °C (735 ppm) compared to 2 °C (386 ppm) immediately after release of oil, but at both temperatures the concentration rapidly declined. | acceptedVersion

Inhalation is the most frequent route and the lung is the primary damaged organ for human exposure to benzene, toluene, ethylbenzene, xylene, and styrene (BTEXS). However, there is limited information on the risk and dose-effect of the BTEXS mixture on pulmonary function, particularly the overall effect. We conducted a cross-sectional study in a petrochemical plant in southern China. Spirometry and cumulative exposure dose (CED) of BTEXS were used to measure lung function and exposure levels for 635 workers in 2020, respectively. Forced vital capacity (FVC) and forced expiratory volume in 1 s (FEV₁) were tested and interpreted as percentages to predicted values [FVC or FEV₁% predicted], and FEV₁ to FVC ratio [FEV₁/FVC (%)]. We found the reduction in FVC% predicted and the risk of lung ventilation dysfunction (LVD) and its two subtypes (mixed and restrictive ventilation dysfunction, MVD, and MVD) were significantly associated with BTEXS individuals. In addition, pulmonary function damage associated with BTEXS was modified by the smoking status and age. Generalized weighted quantile sum (gWQS) regressions were used to estimate the overall dose-effect on lung function damage induced by the BTEXS mixture. Our results show wqs, an index of weighted quartiles for BTEXS, was potentially associated with the reduction in FVC and FEV₁% predicted with the coefficients [95% confidence intervals (CI)] between −1.136 (−2.202, −0.070) and −1.230 (−2.265, −0.195). Odds ratios (ORs) and 95% CIs for the wqs index of LVD, MVD, and RVD were 1.362 (1.129, 1.594), 1.323 (1.084, 1.562), and 1.394 (1.096, 1.692), respectively. Furthermore, xylene, benzene, and toluene in the BTEXS mixture potentially contribute to the development of lung function impairment. Our novel findings demonstrated the dose-response relationships between pulmonary function impairment and the BTEXS mixture and disclosed the potential key pollutants in the BTEXS mixture.

The adsorption of microplastic (MPs) on aquifer media is affected by their own properties and environmental factors. Research results have shown that the adsorption capacity of MPs on the three media has the following order: fine sand > medium sand > coarse sand, and the adsorption equilibrium times are 8 h, 12 h and 24 h, respectively. The adsorption process has three stages (fast linear distribution, slow adsorption and equilibrium stability), and the action law is compounded by the pseudo-second-order kinetic equation. After adsorption, MPs were observed on the three media, and there were single existence and aggregation phenomena. The energy spectrum analysis indicates that elemental carbon (C) appears on the surface of the medium after the action occurs, and the surface of the media adsorbs MPs to varying degrees. According to the results of infrared spectroscopy, after action, the peak areas of the absorption peaks at 680-880 cm⁻¹ and 1450-1620 cm⁻¹ increase. The absorption peaks are mainly C–H out-of-plane bending vibrations from aromatic hydrocarbons and C–H stretching vibrations on the benzene ring skeleton. As the initial concentration increases, the equilibrium adsorption capacity increases linearly. The isothermal adsorption of MPs in porous media conforms to the Freundlich model. The adsorption process is also affected by different anions and cations. The higher the ionic strength of NH₄⁺ is, the weaker the electrostatic effect of negatively charged MPs, thereby increasing the adsorption capacity of microplastics on porous media. Ca²⁺ can promote the adsorption of MPs by the media through the formation of ternary complexes between cations, MPs and surface functional groups. The increase in SO₄²⁻ and HCO₃⁻ concentrations gradually inhibits the adsorption of MPs.

India struggles with frequent exceedances of the ambient air quality standard for particulate matter and benzene. In the past two decades, India has made considerable progress in tackling indoor air pollution, by phasing out kerosene lamps, and pushing biofuel using households towards Liquefied Petroleum Gas (LPG) usage. In this study, we use updated emission inventories and trends in residential fuel consumption, to explore changes in the contribution of different sectors towards India's largest air pollution problem. We find that residential fuel usage is still the largest air pollution source, and that the <10% households using cow dung as cooking fuel contribute ∼50% of the residential PM₂.₅ emissions. However, if current trends persist, residential biofuel usage in India is likely to be phased out by 2035. India's renewable energy policies are likely to reduce emissions in the heat and electricity sector, and manufacturing industries, in the mid-term. PM₂.₅ emissions from open waste burning, on the other hand, hardly changed in the decade from 2010 to 2020. We conclude that without strong policies to promote recycling and upcycling of non-biodegradable waste, and the conversion of biodegradable waste to biogas, open waste burning is likely to become India's largest source of air pollution by 2035. While our study is limited to India, our findings are of relevance for other countries in the global South suffering from similar waste management challenges.

Health risks of typical benzene series and halocarbons (BSHs) in a densely populated area near a large-scale chemical industrial park were investigated. Ambient and indoor air and tap water samples were collected in summer and winter; and the concentration characteristics, sources, and exposure risks of typical BSH species, including five benzene series (benzene, toluene, ethylbenzene, o-xylene, m,p-xylene) and five halocarbons (dichloromethane, trichloromethane, trichloroethylene, tetrachloromethane, and tetrachloroethylene), were analysed. The total mean concentrations of BSHs were 53.32 μg m⁻³, 36.29 μg m⁻³, and 26.88 μg L⁻¹ in indoor air, ambient air, and tap water, respectively. Halocarbons dominated the total BSHs with concentrations relatively higher than those in many other industrial areas. Industrial solvent use, industrial processes, and vehicle exhaust emissions were the principal sources of BSHs in ambient air. The use of household products (e.g., detergents and pesticides) was the principal source of indoor BSHs. Inhalation is the primary human exposure route. Ingestion of drinking water was also an important exposure route but had less impact than inhalation. Lifetime non-cancer risks of individual and cumulative BSHs were below the threshold (HQ = 1), indicating no significant lifetime non-cancer risks in the study area. However, tetrachloromethane, benzene, trichloromethane, ethylbenzene, and trichloroethylene showed potential lifetime cancer risk. The cumulative lifetime cancer risks exceeded the tolerable benchmark (1 × 10⁻⁴), indicating a lifetime cancer risk of BSHs to residents near the chemical industry park. This study provides valuable information for the management of public health in chemical industrial parks.

Biodiesel side stream waste glycerol was identified as a cheap carbon source for rhamnolipids (RLs) production which at the same time could improve the management of waste. The present study aimed to produce RLs by using Pseudomonas aeruginosa RS6 utilizing waste glycerol as a substrate and to evaluate their physico-chemicals properties. Fermentation conditions such as temperature, initial medium pH, waste glycerol concentration, nitrogen sources and concentrations resulted in different compositions of the mono- and di-RLs produced. The maximum RLs production of 2.73 g/L was obtained when P. aeruginosa RS6 was grown in a basal salt medium supplemented with 1% waste glycerol and 0.2 M sodium nitrate at 35 °C and pH 6.5. At optimal fermentation conditions, the emulsification index (E₂₄) values of cooking oil, diesel oil, benzene, olive oil, petroleum, and kerosene were all above E₂₄₌50%. The surface tension reduction obtained from 72.13 mN/m to 29.4–30.4 mN/m was better than the surface activity of some chemical-based surfactants. The RLs produced possessed antimicrobial activities against Gram-negative and Gram-positive bacteria with values ranging from 37% to 77% of growth inhibition when 1 mg/mL of RLs was used. Concentrations of RLs below 1500 μg/mL did not induce phytotoxicity effects on the tested seeds (Vigna radiata) compared to the chemical-based- surfactant, SDS. Furthermore, RLs tested on zebrafish (Danio rerio) embryos only exhibited low acute toxicity with an LC₅₀ value of 72.97 μg/mL at 48 h of exposure suggesting a green and eco-biochemical worthy of future applications to replace chemical-based surfactants.