Benzene, toluene, ethylbenzene, xylenes, naphthalene and n-hexane evaporating from a thin oil film was measured for 30 min in a small-scale test system at 2 and 13 °C and the impact of physicochemical properties on airborne benzene with time after bulk oil release was studied. Linear mixed-effects models for airborne benzene in three time periods; first 5, first 15 and last 15 min of sampling, indicated that benzene content in fresh oil, oil group (condensate/light crude oil) and pour point were significant determinants explaining 63–73% of the total variance in the outcome variables. Oils with a high pour point evaporated considerably slower than oils with a low pour point. The mean air concentration of total volatile organic compounds was significatly higher at 13 °C (735 ppm) compared to 2 °C (386 ppm) immediately after release of oil, but at both temperatures the concentration rapidly declined. | acceptedVersion

Benzene, toluene, ethylbenzene, xylenes, naphthalene and n-hexane evaporating from a thin oil film was measured for 30 min in a small-scale test system at 2 and 13 °C and the impact of physicochemical properties on airborne benzene with time after bulk oil release was studied. Linear mixed-effects models for airborne benzene in three time periods; first 5, first 15 and last 15 min of sampling, indicated that benzene content in fresh oil, oil group (condensate/light crude oil) and pour point were significant determinants explaining 63–73% of the total variance in the outcome variables. Oils with a high pour point evaporated considerably slower than oils with a low pour point. The mean air concentration of total volatile organic compounds was significatly higher at 13 °C (735 ppm) compared to 2 °C (386 ppm) immediately after release of oil, but at both temperatures the concentration rapidly declined.

International audience | The nanoscale size of plastic debris makes them potential efficient vectors of many pollutants and more especially of metals. In order to evaluate this ability, nanoplastics were produced from microplastics collected on a beach exposed to the North Atlantic Gyre. The nanoplastics were characterized using multi-dimensional methods: asymmetrical flow field flow fractionation and dynamic light scattering coupled to several detectors. Lead (II) adsorption kinetics, isotherm and pH-edge were then carried out. The sorption reached a steady state after around 200 min. The maximum sorption capacity varied between 97% and 78.5% for both tested Pb concentrations. Lead (II) adsorption kinetics is controlled by chemical reactions with the nanoplastics surface and to a lesser extent by intraparticle diffusion. Adsorption isotherm modeling using Freundlich model demonstrated that NPG are strong adsorbents equivalent to hydrous ferric oxides such as ferrihydrite (log against 11.76 for NPG and ferrihydrite, respectively). The adsorption is dependent upon pH, in response to the Pb(II) adsorption by the oxygenated binding sites developed on account of the surface UV oxidation under environmental conditions. They could be able to compete with Fe or humic colloids for Pb binding regards to their amount and specific areas. Nanoplastics could therefore be efficient vectors of Pb and probably of many other metals as well in the environment.

The nanoscale size of plastic debris makes them potential efficient vectors of many pollutants and more especially of metals. In order to evaluate this ability, nanoplastics were produced from microplastics collected on a beach exposed to the North Atlantic Gyre. The nanoplastics were characterized using multi-dimensional methods: asymmetrical flow field flow fractionation and dynamic light scattering coupled to several detectors. Lead (II) adsorption kinetics, isotherm and pH-edge were then carried out. The sorption reached a steady state after around 200 min. The maximum sorption capacity varied between 97% and 78.5% for both tested Pb concentrations. Lead (II) adsorption kinetics is controlled by chemical reactions with the nanoplastics surface and to a lesser extent by intraparticle diffusion. Adsorption isotherm modeling using Freundlich model demonstrated that NPG are strong adsorbents equivalent to hydrous ferric oxides such as ferrihydrite (log Kadsfreundlich=8.36 against 11.76 for NPG and ferrihydrite, respectively). The adsorption is dependent upon pH, in response to the Pb(II) adsorption by the oxygenated binding sites developed on account of the surface UV oxidation under environmental conditions. They could be able to compete with Fe or humic colloids for Pb binding regards to their amount and specific areas. Nanoplastics could therefore be efficient vectors of Pb and probably of many other metals as well in the environment.

International audience | Environmental contamination is one of the major factors or cofactors affecting amphibian populations. Since 2000, the number of studies conducted in laboratory conditions to understand impacts of chemical exposures increased. They aimed to characterize biological effects on amphibians. This review proposes an overview of biological responses reported after exposures to metals, phytopharmaceuticals or emerging organic contaminants and focuses on endpoints relating to reproduction and development. Due to amphibian peculiar features, these periods of their life cycle are especially critical to pollutant exposures. Despite the large range of tested compounds, the same model species are often used as biological models and morphological alterations are the most studied observations. From the results, the laboratory-to-field extrapolation remained uneasy and exposure designs have to be more elaborated to be closer to environmental conditions. Few studies proposed such experimental approaches. Lastly, gametes, embryos and larvae constitute key stages of amphibian life cycle that can be harmed by exposures to freshwater pollutants. Specific efforts have to be intensified on the earliest stages and notably germ cells.

Environmental contamination is one of the major factors or cofactors affecting amphibian populations. Since 2000, the number of studies conducted in laboratory conditions to understand impacts of chemical exposures increased. They aimed to characterize biological effects on amphibians. This review proposes an overview of biological responses reported after exposures to metals, phytopharmaceuticals or emerging organic contaminants and focuses on endpoints relating to reproduction and development. Due to amphibian peculiar features, these periods of their life cycle are especially critical to pollutant exposures.Despite the large range of tested compounds, the same model species are often used as biological models and morphological alterations are the most studied observations. From the results, the laboratory-to-field extrapolation remained uneasy and exposure designs have to be more elaborated to be closer to environmental conditions. Few studies proposed such experimental approaches. Lastly, gametes, embryos and larvae constitute key stages of amphibian life cycle that can be harmed by exposures to freshwater pollutants. Specific efforts have to be intensified on the earliest stages and notably germ cells.

International audience | A novel FeSiCa rich material (IS), chicken manure (CM) and its biochar were investigated for their efficiency in simultaneous remediation of Cd and As uptake by the vegetable Brassica chinensis L. Wet chemistry analysis and X-ray powder diffraction, scanning electron microscopy/energy dispersive X-ray spectroscopy as well as Fourier transform infrared spectroscopy were used to reveal the mechanisms responsible for Cd and As fixation in the amended soils. The IS treatment performed best in reducing Cd uptake, while the combination of IS and CM was the optimal one for As fixation. The precipitation/co-precipitation (in cadmium silicate/phosphate/phosphate hydroxide, cadmium iron and manganese oxides under alkaline conditions, and calcium/magnesium/ferric arsenates) and specific chemisorption (by amorphous iron/manganese oxides) were proved to be more efficient in simultaneously lowering As and Cd phytoavailability than was organic complexation. These findings demonstrate that FeSiCa and FeSiCaC amendments are highly efficient and promising in-situ remediation systems for safe crop production on soils contaminated with Cd and As.

A novel FeSiCa rich material (IS), chicken manure (CM) and its biochar were investigated for their efficiency in simultaneous remediation of Cd and As uptake by the vegetable Brassica chinensis L. Wet chemistry analysis and X-ray powder diffraction, scanning electron microscopy/energy dispersive X-ray spectroscopy as well as Fourier transform infrared spectroscopy were used to reveal the mechanisms responsible for Cd and As fixation in the amended soils. The IS treatment performed best in reducing Cd uptake, while the combination of IS and CM was the optimal one for As fixation. The precipitation/co-precipitation (in cadmium silicate/phosphate/phosphate hydroxide, cadmium iron and manganese oxides under alkaline conditions, and calcium/magnesium/ferric arsenates) and specific chemisorption (by amorphous iron/manganese oxides) were proved to be more efficient in simultaneously lowering As and Cd phytoavailability than was organic complexation. These findings demonstrate that FeSiCa and FeSiCaC amendments are highly efficient and promising in-situ remediation systems for safe crop production on soils contaminated with Cd and As.

The impact of ozone (O3) pollution events on the plant drought response needs special attention because spring O3 episodes are often followed by summer drought. By causing stomatal sluggishness, O3 could affect the stomatal dynamic during a subsequent drought event. In this context, we studied the impact of O3 exposure and water deficit (in the presence or in the absence of O3 episode) on the stomatal closure/opening mechanisms relative to irradiance or vapour pressure deficit (VPD) variation. Two genotypes of Populus nigra x deltoides were exposed to various treatments for 21 days. Saplings were exposed to 80 ppb/day O3 for 13 days, and then to moderate drought for 7 days. The curves of the stomatal response to irradiance and VPD changes were determined after 13 days of O3 exposure, and after 21 days in the case of subsequent water deficit, and then fitted using a sigmoidal model. The main responses under O3 exposure were stomatal closure and sluggishness, but the two genotypes showed contrasting responses. During stomatal closure induced by a change in irradiance, closure was slower for both genotypes. Nonetheless, the genotypes differed in stomatal opening under light. Carpaccio stomata opened more slowly than control stomata, whereas Robusta stomata tended to open faster. These effects could be of particular interest, as stomatal impairment was still present after O3 exposure and could result from imperfect recovery. Under water deficit alone, we observed slower stomatal closure in response to VPD and irradiance, but faster stomatal opening in response to irradiance, more marked in Carpaccio. Under the combined treatment, most of the parameters showed antagonistic responses. Our results highlight that it is important to take genotype-specific responses and interactive stress cross-talk into account to improve the prediction of stomatal conductance in response to various environmental modifications.

The impact of ozone (O3) pollution events on the plant drought response needs special attention because spring O3 episodes are often followed by summer drought. By causing stomatal sluggishness, O3 could affect the stomatal dynamic during a subsequent drought event. In this context, we studied the impact of O3 exposure and water deficit (in the presence or in the absence of O3 episode) on the stomatal closure/opening mechanisms relative to irradiance or vapour pressure deficit (VPD) variation. Two genotypes of Populus nigra x deltoides were exposed to various treatments for 21 days. Saplings were exposed to 80 ppb/day O3 for 13 days, and then to moderate drought for 7 days. The curves of the stomatal response to irradiance and VPD changes were determined after 13 days of O3 exposure, and after 21 days in the case of subsequent water deficit, and then fitted using a sigmoidal model. The main responses under O3 exposure were stomatal closure and sluggishness, but the two genotypes showed contrasting responses. During stomatal closure induced by a change in irradiance, closure was slower for both genotypes. Nonetheless, the genotypes differed in stomatal opening under light. Carpaccio stomata opened more slowly than control stomata, whereas Robusta stomata tended to open faster. These effects could be of particular interest, as stomatal impairment was still present after O3 exposure and could result from imperfect recovery. Under water deficit alone, we observed slower stomatal closure in response to VPD and irradiance, but faster stomatal opening in response to irradiance, more marked in Carpaccio. Under the combined treatment, most of the parameters showed antagonistic responses. Our results highlight that it is important to take genotype-specific responses and interactive stress cross-talk into account to improve the prediction of stomatal conductance in response to various environmental modifications.