Organophosphates (OPEs) are manmade organic pollutants that are widely used as flame retardants, plasticizers, and antifoaming and hydraulic agents. In this study, seven OPEs in seawater and sediment from the Yellow Sea and East China Sea were determined to study the distribution and diffusion behavior, and to evaluate the environmental risks. The ΣOPEs in the seawater and sediments ranged from below the method detection limit (<MDL) to 497.40 ng/L and from < MDL to 66.50 ng/g dw, respectively. Tri-n-butyl phosphate (TnBP), tris-(1, 3-Dichloro-2-Propyl) phosphate (TDCPP), and tri-meta-cresyl phosphate (TmCP) were the dominant OPEs in the seawater and sediments. OPEs were mainly distributed in coastal areas and the South Yellow Sea, indicating that they are mainly affected by land-based pollution and ocean currents. Fugacity analysis shows that tri-para-cresyl phosphate (TpCP) was in a state of equilibrium, while TDCPP, TnBP, and TmCP other OPEs tended to diffuse from sediment to water. The diffusion behavior of OPEs is mainly affected by their chemical properties. Hazard quotient (HQ) values of TmCP and TpCP in sediment samples were >1.0, indicating high ecological risks to aquatic organisms.

A dynamic fugacity model was developed to simulate the spatial and seasonal variations of PAHs in Haihe Plain, China. The calculated and measured concentrations exhibited good consistency in magnitude with deviations within a factor of 4 in air and 2 in soil. The spatial distributions of PAHs in air were mainly controlled by emission while the seasonal variations were dominated by emission and gas–particle partition. In soil, the spatial distributions of PAHs were controlled by the soil organic carbon content while the seasonal variations were insignificant. The severest soil contamination was observed in Shanxi and followed by the southwest of Hebei province. Transfer fluxes of total PAHs between air and soil were calculated. The spatial distribution of air-to-soil flux was closely related to the landcover while the soil-to-air flux changed with soil organic matter content. Monte Carlo simulation was done to evaluate the uncertainty of the estimated results in air.

The contribution of ZAMG to MONAROP consists of special weather forecasts to control the SOCs sampling procedure and of the analysis of the specific transport processes for SOCs, which is still in progress. In this paper, air pollutant transport into the Alps is demonstrated by examples of inorganic pollutants: Measurements of NOx and ozone provide evidence for air pollutant transport by local wind systems (valley and slope winds), especially at low elevated sites of the Alps. In addition, trajectory analyses for the high elevation sites demonstrate the importance of large scale synoptic air pollutant transport. The effects of these transport processes with different spatial and temporal scales are governed by the physical and chemical properties of the particular pollutant. First results for the high alpine MONARPOP stations show that air masses from east Europe influence mostly Sonnblick (Austria), whereas the influence of the Po basin is strongest at Weissfluhjoch (Switzerland). Effects of meteorological transport processes on air pollution in the Alps are demonstrated by examples of inorganic pollutants and first conclusions for SOCs are drawn.

This study developed a lightweight air composition measuring equipment (ACME) mounted in unmanned aerial vehicles (UAVs) to measure the vertical distribution characteristics of PM₂.₅ chemical species in the micro-scale urban environment for the first time. 212 samples collected from 0 to 350 m above ground level were analyzed for water-soluble ions. The concentrations of most ions on the above ground level were higher than that on the ground surface during the sampling period. The measurements of the total ion concentrations were approximately 54 to 26% of the PM₂.₅ mass concentrations on the ground surface. The concentrations of NH₄⁺ and NO₃⁻ decreased with increases in the height from the ground, which may be related to the influence of the vehicle emissions and human activities. NO₂⁻ and SO₄²⁻ both had a peak concentration on the higher vertical altitude at night in the sea-land wind system. In the southern wind system, the emissions of sea salts, dust, and stationary pollution, might be transported by the regional prevailing airflow from the southern coastal area, were the major pollutant sources above the boundary layer. The vertical distribution of ionic concentrations and wind field provided information concerning changes in pollutant transport and source regions that affect the local air quality. The ACME mounted in UAVs is the feasible and convenient method to fast understand the vertical distributions of aerosol chemical species. It provides important information about the accumulation and diffusion effects by the boundary layer variation to aerosol characteristics, which is difficulty observed from the conventional ground-based measurements. In future, this technology is the useful application for investigating the pollutant species emitted from the smokestack and the sudden pollution accident.

Mass transfer processes of pollutants from non-aqueous phase liquids (NAPL) may control groundwater pollution at abandoned industrial sites. We studied release kinetics of polycyclic aromatic hydrocarbons (PAHs) from fresh and aged tar phases using a dialysis tubing technique. Time for equilibration ranged from several days to more than three years. For fresh tar materials the release seems to be limited by retarded pore diffusion, while for two of three aged tars diffusion limited release influenced by dissolved organic matter (DOM) was assumed. The equilibration process was driven by solubilization thermodynamics expressed by Raoult's law. Yet, solubility enhancement was observed potentially due to the presence of organic mobile sorbents. The results show that the release of PAHs from tar phases is generally rate limited and partitioning according to Raoult's law is the driving mechanism of the exchanges process.

Contaminated sediments in the St. Lawrence River remain a difficult problem despite decreases in emissions. Here, sediment and pore water phases were analyzed for total mercury (THg) and methyl mercury (MeHg) and diffusion from the sediment to the overlying water was 17.5 ± 10.6 SE ng cm−2 yr−1 for THg and 3.8 ± 1.7 SE ng cm−2 yr−1 for MeHg. These fluxes were very small when compared to the particle-bound mercury flux accumulating in the sediment (183 ± 30 SE ng cm−2 yr−1). Studies have reported that fish from the westernmost site have higher Hg concentrations than fish collected from the other two sites of the Cornwall Area of Concern, which could not be explained by differences in the Hg flux or THg concentrations in sediments, but the highest concentrations of sediment MeHg, and the greatest proportions of MeHg to THg in both sediment and pore water were observed where fish had highest MeHg concentrations.

An open-bottom and a closed-bottom mesocosm were developed to investigate the release of mercury from sediments to the water column in a frozen freshwater lake. The mesoscosms were deployed in a hole in the ice and particulate mercury (HgP) and total dissolved mercury (TDHg) were measured in sediments and in water column vertical profiles. In addition, dissolved gaseous mercury (DGM) in water and mercury water/airflux were quantified. Concentrations of TDHg, DGM, and mercury flux were all higher in the open-bottom mesocosm than in the closed-bottom mesocosm. In this paper we focus on the molecular diffusion of mercury from the sediment in comparison with the TDHg accumulation in the water column. We conclude that the molecular diffusion and sediment resuspension play a minor role in mercury release from sediments suggesting that solute release during ebullition is an important transport process for mercury in the lake. In a frozen lake Hg is released from contaminated sediments mainly due to gas ebullition and molecular diffusion plays a minor role.

Brominated flame retardants (BFRs) are an important group of additives in plastics that increase resistance to ignition and slow down the rate of burning. Because of concerns about their environmental and human health impacts, however, some of the most widely employed BFRs, including hexabromocyclododecane (HBCD) and commercial mixtures of penta-, octa- and deca- (poly)bromodiphenyl ethers (PBDEs), have been restricted or phased out. In this review, the oceanic sources and pathways of PBDEs, the most widely used BFRs, are evaluated and quantified, with particular focus on emissions due to migration from plastics into the atmosphere versus emissions associated with the input of retarded or contaminated plastics themselves. Calculations based on available measurements of PBDEs in the environment suggest that 3.5 and 135 tonnes of PBDEs are annually deposited in the ocean when scavenged by aerosols and through air-water gas exchange, respectively, with rivers contributing a further ∼40 tonnes. Calculations based on PBDE migration from plastic products in use or awaiting or undergoing disposal yield similar net inputs to the ocean but indicate a relatively rapid decline over the next two decades in association with the reduction in the production and recycling of these chemicals. Estimates associated with the input of PBDEs to the ocean when “bound” to marine plastics and microplastics range from about 360 to 950 tonnes per year based on the annual production of plastics and PBDEs over the past decade, and from about 20 to 50 tonnes per annum based on the abundance and distribution of PBDEs in marine plastic litter. Because of the persistence and pervasiveness of plastics in the ocean and diffusion coefficients for PBDEs on the order of 10⁻²⁰ to 10⁻²⁷ m² s⁻¹, microplastics are likely to act as a long-term source of these chemicals though gradual migration. Locally, however, and more important from an ecotoxicological perspective, PBDE migration may be significantly enhanced when physically and chemically weathered microplastics are exposed to the oily digestive fluids conditions of fish and seabirds.

The ARG profiles in pet feces, such as cat and dog feces, and their potential threat to environmental safety are still unclear. In this study, ARGs in 45 cat and 28 dog fecal samples were detected, and a diffusion experiment was performed to assess the risk of ARGs diffusion into the air. The results showed that the abundances of ARGs in cat feces and dog feces were high, and the abundance in dog feces (0.89 ± 0.17 copies/bacterial cell) was significantly higher than that in cat feces (0.46 ± 0.09 copies/bacterial cell) (P < 0.05). The bacterial community, especially Firmicutes and Desulfobacterota in cat feces, and Proteobacteria in dog feces, was the main factor affecting the variation in the ARG profiles, contributing to 31.6% and 32.4% of the variation in cat feces and dog feces, respectively. Physicochemical factors (especially NH₄⁺-N) and age also indirectly affected the variation in the ARG profiles by affecting the bacterial community. In addition, the ARGs in cat feces and dog feces diffused into the air, but there was no evidence that this diffusion posed a threat to environmental safety and human health. These results can provide reference data for healthy animal breeding and the prevention and control of ARG pollution.

Radon is a natural radioactive gas present in the environment, which is considered as the second most important lung cancer cause worldwide. Currently, radon gas is under focus and was classified as contaminant of emerging concern, which is responsible for serious biological/health effects in human. In presented work we propose the numerical model and analysis method for radon diffusion rate measurements and radon transport parameters determination. The experimental setup for radon diffusion was built in a classical, two chamber configuration, in which the radon source and outlet reservoirs are separated by the sample being tested. The main difference with previously known systems is utilization of only one radon detector, what was achieved by a careful characterization of the Rn-222 source and development of a numerical model, which allows for exact determination of radon transport parameters by fitting simulated radon concentration profile in the outlet reservoir to experimental data. For verification of the developed system, several insulation materials commonly used in building industry and civil engineering, as well as, common building materials (gypsum, hardened cement paste, concrete) were tested for radon diffusion rate through these barriers. The results of radon transmittance, permeability and diffusion coefficients for investigated materials are in compliance with values known previously from the literature. The analysis method is fast and efficient, and requires measurement period varying from a dozen or so hours up to 2–3 days depending on material properties. The described method is entirely based on a numerical analysis of the proposed differential equation model using freely available SCILAB software and experimental data obtained during sample measurements.