As energy use in the building sector is increasing worldwide, building materials with characteristics that save energy are becoming increasingly important; in addition, there is an emerging need for high-performance insulation materials with low thermal conductivity. However, thermal insulation should consider thermal conductivity, which is the main performance parameter, in addition to the water adsorption rate, acidity, and deformation and expansion due to drying conditions. This study evaluated the main performance of 21 insulation materials used at construction sites to objectively and clearly evaluate their overall performance, including their thermal conductivity. Thermal conductivity was measured by the heat flow meter method according to ASTM C518 and ISO 8301 standards; it was also evaluated according to the drying conditions. The water absorption rate was evaluated by ISO 2896 to ensure the sustainability and long-term thermal conductivity performance of the material. Acidity was evaluated with ASTM E861 to reduce the environmental load of the buildings and soil. The results of this study reviewed an appropriate method to measure the main performance according to the type of insulation.

The main objective of this study was to assess the uptake and translocation of MnFe₂O₄ magnetic nanoparticles (MNPs) in hydroponically grown barley (Hordeum vulgare L.). Hydrothermally synthesized and well characterized MNPs (average crystallite size of 14.5 ± 0.5 nm) with varied doses (62.5, 125, 250, 500, and 1000 mg L⁻¹) were subjected to the plants at germination and early growing stages (three weeks). The tissues analyzed by vibrating-sample magnetometer (VSM) and transmission electron microscopy (TEM) revealed the uptake and translocation of MNPs, as well as their internalization in the leaf cells. Also, elemental analysis proved that manganese (Mn) and iron (Fe) contents were ∼7–9 times and ∼4–7 times higher in the leaves of MNPs-treated plants than the ones for non-treated control, respectively. 250 mg L⁻¹ of MNPs significantly (at least p < 0.05) promoted the fresh weight (FW, %10.25). However, higher concentrations (500 and 1000 mg L⁻¹) remarkably reduced the increase to %8 and %5, respectively, possibly due to the restricted water uptake. Also, catalase activity was increased from 91 (μM H₂O₂ min⁻¹ mg⁻¹) to 138 in leaves, and decreased to 66 in roots upon 1000 mg L⁻¹ of MNPs application. Chlorophyll and carotenoid contents were not significantly changed, except chlorophyll a (%6 increase at 1000 mg L⁻¹, p < 0.05). Overall, MnFe₂O₄ NPs were up-taken from the roots and migrated to the leaves which promoted the growth parameters of barley. Hence, MNPs can be suggested for barley breeding programs and can be proposed as effective delivery system for agrochemicals. However, the possible negative effect of MNPs due to its potential horizontal transfer from plants to animals via the food chain must be also considered.

It has been postulated that road deicing salts are sufficiently diluted by spring rains to ameliorate any physiological impacts to amphibians breeding in wetlands near roads. We tested this conjecture by exposing clutches of the spotted salamander (Ambystoma maculatum) to three chloride concentrations (1 mg/L, 145 mg/L, 945 mg/L) for nine days, then transferred clutches to control water for nine days, and measured change in mass at three-day intervals. We measured mass change because water uptake by clutches reduces risks to embryos associated with freezing, predation, and disease. Clutches in controls sequestered water asymptotically. Those in the moderate concentrations lost 18% mass initially and regained 14% after transfer to control water. Clutches in high concentration lost 33% mass and then lost an additional 8% after transfer. Our results suggest that spring rains do not ameliorate the effects of deicing salts in wetlands with extremely high chloride concentrations.

Federal agencies of several nations have or are currently developing guidelines for critical forest soil acid loads. These guidelines are used to establish regulations designed to maintain atmospheric acid inputs below levels shown to damage forests and streams. Traditionally, when the critical soil acid load exceeds the amount of acid that the ecosystem can absorb, it is believed to potentially impair forest health. The excess over the critical soil acid load is termed the exceedance, and the larger the exceedance, the greater the risk of ecosystem damage. This definition of critical soil acid load applies to exposure of the soil to a single, long-term pollutant (i.e., acidic deposition). However, ecosystems can be simultaneously under multiple ecosystem stresses and a single critical soil acid load level may not accurately reflect ecosystem health risk when subjected to multiple, episodic environmental stress. For example, the Appalachian Mountains of western North Carolina receive some of the highest rates of acidic deposition in the eastern United States, but these levels are considered to be below the critical acid load (CAL) that would cause forest damage. However, the area experienced a moderate three-year drought from 1999 to 2002, and in 2001 red spruce (Picea rubens Sarg.) trees in the area began to die in large numbers. The initial survey indicated that the affected trees were killed by the southern pine beetle (Dendroctonus frontalis Zimm.). This insect is not normally successful at colonizing these tree species because the trees produce large amounts of oleoresin that exclude the boring beetles. Subsequent investigations revealed that long-term acid deposition may have altered red spruce forest structure and function. There is some evidence that elevated acid deposition (particularly nitrogen) reduced tree water uptake potential, oleoresin production, and caused the trees to become more susceptible to insect colonization during the drought period. While the ecosystem was not in exceedance of the CAL, long-term nitrogen deposition pre-disposed the forest to other ecological stress. In combination, insects, drought, and nitrogen ultimately combined to cause the observed forest mortality. If any one of these factors were not present, the trees would likely not have died. This paper presents a conceptual framework of the ecosystem consequences of these interactions as well as limited plot level data to support this concept. Future assessments of the use of CAL studies need to account for multiple stress impacts to better understand ecosystem response.

Arsenic (As) toxicity is a problem that needs to be solved in terms of both human health and agricultural production in the vast majority of the world. The presence of As causes biomass loss by disrupting the balance of biochemical processes in plants and preventing growth/water absorption in the roots and accumulating in the edible parts of the plant and entering the food chain. A critical method of combating As toxicity is the use of biosafe, natural, bioactive compounds such as hesperidin (HP) or chlorogenic acid (CA). To this end, in this study, the physiological and biochemical effects of HP (100 μM) and CA (50 μM) were investigated in Zea mays under arsenate stress (100 μM). Relative water content, osmotic potential, photosynthesis-related parameters were suppressed under stress. It was determined that stress decreased the activities of the antioxidant system and increased the level of saturated fatty acids and, gene expression of PHT transporters involved in the uptake and translocation of arsenate. After being exposed to stress, HP and CA improved the capacity of superoxide dismutase (SOD), catalase (CAT), peroxidase (POX), glutathione S-transferase (GST) and glutathione peroxidase (GPX) and then ROS accumulation (H₂O₂) and lipid peroxidation (TBARS) were effectively removed. These phenolic compounds contributed to maintaining the cellular redox status by regulating enzyme/non-enzyme activity/contents involved in the AsA-GSH cycle. HP and CA reversed the adverse effects of excessive metal ion accumulation by re-regulated expression of the PHT1.1 and PHT1.3 genes in response to stress. Exogenously applied HP and CA effectively maintained membrane integrity by regulating saturated/unsaturated fatty acid content. However, the combined application of HP and CA did not show a synergistic protective activity against As stress and had a negative effect on the antioxidant capacity of maize leaves. As a result, HP and CA have great potentials to provide tolerance to maize under As stress by reducing oxidative injury and preserving the biochemical reactions of photosynthesis.

Quantitative estimation of soil organic carbon (SOC) is essential for the study of the C cycle and global C storage. Soil spectroscopic technology provides a cost-effective and time-efficient method for SOC quantification and has been successfully used to determine SOC storage. However, the SOC estimation accuracy remains limited by other soil properties, particularly soil water. In this study, we proposed a new deep learning algorithm named the Water Absorption Trough Dewatering Machine (WATDM) to improve estimations of SOC from soil reflectance spectra and reduce the effect of soil water. Soil water and reflectance spectral data of soil samples were measured using spectrometry. Based on the soil water contents derived from the water absorption troughs around 1900 nm, the optimal WATDM model was obtained and treated as the final model of the WATDM method, which performed better than a multiple linear regression model based on moist soil samples. The findings of this study indicate that the WATDM method can improve the estimation accuracy of SOC content by reducing the effect of soil water and can be used as a valuable new methodology within the spectroscopic estimation of soil properties.

Nanoscale zero-valent iron (nZVI) might generate positive and negative effects on plant growth, since it acts as either hazardous or growth-promotion role. It is still unclear whether such dual roles can be mediated by arbuscular mycorrhizal fungi (AMF) in plant-AMF symbiosis. We first identified that in 1.5 g kg⁻¹ nZVI (≤1.5 g kg⁻¹ positively), maize biomass was increased by 15.83%; yet in 2.0 g kg⁻¹ nZVI, it turned to be declined by 6.83%, relative to non-nZVI condition (CK, p < 0.05), showing a negative effect. Interestingly, the inoculation of AMF massively improved biomass by 45.18% in 1.5 g kg⁻¹ nZVI, and relieved the growth inhibition by 2.0 g kg⁻¹ nZVI. The event of water use efficiency followed similar trend as that of biomass. We found that proper concentration of nZVI can positively interact with rhizosphere AMF carrier, enabling more plant photosynthetic carbon to be remobilized to mycorrhiza. The scanning of transmission electron microscopy showed that excessive nZVI can infiltrate into root cortical cells and disrupt cellular homeostasis mechanism, significantly increasing iron content in roots by 76.01% (p < 0.05). Simultaneously, the images of scanning electron microscopy showed that nZVI were attached on root surface to form an insoluble iron ion (Fe³⁺) layer, hindering water absorption. However, they were efficiently immobilized and in situ intercepted by extraradical hyphae in mycorrhizal-nZVI symbiosis, lowering iron translocation efficiency by 6.07% (p < 0.05). Herein, the optimized structure remarkably diminished aperture blockage at root surface and improved root activities by 30.06% (p < 0.05). Particularly, next-generation sequencing demonstrated that appropriate amount of nZVI promoted the colonization and development of Funneliformis mosseae as dominant species in rhizosphere, confirming the positive interaction between AMF and nZVI, and its regulatory mechanism. Therefore, dual effects of nZVI can be actively mediated by AMF via rhizosphere interactions. The findings provided new insights into the safe and efficient application of nanomaterials in agriculture.

During the type approval process of ballast water management systems (BWMS) performance tests need to be conducted according to the BWMS Code (previously Guidelines G8) of the International Maritime Organization (IMO). The shipboard tests previously included a control experiment with untreated ballast water to evaluate the BWMS performance by comparing test results of treated and untreated water. Biological results and abiotic parameters of 97 control water tests conducted during the last >10 years during ballast water uptakes and corresponding discharges were summarized. In general, a strong decline of organisms in ballast tanks was observed, especially during the first few days of the holding time. The IMO validity criteria for uptake water phytoplankton in shipboard control tests were met in 82.5% of all tests. Phytoplankton numbers below the validity criteria occurred predominantly in winter and/or when the water was taken up offshore. For zooplankton the validity criteria were always met. The TSS and POC content in our ballast water uptake samples was frequently much higher than required during IMO BWMS type approval tests so that the current testing requirements do not represent a challenge to BWMS. With this a risk is taken that type approved BWMS fail in water conditions which occur frequently in the real world.

The current study aims to explore the impact of palm oil fuel ash (POFA) heat treatment on the strength activity, porosity, and water absorption of cement mortar. The cement mortar mixtures were typically comprising cement or cement in combination with ultrafine treated POFA (u-TPOFA) which is the final form of the treated POFA, sand, water, and a superplasticizer. Before utilizing the u-TPOFA in mortar mixtures, the treatment processes of POFA were undertaken via five steps (drying at 105 ℃, sieving, grinding, heat treatment, re-grinding) to form u-TPOFA. The heat treatment was performed at three different heating temperatures (i.e., 550 ℃, 600 ℃, and 650 ℃). The ratio on mass/mass basis of the blended ordinary Portland cement (OPC) with u-TPOFA was OPC:u-TPOFA of 70%:30%. A total of four mixtures were prepared, consisting of a plain control mixture (designated as PCM) and three mixtures containing 30% of u-TPOFA treated at three different temperatures designated as M1 “550 ℃,” M2 “600 ℃,” and M3 “650 ℃”. The results show that the optimum mixture was M2 which achieved the highest strength activity index (SAI) of 101.84% and 107% among all mixtures at 7 days and 28 days, respectively. Meanwhile, the porosity (P%) and water absorption (Abs%) of M2 exhibited the lowest values of 9.3% and 4.5%, respectively, among all the mixtures at 28 days. This superior performance of u-TPOFA treated at 600 ℃ represented in the M2 mixture was due to the formation of more binding phases consisting of calcium silicate hydrate (C–S–H) type gel originated from a higher pozzolanic reaction and the filler effects caused by the fine u-TPOFA microparticles. These observations were further confirmed by the improved performance of the M2 mix among all the designed mixes which also exhibited better results in terms of bulk density (BD), ultrasonic pulse velocity (UPV), X-ray diffraction (XRD) as well as thermogravimetry (TGA) and field emission scanning electron microscopy (FESEM-EDX) analyses.

Due to increased industrialization, arsenic (As) in the soil has become a serious issue for wheat production since past few decades. We investigated the role of Azospirillum brasilense and trans-zeatin riboside (tZR) in the mitigation of arsenic toxicity in wheat for 2 years (2018–2019 and 2019–2020) in pot experiments. Wheat plants grown in soil artificially spiked with arsenic (50, 70, and 100 μM) was left alone or amended with A. brasilense, tZR, or their combination as mitigation strategies. A treatment without arsenic or amendments was maintained as control. Arsenic-induced physiological damages were noticed in the wheat plants. Detrimental effects on the plant physiological functions, such as disruption of cell membrane stability, reduced water uptake, and stomatal functions, were noticed with increase in As toxicity. Application of biological amendments reversed the effects of As toxicity by increasing wheat plant growth rate, leaf area, and photosynthesis and also yield. Therefore, application of tZR and wheat seed inoculation with A. brasilense could be a sustainable and environmentally friendly strategy to mitigate arsenic-induced crop physiological damages.