Penicillin fermentation dreg (PFD) is a solid waste discharged by pharmaceutical enterprises in the fermentation production process. Due to the residual antibiotic of PFD, the risk of antibiotic resistance bacteria (ARB) generation should be considered in the disposal process. High-throughput quantitative PCR (HT-qPCR) and 16S rRNA gene sequencing were performed to investigate the effect of PFD on the dynamics of antibiotic resistance genes (ARGs) and bacterial community during a lab-scale soil experiment. After the application of PFD, the bacterial number and diversity showed an obvious decrease in the initial days. The abundances of Streptomyces and Bacillus, which are the most widespread predicted source phyla of ARGs, increased remarkably from 4.42% to 2.59%–22.97% and 21.35%. The increase of ARGs was observed during the PFD application and the ARGs carried by PFD itself contributed to the initiation of soil ARGs. The results of redundancy analysis (RDA) show that the shift in bacterial community induced by variation of penicillin content is the primary driver shaping ARGs compositions.

Oxytracycline (OTC) is a broad spectrum antibiotic authorized for use in European aquaculture. Its photo-degradation has been widely studied in synthetic aqueous solutions, sometimes resorting to expensive methods and without proven effectiveness in natural waters. Thus, this work studied the possibility to apply the solar photo-degradation for removal of OTC from marine aquaculture's waters. For that, water samples were collected at different locals of the water treatment circuit, from two different aquaculture companies. Water samples were firstly characterized regarding to pH, salinity, total suspended solids (TSS), organic carbon and UV–Vis spectroscopic characteristics. Then, the samples were spiked with OTC and irradiated using simulated sunlight in order to evaluate the matrix effects on OTC photo-degradation. From kinetic results, the apparent quantum yields and the outdoor half-life times, at 40°N for midsummer and midwinter days were estimated by the first time for these conditions. For a midsummer day, at sea level, the outdoor half-life time predicted for OTC in these aquaculture's waters ranged between 21 and 25 min. Additionally, the pH and salinity effects on the OTC photo-degradation were evaluated and it has been shown that high pH values and the presence of sea salt increase the OTC photo-degradation rate in aquaculture's waters, compared to results in deionised water. The results are very promising to apply this low-cost methodology using the natural sunlight in aquaculture's waters to remove OTC.

Owing to the production and use of chemicals in chemical industry parks (CIPs), these areas are considered to be highly polluted. However, the type of pollutants presents in the wastewater from CIPs and the risk posed to the environment due to the release of these pollutants remains unclear. In this study, suspect screening was combined with traceability analysis to determine the type of pollutants present in wastewaters at 9 chemical enterprises and wastewater treatment plants (WWTPs) in the CIPs. Additionally, the distribution of nine pollutants from the WWTPs’ effluent stage and the risk they posed to the surrounding river was examined through target analysis. Upon conducting suspect analysis, the presence of 65 and 64 chemicals in the 9 chemical enterprises’ wastewaters and WWTPs, respectively, was tentatively identified. Traceability analysis of the compounds screened in the effluent from the WWTPs determined that 41 substances were identified as characteristic pollutants of the chemical enterprises, indicating that the suspect screening strategy enabled relatively more efficient identification of the characteristic pollutants compared to traditional quantitative analysis. Targeting analysis combined with ecological risk assessment showed that metolachlor, carbendazim, atrazine, diuron, and chlorpyrifos posed relatively higher risks to aquatic organisms in the surrounding river. Therefore, the refined management of the wastewater treatment plant in the CIPs is necessary.

It is a great challenge to identify the many and varied sources of soil heavy metal pollution. Often little information is available regarding the anthropogenic factors and enterprises that could potentially pollute soils. In this study we use freely available geographical data from a search engine in conjunction with machine learning methodologies to identify and classify potentially polluting enterprises in the Yangtze Delta, China. The data were classified into 31 separate and four integrated industry types by five different machine learning approaches. Multinomial naive Bayesian (NB) methods achieved an accuracy of 87% and Kappa coefficient of 0.82 and were used to classify the geographic data from more than 260,000 enterprises. The relationship between the different industry classes and measurements of soil cadmium (Cd) and mercury (Hg) concentrations was explored using bivariate local Moran's I analysis. The analysis revealed areas where different industry classes had led to soil pollution. In the case of Cd, elevated concentrations also occurred in some areas because of excessive fertilization and coal mining. This study provides a new approach to investigate the interaction between anthropogenic pollution and natural sources of soil heavy metals to inform pollution control and planning decisions regarding the location of industrial sites.

In urbanized regions with expansive impervious surfaces and often low vegetation cover, air pollution due to motor vehicles and other combustion sources, is a problem. The poor air quality days in Montreal, Quebec are mainly due to fine particulate matter and ozone. Businesses using wood ovens are a source of particulates. Careful vegetation selection and increased green roof usage can improve air quality. This paper reviews different green roofs and the capability of plants in particulate matter (PM), ozone (O3) as well as nitrogen dioxide (NO2) level reductions. Both the recommended green roof category and plants to reduce these pollutants in Montreal's zone 5 hardiness region are provided. Green roofs with larger vegetation including shrubs and trees, or intensive green roofs, remove air pollutants to a greater extent and are advisable to implement on existing, retrofitted or new buildings. PM is most effectively captured by pines. The small Pinus strobus ‘Nana’, Pinus mugho var. pumilio, Pinus mugho ‘Slowmound’ and Pinus pumila ‘Dwarf Blue’ are good candidates for intensive green roofs. Drought tolerant, deciduous broadleaved trees with low biogenic volatile organic compound emissions including Japanese Maple or Acer palmatum ‘Shaina’ and ‘Mikawa-Yatsubusa’ are options to reduce O3 levels. Magnolias are tolerant to NO2 and it is important in their metabolic pathways. The small cold-tolerant Magnolia ‘Genie’ is a good option to remove NO2 in urban settings and to indirectly reduce O3 formation. Given the emissions by Montreal businesses' wood ovens, calculations performed based on their respective complex roof areas obtained via Google Earth Pro indicates 88% Pinus mugho var. pumilio roof coverage can annually remove 92.37 kg of PM10 of which 35.10 kg is PM2.5. The removal rates are 4.00 g/m2 and 1.52 g/m2 for PM10 and PM2.5, respectively. This paper provides insight to addressing air pollution through urban rooftop greening.

In China, rural chemical SMEs are often believed to still largely operate below the sustainability radar. This paper investigates to what extent and how chemical SMEs are already experiencing pressure to improve their environmental performance, using an in-depth case study in Jasmine County, Hebei province. The results show that local residents had rather low trust in the environmental improvement promises made by the enterprises and the local government, and disagreed with the proposed improvement plans. Although the power of local residents to influence decision making remained limited, the chemical SMEs started to feel increasing pressures to clean up their business, from governments, local communities and civil society, and international value chain stakeholders. Notwithstanding these mounting pressures chemical SME's environmental behavior and performance has not changed radically for the better. The strong economic ties between local county governments and chemical SMEs continue to be a major barrier for stringent environmental regulation.

Irregular discharges of polluted stormwater into drainage systems during base flow (no rainfall) result in acute ecological impacts within fluvial and estuarine environments. In this study, metal and TSS concentrations were significantly more variable during business hours of weekdays (i.e. high-business activity) than weekends/public holidays (i.e. low-business activity) within three highly-urbanised catchments of Sydney estuary (Australia), as determined by analysing multivariate dispersion (PERMDISP). Concentrations of TSS and all metals analysed (Al, Ca, Cu, Fe, Mg, Pb and Zn) were also significantly greater during high- than low-business periods within at least one of the three catchments. In no case were concentrations significantly higher during low- than high-business periods. This pattern of contamination supports the hypothesis that commercial and industrial sources are major contributors of irregular discharges of contamination to Sydney estuary. Irregular discharges and consequential ecological impacts may be effectively reduced in this environment by focussing management efforts on these activities.

Flue gas desulfurized gypsum (FGD gypsum), mainly originates from thermal power plants, smelters, and large-scale enterprise boilers. This article reviews the production in China and the latest beneficial utilizations of FGD gypsum. China is a large coal-consuming country and has always had serious SO₂ emissions. Therefore, the Chinese government has implemented a large number of desulfurization measures since 2006. With continually increasing energy consumption and increasingly stringent environmental requirements, the production of FGD gypsum has exceeded 10⁸ tons. The basic properties and the current beneficial applications of FGD gypsum are summarized here. The practical application of FGD gypsum in four fields—building materials, agriculture, material synthesis, and soil—and its impact on the environment, are analyzed. Finally, a new direction is proposed for the future utilization of FGD gypsum.

To highlight the levels and distributions and to assess the risk of human exposure of chlorinated paraffins (CPs) in PM₂.₅ in China, the concentrations and homologue patterns of short−chain chlorinated paraffins (SCCPs) and medium−chain chlorinated paraffins (MCCPs) in PM₂.₅ from 10 cities in China were studied in 2013 and 2014. The mean concentrations of ΣSCCPs and ΣMCCPs were 19.9 ± 41.1 ng m⁻³ and 15.6 ± 18.6 ng m⁻³, respectively. Unexpectedly, the highest pollution levels occurred in two central cities (Xinxiang and Taiyuan) rather than in well−known eastern megacities such as Beijing, Nanjing, Shanghai, and Guangzhou. By comparing with earlier research, it has indicated the trend of CPs industry shifting from large eastern cities to small and medium-sized cities in central China to some extent. In addition, the composition pattern of SCCPs demonstrated an obviously differences from previous studies, with C₁₁ and Cl₇ predominating and accounting for 45.1% and 24.9%, respectively. Meanwhile, the ratio of MCCPs/SCCPs in most cities was less than 1.00 except for Guangzhou (1.92), Shanghai (1.29), and Taiyuan (1.11). Combined with the results of correlation analysis and principal component analysis, the observed pollution characteristics of CPs in PM₂.₅ had similar sources, which were more influenced by the ratio of MCCPs/SCCPs than by organic carbon, elemental carbon, temperature, population, and gross domestic product. Overall, the composition of CPs reflected the characteristics of local industrial production and consumption, and also implied efforts of Chinese enterprises to reduce the content of short carbon groups of CPs production. The CPs mainly deposited in head airways during the process of entering the human respiratory system. However, at the present levels, there was no significant carcinogenic effect for human health.

Oil extraction activities in the Northern Peruvian Amazon have generated a long-standing socio-environmental conflict between oil companies, governmental authorities and indigenous communities, partly derived from the discharge of produced waters containing high amounts of heavy metals and hydrocarbons. To assess the impact of produced waters discharges we conducted a meta-analysis of 2951 river water and 652 produced water chemical analyses from governmental institutions and oil companies reports, collected in four Amazonian river basins (Marañon, Tigre, Corrientes and Pastaza) and their tributaries. Produced water discharges had much higher concentrations of chloride, barium, cadmium and lead than are typically found in fresh waters, resulting in the widespread contamination of the natural water courses. A significant number of water samples had levels of cadmium, barium, hexavalent chromium and lead that did not meet Peruvian and international water standards. Our study shows that spillage of produced water in Peruvian Amazon rivers placed at risk indigenous population and wildlife during several decades. Furthermore, the impact of such activities in the headwaters of the Amazon extended well beyond the boundaries of oil concessions and national borders, which should be taken into consideration when evaluating large scale anthropogenic impacts in the Amazon.