In winter wheat (Triticum aestivum L.)-summer maize (Zea mays L.) rotation system in the North China Plain, maize roots do not extend beyond 1.2 m in the vertical soil profile, but wheat roots can reach up to 2.0 m. Increases in soil nitrate content at maize harvest and significant reductions after winter wheat harvest were observed in the 1.4-2.0 m depth under field conditions. The recovery of 15N isotope (calcium nitrate) from various (1.0, 1.2, 1.4, 1.6, 1.8 and 2.0 m) soil depths showed that deep-rooting winter wheat could use soil nitrate up to the 2.0 m depth. This accounted partially, for the reduced nitrate in the 1.4-2.0 m depth of the soil after harvest of wheat in the rotation system. Deep-rooted wheat can recycle nitrate leached from maize root zone in winter wheat-summer maize rotation system.

Some of the greatest forest health impacts in North America are caused by invasive forest insects and pathogens (e.g., emerald ash borer and sudden oak death in the US), by severe outbreaks of native pests (e.g., mountain pine beetle in Canada), and fires exacerbated by changing climate. Ozone and N and S pollutants continue to impact the health of forests in several regions of North America. Long-term monitoring of forest health indicators has facilitated the assessment of forest health and sustainability in North America. By linking a nationwide network of forest health plots with the more extensive forest inventory, forest health experts in the US have evaluated current trends for major forest health indicators and developed assessments of future risks. Canada and Mexico currently lack nationwide networks of forest health plots. Development and expansion of these networks is critical to effective assessment of future forest health impacts.

Upcoming decades will experience increasing atmospheric CO2 and likely enhanced O3 exposure which represents a risk for the carbon sink strength of forests, so that the need for cause-effect related O3 risk assessment increases. Although assessment will gain in reliability on an O3 uptake basis, risk is codetermined by the effective dose, i.e. the plant's sensitivity per O3 uptake. Recent progress in research on the molecular and metabolic control of the effective O3 dose is reported along with advances in empirically assessing O3 uptake at the whole-tree and stand level. Knowledge on both O3 uptake and effective dose (measures of stress avoidance and tolerance, respectively) needs to be understood mechanistically and linked as a pre-requisite before practical use of process-based O3 risk assessment can be implemented. To this end, perspectives are derived for validating and promoting new O3 fluxbased modelling tools.

A detailed investigation was conducted to understand the contamination characteristics of a selected set of potentially toxic metals in Shanghai. The amount of Pb, Zn, Cu, Cr, Cd and Ni were determined from 273 soil/dust samples collected within urban area. The results indicated that concentration of all metals except Ni in soils was significant, and metal pollution was even severer in roadside dust. A series of metal spatial distribution maps were created through geostatistical analysis, and the pollution hotspots tended to associate with city core area, major road junctions, and the regions close to industrial zones. In attempt of identifying the source of metals through geostatistical and multivariate statistical analyses, it was concluded as follows: Pb, Zn and Cu mainly originated from traffic contaminants; soil Ni was associated with natural concentration; Cd largely came from point-sourced industrial pollution; and Cr, Ni in dust were mainly related to atmospheric deposition. Human activities have led to high accumulation of potentially toxic metals in urban soils and roadside dust of Shanghai.

We present a user-friendly tool for footprint calculations of flux measurements in the surface layer. The calculations are based on the analytical footprint model by Kormann, R. and Meixner, F.X. [2001. An analytical footprint model for Non-neutral Stratification. Boundary-Layer Meteorology 99, 207-224]. The footprint density function of a flux sensor is determined using readily available data from standard eddy covariance measurements. This footprint density function is integrated over defined surface areas given as quadrangular polygons representing e.g. agricultural fields. We illustrate the use and performance of the tool by applying it to CO2 flux measurements with three eddy covariance system at the Swiss CarboEurope grassland site. Two flux towers were positioned in the centre of two neighbouring fields, respectively, that showed a very different CO2 flux during the study period. The third tower was located near the border of the two fields and was frequently influenced by both fields to a similar degree. The calculated footprint fractions were used to simulate the latter flux from the other two systems. The measured and simulated fluxes showed a good agreement and thus support the reliability of the footprint calculation. The presented simple footprint tool can be used as a routine quality check for flux monitoring stations influenced by surface areas with varying vegetation covers and/or land-use. A simple tool for operational footprint calculations is presented and its reliability is assessed using CO2 flux measurements in a patchy agricultural landscape.

Solid-phase microextraction coupled with gas chromatography-mass spectrometry (SPME-GC-MS) was used to analyze two triazine (atrazine and simazine) and three chloroacetamide herbicides (acetochlor, alachlor, and metolachlor) in water samples from a midwest US agricultural drainage ditch for two growing seasons. The effects of salt concentration, sample volume, extraction time, and injection time on extraction efficiency using a 100-μm polydimethylsiloxane-coated fiber were investigated. By optimizing these parameters, ditch water detection limits of 0.5 μg L-1 simazine and 0.25 μg L-1 atrazine, acetochlor, alachlor, and metolachlor were achieved. The optimum salt concentration was found to be 83% NaCl, while sample volume (10 or 20 mL) negligibly affected analyte peak areas. The optimum extraction time was 40 min, and the optimum injection time was 15 min. Results indicated that atrazine levels in the ditch water exceeded the US maximum contaminant level for drinking water 12% of the time, and atrazine was the most frequently detected among studied analytes. Solid-phase microextraction methods were successfully developed to quantify low levels of herbicides in tile-fed drain water by gas chromatography-mass spectrometry.

Metazachlor is a frequently used herbicide with concentrations in surface waters up to 100 μg L-1. A long-term mesocosm study was performed in order to investigate effects on stream and pond communities also regarding recovery. Single metazachlor doses of 5, 20, 80, 200, and 500 μg L-1 were given and the aquatic communities monitored for 140 days. In this paper, special attention is paid to the plankton response and the results of the entire study are summarised. Metazachlor strongly affected the stream and pond mesocosm communities at concentrations higher than 5 μg L-1. Direct negative effects were most prominent for chlorophytes whereas diatoms and cryptophytes seemed insensitive. The effects on zooplankton were caused by changes in habitat structure due to the strong decline of macrophytes. The slow degradation of metazachlor combined with the absence of recovery in both chlorophytes and macrophytes is likely to cause long-lasting effects on aquatic ecosystems. Metazachlor at levels >5 μg L-1 is likely to cause long-lasting effects in macrophyte dominated aquatic communities.

The effective quantum yield of photochemical energy conversion in photosystem II (Φ2) was shown to be reduced in the terricolous lichens Cetraria aculeata and Cetraria islandica by short-term exposure to aqueous SO2 at pH values occurring in the precipitation of areas with high SO2 pollution. Significant reduction of Φ2 was found at pH <= 3.3. At pH 2.8, Φ2 was close to zero and did not recover within 24 h. This suggests that sensitivity to SO2 (primarily associated with epiphytic lichens in the past) has contributed to the decline of both species in central Europe. In C. islandica, but not in C. aculeata, thalli with the natural content of lichen substances were more tolerant to SO2 than thalli where the extracellular lichen substances were extracted before the experiment. This supports published results that the depsidone fumarprotocetraric acid, a major lichen substance of C. islandica, increases the pollution tolerance in lichens. Artificial acidic precipitation with aqueous sulphur dioxide at pH 2.8-3.5 affects terricolous Cetraria species.

This study focuses on magnetic susceptibility processing and analysis towards fast and cost-efficient discrimination and semi-quantification of anthropogenic heavy metal loads in soil. Spatial variability of magnetic susceptibility was investigated on sets of soil cores from both “polluted” and “less polluted” forest soil close to a steel mill near Leoben, Austria. Test sites of 10 m2 represent “site scale” dimensions. Statistical analysis of magnetic data provides a boundary depth indicating the transition from the “polluted” to the deeper, “unpolluted” zone in contaminated natural soil. Introduction of a block master curve simplifies the complex variations of individual curves, and represents magnetic susceptibility at “site scale”. For linking the block master curve to heavy metals we only require magnetic susceptibility data from one soil core and heavy metal data from two sub-samples from the same core. Our optimized magnetic susceptibility data processing scheme provides an applicable tool to semi-quantify anthropogenic heavy metal loads in soil.

Motor vehicles emit a cocktail of pollutants; however, little is known about the effects of these pollutants on bryophytes located in roadside habitats. Six bryophyte species were transplanted to either a woodland or a moorland site adjacent to a motorway, and were monitored over seven months from autumn through to spring. All species showed an increase in one or more of the following near the motorway: growth, membrane leakage, chlorophyll concentration, and nitrogen concentration. The strongest effects were observed in the first 50–100 m from the motorway: this was consistent with the nitrogen dioxide pollution profile, which decreased to background levels at a distance of 100–125 m. It is hypothesised that motor vehicle pollution was responsible for the effects observed, and that nitrogen oxides had a key influence. The observed effects may lead to changes in vegetation composition with significant implications for nature conservation and management of roadside sites. Motor vehicle pollution has significant effects on the growth, membrane leakage, chlorophyll and nitrogen content of bryophytes.